Alaaeldin Gad
Alaaeldin Gad has a total of 92 co-authors. Here are the top co-authors by number of shared publications:
- Joan Daniel Prades
Institute of Semiconductor Technology (IHT), Technische Universität Braunschweig, D-38106 Braunschweig, Germany
6 shared publications - Cristian Fàbrega
Department of Electronic and Biomedical Engineering, Universitat de Barcelona, Marti i Franqués 1, 08028 Barcelona, Spain
3 shared publications - Francisco Hernandez-Ramirez
Institut de Recerca en Energia de Catalunya (IREC), Barcelona, Spain
3 shared publications H. Shen
3 shared publications- Hutomo Suryo Wasisto
Infineon Technologies AG, Neubiberg, Germany
3 shared publications - Olga Casals
Department of Electronics and Biomedical Engineering, University of Barcelona, Barcelona, Spain
3 shared publications
Latest Publications
- Open Access
How Thin Practical Silicon Heterojunction Solar Cells Could Be? Experimental Study under 1 Sun and under Indoor Illumination
The transition toward thinner microcrystalline silicon wafers for their potential performance gain has been of interest in recent years. Theoretical predictions have estimated a maximum efficiency for silicon wafers to be at about 100−110 μm thickness. The potential and losses in silicon heterojunction solar cells prepared on wafers with thickness in the range of 60−170 μm with focus on open‐circuit voltage (V OC) and fill factor (FF) are studied experimentally. The applicability of thinner wafers for low light and indoor applications using light emitting diode (LED) lighting is also studied. The implied V OC (iV OC) is observed to increase with a decrease in wafer thickness according to theoretical predictions with absolute values approaching the theoretical limit. Unlike the iV OC, the implied FF is observed to decrease with wafer thickness reduction opposite to the theoretical predictions which are related to the effect of surface recombination. A combination of gains and losses results in a broad range of high efficiency under 1 sun for wafer thicknesses ranging from 75 to 170 μm with maximum of 22.3% obtained at 75 μm. As for indoor performance, thinner wafers show slightly better efficiency at lower light intensity under sun and LED illumination, promising improved performance for even thinner devices.
Open AccessHow Thin Practical Silicon Heterojunction Solar Cells Could Be? Experimental Study under 1 Sun and under Indoor Illumination
The transition toward thinner microcrystalline silicon wafers for their potential performance gain has been of interest in recent years. Theoretical predictions have estimated a maximum efficiency for silicon wafers to be at about 100−110 μm thickness. The potential and losses in silicon heterojunction solar cells prepared on wafers with thickness in the range of 60−170 μm with focus on open‐circuit voltage (V OC) and fill factor (FF) are studied experimentally. The applicability of thinner wafers for low light and indoor applications using light emitting diode (LED) lighting is also studied. The implied V OC (iV OC) is observed to increase with a decrease in wafer thickness according to theoretical predictions with absolute values approaching the theoretical limit. Unlike the iV OC, the implied FF is observed to decrease with wafer thickness reduction opposite to the theoretical predictions which are related to the effect of surface recombination. A combination of gains and losses results in a broad range of high efficiency under 1 sun for wafer thicknesses ranging from 75 to 170 μm with maximum of 22.3% obtained at 75 μm. As for indoor performance, thinner wafers show slightly better efficiency at lower light intensity under sun and LED illumination, promising improved performance for even thinner devices.
- 1 June 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 3062-3064
Efficient light trapping in silicon heterojunction solar cells via nanoimprint periodic texturing
The surface patterning of Si heterojunction solar cells is of key importance to enhance the light trapping properties and enable high efficiencies of the emerging thin crystalline silicon solar cells. Herein, periodic inverted pyramids with different periodicity patterns were fabricated by nanoimprint lithography in combination with dry- and wetetching techniques. The impact of their periodicity on the light trapping properties was studied by measuring their reflectance and photoluminescence properties. The inverted pyramids with 700 nm periodicity show excellent anti-reflection and selective light-trapping properties.
- 1 June 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 3062-3064
Efficient light trapping in silicon heterojunction solar cells via nanoimprint periodic texturing
The surface patterning of Si heterojunction solar cells is of key importance to enhance the light trapping properties and enable high efficiencies of the emerging thin crystalline silicon solar cells. Herein, periodic inverted pyramids with different periodicity patterns were fabricated by nanoimprint lithography in combination with dry- and wetetching techniques. The impact of their periodicity on the light trapping properties was studied by measuring their reflectance and photoluminescence properties. The inverted pyramids with 700 nm periodicity show excellent anti-reflection and selective light-trapping properties.
