AMAmit Mehta

Amit Mehta

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Amit Mehta has a total of 42 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    High-Gain Wide-Angle Scanning Array Using Slot-Based Patch Antenna for Ku-Band

    by Amit Mehta, Rawad Asfour, Hisamatsu Nakano, Dariush Mirhsekar-Syahkal

    High-gain wide-angle scanning antennas are vital for emerging Ku-band satellite communication systems supporting mobile, IoT, and UAV platforms. However, achieving compactness, circular polarization, and stable gain over a wide scanning range remains a key design c1hallenge. This paper presents a Slot-Based Microstrip Patch Antenna (SBMPA) array optimized for high-gain, reconfigurable circularly polarized (CP) operation in the Ku-band (12.85–13.05 GHz). Each SBMPA element integrates a slotted circular patch nested inside a concentric annular ring operating in the TM₁₁ (axial) and TM₂₁ (conical) modes, respectively. With a quadrature-feed network, the antenna generates a tilted CP beam (θ = 35°) with a gain of 6.8 dBic and can switch between right-hand circular polarization (RHCP), left-hand circular polarization (LHCP), and linear polarization (LP) modes. A four-element linear SBMPA array, controlled through a phase-shift network, achieves beam steering up to −47° with −3 dB coverage extending to −60°, while maintaining a stable gain of 10.2 ± 1 dBic and low sidelobe levels (–9 dB). The proposed array offers a compact, polarization-agile solution with robust performance, making it suitable for low-profile satellite terminals and near-horizon communication in next-generation Ku-band applications.

  • Radiation from an Active Ring Region

    by Hisamatsu Nakano, Tomoki Abe, Amit Mehta, Junji Yamauchi

    This paper investigates the radiation that is generated by the current flowing on the active ring region of an antenna plane. The circumference of the ring is chosen to be one guided wavelength at frequencies $f_{\mathrm{N}}$ and $f_{\mathrm{H}}$ (where $f_{\mathrm{N}} < f_{\mathrm{H}}$ ), so that the radiation is in the direction normal to the plane of the active ring region (the z-axis direction). We assume that (i) the current on the active ring region flows in a traveling wave fashion with negligible attenuation, and (ii) the propagation phase constant has a negative value at $f_{\mathrm{N}}$ and a positive value at $f_{\mathrm{H}}$ . Derived equations show that the RHCP radiation at $f_{\mathrm{H}}$ is stronger than the LHCP radiation at $f_{\mathrm{N}}$ . However, this situation changes when a current perpendicular to the current on the ring is introduced; the LHCP radiation field at $f_{\mathrm{N}}$ doubles and the RHCP radiation field at $f_{\mathrm{H}}$ disappears.

  • Discussion of the Axial Ratio of a Square Loop Antenna With an Attenuating Current

    by Hisamatsu Nakano, Tomoki Abe, Amit Mehta, Junji Yamauchi

    The quality of the radiation field from a square loop antenna is evaluated using ARz, the axial ratio on the z-axis normal to the loop plane. For this evaluation, a generalized antenna model is used, where the current on a loop that is one guided wavelength in length is assumed to travel only in the forward direction, without backward currents. Firstly, the radiation field is formulated for the situation where the traveling wave current decays with attenuation constant $\alpha$ . It is found that ARz exponentially degrades as $\alpha$ increases. Secondly, a reactive current of weight q is superimposed onto the original current used for the first derivation. It is revealed that the degraded ARz is remarkably improved by the superimposed current. Throughout this discussion the difference in the axial ratios of the square and round loop antenna models is clarified.


