Wesley Hackenberger
Wesley Hackenberger has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
- Christopher S. Lynch
University of California Riverside Marlan and Rosemary Bourns College of Engineering, 900 University Ave
2 shared publications Hwan R. Jo
Department of Mechanical and Aerospace Engineering, University of California at Los Angeles 5 , Los Angeles, California 90095-1597, USA
2 shared publicationsJason Baird
Loki Incorporated 1 , Norwood, Missouri 65717, USA
2 shared publicationsJay B. Chase
Loki Incorporated 1 , Norwood, Missouri 65717, USA
2 shared publicationsSergey I. Shkuratov
Loki Incorporated 1 , Norwood, Missouri 65717, USA
2 shared publications- Shujun Zhang
Department of Chemistry, City University of Hong Kong, Kowloon 999077, Hong Kong, China
2 shared publications
Latest Publications
- Open Access
- 29 April 2019
- Published by AIP Publishing in Applied Physics Letters
- Vol. 114 (17) , 172902
Stress-induced depolarization of single-layer PZT 95/5 ferroelectric films
Ferroelectric (FE) films are widely used in electronic devices and low-power FE transducers. There is significant interest in expanding the usage of FE films to ultrahigh-power systems. The results are reported herein on experimental investigations of stress-induced depolarization of single-layer PbZr0.95Ti0.05O3 doped 2% Nb (PZT 95/5) poled FE films subjected to uniaxial adiabatic compression perpendicular and antiparallel to the direction of polarization. It was found that at a stress of 2.4 GPa, the 32-μm-thick films underwent a pressure induced transition to a nonpolar antiferroelectric phase and became completely depolarized in both modes of high strain rate loading. The experimental results indicate that the behavior of stress-induced current generated by longitudinally compressed films is more complicated than under transverse stress. This complex behavior may be caused by the short stress wave transit distance through the film, that is, comparable with the thickness of the stress wave front. The important result is that the specific electric charge released by PZT 95/5 films under stress, 104 μC/cm3, is more than an order of magnitude higher than that released by bulk PZT 95/5 ceramic specimens. It was experimentally demonstrated that transversely compressed miniature PZT 95/5 film specimens with volume less than 1 cm3 are capable of producing pulses of hundreds of amperes of current. This study promises FE film applications in ultrahigh-power systems.
- 29 April 2019
- Published by AIP Publishing in Applied Physics Letters
- Vol. 114 (17) , 172902
Open AccessStress-induced depolarization of single-layer PZT 95/5 ferroelectric films
Ferroelectric (FE) films are widely used in electronic devices and low-power FE transducers. There is significant interest in expanding the usage of FE films to ultrahigh-power systems. The results are reported herein on experimental investigations of stress-induced depolarization of single-layer PbZr0.95Ti0.05O3 doped 2% Nb (PZT 95/5) poled FE films subjected to uniaxial adiabatic compression perpendicular and antiparallel to the direction of polarization. It was found that at a stress of 2.4 GPa, the 32-μm-thick films underwent a pressure induced transition to a nonpolar antiferroelectric phase and became completely depolarized in both modes of high strain rate loading. The experimental results indicate that the behavior of stress-induced current generated by longitudinally compressed films is more complicated than under transverse stress. This complex behavior may be caused by the short stress wave transit distance through the film, that is, comparable with the thickness of the stress wave front. The important result is that the specific electric charge released by PZT 95/5 films under stress, 104 μC/cm3, is more than an order of magnitude higher than that released by bulk PZT 95/5 ceramic specimens. It was experimentally demonstrated that transversely compressed miniature PZT 95/5 film specimens with volume less than 1 cm3 are capable of producing pulses of hundreds of amperes of current. This study promises FE film applications in ultrahigh-power systems.
