Sofía Teresa Blanco
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Sofía Teresa Blanco has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
- Javier Fernández
Departamento de Química Física, Facultad de Ciencias, Universidad de Zaragoza, 50009 Zaragoza, Spain
5 shared publications - Manuela Artal
Departamento de Química Física, Facultad de Ciencias, Universidad de Zaragoza, Zaragoza, Spain
5 shared publications - Inmaculada Velasco
Departamento de Química Orgánica y Química Física, Facultad de Ciencias, Universidad de Zaragoza, 50009-Zaragoza, Spain
4 shared publications - José Muñoz Embid
Universidad de Zaragoza
3 shared publications Santos Otín
Departamento de Química Orgánica y Química Física, Facultad de Ciencias, Universidad de Zaragoza, 50009-Zaragoza, Spain
3 shared publicationsLaura Gil
Departamento de Química Orgánica y Química Física, Facultad de Ciencias, Universidad de Zaragoza, 50009-Zaragoza, Spain
2 shared publications
Latest Publications
- Open Access
- 2 June 2025
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 39 (23) , 11173-11186
Viability of the Cocapture of CO2 and Impurities from Oxy-Fuel Combustion and Other Processes in Carbon Capture and Storage Technology
The feasibility of cocapturing CO2 with SO2, CO, and (O2 or NO) from unpurified flue gas produced by oxy-fuel combustion and other processes was assessed by determining the influence of the simultaneous presence of these impurities on selected carbon capture and storage (CCS) operational parameters. These parameters were calculated based on experimental results obtained under CCS conditions. The density, vapor-liquid equilibrium, and speed of sound of [CO2 + 3.0038 mol % O2 + 0.09035 mol % SO2 + 0.17032 mol % CO] and [CO2 + 0.1410 mol % NO + 0.09100 mol % SO2 + 0.17002 mol % CO] mixtures were experimentally determined at temperatures between 263 and 373 K and pressures of up to 30 MPa for density and 190 MPa for speed of sound. Joule-Thomson coefficients and isentropic compressibilities of the mixtures were calculated from our experimental results. Using experimental and calculated data, we assessed the predictive capability of the EOS-CG, GERG-2008, and PC-SAFT equations of state. The simultaneous presence of the investigated impurities at the studied concentrations adversely affects the transport and storage steps in CCS; however, the behavior of the NO-containing mixture is very similar to that of pure CO2. The implications of the chemical effects of the impurities were overlooked.
- 2 June 2025
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 39 (23) , 11173-11186
Open AccessViability of the Cocapture of CO2 and Impurities from Oxy-Fuel Combustion and Other Processes in Carbon Capture and Storage Technology
The feasibility of cocapturing CO2 with SO2, CO, and (O2 or NO) from unpurified flue gas produced by oxy-fuel combustion and other processes was assessed by determining the influence of the simultaneous presence of these impurities on selected carbon capture and storage (CCS) operational parameters. These parameters were calculated based on experimental results obtained under CCS conditions. The density, vapor-liquid equilibrium, and speed of sound of [CO2 + 3.0038 mol % O2 + 0.09035 mol % SO2 + 0.17032 mol % CO] and [CO2 + 0.1410 mol % NO + 0.09100 mol % SO2 + 0.17002 mol % CO] mixtures were experimentally determined at temperatures between 263 and 373 K and pressures of up to 30 MPa for density and 190 MPa for speed of sound. Joule-Thomson coefficients and isentropic compressibilities of the mixtures were calculated from our experimental results. Using experimental and calculated data, we assessed the predictive capability of the EOS-CG, GERG-2008, and PC-SAFT equations of state. The simultaneous presence of the investigated impurities at the studied concentrations adversely affects the transport and storage steps in CCS; however, the behavior of the NO-containing mixture is very similar to that of pure CO2. The implications of the chemical effects of the impurities were overlooked.