  • Isolated Gain Enhancement for Dual-Band C-Metaloop Antennas Using a Coplanar Compound Method

    by Hisamatsu Nakano, Tomoki Abe, Amit Mehta, Junji Yamauchi

    When the circumference of a round metaloop antenna (RoMLA), made of C-type meta-atoms, is one guided wavelength (1λ g ) of the current on the loop, the RoMLA radiates a left-hand CP wave at frequency f N and a right-hand CP wave at frequency f H in the direction normal to the antenna plane. These CP waves have different maximum gains. This paper discusses enhancement in the small gain, not affecting the inherent large gain. Such uncorrelated enhancement in the gain, named the isolated gain enhancement (IsoGE), differs from conventional correlated gain enhancement (non-IsoGE). For IsoGE, a parasitic ring is inserted into the open space of the RoMLA, while maintaining the low-profile RoMLA structure on the order of λ 0 /100 with λ 0 being the free-space operating wavelength. It is found that the ring finally transformed into a round patch is effective for the IsoGE, where the induced current on the patch contributes to increasing the small gain. The analysis, for the first time, shows that the axial ratio and VSWR are, respectively, less than 3 dB and 2 across the 3-dB gain bandwidths around f N and f H , as desired. Furthermore, the insertion of a square parasitic patch within the open space of a square metaloop antenna is also found to be effective for the IsoGE.


  • Open Access

    A low-profile wideband compressed single-arm spiral antenna array for mid-band 5G beam steering applications

    by Benjamin J. Falkner, Hengyi Zhou, Wei Zhang, Georgios Metaxas, Amit Mehta, Volker Ziegler, Thomas Multerer, Dariush Mirshekar-Syahkal, Hisamatsu Nakano

    A low profile wideband spiral antenna array is presented for global mid-band 5G beam steering applications. In the global rollout of mid-band 5G, different frequencies have been licensed within each region (e.g. 3.4–3.8 GHz in the EU and 3.7–5 GHz in the USA). Therefore, antenna arrays must be able to cover a bandwidth of 3.3 GHz to 5 GHz to provide true global coverage. Initially, this work presents the design of a wideband compressed spiral antenna that provides an axial beam throughout its operational bandwidth of 3.3 GHz to 5 GHz, enabling beam steering functionality. Then, this antenna has been placed in a 4 × 4 array with a triangular lattice. The proposed spiral antenna array can provide a scanning range of − 40° ≤ θ ≤ + 40° in all azimuth directions with an average back lobe level of less than − 9.5 dB. This development will allow for low-cost integration of 5G systems for global use, such as passenger aircraft, UAVs, drones, and marine and ground vehicles.


  • Open Access

    Radar Cross Section Analysis of Two Wind Turbines via a Novel Millimeter-Wave Technique and Scale Model Measurements

    by Nikolay Litov, Ben Falkner, Hengyi Zhou, Amit Mehta, Wezi Gondwe, Dushmantha N. Thalakotuna, Dariush Mirshekar-Syahkal, Karu Esselle, Hisamatsu Nakano

    A novel, low cost, highly accurate, millimeter-wave RCS characterization method is developed and presented in this paper. In order to develop and verify the validity of the proposed method, full scale models and scale models of the horizontal-axis wind turbine (HAWT) and Crossflow turbines have been simulated and compared for a case study. The RCS of a scaled Crossflow turbine model was then experimentally verified using the novel method presented at frequencies of 76-81GHz. The proposed method utilizes the AWR1843BOOST evaluation board and DCA1000EVM real-time high-speed data capture card from Texas Instruments. To the best of the authors’ knowledge, this is the first RCS analysis of a scaled model performed at the mm-wave frequencies of 76-81GHz. This novel method is quick, simple, and fully automated, while maintaining high accuracy. Additionally, this has been achieved at a low cost using commercially available off the shelf parts. Good agreement was observed between the simulated and experimental results. Comparing the RCS data of the two turbines, it appears that the Crossflow turbine geometry offers a lower RCS and Doppler spectrum contamination as compared with a traditional horizontal axis wind turbine structure. These results are necessary and useful in allaying the increasing concerns regarding wind turbine radar interference, which have appeared as a result of the widespread adoption of wind power generation in recent years.


