Michael A. Gallis
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Michael A. Gallis has a total of 71 co-authors. Here are the top co-authors by number of shared publications:
- John Robert Torczynski
Engineering Sciences Center, Sandia National Laboratories, P. O. Box 5800, Albuquerque, New Mexico 87185-0840, USA
9 shared publications - Ryan Michael McMullen
Sandia National Laboratories (SNL-NM), Albuquerque, NM (United States)
6 shared publications S. J. Plimpton
Center for Computing Research, Sandia National Laboratories, P. O. Box 5800, Albuquerque, New Mexico 87185-0840, USA
6 shared publicationsT. P. Koehler
Sandia National Laboratories 1 , Albuquerque, New Mexico 87185, USA
6 shared publicationsJ. R. Torczynski
Engineering Sciences Center, Sandia National Laboratories, P.O. Box 5800, Albuquerque, New Mexico 87185-0840, USA
5 shared publications- Andrew Y. K. Hong
Sandia National Laboratories, Engineering Sciences Center , Albuquerque, New Mexico 87185, USA
4 shared publications
Latest Publications
- Open Access
- 1 October 2026
- Published by Office of Scientific and Technical Information (OSTI)
Assessing particle-induced hypersonic transition via molecular-level simulations
- 1 October 2026
- Published by Office of Scientific and Technical Information (OSTI)
Open AccessAssessing particle-induced hypersonic transition via molecular-level simulations
- 1 July 2026
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 165 (1)
Coupled internal energy modes in DSMC
The Landau–Teller model for vibrational energy relaxation of gases toward equilibrium is a first-order kinetic model where the rate of relaxation is proportional to the current defect between the energy in that mode and the equilibrium amount of energy in the mode. In Direct Simulation Monte Carlo (DSMC), collisions are first resolved using a total collision cross section; then, if a collision occurs, the internal energy modes of the colliding particles are tested for relaxation. To reproduce the Landau–Teller model in gases with multiple internal modes, the relaxation of multiple internal modes in a single DSMC collision must be prohibited. This work provides analytical comparison of model-form differences between four models: (1) Landau–Teller theory, (2) the vibrational master equation for a mixture of harmonic oscillators, and DSMC when (3) allowing or (4) prohibiting multiple relaxation in a single collision. This is followed by a rigorous examination of the quantitative effect of the algorithmic choice of allowing or prohibiting multiple relaxation in DSMC. The deviation from the Landau–Teller model caused by allowing multiple relaxations in DSMC is minimal compared to the statistical noise in most cases. However, DSMC practitioners are advised to carefully consider the importance of direct coupling between internal modes, as neglecting these can lead to significant errors.
- 1 July 2026
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 165 (1)
Coupled internal energy modes in DSMC
The Landau–Teller model for vibrational energy relaxation of gases toward equilibrium is a first-order kinetic model where the rate of relaxation is proportional to the current defect between the energy in that mode and the equilibrium amount of energy in the mode. In Direct Simulation Monte Carlo (DSMC), collisions are first resolved using a total collision cross section; then, if a collision occurs, the internal energy modes of the colliding particles are tested for relaxation. To reproduce the Landau–Teller model in gases with multiple internal modes, the relaxation of multiple internal modes in a single DSMC collision must be prohibited. This work provides analytical comparison of model-form differences between four models: (1) Landau–Teller theory, (2) the vibrational master equation for a mixture of harmonic oscillators, and DSMC when (3) allowing or (4) prohibiting multiple relaxation in a single collision. This is followed by a rigorous examination of the quantitative effect of the algorithmic choice of allowing or prohibiting multiple relaxation in DSMC. The deviation from the Landau–Teller model caused by allowing multiple relaxations in DSMC is minimal compared to the statistical noise in most cases. However, DSMC practitioners are advised to carefully consider the importance of direct coupling between internal modes, as neglecting these can lead to significant errors.
- Open Access
- 1 September 2025
- Published by Office of Scientific and Technical Information (OSTI)
Assessment of the Stochastic Weighted Particle Method for Taylor-Couette Flow
- 1 September 2025
- Published by Office of Scientific and Technical Information (OSTI)
Open AccessAssessment of the Stochastic Weighted Particle Method for Taylor-Couette Flow
- 1 September 2025
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (9)
A general ablation model for composites based on a coupled direct simulation Monte Carlo and mass-consistent marching cubes approach
A general ablation model based on a coupled direct simulation Monte Carlo (DSMC) and mass-consistent marching cubes (MCMC) approach is presented. MCMC is a novel surface reconstruction algorithm that ensures consistency between the simulated surface recession rate and mass flux. The DSMC-MCMC ablation framework has also been expanded for composites by allowing for unique per-grid-point mass densities and per-cell surface reaction sets. A carbon–carbon composite composed of a square array of cylinders embedded in a matrix is ablated. For a sufficiently high reaction probability on the fiber surface, a counter-intuitive behavior is observed where high pore velocities coincide with reduced permeability and slower ablation. The DSMC-MCMC method is also applied to a more realistic thermal protection system sample which is generated from a tomographic scan.
