Tadanori Hashimoto
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Tadanori Hashimoto has a total of 137 co-authors. Here are the top co-authors by number of shared publications:
Hiroyuki Nasu
Division of Chemistry for Materials, Graduate School of Engineering, Mie University, 1577 Kurimamachiya-Cho, Tsu, Mie, 514-8507, Japan
62 shared publicationsKanichi Kamiya
Department of Chemistry for Materials, Faculty of Engineering, Mie University, Mie 514‐8507, Japan
31 shared publicationsAtsushi Ishihara
30 shared publications- Atsushi Ishihara
Div. of Chemistry for Materials, Graduate School of Engineering, Mie University
14 shared publications Yuji Nishio
10 shared publications- Hiroyuki Nasu
Mie University
6 shared publications
Latest Publications
- Open Access
- 6 January 2025
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 39 (2) , 1316-1326
Effect of Silica–Alumina Ratio on Catalytic Cracking of Polyethylene over Mesoporous Silica–Zeolite Hierarchical Catalysts Produced by Gel Skeletal Reinforcement
- 6 January 2025
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 39 (2) , 1316-1326
Open AccessEffect of Silica–Alumina Ratio on Catalytic Cracking of Polyethylene over Mesoporous Silica–Zeolite Hierarchical Catalysts Produced by Gel Skeletal Reinforcement
- Open Access
- 1 January 2025
- Published by KEAI Publishing in Sensors International
- Vol. 6
KCl-leakage-free reference electrode based on Ag2O–TeO2 glass and Ti
- 1 January 2025
- Published by KEAI Publishing in Sensors International
- Vol. 6
Open AccessKCl-leakage-free reference electrode based on Ag2O–TeO2 glass and Ti
- Open Access
- 5 November 2024
- Published by Elsevier in Results in Chemistry
- Vol. 12
Effect of Ag–Te alloys on pH sensitivity of Ag2O–TeO2 glass/stainless steel enamel
- 5 November 2024
- Published by Elsevier in Results in Chemistry
- Vol. 12
Open AccessEffect of Ag–Te alloys on pH sensitivity of Ag2O–TeO2 glass/stainless steel enamel
- Open Access
- 30 April 2024
- Published by Elsevier in Results in Surfaces and Interfaces
- Vol. 15
Development of Ag2O–TeO2-based glass and glass/stainless steel reference electrodes for pH sensors
- 30 April 2024
- Published by Elsevier in Results in Surfaces and Interfaces
- Vol. 15
Open AccessDevelopment of Ag2O–TeO2-based glass and glass/stainless steel reference electrodes for pH sensors
- Open Access
- 8 January 2024
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 9 (3) , 3669-3674
Production of Sustainable Aviation Fuel by Hydrocracking of n-Heptadecane Using Pt-Supported Y-Zeolite-Al2O3 Composite Catalysts
Hydrocracking of fat or Fischer-Tropsch (FT) wax from biomass to produce the jet fuel of sustainable aviation fuel has been one of the key reactions. n-Heptadecane, which is one of the model diesel fractions produced from fat or FT wax, has hardly been used for hydrocracking of hydrocarbon for jet fuel production, while n-hexadecane has often been used as one of the model compounds for this reaction. In the present study, a HY-zeolite (50 wt %, SiO2/Al2O3 = 100)-Al2O3 (50 wt %) composite-supported Pt (0.5 wt %) catalyst [0.5Pt/Y(100)35A] was tested for hydrocracking of n-heptadecane using a fixed-bed flow reactor at a H2 pressure of 0.5 MPa, H2 flow rate of 300 mL/min, WHSV of 2.3 h-1, and a catalyst weight of 2 g. Fine-tuning of the temperature to 295 °C achieved the highest selectivity of 74% for the jet fuel fraction C8-C15 with the high conversion of 99%. The jet fuel yield reached 73%, which was almost an ideal maximum yield of 75%. Similar hydrocracking of n-hexadecane has just reported the maximum yield of 51% for jet fuel fraction. Further, 0.5Pt/Z(110)35A, which has a composition similar to that of 0.5Pt/Y(100)35A except for the type of zeolite, could not give as high yield of jet fuel as 0.5Pt/Y(100)35A because the rapid conversion to lighter fractions than the jet fuel occurred by the slight increase in the reaction temperature even at a lower temperature range.
