Styliani D. Sklari
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Styliani D. Sklari has a total of 50 co-authors. Here are the top co-authors by number of shared publications:
V.T. Zaspalis
7 shared publications- Anastasios I. Zouboulis
Laboratory of Chemical and Environmental Technology, Department of Chemistry, Aristotle University of Thessaloniki, 54124 Thessaloniki, Greece
5 shared publications - Petros Samaras
Department of Food Science and Technology, International Hellenic University, 57400 Thessaloniki, Greece
5 shared publications - Konstantinos V. Plakas
Laboratory of Natural Resources and Renewable Energies, Chemical Process and Energy Resources Institute, Centre for Research and Technology-Hellas (CERTH), 57001 Thermi-Thessaloniki, Greece
4 shared publications A.E. Pagana
Chemical Process and Energy Resources Institute , Center for Research and Technology , Hellas , GR-57001 , Thessaloniki , Greece Phone: Tel. +30 2310498257 Fax: Tel. +30 2310498257
3 shared publicationsVassilis T. Zaspalis
Chemical Process and Energy Resources Institute, Centre for Research and Technology - Hellas (CERTH), 6th km Charilaou-Thermi Road, Thermi, Thessaloniki, GR 57001, Greece; Department of Chemical Engineering, Aristotle University, Thessaloniki, GR 57001, Greece
3 shared publications
Latest Publications
- 1 October 2019
- Published by Elsevier in Chemical Engineering Journal
- Vol. 373, 700-708
Heterogeneous Fenton-like oxidation of pharmaceutical diclofenac by a catalytic iron-oxide ceramic microfiltration membrane
- 1 October 2019
- Published by Elsevier in Chemical Engineering Journal
- Vol. 373, 700-708
Heterogeneous Fenton-like oxidation of pharmaceutical diclofenac by a catalytic iron-oxide ceramic microfiltration membrane
- 13 April 2017
- Published by Wiley in Journal of Chemical Technology & Biotechnology
- Vol. 92 (9) , 2236-2245
Hydrodeoxygenation of glycerol with in situH2 formation over Pt catalysts supported on Fe modified Al2O3: effect of Fe loading
BACKGROUND: Glycerol hydrodeoxygenation to 1,2‐propanediol is a reaction of commercial and environmental significance. However, the need for hydrogen supply is a main drawback of the process. This study aims at the development of effective catalysts for glycerol hydrodeoxygenation with in situ H2 formed. Pt/Al2O3 and Pt/Fe2O3‐Al2O3 catalysts with different Fe/Pt ratios were synthesized and evaluated. N2 physisorption, XRD, TPR‐H2, TGA and DRIFTS‐CO characterization techniques were used. Main focus was given on catalyst reusability, while a parametric study was also performed.RESULTS: Fe addition promotes catalysts activity. Characterization showed that there is an electron interaction between Pt and Fe which is responsible for this enhancement. However, Fe/Pt ratio and reduction temperature affect catalyst performance. The increase of Fe loading leads to lower H2 formation rates but also to more stable catalyst performance. The most promising results were achieved over the Fe richer catalyst which exhibited 51.5% 1,2‐propanediol selectivity, 93.8% glycerol conversion, under 3.5 MPa N2, at 250 °C, 1 h and pre‐reduction at 200 °C.CONCLUSION: The presence of Fe in Pt/Al2O3 catalysts was proved decisive for the combined cycle of glycerol hydrodeoxygenation–aqueous phase reforming. The high activity and the stable performance in aqueous medium may render these materials as suitable catalysts for various liquid phase hydrodeoxygenation reactions. © 2017 Society of Chemical Industry
- 13 April 2017
- Published by Wiley in Journal of Chemical Technology & Biotechnology
- Vol. 92 (9) , 2236-2245
Hydrodeoxygenation of glycerol with in situH2 formation over Pt catalysts supported on Fe modified Al2O3: effect of Fe loading
BACKGROUND: Glycerol hydrodeoxygenation to 1,2‐propanediol is a reaction of commercial and environmental significance. However, the need for hydrogen supply is a main drawback of the process. This study aims at the development of effective catalysts for glycerol hydrodeoxygenation with in situ H2 formed. Pt/Al2O3 and Pt/Fe2O3‐Al2O3 catalysts with different Fe/Pt ratios were synthesized and evaluated. N2 physisorption, XRD, TPR‐H2, TGA and DRIFTS‐CO characterization techniques were used. Main focus was given on catalyst reusability, while a parametric study was also performed.RESULTS: Fe addition promotes catalysts activity. Characterization showed that there is an electron interaction between Pt and Fe which is responsible for this enhancement. However, Fe/Pt ratio and reduction temperature affect catalyst performance. The increase of Fe loading leads to lower H2 formation rates but also to more stable catalyst performance. The most promising results were achieved over the Fe richer catalyst which exhibited 51.5% 1,2‐propanediol selectivity, 93.8% glycerol conversion, under 3.5 MPa N2, at 250 °C, 1 h and pre‐reduction at 200 °C.CONCLUSION: The presence of Fe in Pt/Al2O3 catalysts was proved decisive for the combined cycle of glycerol hydrodeoxygenation–aqueous phase reforming. The high activity and the stable performance in aqueous medium may render these materials as suitable catalysts for various liquid phase hydrodeoxygenation reactions. © 2017 Society of Chemical Industry
- 1 April 2016
- Published by Elsevier in Fuel Processing Technology
- Vol. 144, 20-26
The suspending role of H2O and CO on catalytic hydrotreatment of gas-oil; myth or reality?