- 1 September 2025
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (9)
A general ablation model for composites based on a coupled direct simulation Monte Carlo and mass-consistent marching cubes approach
A general ablation model based on a coupled direct simulation Monte Carlo (DSMC) and mass-consistent marching cubes (MCMC) approach is presented. MCMC is a novel surface reconstruction algorithm that ensures consistency between the simulated surface recession rate and mass flux. The DSMC-MCMC ablation framework has also been expanded for composites by allowing for unique per-grid-point mass densities and per-cell surface reaction sets. A carbon–carbon composite composed of a square array of cylinders embedded in a matrix is ablated. For a sufficiently high reaction probability on the fiber surface, a counter-intuitive behavior is observed where high pore velocities coincide with reduced permeability and slower ablation. The DSMC-MCMC method is also applied to a more realistic thermal protection system sample which is generated from a tomographic scan.
- 1 December 2024
- Published by AIP Publishing in Physics of Fluids
- Vol. 36 (12)
Toward physically realistic ablation modeling in direct simulation Monte Carlo
The ablation of solid objects embedded in hypersonic flows can be simulated via the direct simulation Monte Carlo method. However, current ablation algorithms can suffer from numerical and geometric issues which distort the receding surface. This in turn can affect near-surface flow behavior and the overall ablation rate. To minimize these effects and enable more physically realistic ablation models, two algorithmic modifications are proposed here. The first is to store multiple values in each grid cell surrounding the surface so that the Marching Cubes algorithm (which triangulates the surface from the grid values) can be made more accurate. The second is to adjust grid values (due to collisions and reactions) in a mass-flux-preserving manner by decrementing multiple grid values simultaneously. Several ablation test cases are simulated to illustrate the effect of these enhancements.
- 1 December 2024
- Published by AIP Publishing in Physics of Fluids
- Vol. 36 (12)
Toward physically realistic ablation modeling in direct simulation Monte Carlo
The ablation of solid objects embedded in hypersonic flows can be simulated via the direct simulation Monte Carlo method. However, current ablation algorithms can suffer from numerical and geometric issues which distort the receding surface. This in turn can affect near-surface flow behavior and the overall ablation rate. To minimize these effects and enable more physically realistic ablation models, two algorithmic modifications are proposed here. The first is to store multiple values in each grid cell surrounding the surface so that the Marching Cubes algorithm (which triangulates the surface from the grid values) can be made more accurate. The second is to adjust grid values (due to collisions and reactions) in a mass-flux-preserving manner by decrementing multiple grid values simultaneously. Several ablation test cases are simulated to illustrate the effect of these enhancements.
- 7 October 2024
- Published by American Physical Society (APS) in Physical Review E
- Vol. 110 (4) , 045104
Hydrodynamic fluctuations near a Hopf bifurcation: Stochastic onset of vortex shedding behind a circular cylinder
We investigate hydrodynamic fluctuations in the flow past a circular cylinder near the critical Reynolds number Re_{c} for the onset of vortex shedding. Starting from the fluctuating Navier-Stokes equations, we perform a perturbation expansion around Re_{c} to derive analytical expressions for the statistics of the fluctuating lift force. Molecular-level simulations using the direct simulation Monte Carlo method support the theoretical predictions of the lift power spectrum and amplitude distribution. Notably, we have been able to collect sufficient statistics at distances Re/Re_{c}-1=O(10^{-3}) from the instability that confirm the appearance of non-Gaussian fluctuations, and we observe that they are associated with intermittent vortex shedding. These results emphasize how unavoidable thermal-noise-induced fluctuations become dramatically amplified in the vicinity of oscillatory flow instabilities and that their onset is fundamentally stochastic.
- 7 October 2024
- Published by American Physical Society (APS) in Physical Review E
- Vol. 110 (4) , 045104
Hydrodynamic fluctuations near a Hopf bifurcation: Stochastic onset of vortex shedding behind a circular cylinder
We investigate hydrodynamic fluctuations in the flow past a circular cylinder near the critical Reynolds number Re_{c} for the onset of vortex shedding. Starting from the fluctuating Navier-Stokes equations, we perform a perturbation expansion around Re_{c} to derive analytical expressions for the statistics of the fluctuating lift force. Molecular-level simulations using the direct simulation Monte Carlo method support the theoretical predictions of the lift power spectrum and amplitude distribution. Notably, we have been able to collect sufficient statistics at distances Re/Re_{c}-1=O(10^{-3}) from the instability that confirm the appearance of non-Gaussian fluctuations, and we observe that they are associated with intermittent vortex shedding. These results emphasize how unavoidable thermal-noise-induced fluctuations become dramatically amplified in the vicinity of oscillatory flow instabilities and that their onset is fundamentally stochastic.