- Top Cited Papers
- 19 April 2019
- Published by American Association for the Advancement of Science (AAAS) in Science
- Vol. 364 (6437) , 264-268
Giant piezoelectricity of Sm-doped Pb(Mg 1/3 Nb 2/3 )O 3 -PbTiO 3 single crystals
Samarium supersensors: Piezoelectric materials produce electric charge in response to changes in stress and are thus good sensor materials. One challenge has been growing single-crystal piezoelectrics with uniform properties. As of now, much of the crystal is discarded because of compositional variations. Li et al. synthesized single crystals of samarium-doped Pb(Mg 1/3 Nb 2/3 )O 3 -PbTiO 3 that have uniform and extremely high piezoelectric properties (see the Perspective by Hlinka). These crystals are ideal for a variety of sensing applications and could reduce cost by eliminating waste. Science , this issue p. 264 ; see also p. 228
- 19 April 2019
- Published by American Association for the Advancement of Science (AAAS) in Science
- Vol. 364 (6437) , 264-268
Top Cited PapersGiant piezoelectricity of Sm-doped Pb(Mg 1/3 Nb 2/3 )O 3 -PbTiO 3 single crystals
Samarium supersensors: Piezoelectric materials produce electric charge in response to changes in stress and are thus good sensor materials. One challenge has been growing single-crystal piezoelectrics with uniform properties. As of now, much of the crystal is discarded because of compositional variations. Li et al. synthesized single crystals of samarium-doped Pb(Mg 1/3 Nb 2/3 )O 3 -PbTiO 3 that have uniform and extremely high piezoelectric properties (see the Perspective by Hlinka). These crystals are ideal for a variety of sensing applications and could reduce cost by eliminating waste. Science , this issue p. 264 ; see also p. 228
- 19 March 2018
- Published by AIP Publishing in Applied Physics Letters
- Vol. 112 (12) , 122903
Complete stress-induced depolarization of relaxor ferroelectric crystals without transition through a non-polar phase
The development of relaxor ferroelectric single crystal technology is driven by the ability to tailor ferroelectric properties through domain engineering not achievable in polycrystalline materials. In this study, three types of domain-engineered rhombohedral Pb(In1/2Nb1/2)O3–Pb(Mg1/3Nb2/3)O3–PbTiO3 crystals were subjected to transverse high strain rate loading. The experimental results indicate that the domain configuration has a significant effect on the stress-induced depolarization and the associated charge released. A complete depolarization of the single-domain crystals with 3m symmetry is observed, while multidomain crystals with 4mm and mm2 symmetries retain a fraction of their initial remanent polarization. The complete depolarization of single-domain crystals is unique without transition to a non-polar phase, with a stress-induced charge density of 0.48 C/m2. This is up to three times higher than that of the multidomain crystals and PbZrxTi1−xO3 ferroelectric ceramics that are critical for ultrahigh-power transducer applications. The main offering of this work is to propose a detailed mechanism for complete stress-induced depolarization in ferroelectric crystals which does not involve an intermediate transformation to a non-polar phase.
- 19 March 2018
- Published by AIP Publishing in Applied Physics Letters
- Vol. 112 (12) , 122903
Complete stress-induced depolarization of relaxor ferroelectric crystals without transition through a non-polar phase
The development of relaxor ferroelectric single crystal technology is driven by the ability to tailor ferroelectric properties through domain engineering not achievable in polycrystalline materials. In this study, three types of domain-engineered rhombohedral Pb(In1/2Nb1/2)O3–Pb(Mg1/3Nb2/3)O3–PbTiO3 crystals were subjected to transverse high strain rate loading. The experimental results indicate that the domain configuration has a significant effect on the stress-induced depolarization and the associated charge released. A complete depolarization of the single-domain crystals with 3m symmetry is observed, while multidomain crystals with 4mm and mm2 symmetries retain a fraction of their initial remanent polarization. The complete depolarization of single-domain crystals is unique without transition to a non-polar phase, with a stress-induced charge density of 0.48 C/m2. This is up to three times higher than that of the multidomain crystals and PbZrxTi1−xO3 ferroelectric ceramics that are critical for ultrahigh-power transducer applications. The main offering of this work is to propose a detailed mechanism for complete stress-induced depolarization in ferroelectric crystals which does not involve an intermediate transformation to a non-polar phase.
- 24 June 2015
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 117 (24) , 244104
Pressure, temperature, and electric field dependence of phase transformations in niobium modified 95/5 lead zirconate titanate
Ceramic niobium modified 95/5 lead zirconate-lead titanate (PZT) undergoes a pressure induced ferroelectric to antiferroelectric phase transformation accompanied by an elimination of polarization and a volume reduction. Electric field and temperature drive the reverse transformation from the antiferroelectric to ferroelectric phase. The phase transformation was monitored under pressure, temperature, and electric field loading. Pressures and temperatures were varied in discrete steps from 0 MPa to 500 MPa and 25 °C to 125 °C, respectively. Cyclic bipolar electric fields were applied with peak amplitudes of up to 6 MV m−1 at each pressure and temperature combination. The resulting electric displacement–electric field hysteresis loops were open “D” shaped at low pressure, characteristic of soft ferroelectric PZT. Just below the phase transformation pressure, the hysteresis loops took on an “S” shape, which split into a double hysteresis loop just above the phase transformation pressure. Far above the phase transformation pressure, when the applied electric field is insufficient to drive an antiferroelectric to ferroelectric phase transformation, the hysteresis loops collapse to linear dielectric behavior. Phase stability maps were generated from the experimental data at each of the temperature steps and used to form a three dimensional pressure–temperature–electric field phase diagram.
