EPEduardo J. Pires

Eduardo J. Pires

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Eduardo J. Pires has a total of 13 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • By-products of Beer Fermentation

    by Eduardo Pires, Tomáš Brányik


  • The Brewing Yeast

    by Eduardo Pires, Tomáš Brányik


  • An Overview of the Brewing Process

    by Eduardo Pires, Tomáš Brányik


  • Open Access

    Continuous beer fermentation - diacetyl as a villain

    by Eduardo J. Pires, José A. Teixeira, Tomás Brányik, Tiago Brandão, António A. Vicente

    This work tested the viability of producing beer of good quality after maturation of green beer obtained by primary continuous fermentation of high‐gravity wort using an airlift bioreactor with flocculated biomass. Fermentation performance of the tested setup was unique as it reached a maximum saccharide consumption rate of 9.43 g L−1 h−1 and an ethanol productivity of 3.75 g L−1 h−1. Despite the high levels of diacetyl present in the green beer, a regular maturation was able to reduce it to below threshold values in up to 15 days. It was observed that diacetyl production was strongly correlated with wort composition injected into the system, rather than with the large amount of biomass immobilized in the bioreactor (up to 727 × 106 cell mL−1). Organoleptic tests showed that the maturated beer had no major defects. Copyright © 2015 The Institute of Brewing & Distilling


  • Open Access

    Carrier-free, continuous primary beer fermentation

    by Eduardo J. Pires, José A. Teixeira, Tomás Brányik, António A. Vicente

    Developing a sustainable continuous fermentation reactor is one of the most ambitious tasks in brewing science, but it could bring great benefits regarding volumetric productivity to modern breweries. Immobilized cell technology is often applied to reach the large densities of yeast needed in a continuous fermentation process. However, the financial cost associated with the use of carriers for yeast immobilization is one of the major drawbacks in the technology. This work suggests that yeast flocculation could address biomass immobilization in a gas-lift reactor for the continuous primary fermentation of beer. Nearly 25 g dry wt L−1 of yeast was flocculated in the reactor before interruption of the fermentation. Stable sugar consumption and ethanol production (4.5% alcohol by volume) from an 11°P wort was evidenced. The key esters and higher alcohols measured in the young beer met the standards of a finished primary beer fermentation. Copyright © 2014 The Institute of Brewing & Distilling


  • Open Access

    High gravity primary continuous beer fermentation using flocculent yeast biomass

    by Eduardo J. Pires, José A. Teixeira, Tomás Brányik, Manuela Côrte-Real, Tiago Brandão, António A. Vicente

    The current work assessed a new immobilized cell reactor system throughout a long-term (54 days) continuous primary fermentation of lager-type wort of high specific gravity. The experiment was performed in a 4 L airlift bioreactor and immobilization of biomass was attained solely by flocculation. Despite the constant liquid agitation and washout of biomass, up to 53 g dry wt/L of yeast remained immobilized in the system. Two types of beer were produced without interrupting the reactor, based on two types of wort: a Pilsener type with high specific gravity of 15.6 ± 0.3°P; and a dark lager wort with specific gravity of 14.4 ± 0.03°P. Even during the inlet of high gravity wort, the desired attenuation was achieved without the need for either recirculation or an auxiliary second stage bioreactor. The specific saccharide consumption rate was kept around 7.9 ± 0.4 g/L/h and ethanol productivity oscillated at 3.36 ± 0.2 g/L/h for nearly a month. During this period the volumetric productivity of the current bioreactor reached 1.6 L beer/L/day. The green beers produced from the Pilsener and dark lager worts met the standards of regular finished primary beer fermentation. The productivity of diacetyl through the entire experiment could be correlated to the free amino nitrogen consumption rate. Copyright © 2014 The Institute of Brewing & Distilling


  • Open Access

    Maintaining yeast viability in continuous primary beer fermentation

    by Eduardo J. Pires, José A. Teixeira, Tomás Brányik, Manuela Côrte-Real, António A. Vicente

    Continuous fermentation is a long known and vastly studied process. The use of immobilized cell technology (ICT) is exploited in a significant number of studies owing to the associated high volumetric productivity, time savings and low capital demand. This work was aimed at solving one of the most relevant obstacles to implementing ICT on a large scale in beer fermentations, namely the control of biomass and the maintenance of cell viability in a gas-lift bioreactor. For this purpose, foam fractionation by skimming was proposed as a tool for control of continuous biomass concentration. The consequences of foaming on lignocellulosic yeast carrier losses were assessed and discussed. A steady consumption of sugars from wort, as well as consistent ethanol production, were achieved. The viability of the suspended cells in the reactor was compared with that of the cell population in the foam using flow cytometry. Results suggest that foam might be used as a promising tool to skim non-viable biomass out of the gas-lift reactor, thus ensuring the maintenance of a cell culture with optimum viability. Copyright © 2014 The Institute of Brewing & Distilling


  • Top Cited Papers

    Yeast: the soul of beer’s aroma—a review of flavour-active esters and higher alcohols produced by the brewing yeast

    by Eduardo J. Pires, José A. Teixeira, Tomás Brányik, António A. Vicente

    Among the most important factors influencing beer quality is the presence of well-adjusted amounts of higher alcohols and esters. Thus, a heavy body of literature focuses on these substances and on the parameters influencing their production by the brewing yeast. Additionally, the complex metabolic pathways involved in their synthesis require special attention. More than a century of data, mainly in genetic and proteomic fields, has built up enough information to describe in detail each step in the pathway for the synthesis of higher alcohols and their esters, but there is still place for more. Higher alcohols are formed either by anabolism or catabolism (Ehrlich pathway) of amino acids. Esters are formed by enzymatic condensation of organic acids and alcohols. The current paper reviews the up-to-date knowledge in the pathways involving the synthesis of higher alcohols and esters by brewing yeasts. Fermentation parameters affecting yeast response during biosynthesis of these aromatic substances are also fully reviewed.


  • A New Approach on Brewer’s Spent Grains Treatment and Potential Use as Lignocellulosic Yeast Cells Carriers

    by Eduardo J. Pires, Héctor A. Ruiz, José A. Teixeira, António A. Vicente

    The major objective of this work is to improve the pretreatments of brewer’s spent grains (BSG) aiming at their use as a source for lignocellulosic yeast carriers (LCYC) production. Therefore, several pretreatments of BSG have been designed aiming at obtaining various yeast carriers, differing on their physicochemical composition. Cellulose, hemicellulose, lignin, fat, protein, and ash content were determined for crude BSG and the LCYCs. The long chain fatty acids profile for the crude BSG was also analyzed. Chemical treatments successfully produced several different LCYC based on BSG. The highest cellulose content in LCYC was achieved upon application of caustic (NaOH) treatment during 40 min. Either caustic or combined acid–caustic treatments predominately generated hydrophobic, negatively charged LCYC. The feasibility of using BSG for LCYC production is strengthened by the fact that added-value byproduct can be extracted before the chemical treatments are applied.