Nicholas Karl
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Nicholas Karl has a total of 112 co-authors. Here are the top co-authors by number of shared publications:
- Igal Brener
Center for Integrated Nanotechnologies, Sandia National Laboratories, Albuquerque, USA
10 shared publications Michael B. Sinclair
Sandia National Laboratories, Albuquerque, USA
9 shared publicationsAlbuquerque Sandia National Laboratories (Snl-Nm)
8 shared publications- Daniel Stick
Sandia National Laboratories (SNL-NM), Albuquerque, NM (United States)
6 shared publications - Hayden J. McGuinness
Sandia National Laboratories 87185 Albuquerque New Mexico USA
5 shared publications Michael Gehl
Sandia National Laboratories 1 , Albuquerque, New Mexico 87185
5 shared publications
Latest Publications
- Open Access
- 12 August 2026
- Published by Springer Nature in Communications Engineering
A broadband silicon photonic-integrated-circuit based RF spectrum analyzer with 10 MHz spectral resolution
- 12 August 2026
- Published by Springer Nature in Communications Engineering
Open AccessA broadband silicon photonic-integrated-circuit based RF spectrum analyzer with 10 MHz spectral resolution
- Open Access
- 16 July 2026
- Published by American Vacuum Society in AVS Quantum Science
- Vol. 8 (3)
Optical nanofiber testbeds for benchmarking membrane-waveguide photonic integrated circuit platforms toward on-chip quantum inertial sensing
Recent advances in cold atom interferometry with optical and magnetic atom guides have set the stage for quantum inertial sensors capable of operating in dynamic environments. In this work, we present three key innovations—evanescent-field (EF) atom guides, optical nanofiber testbeds, and membrane-waveguide photonic integrated circuit (PIC) platforms—to advance EF-guided atom interferometry. First, we demonstrate EF atom guides on optical nanofiber testbeds, which serve as performance benchmarks for our membrane-waveguide PIC platforms. Second, we achieve low-power (∼5 mW) guiding of freely moving, laser-cooled 133Cs atoms in two-color, traveling-wave EF optical dipole traps at the novel, heat-efficient magic wavelengths of 793 and 937 nm (i.e., “793/937-nm EF atom guides”). Concurrently, we design and fabricate membrane-waveguide PIC platforms for these EF atom guides; in our prior work, we showed that these structures safely accommodate 4–6 times the required optical trap power under vacuum and enable dense cold atom generation via magneto-optical trapping in the vicinity of the optical wavguide for efficient loading. Third, we verify preserved atomic coherence via microwave fields and EF-coupled Doppler-free Raman beams; to our knowledge, this is the first report of coherence fringes driven by co-propagating EF-coupled Raman beams with only 150 nW of total optical power. By providing a direct comparison between optical nanofiber testbeds and membrane-waveguide PIC platforms, our results lay critical groundwork for the on-chip realization of EF-guided atom interferometry and the development of fully integrated, compact, lightweight, and low-power quantum accelerometers and gyroscopes.
- 16 July 2026
- Published by American Vacuum Society in AVS Quantum Science
- Vol. 8 (3)
Open AccessOptical nanofiber testbeds for benchmarking membrane-waveguide photonic integrated circuit platforms toward on-chip quantum inertial sensing
Recent advances in cold atom interferometry with optical and magnetic atom guides have set the stage for quantum inertial sensors capable of operating in dynamic environments. In this work, we present three key innovations—evanescent-field (EF) atom guides, optical nanofiber testbeds, and membrane-waveguide photonic integrated circuit (PIC) platforms—to advance EF-guided atom interferometry. First, we demonstrate EF atom guides on optical nanofiber testbeds, which serve as performance benchmarks for our membrane-waveguide PIC platforms. Second, we achieve low-power (∼5 mW) guiding of freely moving, laser-cooled 133Cs atoms in two-color, traveling-wave EF optical dipole traps at the novel, heat-efficient magic wavelengths of 793 and 937 nm (i.e., “793/937-nm EF atom guides”). Concurrently, we design and fabricate membrane-waveguide PIC platforms for these EF atom guides; in our prior work, we showed that these structures safely accommodate 4–6 times the required optical trap power under vacuum and enable dense cold atom generation via magneto-optical trapping in the vicinity of the optical wavguide for efficient loading. Third, we verify preserved atomic coherence via microwave fields and EF-coupled Doppler-free Raman beams; to our knowledge, this is the first report of coherence fringes driven by co-propagating EF-coupled Raman beams with only 150 nW of total optical power. By providing a direct comparison between optical nanofiber testbeds and membrane-waveguide PIC platforms, our results lay critical groundwork for the on-chip realization of EF-guided atom interferometry and the development of fully integrated, compact, lightweight, and low-power quantum accelerometers and gyroscopes.