- 1 April 2016
- Published by Elsevier in Fuel Processing Technology
- Vol. 144, 20-26
The suspending role of H2O and CO on catalytic hydrotreatment of gas-oil; myth or reality?
- 1 March 2016
- Published by Elsevier in Water Research
- Vol. 91, 183-194
Removal of organic micropollutants from drinking water by a novel electro-Fenton filter: Pilot-scale studies
- 1 March 2016
- Published by Elsevier in Water Research
- Vol. 91, 183-194
Removal of organic micropollutants from drinking water by a novel electro-Fenton filter: Pilot-scale studies
- 1 October 2015
- Published by Elsevier in Journal of Membrane Science
- Vol. 492, 40-47
Development of bubble-less ozonation and membrane filtration process for the treatment of contaminated water
- 1 October 2015
- Published by Elsevier in Journal of Membrane Science
- Vol. 492, 40-47
Development of bubble-less ozonation and membrane filtration process for the treatment of contaminated water
- 1 April 2015
- Published by Elsevier in Journal of Water Process Engineering
- Vol. 5, 42-47
Ceramic membrane materials and process for the removal of As(III)/As(V) ions from water
- 1 April 2015
- Published by Elsevier in Journal of Water Process Engineering
- Vol. 5, 42-47
Ceramic membrane materials and process for the removal of As(III)/As(V) ions from water
- 11 February 2015
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 54 (7) , 2059-2073
Toward the Development of a Novel Electro-Fenton System for Eliminating Toxic Organic Substances from Water. Part 2. Preparation, Characterization, and Evaluation of Iron-Impregnated Carbon Felts as Cathodic Electrodes
- 11 February 2015
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 54 (7) , 2059-2073
Toward the Development of a Novel Electro-Fenton System for Eliminating Toxic Organic Substances from Water. Part 2. Preparation, Characterization, and Evaluation of Iron-Impregnated Carbon Felts as Cathodic Electrodes
- 18 June 2014
- Published by Elsevier in Desalination and Water Treatment
- Vol. 55 (7) , 1697-1702
The use of steelmaking slag for sewage sludge stabilization
The objective of this work was the examination of the stabilization of sewage sludge by the addition of a steel slag (slag), and the investigation of the effect of stabilization time on the properties of the produced mixtures. The used slag was a by-product from steelmaking refining processes in ladle furnaces, the steelmaking slag that presented high calcium content. Four samples were prepared by mixing the slag and sewage sludge in various ratios (2.5–20% on a dry basis) and the mixtures were stabilized for a period of 48 d. Monitoring of the mixtures properties was carried out for the determination of the pH, the moisture content, the pathogens removal rate and the mineralogical phases present. The addition of slag resulted in the increase of mixture pH exceeding 12, the increase of total solids content and the reduction of volatile percentage; these effects were more pronounced at the highest slag dosage. In addition, effective pathogens removal was observed in mixtures containing more than 10% slag, from the early time of mixing, due to the high pH values of the mixtures. It was concluded that this method might have a high potential for the efficient management of two solid waste streams.
- 18 June 2014
- Published by Elsevier in Desalination and Water Treatment
- Vol. 55 (7) , 1697-1702
The use of steelmaking slag for sewage sludge stabilization
The objective of this work was the examination of the stabilization of sewage sludge by the addition of a steel slag (slag), and the investigation of the effect of stabilization time on the properties of the produced mixtures. The used slag was a by-product from steelmaking refining processes in ladle furnaces, the steelmaking slag that presented high calcium content. Four samples were prepared by mixing the slag and sewage sludge in various ratios (2.5–20% on a dry basis) and the mixtures were stabilized for a period of 48 d. Monitoring of the mixtures properties was carried out for the determination of the pH, the moisture content, the pathogens removal rate and the mineralogical phases present. The addition of slag resulted in the increase of mixture pH exceeding 12, the increase of total solids content and the reduction of volatile percentage; these effects were more pronounced at the highest slag dosage. In addition, effective pathogens removal was observed in mixtures containing more than 10% slag, from the early time of mixing, due to the high pH values of the mixtures. It was concluded that this method might have a high potential for the efficient management of two solid waste streams.
