Lupita D. Montoya
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Lupita D. Montoya has a total of 39 co-authors. Here are the top co-authors by number of shared publications:
- Wyatt M. Champion
Air Methods and Characterization Division, U.S. Environmental Protection Agency, Office of Research and Development, 109 T.W. Alexander Drive, Research Triangle Park, North Carolina 27711, United States
4 shared publications - Aaron Lamplugh
Cooperative Institute for Research in Environmental Sciences
2 shared publications - Jean Hertzberg
Department of Mechanical Engineering, University of Colorado Boulder, Boulder, Colorado, USA
2 shared publications - Ning Li
Department of Pathobiology and Diagnostic Investigation, College of Veterinary Medicine, Michigan State University, East Lansing, MI, USA
2 shared publications A. Nguyen
1 shared publication- Arsineh Hecobian
Department of Atmospheric Science, 200 West Lake Street, 1371 Campus Delivery, Colorado State University, Fort Collins, CO, 80523-1371, USA
1 shared publication
Latest Publications
- Open Access
- 4 September 2020
- Published by American Society for Engineering Education
- p. 23.772.1-23.772.13
Integrating Engineering for Developing Communities into Engineering Education A Case Study
- 4 September 2020
- Published by American Society for Engineering Education
- p. 23.772.1-23.772.13
Open AccessIntegrating Engineering for Developing Communities into Engineering Education A Case Study
- Open Access
- 4 September 2020
- Published by American Society for Engineering Education
- p. 13.965.1-13.965.8
Paths To Discovery: Chicanas In Mathematics, Science, And Engineering.
- 4 September 2020
- Published by American Society for Engineering Education
- p. 13.965.1-13.965.8
Open AccessPaths To Discovery: Chicanas In Mathematics, Science, And Engineering.
- 1 January 2020
- Published by Elsevier in Building and Environment
- Vol. 168
VOC emissions from nail salon products and their effective removal using affordable adsorbents and synthetic jets
- 1 January 2020
- Published by Elsevier in Building and Environment
- Vol. 168
VOC emissions from nail salon products and their effective removal using affordable adsorbents and synthetic jets
- 1 November 2019
- Published by Elsevier in Science of The Total Environment
- Vol. 690, 209-216
PM2.5 generated during rapid failure of fiber-reinforced concrete induces TNF-alpha response in macrophages
- 1 November 2019
- Published by Elsevier in Science of The Total Environment
- Vol. 690, 209-216
PM2.5 generated during rapid failure of fiber-reinforced concrete induces TNF-alpha response in macrophages
- 1 June 2019
- Published by Elsevier in Environmental Pollution
- Vol. 249, 518-526
Occupational exposure to volatile organic compounds and health risks in Colorado nail salons
- 1 June 2019
- Published by Elsevier in Environmental Pollution
- Vol. 249, 518-526
Occupational exposure to volatile organic compounds and health risks in Colorado nail salons
- 1 September 2017
- Published by Elsevier in Building and Environment
- Vol. 122, 134-144
Investigation of efficient air pollutant removal using active flow control
- 1 September 2017
- Published by Elsevier in Building and Environment
- Vol. 122, 134-144
Investigation of efficient air pollutant removal using active flow control
- 24 July 2017
- Published by Taylor & Francis in Journal of the Air & Waste Management Association
- Vol. 67 (9) , 1020-1035
Emission factors of fine particulate matter, organic and elemental carbon, carbon monoxide, and carbon dioxide for four solid fuels commonly used in residential heating by the U.S. Navajo Nation
Most homes in the Navajo Nation use wood as their primary heating fuel, often in combination with locally mined coal. Previous studies observed health effects linked to this solid-fuel use in several Navajo communities. Emission factors (EFs) for common fuels used by the Navajo have not been reported using a relevant stove type. In this study, two softwoods (ponderosa pine and Utah juniper) and two high-volatile bituminous coals (Black Mesa and Fruitland) were tested with an in-use residential conventional wood stove (homestove) using a modified American Society for Testing and Materials/U.S. Environmental Protection Agency (ASTM/EPA) protocol. Filter sampling quantified PM2.5 (particulate matter with an aerodynamic diameter ≤2.5 μm) and organic (OC) and elemental (EC) carbon in the emissions. Real-time monitoring quantified carbon monoxide (CO), carbon dioxide (CO2), and total suspended particles (TSP). EFs for these air pollutants were developed and normalized to both fuel mass and energy consumed. In general, coal had significantly higher mass EFs than wood for all pollutants studied. In particular, coal emitted, on average, 10 times more PM2.5 than wood on a mass basis, and 2.4 times more on an energy basis. The EFs developed here were based on fuel types, stove design, and operating protocols relevant to the Navajo Nation, but they could be useful to other Native Nations with similar practices, such as the nearby Hopi Nation. Implications: Indoor wood and coal combustion is an important contributor to public health burdens in the Navajo Nation. Currently, there exist no emission factors representative of Navajo homestoves, fuels, and practices. This study developed emission factors for PM2.5, OC, EC, CO, and CO2 using a representative Navajo homestove. These emission factors may be utilized in regional-, national-, and global-scale health and environmental models. Additionally, the protocols developed and results presented here may inform on-going stove design of the first EPA-certified wood and coal combination stove.
