Mostafa Hassanzadeh
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Mostafa Hassanzadeh has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
- Seyed Amir Hossein Feghhi
Department of Radiation Application, Shahid Beheshti University G.C, Tehran, Iran
6 shared publications H. Khalafi
Nuclear Science & Technology Research Institute, AEOI, Tehran, Iran
2 shared publicationsM. Shahriari
Physics Department, Amir Kabir University of Technology, Tehran, IR Iran
2 shared publicationsA. Abbasi
1 shared publicationA. Mohammadi
Iran Radioactive Waste Management Company, Tehran, Iran
1 shared publicationA. Tobeh
1 shared publication
Latest Publications
- 18 January 2019
- Published by Elsevier in Progress in Nuclear Energy
- Vol. 113, 45-52
The use of new irradiation instrument in a pool type research reactor
- 18 January 2019
- Published by Elsevier in Progress in Nuclear Energy
- Vol. 113, 45-52
The use of new irradiation instrument in a pool type research reactor
- Open Access
- 15 September 2018
- Published by Elsevier in Nuclear Engineering and Technology
- Vol. 51 (1) , 293-302
Simulation and design of individual neutron dosimeter and optimization of energy response using an array of semiconductor sensors
- 15 September 2018
- Published by Elsevier in Nuclear Engineering and Technology
- Vol. 51 (1) , 293-302
Open AccessSimulation and design of individual neutron dosimeter and optimization of energy response using an array of semiconductor sensors
- Open Access
- 1 March 2018
- Published by IOP Publishing in Journal of Physics Communications
- Vol. 2 (3) , 035030
Analysis of the thermal feedback and burn up effects on kinetic parameters in TRR by the Monte Carlo method
In safety analysis of nuclear reactors, the knowledge about kinetic parameters is significant. Effective delayed neutron fraction (β_eff) and prompt neutron life time (l_p) depend to the time behaviour of the reactor power transient after reactivity insertion. Thus, in this article, the sensitivity analysis of the kinetic parameters to physical parameters such as fuel enrichment, fuel consumption (burn-up) and temperature changes in Tehran Research Reactor (TRR) has been investigated. For this purpose, in this research has been used of MCNPX code for theses parameters. According to the results, the amounts of ℓp parameter for 1/v poisoning method and Safety Analysis Report (SAR) are 47.9 and 45.0µs, respectively. The obtained results have been compared to SAR. It was found that the relative difference is 6.4% for l_(p )parameter. Moreover, the values of β_eff parameter for MCNPX code and SAR are 785.64 and 777.7 pcm, respectively. When compared to the available SAR data, a relative difference of 1.1% was obtained for β_eff parameter. In most cases, raising the temperature produces higher values of l_(p )but reduces β_eff parameters in both LEU and HEU cases. Also, any increment in burn-up no changes in l_(p ) parameter but β_eff parameter reduces for both LEU and HEU cases.
- 1 March 2018
- Published by IOP Publishing in Journal of Physics Communications
- Vol. 2 (3) , 035030
Open AccessAnalysis of the thermal feedback and burn up effects on kinetic parameters in TRR by the Monte Carlo method
In safety analysis of nuclear reactors, the knowledge about kinetic parameters is significant. Effective delayed neutron fraction (β_eff) and prompt neutron life time (l_p) depend to the time behaviour of the reactor power transient after reactivity insertion. Thus, in this article, the sensitivity analysis of the kinetic parameters to physical parameters such as fuel enrichment, fuel consumption (burn-up) and temperature changes in Tehran Research Reactor (TRR) has been investigated. For this purpose, in this research has been used of MCNPX code for theses parameters. According to the results, the amounts of ℓp parameter for 1/v poisoning method and Safety Analysis Report (SAR) are 47.9 and 45.0µs, respectively. The obtained results have been compared to SAR. It was found that the relative difference is 6.4% for l_(p )parameter. Moreover, the values of β_eff parameter for MCNPX code and SAR are 785.64 and 777.7 pcm, respectively. When compared to the available SAR data, a relative difference of 1.1% was obtained for β_eff parameter. In most cases, raising the temperature produces higher values of l_(p )but reduces β_eff parameters in both LEU and HEU cases. Also, any increment in burn-up no changes in l_(p ) parameter but β_eff parameter reduces for both LEU and HEU cases.
