Philippe Mertens
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Philippe Mertens has a total of 111 co-authors. Here are the top co-authors by number of shared publications:
- Yury Krasikov
Forschungszentrum Julich, Inst Energy & Climate Res, D-52428 Julich, Germany
14 shared publications - Wolfgang Biel
Institut für Energie- und Klimaforschung, Forschungszentrum Jülich GmbH, Jülich, GERMANY
9 shared publications Anatoly Panin
8 shared publications- Christian Linsmeier
Forschungszentrum Jülich GmbH, Institute of Fusion Energy and Nuclear Waste Management, Plasma Physics IFN-1, 52428 Jülich, Germany
7 shared publications - Olaf Neubauer
Forschungszentrum Julich, Inst Energie & Klimaforsch Plasmaphys, Partner Trilateral Euregio Cluster TEC, D-52425 Julich, Germany
7 shared publications - Alexander Huber
Forschungszentrum Jülich GmbH, Institut für Energie- und Klimaforschung—Plasmaphysik, Partner of the Trilateral Euregio Cluster (TEC), 52425 Jülich, Germany
5 shared publications
Latest Publications
- 1 October 2020
- Published by Elsevier in Fusion Engineering and Design
- Vol. 159
TFC-PREDIM: A FE dimensioning procedure for the TF coil system of a DEMO tokamak reactor
- 1 October 2020
- Published by Elsevier in Fusion Engineering and Design
- Vol. 159
TFC-PREDIM: A FE dimensioning procedure for the TF coil system of a DEMO tokamak reactor
- 1 September 2019
- Published by Elsevier in Fusion Engineering and Design
- Vol. 146, 2514-2518
On the use of rhodium mirrors for optical diagnostics in ITER
- 1 September 2019
- Published by Elsevier in Fusion Engineering and Design
- Vol. 146, 2514-2518
On the use of rhodium mirrors for optical diagnostics in ITER
- 1 September 2019
- Published by Elsevier in Fusion Engineering and Design
- Vol. 146, 535-538
Detailed structural analysis of a graded TF coil winding pack for EU DEMO
- 1 September 2019
- Published by Elsevier in Fusion Engineering and Design
- Vol. 146, 535-538
Detailed structural analysis of a graded TF coil winding pack for EU DEMO
- 1 September 2019
- Published by Elsevier in Fusion Engineering and Design
- Vol. 146, 228-231
Design status of the ITER core CXRS diagnostic setup
- 1 September 2019
- Published by Elsevier in Fusion Engineering and Design
- Vol. 146, 228-231
Design status of the ITER core CXRS diagnostic setup
- Open Access
Emission of Fast Hydrogen Atoms in a Low Density Gas Discharge—The Most “Natural” Mirror Laboratory
In this work, we present a new application for the line shapes of emission induced by reflected hydrogen atoms. Optical properties of the solids in contact with the plasma could be effectively measured at the wavelength of Balmer lines: time-resolved measurements of reflectance and polarization properties of mirrors are performed using the wavelength separation of the direct and reflected signals. One uses the Doppler effect of emission of atoms excited by collisions with noble gases, primarily with Ar or with Kr. In spite of a new application of line shapes, the question of the source of the strong signal in the case of Ar exists: the emission observed in the case of the excitation of H or D atoms by Ar exceeds the signal induced by collisions with Kr atoms by a factor of five, and the only available experimental data for the ground state excitation show practically equal cross-sections for both gases in the energy range of 80–200 eV.
Open AccessEmission of Fast Hydrogen Atoms in a Low Density Gas Discharge—The Most “Natural” Mirror Laboratory
In this work, we present a new application for the line shapes of emission induced by reflected hydrogen atoms. Optical properties of the solids in contact with the plasma could be effectively measured at the wavelength of Balmer lines: time-resolved measurements of reflectance and polarization properties of mirrors are performed using the wavelength separation of the direct and reflected signals. One uses the Doppler effect of emission of atoms excited by collisions with noble gases, primarily with Ar or with Kr. In spite of a new application of line shapes, the question of the source of the strong signal in the case of Ar exists: the emission observed in the case of the excitation of H or D atoms by Ar exceeds the signal induced by collisions with Kr atoms by a factor of five, and the only available experimental data for the ground state excitation show practically equal cross-sections for both gases in the energy range of 80–200 eV.
- 1 July 2019
- Published by AIP Publishing in Physics of Plasmas
- Vol. 26 (7) , 073513
Polarization by light reflection at metallic surfaces observed in the shape of the Balmer-α line of low density plasmas
The degree of linear polarization of light reflected at metallic surfaces is obtained from the shape of the Balmer-α line measured in a low density plasma. The measurements of the polarization properties of metallic surfaces utilize only the high-resolution emission spectra induced by fast reflected H atoms (≈100 eV) in ArH plasmas. The measurements are performed at two different lines-of-sight to the target surfaces of Mo and Cu. Only at the observation angle close to the Brewster one, a significant drop of the measured red-shifted signal is detected for the Mo target: the red-shifted emission reduces by ≈50% depending on whether the transverse (S) or the parallel (P) polarization component of the reflected light is selected. In contrast to this, a very weak change of emission is observed for the Cu surface for the same angle. The spectra measured in front of the Mo target were modeled utilizing the energy and angular distribution of reflected atoms and excitation of the cross section of Ar-H collision combined in a Doppler-shifted emission model. A good agreement with the theoretical calculations is found for polarization components (except for the weak P polarization at 70°). Finally, the undercosine distribution of the reflected atoms with b ≈ 0.2 (b is the power of the cosine distribution) shows the best agreement with the spectra measured at both lines-of-sight.
