Huafeng Xiao
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Huafeng Xiao has a total of 63 co-authors. Here are the top co-authors by number of shared publications:
- Ming Cheng
Southeast University
15 shared publications - Ruibin Wang
Southeast University
9 shared publications Xiaobiao Wang
School of Electrical Engineering, Southeast University, Nanjing, China
9 shared publications- Chenhui Niu
China Huaneng Jiangsu Company
7 shared publications - Mingming Li
Jiangsu Ocean University
7 shared publications - Kairong Qian
China Huaneng Jiangsu Company
6 shared publications
Latest Publications
- 5 May 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 41 (9) , 14437-14443
Integrated Harmonic Mitigation and Fault Current Limiting for Grid-Forming Inverters
In microgrids with high penetration of power electronics-interfaced sources, harmonic distortion from nonlinear loads degrades the power quality at the terminals of virtual synchronous generators (VSGs). Conventional impedance-reshaping methods mitigate harmonics by reducing output impedance but often exacerbate fault currents during voltage sags. This letter proposes an integrated control strategy for harmonic mitigation and fault current limiting based on Virtual Forced Excitation Control (VFEC). The scheme extracts harmonic components from the point of common coupling (PCC) voltage and directly superimposes them onto the amplitude command of the internal electromotive force (EMF) of the VSG. Under normal operation, this mechanism reduces the equivalent output impedance at harmonic frequencies, thereby attenuating nonlinear harmonic content and improving PCC voltage quality. During grid faults, the same architecture leverages inherent amplitude limiting to prevent overmodulation without control mode transitions or auxiliary circuits, effectively restricting fault currents to levels comparable to conventional VSGs and significantly below those of impedance-reshaping approaches. The proposed strategy ensures full compatibility with standard VSG control frameworks. Experimental results validate its effectiveness in both grid-connected and islanded microgrids.
- 5 May 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 41 (9) , 14437-14443
Integrated Harmonic Mitigation and Fault Current Limiting for Grid-Forming Inverters
In microgrids with high penetration of power electronics-interfaced sources, harmonic distortion from nonlinear loads degrades the power quality at the terminals of virtual synchronous generators (VSGs). Conventional impedance-reshaping methods mitigate harmonics by reducing output impedance but often exacerbate fault currents during voltage sags. This letter proposes an integrated control strategy for harmonic mitigation and fault current limiting based on Virtual Forced Excitation Control (VFEC). The scheme extracts harmonic components from the point of common coupling (PCC) voltage and directly superimposes them onto the amplitude command of the internal electromotive force (EMF) of the VSG. Under normal operation, this mechanism reduces the equivalent output impedance at harmonic frequencies, thereby attenuating nonlinear harmonic content and improving PCC voltage quality. During grid faults, the same architecture leverages inherent amplitude limiting to prevent overmodulation without control mode transitions or auxiliary circuits, effectively restricting fault currents to levels comparable to conventional VSGs and significantly below those of impedance-reshaping approaches. The proposed strategy ensures full compatibility with standard VSG control frameworks. Experimental results validate its effectiveness in both grid-connected and islanded microgrids.
- 12 March 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Emerging and Selected Topics in Power Electronics
- Vol. 14 (3) , 2765-2775
A Fault-Tolerant Strategy for Parallel Inverters in Grid-Connected Power Conversion System
Renewable energy power generation has been extensively developed. Fault-tolerant operation is required for power conversion system to maximize power delivery and system availability. This paper presents a fault-tolerant operation strategy for parallel inverters in grid-connected power conversion system that enables continued operation under multiple power switch failures without additional redundant hardware. Two distinct reconfiguration modes based on fault distribution are presented. When the faulty switches within a phase are located within a single inverter unit, the entire affected bridge leg is deactivated while healthy phases maintain normal operation. When the faulty switches within a phase are distributed across different inverter units, only the half-legs containing faults are deactivated, preserving the remaining healthy switches for system reconfiguration. The healthy half-legs and the inductors operate in every half-cycle of grid in faulty phase. The parallel architecture inherent redundancy is fully exploited to achieve fault tolerance under various faulty scenarios. Finally, the effectiveness of the proposed strategy is verified by simulations and experiments.
- 12 March 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Emerging and Selected Topics in Power Electronics
- Vol. 14 (3) , 2765-2775
A Fault-Tolerant Strategy for Parallel Inverters in Grid-Connected Power Conversion System
Renewable energy power generation has been extensively developed. Fault-tolerant operation is required for power conversion system to maximize power delivery and system availability. This paper presents a fault-tolerant operation strategy for parallel inverters in grid-connected power conversion system that enables continued operation under multiple power switch failures without additional redundant hardware. Two distinct reconfiguration modes based on fault distribution are presented. When the faulty switches within a phase are located within a single inverter unit, the entire affected bridge leg is deactivated while healthy phases maintain normal operation. When the faulty switches within a phase are distributed across different inverter units, only the half-legs containing faults are deactivated, preserving the remaining healthy switches for system reconfiguration. The healthy half-legs and the inductors operate in every half-cycle of grid in faulty phase. The parallel architecture inherent redundancy is fully exploited to achieve fault tolerance under various faulty scenarios. Finally, the effectiveness of the proposed strategy is verified by simulations and experiments.