- 13 July 2018
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 32 (8) , 8641-8657
Influence of SO2 on CO2 Transport by Pipeline for Carbon Capture and Storage Technology: Evaluation of CO2/SO2 Cocapture
- 13 July 2018
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 32 (8) , 8641-8657
Influence of SO2 on CO2 Transport by Pipeline for Carbon Capture and Storage Technology: Evaluation of CO2/SO2 Cocapture
- 8 April 2010
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry B
- Vol. 114 (16) , 5447-5469
Volumetric Behavior of the {CO2 (1) + C2H6 (2)} System in the Subcritical (T = 293.15 K), Critical, and Supercritical (T = 308.15 K) Regions
The volumetric behavior for the {CO2 (1) + C2H6 (2)} system has been studied. Density measurements of {CO2 (1) + C2H6 (2)} binary mixtures at 293.15 and 308.15 K, at several pressures and compositions, and density measurements for infinitely dilute solutions at 304.21 and 308.15 K were carried out using an Anton Paar DMA 512-P vibrating-tube densimeter calibrated with the forced path mechanical calibration model. The mean relative standard deviation of density, s̅ρr, was estimated to be better than 0.1%, and the uncertainties in temperature and pressure were estimated as ±0.01 K and ±0.001 MPa, respectively. In the experimental setup, an uncertainty in the mole fraction of u(xj) = ±0.0015 has been achieved. Other properties related to P−ρ−T−x data such as the compressibility factor, Z, excess molar volumes, VmE, and partial molar volumes, V̅i and V̅i∞ have been calculated. The volumetric behavior has been compared with literature data and with that obtained from the PC-SAFT EoS rescaled parameters; these parameters have been obtained from our previous experimental values for the critical temperature and pressure of pure compounds. The value for the Krichevskii parameter, AKr, was obtained from the experimental density data for infinitely dilute solutions measured in this work, and it has been compared with that obtained from critical properties. Structural properties such as direct and total correlation function integrals and cluster size were calculated using the Krichevskii function concept.
- 8 April 2010
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry B
- Vol. 114 (16) , 5447-5469
Volumetric Behavior of the {CO2 (1) + C2H6 (2)} System in the Subcritical (T = 293.15 K), Critical, and Supercritical (T = 308.15 K) Regions
The volumetric behavior for the {CO2 (1) + C2H6 (2)} system has been studied. Density measurements of {CO2 (1) + C2H6 (2)} binary mixtures at 293.15 and 308.15 K, at several pressures and compositions, and density measurements for infinitely dilute solutions at 304.21 and 308.15 K were carried out using an Anton Paar DMA 512-P vibrating-tube densimeter calibrated with the forced path mechanical calibration model. The mean relative standard deviation of density, s̅ρr, was estimated to be better than 0.1%, and the uncertainties in temperature and pressure were estimated as ±0.01 K and ±0.001 MPa, respectively. In the experimental setup, an uncertainty in the mole fraction of u(xj) = ±0.0015 has been achieved. Other properties related to P−ρ−T−x data such as the compressibility factor, Z, excess molar volumes, VmE, and partial molar volumes, V̅i and V̅i∞ have been calculated. The volumetric behavior has been compared with literature data and with that obtained from the PC-SAFT EoS rescaled parameters; these parameters have been obtained from our previous experimental values for the critical temperature and pressure of pure compounds. The value for the Krichevskii parameter, AKr, was obtained from the experimental density data for infinitely dilute solutions measured in this work, and it has been compared with that obtained from critical properties. Structural properties such as direct and total correlation function integrals and cluster size were calculated using the Krichevskii function concept.