- 17 March 2026
- Published by Optica Publishing Group in Optica Quantum
- Vol. 4 (2) , 114
CMOS-fabricated ultraviolet light modulator using low-loss alumina piezo-optomechanical photonics
Ultra-violet (UV) and near-UV wavelengths are necessary for many important optical transitions for quantum technologies and various sensing mechanisms for biological and chemical detection. However, all well-known photonic platforms have excessively high losses in the UV, which has prevented photonic integrated circuits (PICs) being used to address these and other important application spaces. Photonic waveguides using low-loss alumina cores and silicon dioxide cladding have emerged as a promising solution because of alumina’s large optical bandgap and the high quality of films enabled by atomic layer deposition. These properties allow passive, low-loss waveguide operation down to at least 266 nm using multimode widths. However, to the best of our knowledge, active alumina PICs have only been realized using thermo-optic tuning, which precludes switching speeds shorter than approximately 100 microseconds, high circuit densities, and cryogenically compatible operation. Here, we introduce a CMOS-fabricated, piezo-optomechanical PIC platform using alumina waveguides and piezoelectric aluminum nitride strain actuators. The platform allows for sub-microsecond switching times, high circuit densities, and cryogenic operation which is desired in many UV PIC applications. We demonstrate a high-performance, reconfigurable optical filter operating at wavelengths as low as 320 nm. The filter has a 6-nanosecond switching time, a loaded linewidth of 3.3 GHz, tuning rate of 28 V/linewidth, and a hold power of less than 20 nW at one linewidth detuning. This work establishes the foundations for a new class of CMOS-fabricated, rapidly reconfigurable, and low-power UV photonic circuits compatible with wavelengths as low as 225 nm.
- 17 March 2026
- Published by Optica Publishing Group in Optica Quantum
- Vol. 4 (2) , 114
CMOS-fabricated ultraviolet light modulator using low-loss alumina piezo-optomechanical photonics
Ultra-violet (UV) and near-UV wavelengths are necessary for many important optical transitions for quantum technologies and various sensing mechanisms for biological and chemical detection. However, all well-known photonic platforms have excessively high losses in the UV, which has prevented photonic integrated circuits (PICs) being used to address these and other important application spaces. Photonic waveguides using low-loss alumina cores and silicon dioxide cladding have emerged as a promising solution because of alumina’s large optical bandgap and the high quality of films enabled by atomic layer deposition. These properties allow passive, low-loss waveguide operation down to at least 266 nm using multimode widths. However, to the best of our knowledge, active alumina PICs have only been realized using thermo-optic tuning, which precludes switching speeds shorter than approximately 100 microseconds, high circuit densities, and cryogenically compatible operation. Here, we introduce a CMOS-fabricated, piezo-optomechanical PIC platform using alumina waveguides and piezoelectric aluminum nitride strain actuators. The platform allows for sub-microsecond switching times, high circuit densities, and cryogenic operation which is desired in many UV PIC applications. We demonstrate a high-performance, reconfigurable optical filter operating at wavelengths as low as 320 nm. The filter has a 6-nanosecond switching time, a loaded linewidth of 3.3 GHz, tuning rate of 28 V/linewidth, and a hold power of less than 20 nW at one linewidth detuning. This work establishes the foundations for a new class of CMOS-fabricated, rapidly reconfigurable, and low-power UV photonic circuits compatible with wavelengths as low as 225 nm.
- Open Access
- 1 October 2025
- Published by Office of Scientific and Technical Information (OSTI)
Integrated photonics ytterbium ion ensemble clock
Powerpoint slides for use by Tharon Morrison in his presentation at the Southwest Quantum Information and Technology conference. Presentation Oct 9, 2025. Session 02.
- 1 October 2025
- Published by Office of Scientific and Technical Information (OSTI)
Open AccessIntegrated photonics ytterbium ion ensemble clock
Powerpoint slides for use by Tharon Morrison in his presentation at the Southwest Quantum Information and Technology conference. Presentation Oct 9, 2025. Session 02.
