Victoria Rigual
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Victoria Rigual has a total of 32 co-authors. Here are the top co-authors by number of shared publications:
Francisco Rodriguez
Department of Chemical Engineering and Materials, Complutense University of Madrid, 28040 Madrid, Spain
9 shared publications- Juan Carlos Domínguez
Department of Chemical Engineering and Materials, Complutense University of Madrid, 28040 Madrid, Spain
9 shared publications M. Virginia Alonso
Department of Chemical Engineering and Materials, Complutense University of Madrid, 28040 Madrid, Spain
9 shared publicationsMercedes Oliet
Department of Chemical Engineering and Materials, Complutense University of Madrid, Av Complutense s/n, Madrid 28040, Spain
8 shared publications- Antonio Ovejero-Pérez
Imperial College London South Kensington Campus, Exhibition Road
5 shared publications - Mercedes Oliet
Department of Chemical Engineering and Materials, Complutense University of Madrid, 28040 Madrid, Spain
5 shared publications
Latest Publications
- 17 June 2026
- Published by Wiley in ChemSusChem
- Vol. 19 (12) , e70776
Recovery of Monoethanolammonium Acetate from Ionosolv Liquors Using a γ–Valerolactone–Based Aqueous Two–Phase System
Ionic liquids (ILs) enable efficient lignin extraction in the Ionosolv process, but their sustainable implementation requires effective lignin recovery from IL extract to allow IL recycling. Conventional water‐based precipitation of lignin is energy intensive due to the high enthalpy of vaporization of water. In this work, we propose a γ‐valerolactone (GVL)‐based aqueous two‐phase system (ATPS) as a more energy‐efficient separation strategy. The phase behavior of the ternary ATPS water + GVL + monoethanolammonium acetate ([MEA][OAc]) was experimentally determined and correlated using the thermodynamic non‐random two‐liquid model. Then, lignin was extracted from Eucalyptus wood using the IL [MEA][OAc]. Application of this ATPS to the Ionosolv liquor enabled selective partitioning of lignin into the GVL‐rich phase, followed by its isolation using low‐enthalpy organic antisolvents (acetone, tert‐butanol, 2‐propanol, or 1‐butanol). The GVL‐rich phases were examined for suspended lignin particles. Structural characterization by 2D‐NMR confirmed precipitated lignins exhibit high syringyl content and low degrees of recondensation, resulting in materials with enhanced depolymerizability. These findings show that GVL‐based ATPSs are a promising lower‐energy downstream option for lignin recovery from Ionosolv liquors. Relative to conventional water precipitation, the proposed route lowers solvent‐regeneration energy demand by up to 44% while preserving favorable lignin structural features.
- 17 June 2026
- Published by Wiley in ChemSusChem
- Vol. 19 (12) , e70776
Recovery of Monoethanolammonium Acetate from Ionosolv Liquors Using a γ–Valerolactone–Based Aqueous Two–Phase System
Ionic liquids (ILs) enable efficient lignin extraction in the Ionosolv process, but their sustainable implementation requires effective lignin recovery from IL extract to allow IL recycling. Conventional water‐based precipitation of lignin is energy intensive due to the high enthalpy of vaporization of water. In this work, we propose a γ‐valerolactone (GVL)‐based aqueous two‐phase system (ATPS) as a more energy‐efficient separation strategy. The phase behavior of the ternary ATPS water + GVL + monoethanolammonium acetate ([MEA][OAc]) was experimentally determined and correlated using the thermodynamic non‐random two‐liquid model. Then, lignin was extracted from Eucalyptus wood using the IL [MEA][OAc]. Application of this ATPS to the Ionosolv liquor enabled selective partitioning of lignin into the GVL‐rich phase, followed by its isolation using low‐enthalpy organic antisolvents (acetone, tert‐butanol, 2‐propanol, or 1‐butanol). The GVL‐rich phases were examined for suspended lignin particles. Structural characterization by 2D‐NMR confirmed precipitated lignins exhibit high syringyl content and low degrees of recondensation, resulting in materials with enhanced depolymerizability. These findings show that GVL‐based ATPSs are a promising lower‐energy downstream option for lignin recovery from Ionosolv liquors. Relative to conventional water precipitation, the proposed route lowers solvent‐regeneration energy demand by up to 44% while preserving favorable lignin structural features.