  • Use of Narrower Reflection-Canceling Slots to Design Linearly Polarized Radial Line Slot Arrays With Improved Radiation Performance

    by Mst Nishat Yasmin Koli, Muhammad Usman Afzal, Karu P. Esselle, Amit Mehta

    In linearly polarized (LP) radial line slot arrays (RLSAs), reflection cancelling slots (RCSs) are used in addition to the radiating slots (RSs) to reduce the return loss. The densely populated slotted RLSA apertures present the challenge of avoiding physical overlap between the RCSs and RSs. A solution to displace RCSs from their optimal position complicates the design and make it less predictable. A design presented here addresses this issue using narrower RCSs on the same current-flow lines as their corresponding RSs. A high-gain LP RLSA antenna is designed, fabricated, and tested using the proposed strategy. The measured prototype demonstrated a wide matching bandwidth of 74.3%. The antenna achieved a maximum gain of 28.3 dBi at the operating frequency of 17 GHz, and a 3dB gain bandwidth of 6.3%. At this frequency, it has an aperture efficiency of 51%, a total efficiency of 95.3% along with high cross-polar discrimination, which is more than 70 dB in the direction of the beam peak


  • A Circularly Polarized Low-Cost Flat Panel Antenna Array With a High Impedance Surface Meta-Substrate for Satellite On-the-Move Medical IoT Applications

    by Benjamin J. Falkner, Hengyi Zhou, Amit Mehta, Thanos Arampatzis, Dariush Mirshekar-Syahkal, Hisamatsu Nakano

    A 1 ×3 linear antenna array consisting of Quad-Arm Curl antenna with a High impedance surface (QACH) is presented. We believe that it is the first linear phased array solution which can provide 360° azimuth coverage. This array has been designed to operate at the L-band (1.518-1.675 GHz) and generate right-hand circularly polarized radiation to primarily target the Inmarsat Broadband Global Area Network (BGAN) satellite constellation. The metamaterial structure integrated into each antenna element allows a low-profile height of 17.2 mm ( λ 1.597 /10.9). Since the curl element has wideband characteristics, the array is able to provide shared aperture functionality. The array guarantees high-gain beam steering for low elevation angles (up to θ = 70 ° from the zenith) with an average gain of 7.96 dBic at θ = 70 ° . In comparison, to achieve an equivalent high gain a conventional 4 × 5 patch array would be required (three elements versus 20 elements). This means that the proposed array requires 80% fewer phase shifters, amplifiers, and low-noise amplifiers (LNAs). This translates to a crucial commercial advantage in relation to the manufacturing cost. This development can lead to disruption of the existing Satcom market by lowering the barrier-to-entry for customers looking for a mass deployable, low-cost Internet of Things (IoT) on Satcom solution.


  • Concentric Round Metaloops

    by Hisamatsu Nakano, Tomoki Abe, Amit Mehta, Junji Yamauchi

    This paper presents an antenna system where a small round metaloop, S, and a larger round metaloop,L, are arrayed concentrically on a single dielectric substrate. Metaloop S generates circularly polarized broadside radiation. Metaloop L also generates circularly polarized radiation, but the maximum intensity is directed off the zaxis. The antenna system is designed such that it does not radiate/transmit an RF signal in a specific direction (forbidden direction). To achieve this, the radiation from metaloop L is superimposed onto the radiation from metaloop S, producing a dip in the radiation pattern. It is found that the direction of the dip changes when the input voltages applied to the metaloops are changed. Examples where the dip moves in the elevation and azimuth planes are presented.

  • A Four-Arm Circularly Polarized High-Gain High-Tilt Beam Curl Antenna for Beam Steering Applications

    by Hengyi Zhou, Arpan Pal, Amit Mehta, Dariush Mirshekar-Syahkal, Hisamatsu Nakano

    A novel circularly polarized beam steering four-arm curl antenna with four feed points is presented. The antenna provides steerable high-gain high-tilt right-handed circularly polarized (RHCP) beams for satellite communications. The antenna operates over a test frequency band of 1500 MHz to 1670 MHz and covers the entire L1 band. The four arms are arranged symmetrically with respect to the center of the antenna and each arm is fed by a coaxial line. When one of the four feed points is excited and the remaining feed points either open-circuited or terminated to 50° impedance, the antenna generates an RHCP tilted beam of 49° in the elevation plane. At a test frequency of 1575 MHz, the antenna provides a gain of 8.12 dBic. The antenna can switch the tilted beam in the four different space quadrants in the azimuth plane by exciting one feed point at a time. It is found that over the test band, the antenna provides a total efficiency of more than 89% and a gain of greater than 8 dBic.