- Open Access
- 3 June 2013
- Published by Elsevier in Desalination and Water Treatment
- Vol. 51 (25-27) , 4938-4946
Nano Membrane Water: development of innovative hybrid processes for contaminated water treatment using nanoporous membranes
This study aims at the development of a hybrid process for the efficient treatment of water and potentially of wastewater, by the combination of ozonation and membrane filtration and the investigation of the complete ozone utilization by the employment of a novel ceramic membrane reactor concept. The advantages of the process are mainly referred to the achievement of a homogeneous (down to microscale) transfer and distribution of ozone (“bubbles aeration”) within the main body of bulk water stream, which results in very efficient oxidation. Ceramic membranes were prepared initially, in order to investigate the single filtration of groundwater; tubular shaped nonsymmetric ceramic membranes were developed and their efficiency was examined for the removal of As-loaded water. Microporous γ-Al2O3–17Fe (molar ratio Al and Fe: 1:1) membrane was found to adsorb the pollutant As(V) ions up to 95%. The combined process of ozonation and membrane filtration was examined in a bench scale unit, where ozone was added through a ceramic diffuser at low flow rates, under continuous and intermittent modes. Simulated ground and surface water containing 25 mg L−1 of kaolin and humic acid was fed to the reactor; it was found that the intermittent mode of ozone addition was beneficial over the continuous mode of operation, resulting in lower trans-membrane pressure values. However, the hybrid process of ozonation-membrane filtration resulted in a lower quality effluent with a higher Total Organic Carbon content, possibly due to the effect of ozone on organic substances: ozone resulted to the dissociation of large molecular weight compounds and the formation of smaller molecules that could easily pass through the membranes in the effluent. In addition, a new hybrid ozone-filtration unit has been constructed. In this unit, the water to be treated flows through the inner side of a tubular membrane while gaseous ozone stream flows along the outer. An appropriate pressure drop gradient causes ozone to flow towards the inner water stream through the nanopores of the ceramic membrane, causing oxidation (and decomposition) of the organic substances or complexes, which are present in the water stream. The retentate stream of the first step represents the influent to the second step where the removal of ions is achieved by ceramic membranes (ultrafiltration).
- 3 June 2013
- Published by Elsevier in Desalination and Water Treatment
- Vol. 51 (25-27) , 4938-4946
Open AccessNano Membrane Water: development of innovative hybrid processes for contaminated water treatment using nanoporous membranes
This study aims at the development of a hybrid process for the efficient treatment of water and potentially of wastewater, by the combination of ozonation and membrane filtration and the investigation of the complete ozone utilization by the employment of a novel ceramic membrane reactor concept. The advantages of the process are mainly referred to the achievement of a homogeneous (down to microscale) transfer and distribution of ozone (“bubbles aeration”) within the main body of bulk water stream, which results in very efficient oxidation. Ceramic membranes were prepared initially, in order to investigate the single filtration of groundwater; tubular shaped nonsymmetric ceramic membranes were developed and their efficiency was examined for the removal of As-loaded water. Microporous γ-Al2O3–17Fe (molar ratio Al and Fe: 1:1) membrane was found to adsorb the pollutant As(V) ions up to 95%. The combined process of ozonation and membrane filtration was examined in a bench scale unit, where ozone was added through a ceramic diffuser at low flow rates, under continuous and intermittent modes. Simulated ground and surface water containing 25 mg L−1 of kaolin and humic acid was fed to the reactor; it was found that the intermittent mode of ozone addition was beneficial over the continuous mode of operation, resulting in lower trans-membrane pressure values. However, the hybrid process of ozonation-membrane filtration resulted in a lower quality effluent with a higher Total Organic Carbon content, possibly due to the effect of ozone on organic substances: ozone resulted to the dissociation of large molecular weight compounds and the formation of smaller molecules that could easily pass through the membranes in the effluent. In addition, a new hybrid ozone-filtration unit has been constructed. In this unit, the water to be treated flows through the inner side of a tubular membrane while gaseous ozone stream flows along the outer. An appropriate pressure drop gradient causes ozone to flow towards the inner water stream through the nanopores of the ceramic membrane, causing oxidation (and decomposition) of the organic substances or complexes, which are present in the water stream. The retentate stream of the first step represents the influent to the second step where the removal of ions is achieved by ceramic membranes (ultrafiltration).