- 24 June 2015
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 117 (24) , 244104
Pressure, temperature, and electric field dependence of phase transformations in niobium modified 95/5 lead zirconate titanate
Ceramic niobium modified 95/5 lead zirconate-lead titanate (PZT) undergoes a pressure induced ferroelectric to antiferroelectric phase transformation accompanied by an elimination of polarization and a volume reduction. Electric field and temperature drive the reverse transformation from the antiferroelectric to ferroelectric phase. The phase transformation was monitored under pressure, temperature, and electric field loading. Pressures and temperatures were varied in discrete steps from 0 MPa to 500 MPa and 25 °C to 125 °C, respectively. Cyclic bipolar electric fields were applied with peak amplitudes of up to 6 MV m−1 at each pressure and temperature combination. The resulting electric displacement–electric field hysteresis loops were open “D” shaped at low pressure, characteristic of soft ferroelectric PZT. Just below the phase transformation pressure, the hysteresis loops took on an “S” shape, which split into a double hysteresis loop just above the phase transformation pressure. Far above the phase transformation pressure, when the applied electric field is insufficient to drive an antiferroelectric to ferroelectric phase transformation, the hysteresis loops collapse to linear dielectric behavior. Phase stability maps were generated from the experimental data at each of the temperature steps and used to form a three dimensional pressure–temperature–electric field phase diagram.
- 22 June 2015
- Published by AIP Publishing in Applied Physics Letters
- Vol. 106 (25) , 252901
Multilayer ceramic capacitors based on relaxor BaTiO3-Bi(Zn1/2Ti1/2)O3 for temperature stable and high energy density capacitor applications
The need for miniaturization without compromising cost and performance continues to motivate research in advanced capacitor devices. In this report, multilayer ceramic capacitors based on relaxor BaTiO3-Bi(Zn1/2Ti1/2)O3 (BT-BZT) were fabricated and characterized. In bulk ceramic embodiments, BT-BZT has been shown to exhibit relative permittivities greater than 1000, high resistivities (ρ > 1 GΩ-cm at 300 °C), and negligible saturation up to fields as high as 150 kV/cm. Multilayer capacitor embodiments were fabricated and found to exhibit similar dielectric and resistivity properties. The energy density for the multilayer ceramics reached values of ∼2.8 J/cm3 at room temperature at an applied electric field of ∼330 kV/cm. This represents a significant improvement compared to commercially available multilayer capacitors. The dielectric properties were also found to be stable over a wide range of temperatures with a temperature coefficient of approximately −2000 ppm/K measured from 50 to 350 °C, an important criteria for high temperature applications. Finally, the compatibility of inexpensive Ag-Pd electrodes with these ceramics was also demonstrated, which can have implications on minimizing the device cost.
- 22 June 2015
- Published by AIP Publishing in Applied Physics Letters
- Vol. 106 (25) , 252901
Multilayer ceramic capacitors based on relaxor BaTiO3-Bi(Zn1/2Ti1/2)O3 for temperature stable and high energy density capacitor applications
The need for miniaturization without compromising cost and performance continues to motivate research in advanced capacitor devices. In this report, multilayer ceramic capacitors based on relaxor BaTiO3-Bi(Zn1/2Ti1/2)O3 (BT-BZT) were fabricated and characterized. In bulk ceramic embodiments, BT-BZT has been shown to exhibit relative permittivities greater than 1000, high resistivities (ρ > 1 GΩ-cm at 300 °C), and negligible saturation up to fields as high as 150 kV/cm. Multilayer capacitor embodiments were fabricated and found to exhibit similar dielectric and resistivity properties. The energy density for the multilayer ceramics reached values of ∼2.8 J/cm3 at room temperature at an applied electric field of ∼330 kV/cm. This represents a significant improvement compared to commercially available multilayer capacitors. The dielectric properties were also found to be stable over a wide range of temperatures with a temperature coefficient of approximately −2000 ppm/K measured from 50 to 350 °C, an important criteria for high temperature applications. Finally, the compatibility of inexpensive Ag-Pd electrodes with these ceramics was also demonstrated, which can have implications on minimizing the device cost.