- 1 August 2017
- Published by Elsevier in Biosensors and Bioelectronics
- Vol. 94, 74-80
Gold-modified indium tin oxide as a transparent window in optoelectronic diagnostics of electrochemically active biofilms
- 1 August 2017
- Published by Elsevier in Biosensors and Bioelectronics
- Vol. 94, 74-80
Gold-modified indium tin oxide as a transparent window in optoelectronic diagnostics of electrochemically active biofilms
- 13 June 2017
- Published by SPIE-Intl Soc Optical Eng
- Vol. 10246, 102460C
Gravimetric humidity sensor based on ZnO nanorods covered piezoresistive Si microcantilever
A ZnO nanorods film covered silicon resonant cantilever sensor is developed for atmosphere humidity detection by monitoring the resonant frequency shifts induced by the additional weight of adsorbed water molecules. Two different crystalline seed-layer deposition methods were applied to grow different nanorods films. The morphology of the ZnO films were characterized and the sensor sensitivities were measured under different relative humidity (RH) levels. The experiments results showed that this novel humidity sensor with ZnO nanorods has a sensitivity of 101.5 ± 12.0 ppm/RH% (amount of adsorbed water of 36.9 ± 4.4 ng/RH%), indicating its potential for portable sensing applications.
- 13 June 2017
- Published by SPIE-Intl Soc Optical Eng
- Vol. 10246, 102460C
Gravimetric humidity sensor based on ZnO nanorods covered piezoresistive Si microcantilever
A ZnO nanorods film covered silicon resonant cantilever sensor is developed for atmosphere humidity detection by monitoring the resonant frequency shifts induced by the additional weight of adsorbed water molecules. Two different crystalline seed-layer deposition methods were applied to grow different nanorods films. The morphology of the ZnO films were characterized and the sensor sensitivities were measured under different relative humidity (RH) levels. The experiments results showed that this novel humidity sensor with ZnO nanorods has a sensitivity of 101.5 ± 12.0 ppm/RH% (amount of adsorbed water of 36.9 ± 4.4 ng/RH%), indicating its potential for portable sensing applications.
- Open Access
- 16 December 2016
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 120 (51) , 28917-28923
Charge Transfer Characteristics of n-type In0.1Ga0.9N Photoanode across Semiconductor–Liquid Interface
- 16 December 2016
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 120 (51) , 28917-28923
Open AccessCharge Transfer Characteristics of n-type In0.1Ga0.9N Photoanode across Semiconductor–Liquid Interface
- Open Access
- 29 September 2016
- Published by American Chemical Society (ACS) in ACS Sensors
- Vol. 1 (10) , 1256-1264
Integrated Strategy toward Self-Powering and Selectivity Tuning of Semiconductor Gas Sensors
- 29 September 2016
- Published by American Chemical Society (ACS) in ACS Sensors
- Vol. 1 (10) , 1256-1264
Open AccessIntegrated Strategy toward Self-Powering and Selectivity Tuning of Semiconductor Gas Sensors
- 23 May 2016
- Published by AIP Publishing in Applied Physics Letters
- Vol. 108 (21) , 213503
Vertical architecture for enhancement mode power transistors based on GaN nanowires
The demonstration of vertical GaN wrap-around gated field-effect transistors using GaN nanowires is reported. The nanowires with smooth a-plane sidewalls have hexagonal geometry made by top-down etching. A 7-nanowire transistor exhibits enhancement mode operation with threshold voltage of 1.2 V, on/off current ratio as high as 108, and subthreshold slope as small as 68 mV/dec. Although there is space charge limited current behavior at small source-drain voltages (Vds), the drain current (Id) and transconductance (gm) reach up to 314 mA/mm and 125 mS/mm, respectively, when normalized with hexagonal nanowire circumference. The measured breakdown voltage is around 140 V. This vertical approach provides a way to next-generation GaN-based power devices.