- 27 April 2009
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry B
- Vol. 113 (20) , 7243-7256
Critical Properties and High-Pressure Volumetric Behavior of the Carbon Dioxide + Propane System at T = 308.15 K. Krichevskii Function and Related Thermodynamic Properties
Critical properties and volumetric behavior for the {CO2(1) + C3H8(2)} system have been studied. The critical locus was measured with a flow apparatus and detected by critical opalescence. For the mixtures, repeatabilities in critical temperature and pressure are rTc ≤ 0.15 K and rPc ≤ 0.013 MPa, respectively, and the confidence intervals calculated are c.i.(Tc) < 0.32 K and c.i.(Pc) < 0.034 MPa. The value for the Krichevskii parameter, AKr = −4.12 MPa, was obtained from the experimental critical data in this work. Additionally, the density measurements of 15 {CO2(1) + C3H8(2)} binary mixtures at 308.15 K and pressures up to 20 MPa were carried out using an Anton Paar DMA 512-P vibrating-tube densimeter calibrated with the forced path mechanical calibration model. The mean relative standard deviation of density, s̅ρr, was estimated to be better than 0.1%, and the uncertainties in temperature and pressure are ±0.01 K and ±0.001 MPa, respectively. In the experimental setup, an uncertainty in the mole fraction, u(xj) = ±0.0015, has been achieved. Other properties related to P-ρ−T-x data such as saturated densities, ρL and ρV, compressibility factor, Z, excess molar volumes,VmE, and partial molar volumes, V̅i, have been calculated. Structural properties such as direct and total correlation function integrals and cluster size were calculated using the Krichevskii function concept. Both the critical and volumetric behavior have been compared with literature data and with those obtained from the PC-SAFT and Patel−Teja equations of state.
- 27 April 2009
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry B
- Vol. 113 (20) , 7243-7256
Critical Properties and High-Pressure Volumetric Behavior of the Carbon Dioxide + Propane System at T = 308.15 K. Krichevskii Function and Related Thermodynamic Properties
Critical properties and volumetric behavior for the {CO2(1) + C3H8(2)} system have been studied. The critical locus was measured with a flow apparatus and detected by critical opalescence. For the mixtures, repeatabilities in critical temperature and pressure are rTc ≤ 0.15 K and rPc ≤ 0.013 MPa, respectively, and the confidence intervals calculated are c.i.(Tc) < 0.32 K and c.i.(Pc) < 0.034 MPa. The value for the Krichevskii parameter, AKr = −4.12 MPa, was obtained from the experimental critical data in this work. Additionally, the density measurements of 15 {CO2(1) + C3H8(2)} binary mixtures at 308.15 K and pressures up to 20 MPa were carried out using an Anton Paar DMA 512-P vibrating-tube densimeter calibrated with the forced path mechanical calibration model. The mean relative standard deviation of density, s̅ρr, was estimated to be better than 0.1%, and the uncertainties in temperature and pressure are ±0.01 K and ±0.001 MPa, respectively. In the experimental setup, an uncertainty in the mole fraction, u(xj) = ±0.0015, has been achieved. Other properties related to P-ρ−T-x data such as saturated densities, ρL and ρV, compressibility factor, Z, excess molar volumes,VmE, and partial molar volumes, V̅i, have been calculated. Structural properties such as direct and total correlation function integrals and cluster size were calculated using the Krichevskii function concept. Both the critical and volumetric behavior have been compared with literature data and with those obtained from the PC-SAFT and Patel−Teja equations of state.
- 1 January 2001
- Published by Taylor & Francis in JOURNAL OF CHEMICAL ENGINEERING OF JAPAN
- Vol. 34 (8) , 971-978
Dew Points of Ternary Propane + Water + Methanol: Measurement and Correlation.
- 1 January 2001
- Published by Taylor & Francis in JOURNAL OF CHEMICAL ENGINEERING OF JAPAN
- Vol. 34 (8) , 971-978
Dew Points of Ternary Propane + Water + Methanol: Measurement and Correlation.
- 1 December 1993
- Published by Elsevier in Fluid Phase Equilibria
- Vol. 91 (2) , 281-290
Excess enthalpies of dibromoalkane + tetrachloromethane mixtures. Measurement and analysis in terms of group contributions (DISQUAC)
- 1 December 1993
- Published by Elsevier in Fluid Phase Equilibria
- Vol. 91 (2) , 281-290
Excess enthalpies of dibromoalkane + tetrachloromethane mixtures. Measurement and analysis in terms of group contributions (DISQUAC)
- 1 October 1993
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 38 (4) , 587-588
Excess enthalpies of dibromoalkane + benzene binary mixtures at 298.15 K
- 1 October 1993
- Published by American Chemical Society (ACS) in Journal of Chemical & Engineering Data
- Vol. 38 (4) , 587-588
Excess enthalpies of dibromoalkane + benzene binary mixtures at 298.15 K