- 8 January 2024
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 9 (3) , 3669-3674
Open AccessProduction of Sustainable Aviation Fuel by Hydrocracking of n-Heptadecane Using Pt-Supported Y-Zeolite-Al2O3 Composite Catalysts
Hydrocracking of fat or Fischer-Tropsch (FT) wax from biomass to produce the jet fuel of sustainable aviation fuel has been one of the key reactions. n-Heptadecane, which is one of the model diesel fractions produced from fat or FT wax, has hardly been used for hydrocracking of hydrocarbon for jet fuel production, while n-hexadecane has often been used as one of the model compounds for this reaction. In the present study, a HY-zeolite (50 wt %, SiO2/Al2O3 = 100)-Al2O3 (50 wt %) composite-supported Pt (0.5 wt %) catalyst [0.5Pt/Y(100)35A] was tested for hydrocracking of n-heptadecane using a fixed-bed flow reactor at a H2 pressure of 0.5 MPa, H2 flow rate of 300 mL/min, WHSV of 2.3 h-1, and a catalyst weight of 2 g. Fine-tuning of the temperature to 295 °C achieved the highest selectivity of 74% for the jet fuel fraction C8-C15 with the high conversion of 99%. The jet fuel yield reached 73%, which was almost an ideal maximum yield of 75%. Similar hydrocracking of n-hexadecane has just reported the maximum yield of 51% for jet fuel fraction. Further, 0.5Pt/Z(110)35A, which has a composition similar to that of 0.5Pt/Y(100)35A except for the type of zeolite, could not give as high yield of jet fuel as 0.5Pt/Y(100)35A because the rapid conversion to lighter fractions than the jet fuel occurred by the slight increase in the reaction temperature even at a lower temperature range.
- Open Access
- 18 February 2021
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 6 (8) , 5509-5517
Effects of Zn Addition into ZSM-5 Zeolite on Dehydrocyclization-Cracking of Soybean Oil Using Hierarchical Zeolite-Al2O3 Composite-Supported Pt/NiMo Sulfided Catalysts
- 18 February 2021
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 6 (8) , 5509-5517
Open AccessEffects of Zn Addition into ZSM-5 Zeolite on Dehydrocyclization-Cracking of Soybean Oil Using Hierarchical Zeolite-Al2O3 Composite-Supported Pt/NiMo Sulfided Catalysts
- Open Access
- 5 January 2021
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 6 (2) , 1197-1204
Analysis of Thermal Behavior of Crystalline Minerals in Bituminous Coal Samples under Air and Argon Atmospheres
The thermal behavior of ash components in two bituminous coal samples [Upper Freeport (the “UF”) and Illinois #6 (the “IL”)] was investigated under air and argon atmospheres in the temperature range of 800–1200 °C using thermal gravimetric–differential thermal analysis, X-ray diffraction transmission electron microscopy (TEM), and TEM–energy dispersive X-ray spectrometry measurements. The UF treated under air formed the needle-like crystals which were assumed to be mullite-related substances formed by transformation of andalusite, because the crystals are mainly composed of SiO2 and Al2O3. In contrast to the UF, the IL did not generate such crystals; however, when the IL was treated under air after carbonization under Ar, crystals appeared. The composition of the UF with an Al/Si ratio higher than that of the IL favored the formation of mullite-related substances, while the presence of lime in the IL inhibited the formation of mullite-related substances. Oldhamite was formed by the reaction of lime with sulfur at the carbonization of the IL under Ar and remained even at the successive air treatment. As lime was consumed, the formation of mullite-related substances was ceased to be inhibited under air after Ar treatment.
- 5 January 2021
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 6 (2) , 1197-1204
Open AccessAnalysis of Thermal Behavior of Crystalline Minerals in Bituminous Coal Samples under Air and Argon Atmospheres
The thermal behavior of ash components in two bituminous coal samples [Upper Freeport (the “UF”) and Illinois #6 (the “IL”)] was investigated under air and argon atmospheres in the temperature range of 800–1200 °C using thermal gravimetric–differential thermal analysis, X-ray diffraction transmission electron microscopy (TEM), and TEM–energy dispersive X-ray spectrometry measurements. The UF treated under air formed the needle-like crystals which were assumed to be mullite-related substances formed by transformation of andalusite, because the crystals are mainly composed of SiO2 and Al2O3. In contrast to the UF, the IL did not generate such crystals; however, when the IL was treated under air after carbonization under Ar, crystals appeared. The composition of the UF with an Al/Si ratio higher than that of the IL favored the formation of mullite-related substances, while the presence of lime in the IL inhibited the formation of mullite-related substances. Oldhamite was formed by the reaction of lime with sulfur at the carbonization of the IL under Ar and remained even at the successive air treatment. As lime was consumed, the formation of mullite-related substances was ceased to be inhibited under air after Ar treatment.