Hanlei Zhang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Hanlei Zhang has a total of 46 co-authors. Here are the top co-authors by number of shared publications:
- Guangwen Zhou
State University of New York
9 shared publications - Chongmin Wang
Environmental Molecular Sciences Laboratory Pacific Northwest National Laboratory Richland Washington USA
4 shared publications Fredrick Omenya
NorthEast Center for Chemical Energy Storage, State University of New York, Binghamton, New York 13902, United States
4 shared publications- M. Stanley Whittingham
Binghamton University
4 shared publications - Brian M. May
Chemistry, Engineering Systems Inc. (ESi), Aurora, USA
2 shared publications Hui Zhou
NorthEast Center for Chemical Energy Storage, State University of New York, Binghamton, New York13902, United States
2 shared publications
Latest Publications
- 11 April 2023
- Published by American Chemical Society (ACS) in Nano Letters
- Vol. 23 (8) , 3476-3483
Improving Oxygen Reduction Performance of Surface-Layer-Controlled Pt–Ni Nano-Octahedra via Gaseous Etching
This study demonstrates an atomic composition manipulation on Pt-Ni nano-octahedra to enhance their electrocatalytic performance. By selectively extracting Ni atoms from the {111} facets of the Pt-Ni nano-octahedra using gaseous carbon monoxide at an elevated temperature, a Pt-rich shell is formed, resulting in an ∼2 atomic layer Pt-skin. The surface-engineered octahedral nanocatalyst exhibits a significant enhancement in both mass activity (∼1.8-fold) and specific activity (∼2.2-fold) toward the oxygen reduction reaction compared with its unmodified counterpart. After 20,000 potential cycles of durability tests, the surface-etched Pt-Ni nano-octahedral sample shows a mass activity of 1.50 A/mgPt, exceeding the initial mass activity of the unetched counterpart (1.40 A/mgPt) and outperforming the benchmark Pt/C (0.18 A/mgPt) by a factor of 8. DFT calculations predict this improvement with the Pt surface layers and support these experimental observations. This surface-engineering protocol provides a promising strategy for developing novel electrocatalysts with improved catalytic features.
- 11 April 2023
- Published by American Chemical Society (ACS) in Nano Letters
- Vol. 23 (8) , 3476-3483
Improving Oxygen Reduction Performance of Surface-Layer-Controlled Pt–Ni Nano-Octahedra via Gaseous Etching
This study demonstrates an atomic composition manipulation on Pt-Ni nano-octahedra to enhance their electrocatalytic performance. By selectively extracting Ni atoms from the {111} facets of the Pt-Ni nano-octahedra using gaseous carbon monoxide at an elevated temperature, a Pt-rich shell is formed, resulting in an ∼2 atomic layer Pt-skin. The surface-engineered octahedral nanocatalyst exhibits a significant enhancement in both mass activity (∼1.8-fold) and specific activity (∼2.2-fold) toward the oxygen reduction reaction compared with its unmodified counterpart. After 20,000 potential cycles of durability tests, the surface-etched Pt-Ni nano-octahedral sample shows a mass activity of 1.50 A/mgPt, exceeding the initial mass activity of the unetched counterpart (1.40 A/mgPt) and outperforming the benchmark Pt/C (0.18 A/mgPt) by a factor of 8. DFT calculations predict this improvement with the Pt surface layers and support these experimental observations. This surface-engineering protocol provides a promising strategy for developing novel electrocatalysts with improved catalytic features.
- 20 December 2022
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 15 (1) , 963-972
Oxygen-Loss-Induced Structural Degradation in ε-LiVOPO4
The epsilon-LiVOPO4 cathode for Li-ion batteries has attracted wide attention with its multivalent electronic states and improved discharge capacity of over 300 mAh/g. Oxygen loss stands as a potential cause for structural degradations of the epsilon-LiVOPO4 cathode and its derivatives but has been barely studied. Through in situ environmental transmission electron microscopy, we probe lattice oxygen loss and the associated structural degradations by spatially and temporally resolving the atomicscale structural dynamics and phase transformation pathways in epsilon-LiVOPO4. We demonstrate that the mild oxygen loss at 400 degrees C induces a topotactic phase transformation of epsilon-LiVOPO4 -> alpha Li3V2(PO4)(3) in the particle surface via a nucleation and growth mechanism, leading to the formation of a core-shell configuration. The phase transformation can be reversed by switching to an oxidizing environment, in which the alpha-Li3V2(PO4)(3) is reoxidized to epsilon-LiVOPO4. By contrast, oxygen loss at higher temperatures of 500 and 600 degrees C results in a high concentration of oxygen vacancies that subsequently induces irreversible structural damages including lattice amorphization and formation of nanocavities. This work illustrates the fundamental mechanisms governing the structural failure of oxide cathodes and underlines possible strategies to overcome such issues by exploiting environmental constraints.