- 23 May 2016
- Published by AIP Publishing in Applied Physics Letters
- Vol. 108 (21) , 213503
Vertical architecture for enhancement mode power transistors based on GaN nanowires
The demonstration of vertical GaN wrap-around gated field-effect transistors using GaN nanowires is reported. The nanowires with smooth a-plane sidewalls have hexagonal geometry made by top-down etching. A 7-nanowire transistor exhibits enhancement mode operation with threshold voltage of 1.2 V, on/off current ratio as high as 108, and subthreshold slope as small as 68 mV/dec. Although there is space charge limited current behavior at small source-drain voltages (Vds), the drain current (Id) and transconductance (gm) reach up to 314 mA/mm and 125 mS/mm, respectively, when normalized with hexagonal nanowire circumference. The measured breakdown voltage is around 140 V. This vertical approach provides a way to next-generation GaN-based power devices.
- 17 March 2016
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 8 (12) , 8232-8238
Insights into Interfacial Changes and Photoelectrochemical Stability of InxGa1–xN (0001) Photoanode Surfaces in Liquid Environments
The long-term stability of InGaN photoanodes in liquid environments is an essential requirement for their use in photoelectrochemistry. In this paper, we investigate the relationships between the compositional changes at the surface of n-type InxGa1–xN (x ∼ 0.10) and its photoelectrochemical stability in phosphate buffer solutions with pH 7.4 and 11.3. Surface analyses reveal that InGaN undergoes oxidation under photoelectrochemical operation conditions (i.e., under solar light illumination and constant bias of 0.5 VRHE), forming a thin amorphous oxide layer having a pH-dependent chemical composition. We found that the formed oxide is mainly composed of Ga–O bonds at pH 7.4, whereas at pH 11.3 the In–O bonds are dominant. The photoelectrical properties of InGaN photoanodes are intimately related to the chemical composition of their surface oxides. For instance, after the formation of the oxide layer (mainly Ga–O bonds) at pH 7.4, no photocurrent flow was observed, whereas the oxide layer (mainly In–O bonds) at pH 11.3 contributes to enhance the photocurrent, possibly because of its reported high photocatalytic activity. Once a critical oxide thickness was reached, especially at pH 7.4, no significant changes in the photoelectrical properties were observed for the rest of the test duration. This study provides new insights into the oxidation processes occurring at the InGaN/liquid interface, which can be exploited to improve InGaN stability and enhance photoanode performance for biosensing and water-splitting applications.
- 17 March 2016
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 8 (12) , 8232-8238
Insights into Interfacial Changes and Photoelectrochemical Stability of InxGa1–xN (0001) Photoanode Surfaces in Liquid Environments
The long-term stability of InGaN photoanodes in liquid environments is an essential requirement for their use in photoelectrochemistry. In this paper, we investigate the relationships between the compositional changes at the surface of n-type InxGa1–xN (x ∼ 0.10) and its photoelectrochemical stability in phosphate buffer solutions with pH 7.4 and 11.3. Surface analyses reveal that InGaN undergoes oxidation under photoelectrochemical operation conditions (i.e., under solar light illumination and constant bias of 0.5 VRHE), forming a thin amorphous oxide layer having a pH-dependent chemical composition. We found that the formed oxide is mainly composed of Ga–O bonds at pH 7.4, whereas at pH 11.3 the In–O bonds are dominant. The photoelectrical properties of InGaN photoanodes are intimately related to the chemical composition of their surface oxides. For instance, after the formation of the oxide layer (mainly Ga–O bonds) at pH 7.4, no photocurrent flow was observed, whereas the oxide layer (mainly In–O bonds) at pH 11.3 contributes to enhance the photocurrent, possibly because of its reported high photocatalytic activity. Once a critical oxide thickness was reached, especially at pH 7.4, no significant changes in the photoelectrical properties were observed for the rest of the test duration. This study provides new insights into the oxidation processes occurring at the InGaN/liquid interface, which can be exploited to improve InGaN stability and enhance photoanode performance for biosensing and water-splitting applications.
- Open Access
- 1 January 2015
- Published by Elsevier in Procedia Engineering
- Vol. 120, 623-627
Novel Approaches Towards Highly Selective Self-Powered Gas Sensors
- 1 January 2015
- Published by Elsevier in Procedia Engineering
- Vol. 120, 623-627
Open AccessNovel Approaches Towards Highly Selective Self-Powered Gas Sensors