- 24 July 2017
- Published by Taylor & Francis in Journal of the Air & Waste Management Association
- Vol. 67 (9) , 1020-1035
Emission factors of fine particulate matter, organic and elemental carbon, carbon monoxide, and carbon dioxide for four solid fuels commonly used in residential heating by the U.S. Navajo Nation
Most homes in the Navajo Nation use wood as their primary heating fuel, often in combination with locally mined coal. Previous studies observed health effects linked to this solid-fuel use in several Navajo communities. Emission factors (EFs) for common fuels used by the Navajo have not been reported using a relevant stove type. In this study, two softwoods (ponderosa pine and Utah juniper) and two high-volatile bituminous coals (Black Mesa and Fruitland) were tested with an in-use residential conventional wood stove (homestove) using a modified American Society for Testing and Materials/U.S. Environmental Protection Agency (ASTM/EPA) protocol. Filter sampling quantified PM2.5 (particulate matter with an aerodynamic diameter ≤2.5 μm) and organic (OC) and elemental (EC) carbon in the emissions. Real-time monitoring quantified carbon monoxide (CO), carbon dioxide (CO2), and total suspended particles (TSP). EFs for these air pollutants were developed and normalized to both fuel mass and energy consumed. In general, coal had significantly higher mass EFs than wood for all pollutants studied. In particular, coal emitted, on average, 10 times more PM2.5 than wood on a mass basis, and 2.4 times more on an energy basis. The EFs developed here were based on fuel types, stove design, and operating protocols relevant to the Navajo Nation, but they could be useful to other Native Nations with similar practices, such as the nearby Hopi Nation. Implications: Indoor wood and coal combustion is an important contributor to public health burdens in the Navajo Nation. Currently, there exist no emission factors representative of Navajo homestoves, fuels, and practices. This study developed emission factors for PM2.5, OC, EC, CO, and CO2 using a representative Navajo homestove. These emission factors may be utilized in regional-, national-, and global-scale health and environmental models. Additionally, the protocols developed and results presented here may inform on-going stove design of the first EPA-certified wood and coal combination stove.
- 24 April 2017
- Published by ASME International in Journal of Fluids Engineering
- Vol. 139 (7)
Characterization of a Commercial Synthetic Jet Actuator for Air Quality Applications
In this study, a commercial electromagnetic synthetic jet actuator (SJA) was characterized to determine its flow patterns and sphere of influence within a room. Its axisymmetry was also evaluated. The objective of this research is to explore the potential application of this commercial SJA for indoor air quality (IAQ) control and its limitations for such application. A small fan of similar size was also partially characterized. Results showed that the SJA is axisymmetric, and it uses a small power input to impact the airflow over 1 m from the jet exit. Further, while the SJA showed less flow output than the fan in this study, it had significantly greater dynamic pressure per unit power. This feature could be potentially useful for indoor air quality control applications.
- 24 April 2017
- Published by ASME International in Journal of Fluids Engineering
- Vol. 139 (7)
Characterization of a Commercial Synthetic Jet Actuator for Air Quality Applications
In this study, a commercial electromagnetic synthetic jet actuator (SJA) was characterized to determine its flow patterns and sphere of influence within a room. Its axisymmetry was also evaluated. The objective of this research is to explore the potential application of this commercial SJA for indoor air quality (IAQ) control and its limitations for such application. A small fan of similar size was also partially characterized. Results showed that the SJA is axisymmetric, and it uses a small power input to impact the airflow over 1 m from the jet exit. Further, while the SJA showed less flow output than the fan in this study, it had significantly greater dynamic pressure per unit power. This feature could be potentially useful for indoor air quality control applications.