- 20 December 2022
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 15 (1) , 963-972
Oxygen-Loss-Induced Structural Degradation in ε-LiVOPO4
The epsilon-LiVOPO4 cathode for Li-ion batteries has attracted wide attention with its multivalent electronic states and improved discharge capacity of over 300 mAh/g. Oxygen loss stands as a potential cause for structural degradations of the epsilon-LiVOPO4 cathode and its derivatives but has been barely studied. Through in situ environmental transmission electron microscopy, we probe lattice oxygen loss and the associated structural degradations by spatially and temporally resolving the atomicscale structural dynamics and phase transformation pathways in epsilon-LiVOPO4. We demonstrate that the mild oxygen loss at 400 degrees C induces a topotactic phase transformation of epsilon-LiVOPO4 -> alpha Li3V2(PO4)(3) in the particle surface via a nucleation and growth mechanism, leading to the formation of a core-shell configuration. The phase transformation can be reversed by switching to an oxidizing environment, in which the alpha-Li3V2(PO4)(3) is reoxidized to epsilon-LiVOPO4. By contrast, oxygen loss at higher temperatures of 500 and 600 degrees C results in a high concentration of oxygen vacancies that subsequently induces irreversible structural damages including lattice amorphization and formation of nanocavities. This work illustrates the fundamental mechanisms governing the structural failure of oxide cathodes and underlines possible strategies to overcome such issues by exploiting environmental constraints.
- Open Access
- 9 September 2022
- Published by American Association for the Advancement of Science (AAAS) in Science Advances
- Vol. 8 (36) , eabo7333
Design metastability in high-entropy alloys by tailoring unstable fault energies
Metastable alloys with transformation-/twinning-induced plasticity (TRIP/TWIP) can overcome the strength-ductility trade-off in structural materials. Originated from the development of traditional alloys, the intrinsic stacking fault energy (ISFE) has been applied to tailor TRIP/TWIP in high-entropy alloys (HEAs) but with limited quantitative success. Here, we demonstrate a strategy for designing metastable HEAs and validate its effectiveness by discovering seven alloys with experimentally observed metastability for TRIP/TWIP. We propose unstable fault energies as the more effective design metric and attribute the deformation mechanism of metastable face-centered cubic alloys to unstable martensite fault energy (UMFE)/unstable twin fault energy (UTFE) rather than ISFE. Among the studied HEAs and steels, the traditional ISFE criterion fails in more than half of the cases, while the UMFE/UTFE criterion accurately predicts the deformation mechanisms in all cases. The UMFE/UTFE criterion provides an effective paradigm for developing metastable alloys with TRIP/TWIP for an enhanced strength-ductility synergy.
- 9 September 2022
- Published by American Association for the Advancement of Science (AAAS) in Science Advances
- Vol. 8 (36) , eabo7333
Open AccessDesign metastability in high-entropy alloys by tailoring unstable fault energies
Metastable alloys with transformation-/twinning-induced plasticity (TRIP/TWIP) can overcome the strength-ductility trade-off in structural materials. Originated from the development of traditional alloys, the intrinsic stacking fault energy (ISFE) has been applied to tailor TRIP/TWIP in high-entropy alloys (HEAs) but with limited quantitative success. Here, we demonstrate a strategy for designing metastable HEAs and validate its effectiveness by discovering seven alloys with experimentally observed metastability for TRIP/TWIP. We propose unstable fault energies as the more effective design metric and attribute the deformation mechanism of metastable face-centered cubic alloys to unstable martensite fault energy (UMFE)/unstable twin fault energy (UTFE) rather than ISFE. Among the studied HEAs and steels, the traditional ISFE criterion fails in more than half of the cases, while the UMFE/UTFE criterion accurately predicts the deformation mechanisms in all cases. The UMFE/UTFE criterion provides an effective paradigm for developing metastable alloys with TRIP/TWIP for an enhanced strength-ductility synergy.
