Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Matteo Chiatto has a total of 31 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Orbital cluster-based network modelling

    by Antonio Colanera, Nan Deng, Matteo Chiatto, Luigi de Luca, Bernd R. Noack


  • Extended cluster-based network modeling for coherent structures in turbulent flows

    by Antonio Colanera, Johann Moritz Reumschüssel, Jan Paul Beuth, Matteo Chiatto, Luigi de Luca, Kilian Oberleithner


  • Open Access

    Reduced-Order Model Approaches for Predicting Airfoil Performance

    by Antonio Colanera, Eduardo Di Costanzo, Matteo Chiatto, Luigi de Luca

    This study delves into the construction of reduced-order models (ROMs) of a flow field over a NACA 0012 airfoil at a moderate Reynolds number and an angle of attack of 8∘. Numerical simulations were computed through the finite-volume solver OpenFOAM. The analysis considers two different reduction techniques: the standard Galerkin projection method, which involves projecting the governing equations onto proper orthogonal decomposition modes (POD−ROMs), and the cluster-based network model (CNM), a fully data-driven nonlinear approach. An analysis of the topology of the dominant POD modes was conducted, uncovering a traveling wave pattern in the wake dynamics. We compared the performances of both ROM techniques regarding their prediction of flow field behavior and integral quantities. The ROM framework facilitates the practical actuation of control strategies with significantly reduced computational demands compared to the full-order approach.


  • Open Access

    Global dynamics and topology of two-phase mixing layer flow through simultaneous gas and liquid velocity measurements

    by Alessandro Della Pia, Theodoros Michelis, Matteo Chiatto, Marios Kotsonis, Luigi de Luca

    This study reports the first time-resolved particle image velocimetry characterization of a planar two-phase mixing layer flow, whose velocity field is measured simultaneously in gas and liquid streams. Two parallel air and water flows meet downstream of a splitter plate, giving rise to an initially spanwise invariant configuration. The aim is to elucidate further the mechanisms leading to the flow breakup in gas-assisted atomization. The complete experimental characterization of the velocity field represents a database that could be used in data-driven reduced-order models to investigate the global behaviour of the flow system. After the analysis of a selected reference case, a parametric study of the flow behaviour is performed by varying the liquid ( $Re_l$ ) and gas ( $Re_g$ ) Reynolds numbers, and as a consequence also the gas-to-liquid dynamic pressure ratio ( $M$ ), shedding light on both time-averaged (mean) and unsteady velocity fields. In the reference case, it is shown that the mean flow exhibits a wake region just downstream of the splitter plate, followed by the development of a mixing layer. By increasing both $Re_l$ and $Re_g$ , the streamwise extent of the wake decreases and eventually vanishes, the flow resulting in a pure mixing layer regime. The spectral analysis of the normal-to-flow velocity fluctuations outlines different flow regimes by variation of the governing parameters, giving more insights into the global characteristics of the flow field. As a major result, it is found that at high $Re_g$ and $M$ values, the velocity fluctuations are characterized by low-frequency temporal oscillations synchronized in several locations within the flow field, which suggest the presence of a global mode of instability. The proper orthogonal decomposition of velocity fluctuations, performed in both gas and liquid phases, reveals finally that the synchronized oscillations are associated with a low-frequency dominant flapping mode of the gas–liquid interface. Higher-order modes correspond to interfacial wave structures travelling with the so-called Dimotakis velocity. For lower gas Reynolds numbers, the leading modes describe higher frequency fingers shedding at the interface.