- 1 July 2019
- Published by AIP Publishing in Physics of Plasmas
- Vol. 26 (7) , 073513
Polarization by light reflection at metallic surfaces observed in the shape of the Balmer-α line of low density plasmas
The degree of linear polarization of light reflected at metallic surfaces is obtained from the shape of the Balmer-α line measured in a low density plasma. The measurements of the polarization properties of metallic surfaces utilize only the high-resolution emission spectra induced by fast reflected H atoms (≈100 eV) in ArH plasmas. The measurements are performed at two different lines-of-sight to the target surfaces of Mo and Cu. Only at the observation angle close to the Brewster one, a significant drop of the measured red-shifted signal is detected for the Mo target: the red-shifted emission reduces by ≈50% depending on whether the transverse (S) or the parallel (P) polarization component of the reflected light is selected. In contrast to this, a very weak change of emission is observed for the Cu surface for the same angle. The spectra measured in front of the Mo target were modeled utilizing the energy and angular distribution of reflected atoms and excitation of the cross section of Ar-H collision combined in a Doppler-shifted emission model. A good agreement with the theoretical calculations is found for polarization components (except for the weak P polarization at 70°). Finally, the undercosine distribution of the reflected atoms with b ≈ 0.2 (b is the power of the cosine distribution) shows the best agreement with the spectra measured at both lines-of-sight.
- Open Access
- 1 January 2019
- Published by Elsevier in Nuclear Materials and Energy
- Vol. 18, 118-124
Determination of tungsten sources in the JET-ILW divertor by spectroscopic imaging in the presence of a strong plasma continuum
- 1 January 2019
- Published by Elsevier in Nuclear Materials and Energy
- Vol. 18, 118-124
Open AccessDetermination of tungsten sources in the JET-ILW divertor by spectroscopic imaging in the presence of a strong plasma continuum
- Open Access
- 1 December 2018
- Published by Elsevier in Nuclear Materials and Energy
- Vol. 17, 302-306
In situ measurement of the spectral reflectance of mirror-like metallic surfaces during plasma exposition
- 1 December 2018
- Published by Elsevier in Nuclear Materials and Energy
- Vol. 17, 302-306
Open AccessIn situ measurement of the spectral reflectance of mirror-like metallic surfaces during plasma exposition
- 19 November 2018
- Published by Springer Nature in Journal of Fusion Energy
- Vol. 38 (3-4) , 264-282
The Core-Plasma CXRS Diagnostic for ITER: An Introduction to the Current Design
- 19 November 2018
- Published by Springer Nature in Journal of Fusion Energy
- Vol. 38 (3-4) , 264-282
The Core-Plasma CXRS Diagnostic for ITER: An Introduction to the Current Design
- Open Access
- 1 June 2018
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 89 (6) , 063112
In situ measurements of the spectral reflectance of metallic mirrors at the H α line in a low density Ar–H plasma
The efficient and reliable control and monitoring of the quality of the optical properties of mirrors is an open problem in laboratory plasmas. Until now, the measurement of the reflectance of the first mirrors was based on the methods that require additional light calibration sources. We propose a new technique based on the ratio of the red- and blue-shifted emission signals of the reflected hydrogen atoms which enables the in situ measurement of the spectral reflectance of metallic mirrors in low-density Ar–H or Ar–D plasmas. The spectral reflectance coefficients were measured for C, Al, Ag, Fe, Pd, Ti, Sn, Rh, Mo, and W mirrors installed in the linear magnetized plasma device PSI-2 operating in the pressure range of 0.01-0.1 Pa. The results are obtained for the Hα line using the emission of fast atoms induced by excitation of H atoms through Ar at a plasma-solid interface by applying a negative potential U = −80, …, −220 V to the mirror. The agreement between the measured and theoretical data of reflectance is found to be within 10% for the investigated materials (except for C). The spectra also allow us to efficiently determine the material of the mirror.
- 1 June 2018
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 89 (6) , 063112
Open AccessIn situ measurements of the spectral reflectance of metallic mirrors at the H α line in a low density Ar–H plasma
The efficient and reliable control and monitoring of the quality of the optical properties of mirrors is an open problem in laboratory plasmas. Until now, the measurement of the reflectance of the first mirrors was based on the methods that require additional light calibration sources. We propose a new technique based on the ratio of the red- and blue-shifted emission signals of the reflected hydrogen atoms which enables the in situ measurement of the spectral reflectance of metallic mirrors in low-density Ar–H or Ar–D plasmas. The spectral reflectance coefficients were measured for C, Al, Ag, Fe, Pd, Ti, Sn, Rh, Mo, and W mirrors installed in the linear magnetized plasma device PSI-2 operating in the pressure range of 0.01-0.1 Pa. The results are obtained for the Hα line using the emission of fast atoms induced by excitation of H atoms through Ar at a plasma-solid interface by applying a negative potential U = −80, …, −220 V to the mirror. The agreement between the measured and theoretical data of reflectance is found to be within 10% for the investigated materials (except for C). The spectra also allow us to efficiently determine the material of the mirror.