Nanometal Thermocatalysts: Transformations, Deactivation, and Mitigation
Nanometals have been proven to be efficient thermocatalysts in the last decades. Their enhanced catalytic activity and tunable functionalities make them intriguing candidates for a wide range of catalytic applications, such as gaseous reactions and compound synthesis/decomposition. On the other hand, the enhanced specific surface energy and reactivity of nanometals can lead to configuration transformation and thus catalytic deactivation during the synthesis and catalysis, which largely undermines the activity and service time, thereby calling for urgent research effort to understand the deactivating mechanisms and develop efficient mitigating methods. Herein, the recent progress in understanding the configuration transformation‐induced catalytic deactivation within nanometals is reviewed. The major pathways of configuration transformations, and their kinetics controlled by the environmental factors are presented. The approaches toward mitigating the transformation‐induced deactivation are also presented. Finally, a perspective on the future academic approaches toward in‐depth understanding of the kinetics of the deactivation of nanometals is proposed.
Nanometal Thermocatalysts: Transformations, Deactivation, and Mitigation
Nanometals have been proven to be efficient thermocatalysts in the last decades. Their enhanced catalytic activity and tunable functionalities make them intriguing candidates for a wide range of catalytic applications, such as gaseous reactions and compound synthesis/decomposition. On the other hand, the enhanced specific surface energy and reactivity of nanometals can lead to configuration transformation and thus catalytic deactivation during the synthesis and catalysis, which largely undermines the activity and service time, thereby calling for urgent research effort to understand the deactivating mechanisms and develop efficient mitigating methods. Herein, the recent progress in understanding the configuration transformation‐induced catalytic deactivation within nanometals is reviewed. The major pathways of configuration transformations, and their kinetics controlled by the environmental factors are presented. The approaches toward mitigating the transformation‐induced deactivation are also presented. Finally, a perspective on the future academic approaches toward in‐depth understanding of the kinetics of the deactivation of nanometals is proposed.
- 15 August 2019
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 31 (18) , 7790-7798
Layered Oxide Cathodes for Li-Ion Batteries: Oxygen Loss and Vacancy Evolution
- 15 August 2019
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 31 (18) , 7790-7798
Layered Oxide Cathodes for Li-Ion Batteries: Oxygen Loss and Vacancy Evolution
- 14 June 2019
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 2 (7) , 5243-5253
Intrinsic Challenges to the Electrochemical Reversibility of the High Energy Density Copper(II) Fluoride Cathode Material
- 14 June 2019
- Published by American Chemical Society (ACS) in ACS Applied Energy Materials
- Vol. 2 (7) , 5243-5253
Intrinsic Challenges to the Electrochemical Reversibility of the High Energy Density Copper(II) Fluoride Cathode Material
- 1 September 2018
- Published by Elsevier in Acta Materialia
- Vol. 156, 266-274
Tailoring the formation of textured oxide films via primary and secondary nucleation of oxide islands
- 1 September 2018
- Published by Elsevier in Acta Materialia
- Vol. 156, 266-274
Tailoring the formation of textured oxide films via primary and secondary nucleation of oxide islands
- 18 January 2018
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 30 (3) , 692-699
Facet-Dependent Rock-Salt Reconstruction on the Surface of Layered Oxide Cathodes
- 18 January 2018
- Published by American Chemical Society (ACS) in Chemistry of Materials
- Vol. 30 (3) , 692-699
Facet-Dependent Rock-Salt Reconstruction on the Surface of Layered Oxide Cathodes
- 24 October 2017
- Published by American Chemical Society (ACS) in ACS Energy Letters
- Vol. 2 (11) , 2607-2615
Rock-Salt Growth-Induced (003) Cracking in a Layered Positive Electrode for Li-Ion Batteries
- 24 October 2017
- Published by American Chemical Society (ACS) in ACS Energy Letters
- Vol. 2 (11) , 2607-2615
Rock-Salt Growth-Induced (003) Cracking in a Layered Positive Electrode for Li-Ion Batteries
- 23 October 2017
- Published by American Chemical Society (ACS) in ACS Energy Letters
- Vol. 2 (11) , 2598-2606
Formation of an Anti-Core–Shell Structure in Layered Oxide Cathodes for Li-Ion Batteries
- 23 October 2017
- Published by American Chemical Society (ACS) in ACS Energy Letters
- Vol. 2 (11) , 2598-2606
Formation of an Anti-Core–Shell Structure in Layered Oxide Cathodes for Li-Ion Batteries