- Open Access
- 1 January 2024
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 3050 (1) , 080007
Noncontinuum effects at the smallest scales of turbulence
Currently accepted turbulence theory assumes that the flow is continuum at all length scales, including the smallest length scale of turbulence, known as the Ko
- 1 January 2024
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 3050 (1) , 080007
Open AccessNoncontinuum effects at the smallest scales of turbulence
Currently accepted turbulence theory assumes that the flow is continuum at all length scales, including the smallest length scale of turbulence, known as the Ko
- 28 August 2023
- Published by American Physical Society (APS) in Physical Review Fluids
- Vol. 8 (8) , 083401
Molecular-gas-dynamics simulations of turbulent Couette flow over a mean-free-path-scale permeable substrate
We report flow statistics and visualizations from molecular-gas-dynamics simulations using the direct simulation Monte Carlo (DSMC) method for turbulent Couette flow in a minimal domain where the lower wall is replaced by an idealized permeable fibrous substrate representative of thermal-protection-system materials for which the Knudsen number is . Comparisons are made with smooth-wall DSMC simulations and smooth-wall direct numerical simulations (DNS) of the Navier-Stokes equations for the same conditions. Roughness, permeability, and noncontinuum effects are assessed. In the range of Reynolds numbers considered herein, the scalings of the skin friction on the permeable substrate and of the mean flow within the substrate suggest that they are dominated by viscous effects. While the regenerative cycle characteristic of smooth-wall turbulence remains intact for all cases considered, we observe that the near-wall velocity fluctuations are modulated by the permeable substrate with a wavelength equal to the pore spacing. Additionally, the flow within the substrate shows significant rarefaction effects, resulting in an apparent permeability that is 13% larger than the intrinsic permeability. In contrast, the smooth-wall DSMC and DNS simulations exhibit remarkably good agreement for the statistics examined, despite the Knudsen number based on the viscous length scale being as large as . This latter result is at variance with classical estimates for the breakdown of the continuum assumption and calls for further investigations into the interaction of noncontinuum effects and turbulence.- 28 August 2023
- Published by American Physical Society (APS) in Physical Review Fluids
- Vol. 8 (8) , 083401
Molecular-gas-dynamics simulations of turbulent Couette flow over a mean-free-path-scale permeable substrate
We report flow statistics and visualizations from molecular-gas-dynamics simulations using the direct simulation Monte Carlo (DSMC) method for turbulent Couette flow in a minimal domain where the lower wall is replaced by an idealized permeable fibrous substrate representative of thermal-protection-system materials for which the Knudsen number is . Comparisons are made with smooth-wall DSMC simulations and smooth-wall direct numerical simulations (DNS) of the Navier-Stokes equations for the same conditions. Roughness, permeability, and noncontinuum effects are assessed. In the range of Reynolds numbers considered herein, the scalings of the skin friction on the permeable substrate and of the mean flow within the substrate suggest that they are dominated by viscous effects. While the regenerative cycle characteristic of smooth-wall turbulence remains intact for all cases considered, we observe that the near-wall velocity fluctuations are modulated by the permeable substrate with a wavelength equal to the pore spacing. Additionally, the flow within the substrate shows significant rarefaction effects, resulting in an apparent permeability that is 13% larger than the intrinsic permeability. In contrast, the smooth-wall DSMC and DNS simulations exhibit remarkably good agreement for the statistics examined, despite the Knudsen number based on the viscous length scale being as large as . This latter result is at variance with classical estimates for the breakdown of the continuum assumption and calls for further investigations into the interaction of noncontinuum effects and turbulence.- Open Access
- 1 August 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (8)
Publisher's Note: “Optimized collision-specific parameters for binary mixtures of nitrogen, oxygen, argon, and helium” [Phys. Fluids 35, 061705 (2023)]
This article was published online on 12 June 2023 with an error on page 2 in the equation defining alpha; the “1/2” should have been a superscript. The correct
- 1 August 2023
- Published by AIP Publishing in Physics of Fluids
- Vol. 35 (8)
Open AccessPublisher's Note: “Optimized collision-specific parameters for binary mixtures of nitrogen, oxygen, argon, and helium” [Phys. Fluids 35, 061705 (2023)]
This article was published online on 12 June 2023 with an error on page 2 in the equation defining alpha; the “1/2” should have been a superscript. The correct