  • On the shapes of liquid curtains flowing from a non-vertical slot

    by Alessandro Della Pia, Michael G. Antoniades, Eleni S. Ioannidis, Zoe A. Wejko, Nathaniel S. Barlow, Matteo Chiatto, Steven J. Weinstein, Luigi de Luca

    A theoretical and experimental investigation of two-dimensional (2-D) liquid curtains (gravitationally thinning liquid sheets) is provided under conditions where the curtain issues from a thin slot whose centreline is inclined with respect to the vertical. This analysis is motivated in part by recent works where it has been proposed that oblique liquid curtains (those exiting a non-vertical slot) may bend upwards against gravity when the relevant Weber number at the slot is less than unity ( $We <1$ ). By contrast, Weinstein et al. (J. Fluid Mech., vol. 876, 2019, R3) have proposed that such $We<1$ curtains must be vertical and downward falling regardless of the inclination of the slot. Under low-Reynolds-number ( $Re$ ) conditions typical of liquid film coating operations, our experiments show that the curtain shape follows the classic ballistic (parabolic) trajectory in the supercritical regime ( $We>1$ ). In subcritical conditions ( $We<1$ ), experiments show that the downward-falling curtain is vertical except in a relatively small region near the slot, where the combined effects of viscosity and surface tension induce the so-called teapot effect. These experimental results are confirmed by 2-D numerical simulations, which predict the curtain behaviour ranging from highly viscous ( $Re = O(1)$ ) to nearly inviscid conditions. The one-dimensional (1-D) inviscid model of Weinstein et al. is recast in a different form to facilitate comparisons with the 2-D model, and 1-D and 2-D results agree favourably for supercritical and subcritical conditions. Despite the large parameter range explored, we have found no evidence that upward-bending curtains exist in an oblique configuration.


  • Open Access

    Hole-driven dynamics of a three-dimensional gravitational liquid curtain

    by Maria Rosaria Acquaviva, Alessandro Della Pia, Matteo Chiatto, Luigi de Luca

    It is known that the disintegration of vertical liquid curtains (sheets) is affected crucially by the amplification of free edge holes forming inside the curtain. This paper aims to investigate the influence of the hole expansion dynamics, driven by the so-called rim retraction, on the breakup of a liquid curtain, in both supercritical (Weber number $We > 1$ ) and subcritical ( $We < 1$ ) conditions. The analysis is based on three-dimensional direct numerical simulations. For a selected supercritical configuration, the steady flow topology is first analysed. The investigation reveals the classic triangular shape regime of the steady curtain, due to the surface-tension-induced borders retraction towards its centre plane. The unsteady dynamics is then investigated as the curtain response to a hole perturbation introduced artificially in the steady flow configuration. The hole evolution determines a rim retraction phenomenon inside the curtain, which is influenced by both capillary and gravity forces. In supercritical conditions, the hole does not influence the curtain flow dynamics in the long-time limit. By reducing the Weber number slightly under the critical threshold ( $We=1$ ), the initial amplification rate of the hole area increases, due to the stronger retraction effect of surface tension acting on the hole rims. The free hole expansion in fully subcritical conditions ( $We < 1$ ) is investigated finally by simulating an edge-free curtain flow. As $We$ decreases progressively, the hole expands while it is convected downstream by gravity acceleration. In the range $0.4< We<1$ , the subcritical curtain returns to the intact unperturbed configuration after the hole expulsion at the downstream outflow. For $We<0.4$ , the surface tension force becomes strong enough to reverse the gravitational motion of the hole top point, which retracts upstream towards the sheet inlet section while expanding along the lateral directions. This last phenomenon causes finally the breakup of the curtain, which results in a columnar regime strictly resembling similar experimental findings of the literature.


  • Open Access

    Analysis of the wake flow behind concave curved cylinders with velocity measurements by particle image velocimetry and modal decomposition

