Igor G. Assovskiy
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Igor G. Assovskiy has a total of 21 co-authors. Here are the top co-authors by number of shared publications:
A. A. Berlin
N.N. Semenov Federal Research Center for Chemical Physics, Russian Academy of Sciences; Moscow Institute of Physics and Technology
4 shared publications- Sergey A. Rashkovskiy
Ishlinsky Institute for Problems in Mechanics RAS, 119526 Moscow, Russia
2 shared publications - Yu. A. Nikitaev
Semenov Federal Research Center of Chemical Physics, Russian Academy of Sciences, Moscow, Russia
2 shared publications A. A. Denisaev
Russian Academy of Sciences
1 shared publicationA. A. Solov’YAnov
Russian Academy of Sciences
1 shared publicationA. G. Istratov
Semenov Institute of Chemical Physics, Russian Academy of Sciences, Moscow, Russia
1 shared publication
Latest Publications
- 1 June 2022
- Published by Optica Publishing Group in Journal of Optical Technology
- Vol. 89 (6) , 365-370
Attenuation of a single pulse of a neodymium laser in colored optical glasses
Subject of study. The energy of a laser flash was measured directly using a calorimeter. The shape of an optical pulse was recorded using a photocell. The intensity of the radiation converted to photocurrent is presented in relative units. The illuminance in a highly diffusive optical medium varied over a wide range. The photocell was calibrated directly using the laser to obtain the radiative energy balance in energy units. This was achieved by successively attenuating the energy of the laser beam using colored filters. Method. Attenuation of a single pulse of a neodymium laser (wavelength λ=1064nm, duration at the level of 0.5t1/2≈5×10−9s) passing through different types of colored filters was investigated. Main results. A significant discrepancy between the intensities of the transmitted radiation was found for samples with equal optical densities but composed of different types of glasses. Three groups of glasses with different transmission degrees and characters were identified. The experimental data were interpreted using a nonlinear radiation absorption model. Practical significance. Colored filters most suitable for operation under the specified conditions were selected experimentally. Yellow–green glass showed the best parameters. It was found that glasses with the highest absorption coefficients should not be used.
- 1 June 2022
- Published by Optica Publishing Group in Journal of Optical Technology
- Vol. 89 (6) , 365-370
Attenuation of a single pulse of a neodymium laser in colored optical glasses
Subject of study. The energy of a laser flash was measured directly using a calorimeter. The shape of an optical pulse was recorded using a photocell. The intensity of the radiation converted to photocurrent is presented in relative units. The illuminance in a highly diffusive optical medium varied over a wide range. The photocell was calibrated directly using the laser to obtain the radiative energy balance in energy units. This was achieved by successively attenuating the energy of the laser beam using colored filters. Method. Attenuation of a single pulse of a neodymium laser (wavelength λ=1064nm, duration at the level of 0.5t1/2≈5×10−9s) passing through different types of colored filters was investigated. Main results. A significant discrepancy between the intensities of the transmitted radiation was found for samples with equal optical densities but composed of different types of glasses. Three groups of glasses with different transmission degrees and characters were identified. The experimental data were interpreted using a nonlinear radiation absorption model. Practical significance. Colored filters most suitable for operation under the specified conditions were selected experimentally. Yellow–green glass showed the best parameters. It was found that glasses with the highest absorption coefficients should not be used.
- 1 April 2021
- Published by Elsevier in Acta Astronautica
- Vol. 181, 643-648
Energetic water compositions as rocket propellants
- 1 April 2021
- Published by Elsevier in Acta Astronautica
- Vol. 181, 643-648
Energetic water compositions as rocket propellants
- Open Access
- 24 September 2019
- Published by The Russian Academy of Sciences in Доклады Академии наук
- Vol. 488 (2) , 142-146
Photopurification of aqueous media using heterogeneous photosensitizers
A new materialconsisted of titanium dioxide microparticles photosensitized by organic dyes to generate photodynamic effect is suggested and tested. The effectivity of using such material for water photopurification from organic pollution using daylight is proven.
- 24 September 2019
- Published by The Russian Academy of Sciences in Доклады Академии наук
- Vol. 488 (2) , 142-146
Open AccessPhotopurification of aqueous media using heterogeneous photosensitizers
A new materialconsisted of titanium dioxide microparticles photosensitized by organic dyes to generate photodynamic effect is suggested and tested. The effectivity of using such material for water photopurification from organic pollution using daylight is proven.
- 1 September 2019
- Published by Pleiades Publishing Ltd in Doklady Physics
- Vol. 64 (9) , 349-352
Photopurification of Aquatic Media by Heterogeneous Photosensitizers
A new material consisted of titanium dioxide microparticles photosensitized by organic dyes for generating the photodynamic effect is proposed and tested. The efficiency of using such a...
- 1 September 2019
- Published by Pleiades Publishing Ltd in Doklady Physics
- Vol. 64 (9) , 349-352
Photopurification of Aquatic Media by Heterogeneous Photosensitizers
A new material consisted of titanium dioxide microparticles photosensitized by organic dyes for generating the photodynamic effect is proposed and tested. The efficiency of using such a...