- 14 June 2017
- Published by Walter de Gruyter GmbH in Kerntechnik
- Vol. 82 (3) , 334-338
Optimization and analysis of the effects of physical parameters in a TRIGA-ADSR
In the current research, sensitivity analysis of the accelerator and fissionable and non-fissionable spallation targets containing U-238, Pb, LBE and W materials, Yn/p (spallation neutron yield), Ep (proton energy), G (energy gain), ϕ* (importance of neutron source), Keff (effective multiplication coefficient), Ks (source multiplication coefficient) and Ip (accelerator current) for two cases of Ks including: 0.91 and 0.97 in an Accelerator Driven Subcritical Reactor TRIGA (TRIGA-ADSR) were studied. These neutronic factors were computed by MCNPX code. The obtained results of this study show that for the Yn/p and G parameters, there is an optimum energy from 800 to 1000 MeV. Furthermore, according to the results, if this reactor would be operated close to criticality, the effect of reactivity insertion on the core power is raised. Also, the optimum value of Ks = 0.97 was chosen as adequate multiplication coefficient in this research because of appropriate margins. Lastly, the results of these investigations show that analysis of sensitivity and specificity of the accelerator and spallation target factors is required to optimize the neutronic plan of ADSR.
- 14 June 2017
- Published by Walter de Gruyter GmbH in Kerntechnik
- Vol. 82 (3) , 334-338
Optimization and analysis of the effects of physical parameters in a TRIGA-ADSR
In the current research, sensitivity analysis of the accelerator and fissionable and non-fissionable spallation targets containing U-238, Pb, LBE and W materials, Yn/p (spallation neutron yield), Ep (proton energy), G (energy gain), ϕ* (importance of neutron source), Keff (effective multiplication coefficient), Ks (source multiplication coefficient) and Ip (accelerator current) for two cases of Ks including: 0.91 and 0.97 in an Accelerator Driven Subcritical Reactor TRIGA (TRIGA-ADSR) were studied. These neutronic factors were computed by MCNPX code. The obtained results of this study show that for the Yn/p and G parameters, there is an optimum energy from 800 to 1000 MeV. Furthermore, according to the results, if this reactor would be operated close to criticality, the effect of reactivity insertion on the core power is raised. Also, the optimum value of Ks = 0.97 was chosen as adequate multiplication coefficient in this research because of appropriate margins. Lastly, the results of these investigations show that analysis of sensitivity and specificity of the accelerator and spallation target factors is required to optimize the neutronic plan of ADSR.
- 26 December 2016
- Published by Springer Nature in Nuclear Science and Techniques
- Vol. 28 (2) , 20
Measurement and Monte Carlo simulation of γ-ray dose rate in high-exposure building materials
- 26 December 2016
- Published by Springer Nature in Nuclear Science and Techniques
- Vol. 28 (2) , 20
Measurement and Monte Carlo simulation of γ-ray dose rate in high-exposure building materials
- 1 February 2016
- Published by Elsevier in Applied Radiation and Isotopes
- Vol. 108, 129-132
Shielding calculation and criticality safety analysis of spent fuel transportation cask in research reactors
- 1 February 2016
- Published by Elsevier in Applied Radiation and Isotopes
- Vol. 108, 129-132
Shielding calculation and criticality safety analysis of spent fuel transportation cask in research reactors
- 1 November 2015
- Published by Elsevier in Annals of Nuclear Energy
- Vol. 85, 326-330
Calculation of the spallation target neutronic parameters in Accelerator Driven Subcritical TRIGA reactor
- 1 November 2015
- Published by Elsevier in Annals of Nuclear Energy
- Vol. 85, 326-330
Calculation of the spallation target neutronic parameters in Accelerator Driven Subcritical TRIGA reactor
- 8 April 2015
- Published by Elsevier in Annals of Nuclear Energy
- Vol. 83, 322-327
Monte Carlo simulation for calculation of kinetic parameters in an Accelerator Driven Subcritical TRIGA reactor
- 8 April 2015
- Published by Elsevier in Annals of Nuclear Energy
- Vol. 83, 322-327
Monte Carlo simulation for calculation of kinetic parameters in an Accelerator Driven Subcritical TRIGA reactor
- 30 September 2013
- Published by Elsevier in Annals of Nuclear Energy
- Vol. 59, 188-193
Calculation of kinetic parameters in an accelerator driven subcritical TRIGA reactor using MCNIC method
- 30 September 2013
- Published by Elsevier in Annals of Nuclear Energy
- Vol. 59, 188-193
Calculation of kinetic parameters in an accelerator driven subcritical TRIGA reactor using MCNIC method