    by Matteo Chiatto, Caroline Cardinale, Jessica K. Shang, Francesco Grasso

    The properties of the wake flow behind concave curved cylinders have been investigated analyzing simultaneously the mean velocity profiles extracted along concentric arcs parallel to the cylinder axis and the dynamically most relevant coherent structures obtained by spectral proper orthogonal decomposition. These analyzes have allowed us to determine the position, the extension, and the evolution of the different wake regimes. The velocity measurements have been obtained through the stereo particle image velocimetry (stereo-PIV) technique. The study considers various Reynolds numbers, based on cylinder diameter (240<Re<840), and curvatures. The quarter-of-ring cylinder is first analyzed. Near the cylinder root, the flow exhibits a topology dominated by an oblique vortex shedding, contrary to what is observed in the literature for similar geometric configurations. We attribute this disagreement to differences in the treatment of the free-end conditions that play a role in triggering the shedding regime. We find that the local shedding inclination is driven by the axial velocity, whereas its extension and wavelength depend mainly on the Reynolds number. The near free-end region presents, instead, two counter-rotating standing vortices that induce a cross-wise velocity directed toward the cylinder root and a tip vortex that expands evolving downstream. As the Reynolds number increases, the wake presents irregularities and the shedding spreads becoming nearly normal to the incoming flow. At smaller curvatures, the cylinder free-end becoming more inclined with respect to the incoming flow, and the free-end effects are enhanced. The interaction with the vortex sheets of the standing vortices that develop at the leeward side weakens. As a consequence, these vortices stretch in the stream-wise direction giving rise to the trailing vortices that stem from the cylinder surface and affect the cross-wise velocity distributions.


  • Open Access

    Advances in Flow Control by Means of Synthetic Jet Actuators

    by Matteo Chiatto, Luigi de Luca

    The need for flow control is widely recognized in various fields of technological applications such as fluid dynamics, atomization, heat transfer, and others

  • Data-driven global stability of vertical planar liquid jets by dynamic mode decomposition on random perturbations

    by Antonio Colanera, Alessandro Della Pia, Matteo Chiatto

    A data-driven approach to estimate the global spectrum of gravitational planar liquid jets (sheet or curtain flows) is presented in this work. The investigation is carried out by means of two-dimensional numerical simulations performed through the solver BASILISK, based on the one-fluid formulation and the volume-of-fluid approach. The dynamic mode decomposition technique is applied to extract the underlying linear operator, considering random perturbations of the base flow. The effectiveness of this procedure is first evaluated comparing results with those of a simplified one-dimensional curtain model in terms of spectrum and eigenfunctions. The methodology is then applied to a two-dimensional configuration obtaining the BiGlobal spectra for both supercritical (Weber number We > 1) and subcritical (We < 1) regimes. Results highlight that in supercritical regime, the spectrum presents three branches: the upper and lower ones exhibit a purely sinuous behavior with frequencies quite close to those predicted by the one-dimensional model; the middle branch presents a predominant varicose component, increasing with the frequency. The subcritical spectrum, instead, shows that the first two less stable eigenvalues, sorted by increasing frequency, exhibit, respectively, a sinuous and a varicose behavior, while their growth rate is almost the same. As expected, the subcritical regime does not reveal the slow branch. The effect of the density ratio, rρ , between the two phases is investigated, revealing that the flow system is unstable for rρ>0.05 . Topological inspections of the leading modes in this unstable configuration show that the predominance of a varicose behavior is related to the rupture of the curtain.


  • Open Access

    Natural frequency discontinuity of vertical liquid sheet flows at transcritical threshold

    by Matteo Chiatto, Alessandro Della Pia

    The natural and forced dynamic response of a gravitational plane liquid sheet (curtain) of finite length interacting with an unconfined gaseous ambient is numerically and experimentally investigated. The global eigenvalue spectrum obtained by means of a linear inviscid one-dimensional model, accounting for the coupling between the curtain motion and the ambient pressure disturbances, clearly shows an abrupt increase (jump) in the characteristic natural frequency of the flow when the supercritical ( $We>1$ ) to subcritical ( $We<1$ ) transition occurs, with the Weber number $We$ defined as the ratio between inertia and capillary forces. On the other hand, the numerical simulation of the forced sheet response does not show any discontinuity between supercritical and subcritical conditions, as recently found by Torsey et al. (J. Fluid Mech., vol. 910, 2021, pp. 1–14) in the case of an infinite liquid sheet subjected to imposed ambient pressure disturbances not coupled with the curtain motion. It is argued that the forced liquid sheet behaviour varies continuously in shape and amplitude between the two regimes, not depending on the specific liquid–gas interaction model considered, whilst the natural frequency of the finite flow system does undergo a discontinuity, which can be theoretically predicted by the model of sheet–ambient interaction employed here. As a major result, the experimental evidence of the natural frequency jump is for the first time provided as well.