- 9 April 2025
- Published by American Chemical Society (ACS) in ACS Nano
- Vol. 19 (18) , 17374-17384
Inverse Design of an All-Dielectric Nonlinear Polaritonic Metasurface
Nonlinear metasurfaces offer the ability to realize optical nonlinear devices with unparalleled properties compared to nonlinear crystals, due to the interplay between photonic resonances and materials properties. The complicated interdependency between efficiency and emission directionality of the nonlinear optical signal on the existence, localization, and lifetimes of photonic resonances, as well as on the nonlinear susceptibility, makes it extremely difficult to design optimal metasurfaces using conventional materials and geometries. Inverse design using topology optimization is a powerful design tool for photonic structures, but traditional approaches developed for linear photonics are not suitable for such high dimensional nonlinear problems. Here, we use a topology optimization approach to inverse-design a fabrication-robust nonlinear metasurface that includes quantum-engineered resonant nonlinearities in semiconductor heterostructures for efficient and directional second harmonic generation. Furthermore, we also demonstrate that under practical constraints, among all the parameters, the nonlinear modal overlap emerges as the dominant parameter that enhances conversion efficiency, a finding that contrasts with intuition-driven studies that often emphasize Purcell enhancement. Our results demonstrate an efficient approach for optimizing nonlinear processes in nanophotonic structures for classical and quantum light sources, quantum information applications, and communication.
- 9 April 2025
- Published by American Chemical Society (ACS) in ACS Nano
- Vol. 19 (18) , 17374-17384
Inverse Design of an All-Dielectric Nonlinear Polaritonic Metasurface
Nonlinear metasurfaces offer the ability to realize optical nonlinear devices with unparalleled properties compared to nonlinear crystals, due to the interplay between photonic resonances and materials properties. The complicated interdependency between efficiency and emission directionality of the nonlinear optical signal on the existence, localization, and lifetimes of photonic resonances, as well as on the nonlinear susceptibility, makes it extremely difficult to design optimal metasurfaces using conventional materials and geometries. Inverse design using topology optimization is a powerful design tool for photonic structures, but traditional approaches developed for linear photonics are not suitable for such high dimensional nonlinear problems. Here, we use a topology optimization approach to inverse-design a fabrication-robust nonlinear metasurface that includes quantum-engineered resonant nonlinearities in semiconductor heterostructures for efficient and directional second harmonic generation. Furthermore, we also demonstrate that under practical constraints, among all the parameters, the nonlinear modal overlap emerges as the dominant parameter that enhances conversion efficiency, a finding that contrasts with intuition-driven studies that often emphasize Purcell enhancement. Our results demonstrate an efficient approach for optimizing nonlinear processes in nanophotonic structures for classical and quantum light sources, quantum information applications, and communication.
- 1 January 2025
- Published by Optica Publishing Group
- p. FF153_3
Ultrafast Photonic Streaking using Temporal Phase Engineered Metasurfaces
We demonstrate a time-domain nano-photonic design principle for controlling electromagnetic waves at femtosecond timescales and develop the concept of a static metasurface that streaks an ultrafast pulse using metasurfaces consisting of arrays of dielectric resonators. Preliminary experimental results are consistent with ultrafast streaking.
- 1 January 2025
- Published by Optica Publishing Group
- p. FF153_3
Ultrafast Photonic Streaking using Temporal Phase Engineered Metasurfaces
We demonstrate a time-domain nano-photonic design principle for controlling electromagnetic waves at femtosecond timescales and develop the concept of a static metasurface that streaks an ultrafast pulse using metasurfaces consisting of arrays of dielectric resonators. Preliminary experimental results are consistent with ultrafast streaking.
- Open Access
- 1 August 2024
- Published by Office of Scientific and Technical Information (OSTI)
Characterization of Hot-carrier Enhanced Pixels for Out-of-band CMOS Camera
Infrared (IR) Imaging • Many defense applications require IR detection • InGaAs and HgCdTe work, but are comparatively expensive with complex heterogeneous integration (though certainly well-developed, ongoing area of research) • Capitalizing on robust, inexpensive Si manufacturing for IR detection is desirable
- 1 August 2024
- Published by Office of Scientific and Technical Information (OSTI)
Open AccessCharacterization of Hot-carrier Enhanced Pixels for Out-of-band CMOS Camera
Infrared (IR) Imaging • Many defense applications require IR detection • InGaAs and HgCdTe work, but are comparatively expensive with complex heterogeneous integration (though certainly well-developed, ongoing area of research) • Capitalizing on robust, inexpensive Si manufacturing for IR detection is desirable
- Open Access
- 1 July 2024
- Published by Office of Scientific and Technical Information (OSTI)
Nanostructuring wide bandgap semiconductors for light manipulation
- 1 July 2024
- Published by Office of Scientific and Technical Information (OSTI)
Open AccessNanostructuring wide bandgap semiconductors for light manipulation