- 18 November 2025
- Published by Wiley in Computer Applications in Engineering Education
- Vol. 33 (6)
Teaching Multivariate Optimization in Process Systems Engineering Through a Case‐Based Learning Methodology
Process Systems Engineering (PSE) is a pillar of Chemical Engineering. It has undergone a great change during the last decades due to the depletion of natural resources, environmental regulations, and increased global business competitiveness. All this has led to an evolution towards the integration and intensification of processes, which requires solving complex and multivariate decision problems. Process optimization provides a scientifically proven methodology for finding the best alternatives in making these decisions through mathematical and computational models. This paper describes a set of exercises integrated into a project that aimed to teach basic concepts of multivariable optimization in the real context of the refining and petrochemical industry within a course in PSE in the BSc degree in Chemical Engineering. For this, the proposed cases were solved using MS Excel Solver. The experience was successful since the students were able to learn the concepts and acquire the skills needed to solve the cases successfully, and this was reflected in the grades obtained. Furthermore, the survey results on the activity, employed to get feedback from the students, showed excellent acceptance.
- 18 November 2025
- Published by Wiley in Computer Applications in Engineering Education
- Vol. 33 (6)
Teaching Multivariate Optimization in Process Systems Engineering Through a Case‐Based Learning Methodology
Process Systems Engineering (PSE) is a pillar of Chemical Engineering. It has undergone a great change during the last decades due to the depletion of natural resources, environmental regulations, and increased global business competitiveness. All this has led to an evolution towards the integration and intensification of processes, which requires solving complex and multivariate decision problems. Process optimization provides a scientifically proven methodology for finding the best alternatives in making these decisions through mathematical and computational models. This paper describes a set of exercises integrated into a project that aimed to teach basic concepts of multivariable optimization in the real context of the refining and petrochemical industry within a course in PSE in the BSc degree in Chemical Engineering. For this, the proposed cases were solved using MS Excel Solver. The experience was successful since the students were able to learn the concepts and acquire the skills needed to solve the cases successfully, and this was reflected in the grades obtained. Furthermore, the survey results on the activity, employed to get feedback from the students, showed excellent acceptance.
- Open Access
- 19 August 2025
- Published by Royal Society of Chemistry (RSC) in Faraday Discussions
- Vol. 263, 65-80
Comparison of bottom-up and top-down precipitation strategies for lignin nanoparticle obtention from organosolv and ionosolv Eucalyptus globulus liquors
A side-by-side comparison is carried out between organosolv and ionosolv liquors employed in the formation of lignin nanoparticles.
- 19 August 2025
- Published by Royal Society of Chemistry (RSC) in Faraday Discussions
- Vol. 263, 65-80
Open AccessComparison of bottom-up and top-down precipitation strategies for lignin nanoparticle obtention from organosolv and ionosolv Eucalyptus globulus liquors
A side-by-side comparison is carried out between organosolv and ionosolv liquors employed in the formation of lignin nanoparticles.
- Open Access
- 6 May 2025
- Published by Elsevier in Industrial Crops and Products
- Vol. 230
Selective precipitation of ionosolv lignins: Replacing water with low enthalpy of vaporization antisolvents
- 6 May 2025
- Published by Elsevier in Industrial Crops and Products
- Vol. 230
Open AccessSelective precipitation of ionosolv lignins: Replacing water with low enthalpy of vaporization antisolvents
- Open Access
- 27 March 2023
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 13 (15) , 10338-10348
Effect of autohydrolysis and ionosolv treatments on eucalyptus fractionation and recovered lignin properties
This work enhances the understanding of the effect of autohydrolysis and ionosolv treatments combination on fractionation yields and lignin properties.
- 27 March 2023
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 13 (15) , 10338-10348
Open AccessEffect of autohydrolysis and ionosolv treatments on eucalyptus fractionation and recovered lignin properties
This work enhances the understanding of the effect of autohydrolysis and ionosolv treatments combination on fractionation yields and lignin properties.