- Open Access
- 11 November 2015
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 653 (1) , 012014
Direct laser initiation of open secondary explosives
The goal of this paper is experimental study of the mechanism of initiation of secondary explosives (SE) by short laser pulse. Laser initiation of SE is much more difficult in comparison with initiation of primary explosives. Using of some special methods is typically requested to realize laser initiation of SE: using of porous SE, putting it in a closed envelope, and using some optically dense additives. In this paper we consider interaction of laser pulse with open surface of non-porous, optically uniform SE. Only pure chemical methods were used to control the light sensitivity of SE. Implementation of the method of laser initiation is reduced to the optimization of composition and molecular structure of the explosives, along with the optimization of the laser pulse (its duration, energy density and wavelength).
- 11 November 2015
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 653 (1) , 012014
Open AccessDirect laser initiation of open secondary explosives
The goal of this paper is experimental study of the mechanism of initiation of secondary explosives (SE) by short laser pulse. Laser initiation of SE is much more difficult in comparison with initiation of primary explosives. Using of some special methods is typically requested to realize laser initiation of SE: using of porous SE, putting it in a closed envelope, and using some optically dense additives. In this paper we consider interaction of laser pulse with open surface of non-porous, optically uniform SE. Only pure chemical methods were used to control the light sensitivity of SE. Implementation of the method of laser initiation is reduced to the optimization of composition and molecular structure of the explosives, along with the optimization of the laser pulse (its duration, energy density and wavelength).
- 1 February 2014
- Published by Pleiades Publishing Ltd in Doklady Chemistry
- Vol. 454 (2) , 39-41
Oligo(glycidyl azides): New approaches to synthesis and properties
- 1 February 2014
- Published by Pleiades Publishing Ltd in Doklady Chemistry
- Vol. 454 (2) , 39-41
Oligo(glycidyl azides): New approaches to synthesis and properties
- 1 November 2013
- Published by Pleiades Publishing Ltd in Doklady Physical Chemistry
- Vol. 453 (1) , 261-263
Study of the impact sensitivity of sodium azide and its mixtures with water
- 1 November 2013
- Published by Pleiades Publishing Ltd in Doklady Physical Chemistry
- Vol. 453 (1) , 261-263
Study of the impact sensitivity of sodium azide and its mixtures with water
- 1 May 2013
- Published by Pleiades Publishing Ltd in Combustion, Explosion, and Shock Waves
- Vol. 49 (3) , 264-272
Validity of experimental and theoretical modeling of combustion of high-energy materials
Problems of theoretical and experimental modeling of combustion of high-energy materials in technological devices are considered. Requirements for modeling, validation criteria of modeling, and similarity criteria of combustion conditions are formulated. Classification of the validity of theoretical and experimental modeling is considered taking into account the features of intrachamber combustion of high-energy materials in technological devices.
- 1 May 2013
- Published by Pleiades Publishing Ltd in Combustion, Explosion, and Shock Waves
- Vol. 49 (3) , 264-272
Validity of experimental and theoretical modeling of combustion of high-energy materials
Problems of theoretical and experimental modeling of combustion of high-energy materials in technological devices are considered. Requirements for modeling, validation criteria of modeling, and similarity criteria of combustion conditions are formulated. Classification of the validity of theoretical and experimental modeling is considered taking into account the features of intrachamber combustion of high-energy materials in technological devices.
- 1 February 2012
- Published by Pleiades Publishing Ltd in Doklady Physical Chemistry
- Vol. 442 (2) , 40-44
Reduction of energy of laser initiation of energetic materials
- 1 February 2012
- Published by Pleiades Publishing Ltd in Doklady Physical Chemistry
- Vol. 442 (2) , 40-44
Reduction of energy of laser initiation of energetic materials
- 1 January 2009
- Published by Begell House Inc. Publishers in International Journal of Energetic Materials and Chemical Propulsion
- Vol. 8 (4) , 281-289
METALLIZED CARBON NANOTUBES
The subject of this paper is carbon nanotubes filled or covered by metal, which are promising for application in energetic materials. The most valuable single-walled carbon nanotubes (SWCNT) are proposed to be the best protective coating for energetic metal nanoparticles and as a base for a catalyst in the propellant. Advanced technology has been proposed to synthesize metallized SWCNT (MSWCNT) using a CO2 laser for ablation of the composite graphite target. This laser synthesis operates under the normal conditions, and therefore serves as a basis for a high-productive continuous synthesis of MSWCNT.
- 1 January 2009
- Published by Begell House Inc. Publishers in International Journal of Energetic Materials and Chemical Propulsion
- Vol. 8 (4) , 281-289
METALLIZED CARBON NANOTUBES
The subject of this paper is carbon nanotubes filled or covered by metal, which are promising for application in energetic materials. The most valuable single-walled carbon nanotubes (SWCNT) are proposed to be the best protective coating for energetic metal nanoparticles and as a base for a catalyst in the propellant. Advanced technology has been proposed to synthesize metallized SWCNT (MSWCNT) using a CO2 laser for ablation of the composite graphite target. This laser synthesis operates under the normal conditions, and therefore serves as a basis for a high-productive continuous synthesis of MSWCNT.