- Open Access
- 18 January 2026
- Published by Institution of Engineering and Technology (IET) in IET Power Electronics
- Vol. 19 (1)
A Stability Enhancement Method for Grid‐Forming Inverters With Inductor Current Feedforward and Coupling‐Enhancing Control
Although the stable operation of grid‐forming inverters (GFMIs) in weak grids is well‐documented, undesirable oscillations tend to arise when cascaded multi‐loop control architectures are employed, particularly under strong‐grid conditions. In this work, a sequence impedance model of the GFMI is developed, through which the closed‐loop feedback control of the inductor current is identified as the main contributor to oscillations. Accordingly, a stabilisation strategy for GFMIs, combining inductor current feedforward and coupling‐enhancing techniques, is proposed for strong‐grid applications. Finally, a 2 kW experimental prototype was constructed to validate the stability enhancement method, thereby providing practical verification.
- 18 January 2026
- Published by Institution of Engineering and Technology (IET) in IET Power Electronics
- Vol. 19 (1)
Open AccessA Stability Enhancement Method for Grid‐Forming Inverters With Inductor Current Feedforward and Coupling‐Enhancing Control
Although the stable operation of grid‐forming inverters (GFMIs) in weak grids is well‐documented, undesirable oscillations tend to arise when cascaded multi‐loop control architectures are employed, particularly under strong‐grid conditions. In this work, a sequence impedance model of the GFMI is developed, through which the closed‐loop feedback control of the inductor current is identified as the main contributor to oscillations. Accordingly, a stabilisation strategy for GFMIs, combining inductor current feedforward and coupling‐enhancing techniques, is proposed for strong‐grid applications. Finally, a 2 kW experimental prototype was constructed to validate the stability enhancement method, thereby providing practical verification.
- 16 December 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Emerging and Selected Topics in Power Electronics
- Vol. 14 (2) , 1571-1582
Virtual Synchronous Condenser Control Strategy for Enhancing Transient Voltage Support During Grid Faults and Recovery
Synchronous condensers (SCs) are widely recognized for their superior dynamic reactive power support capability. However, their large-scale deployment in distributed power systems with high renewable energy penetration is constrained by high capital costs and maintenance complexity. To address this limitation, a virtual synchronous condenser control strategy is proposed for grid-connected renewable energy inverters. The method enables these inverters to emulate the field-forcing characteristics of SCs, thereby providing effective transient voltage support at the point of common coupling (PCC) during the fault recovery period phase, while simultaneously suppressing transient overvoltage at the onset of recovery. A mathematical model capturing the internal electromotive force (EMF) dynamics of SCs is developed, and practical control laws are derived for direct implementation in inverters. Through phasor-domain analysis, the transient voltage support capability is analytically characterized, and the physical significance of key control parameters is elucidated. Experimental validation under various grid fault scenarios is conducted, confirming the effectiveness and safety of the proposed strategy.
- 16 December 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Emerging and Selected Topics in Power Electronics
- Vol. 14 (2) , 1571-1582
Virtual Synchronous Condenser Control Strategy for Enhancing Transient Voltage Support During Grid Faults and Recovery
Synchronous condensers (SCs) are widely recognized for their superior dynamic reactive power support capability. However, their large-scale deployment in distributed power systems with high renewable energy penetration is constrained by high capital costs and maintenance complexity. To address this limitation, a virtual synchronous condenser control strategy is proposed for grid-connected renewable energy inverters. The method enables these inverters to emulate the field-forcing characteristics of SCs, thereby providing effective transient voltage support at the point of common coupling (PCC) during the fault recovery period phase, while simultaneously suppressing transient overvoltage at the onset of recovery. A mathematical model capturing the internal electromotive force (EMF) dynamics of SCs is developed, and practical control laws are derived for direct implementation in inverters. Through phasor-domain analysis, the transient voltage support capability is analytically characterized, and the physical significance of key control parameters is elucidated. Experimental validation under various grid fault scenarios is conducted, confirming the effectiveness and safety of the proposed strategy.
- 3 May 2025
- Published by Springer Nature
- p. 209-230
Stability Margin Enhancement Strategies with Differentiation Elements
- 3 May 2025
- Published by Springer Nature
- p. 209-230
Stability Margin Enhancement Strategies with Differentiation Elements
- 3 May 2025
- Published by Springer Nature
- p. 1-36
Introduction
- 3 May 2025
- Published by Springer Nature
- p. 231-254
Capacitor Voltage Fast Control Method for Grid-Connected Current-Source Inverters
- 3 May 2025
- Published by Springer Nature
- p. 231-254
Capacitor Voltage Fast Control Method for Grid-Connected Current-Source Inverters
- 3 May 2025
- Published by Springer Nature
- p. 113-143
Grid Voltage Feedforward Control Strategies with Differentiation Elements
- 3 May 2025
- Published by Springer Nature
- p. 113-143
Grid Voltage Feedforward Control Strategies with Differentiation Elements
- 3 May 2025
- Published by Springer Nature
- p. 255-257
Summary
- 3 May 2025
- Published by Springer Nature
- p. 37-112
Inductor Current Fast Control Method for Grid-Connected Voltage-Source Inverters
- 3 May 2025
- Published by Springer Nature
- p. 37-112
Inductor Current Fast Control Method for Grid-Connected Voltage-Source Inverters