- Open Access
- 19 January 2022
- Published by Springer Nature in Biomass Conversion and Biorefinery
- Vol. 14 (1) , 451-464
Fractionation of Pinus radiata by ethanol-based organosolv process
The lignocellulosic materials are promising feedstock to produce biofuels and bioproducts in the biorefinery framework. However, a pretreatment step is required to disrupt lignin-carbohydrate complex. In this work, the fractionation of Pinus radiata wood into its main components, cellulose-rich delignified solid, recovered lignin after precipitation, and soluble-in-black liquor hemicellulose, was studied. For this purpose, an organosolv process employing ethanol/water mixture as solvent in absence of a catalyst was carried out. The effects of operating conditions on delignified solid were evaluated by using a 23 central composite experimental design, being the responses delignified solid yield, delignification degree, hemicellulose content, and glucan content. The variables studied were temperature (170–200 °C), time (50–100 min), and ethanol concentration (40–60%). The increase of organosolv severity (temperature and time) and reduction of ethanol concentration favor the glucan enrichment of delignified solid, due to lignin removal and hemicellulose solubilization. A glucan content of more than 66% is obtained by applying temperature higher than 195 °C and time longer than 90 min, when 40 wt% alcohol concentration is used. The liquid fraction obtained during the organosolv process (black liquors) was used to recover lignin and hemicellulosic fractions solubilized. Furthermore, hemicellulose and lignin content of delignified solid was correlated with the thermal stability measured as T10%.
- 19 January 2022
- Published by Springer Nature in Biomass Conversion and Biorefinery
- Vol. 14 (1) , 451-464
Open AccessFractionation of Pinus radiata by ethanol-based organosolv process
The lignocellulosic materials are promising feedstock to produce biofuels and bioproducts in the biorefinery framework. However, a pretreatment step is required to disrupt lignin-carbohydrate complex. In this work, the fractionation of Pinus radiata wood into its main components, cellulose-rich delignified solid, recovered lignin after precipitation, and soluble-in-black liquor hemicellulose, was studied. For this purpose, an organosolv process employing ethanol/water mixture as solvent in absence of a catalyst was carried out. The effects of operating conditions on delignified solid were evaluated by using a 23 central composite experimental design, being the responses delignified solid yield, delignification degree, hemicellulose content, and glucan content. The variables studied were temperature (170–200 °C), time (50–100 min), and ethanol concentration (40–60%). The increase of organosolv severity (temperature and time) and reduction of ethanol concentration favor the glucan enrichment of delignified solid, due to lignin removal and hemicellulose solubilization. A glucan content of more than 66% is obtained by applying temperature higher than 195 °C and time longer than 90 min, when 40 wt% alcohol concentration is used. The liquid fraction obtained during the organosolv process (black liquors) was used to recover lignin and hemicellulosic fractions solubilized. Furthermore, hemicellulose and lignin content of delignified solid was correlated with the thermal stability measured as T10%.
- Open Access
- 16 June 2021
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 9 (25) , 8467-8476
Technoeconomic Assessment of a Biomass Pretreatment + Ionic Liquid Recovery Process with Aprotic and Choline Derived Ionic Liquids
- 16 June 2021
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 9 (25) , 8467-8476
Open AccessTechnoeconomic Assessment of a Biomass Pretreatment + Ionic Liquid Recovery Process with Aprotic and Choline Derived Ionic Liquids
- 1 September 2020
- Published by Elsevier in Food and Bioproducts Processing
- Vol. 123, 398-408
A biorefinery strategy for the manufacture and characterization of oligosaccharides and antioxidants from poplar hemicelluloses
- 1 September 2020
- Published by Elsevier in Food and Bioproducts Processing
- Vol. 123, 398-408
A biorefinery strategy for the manufacture and characterization of oligosaccharides and antioxidants from poplar hemicelluloses
- 25 November 2019
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 8 (2) , 782-791
Evaluating Protic Ionic Liquid for Woody Biomass One-Pot Pretreatment + Saccharification, Followed by Rhodosporidium toruloides Cultivation
- 25 November 2019
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 8 (2) , 782-791
Evaluating Protic Ionic Liquid for Woody Biomass One-Pot Pretreatment + Saccharification, Followed by Rhodosporidium toruloides Cultivation
- 1 October 2019
- Published by Elsevier in Industrial Crops and Products
- Vol. 138
Application of microscopy techniques for a better understanding of biomass pretreatment
- 1 October 2019
- Published by Elsevier in Industrial Crops and Products
- Vol. 138
Application of microscopy techniques for a better understanding of biomass pretreatment