Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Ondřej Tichý has a total of 45 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Comment on egusphere-2026-5158

    by OndřEj Tichý, Václav Košík, Sabine Eckhardt, Nikolaos Evangeliou, Václav Šmídl

    In this paper, we present global atmospheric microplastic (MP) emissions calculated using remote deposition measurements, Lagrangian transport modelling and a pattern-restricted Bayesian inversion. Emissions were constrained using four source patterns representing agricultural activity, bare-soil resuspension, road dust, and oceanic resuspension. A Gibbs-sampling framework combined with an orthogonal transformation of the inverse problem was used to quantify posterior source budgets and their associated uncertainties. We estimate annual atmospheric MP emissions to be 1.46×1018 particles y−1, equivalent to 1001±781 Gg y−1 for particles between 5 and 250 μm. Oceanic emissions dominate the global budget, contributing 763 ± 611 Gg y−1, while agriculture, road dust, and bare-soil resuspension contribute 170 ± 125, 51 ± 31, and 17 ± 14 Gg y−1, respectively. Independent validation against global atmospheric MP observations gives a correlation coefficient of 0.57, with 50% of modelled values within one order of magnitude and only 12% as outliers. Restricting this comparison to only observations over the ocean, together with a sensitivity experiment in which marine emissions were strongly reduced, reveals that oceanic emissions are likely non-negligible. The measured size distribution further indicates a strong decoupling between particle number and mass, with the 10–25 μm fraction dominating particle-number emissions, but not emitted mass. Consequently, assumptions regarding particle size, density, and geometry affect global mass estimates significantly and explain the large spread observed in previously reported inventories. Our results provide an observation-constrained estimate of the global atmospheric MP budget, in which the accuracy of the emissions is supported by an independent comparison.

  • Open Access

    Reply on RC1

    by OndřEj Tichý, Václav Košík, Sabine Eckhardt, Nikolaos Evangeliou, Václav Šmídl

    In this paper, we present global atmospheric microplastic (MP) emissions calculated using remote deposition measurements, Lagrangian transport modelling and a pattern-restricted Bayesian inversion. Emissions were constrained using four source patterns representing agricultural activity, bare-soil resuspension, road dust, and oceanic resuspension. A Gibbs-sampling framework combined with an orthogonal transformation of the inverse problem was used to quantify posterior source budgets and their associated uncertainties. We estimate annual atmospheric MP emissions to be 1.46×1018 particles y−1, equivalent to 1001±781 Gg y−1 for particles between 5 and 250 μm. Oceanic emissions dominate the global budget, contributing 763 ± 611 Gg y−1, while agriculture, road dust, and bare-soil resuspension contribute 170 ± 125, 51 ± 31, and 17 ± 14 Gg y−1, respectively. Independent validation against global atmospheric MP observations gives a correlation coefficient of 0.57, with 50% of modelled values within one order of magnitude and only 12% as outliers. Restricting this comparison to only observations over the ocean, together with a sensitivity experiment in which marine emissions were strongly reduced, reveals that oceanic emissions are likely non-negligible. The measured size distribution further indicates a strong decoupling between particle number and mass, with the 10–25 μm fraction dominating particle-number emissions, but not emitted mass. Consequently, assumptions regarding particle size, density, and geometry affect global mass estimates significantly and explain the large spread observed in previously reported inventories. Our results provide an observation-constrained estimate of the global atmospheric MP budget, in which the accuracy of the emissions is supported by an independent comparison.

  • Open Access

    Comment on egusphere-2026-5158

    by OndřEj Tichý, Václav Košík, Sabine Eckhardt, Nikolaos Evangeliou, Václav Šmídl

    In this paper, we present global atmospheric microplastic (MP) emissions calculated using remote deposition measurements, Lagrangian transport modelling and a pattern-restricted Bayesian inversion. Emissions were constrained using four source patterns representing agricultural activity, bare-soil resuspension, road dust, and oceanic resuspension. A Gibbs-sampling framework combined with an orthogonal transformation of the inverse problem was used to quantify posterior source budgets and their associated uncertainties. We estimate annual atmospheric MP emissions to be 1.46×1018 particles y−1, equivalent to 1001±781 Gg y−1 for particles between 5 and 250 μm. Oceanic emissions dominate the global budget, contributing 763 ± 611 Gg y−1, while agriculture, road dust, and bare-soil resuspension contribute 170 ± 125, 51 ± 31, and 17 ± 14 Gg y−1, respectively. Independent validation against global atmospheric MP observations gives a correlation coefficient of 0.57, with 50% of modelled values within one order of magnitude and only 12% as outliers. Restricting this comparison to only observations over the ocean, together with a sensitivity experiment in which marine emissions were strongly reduced, reveals that oceanic emissions are likely non-negligible. The measured size distribution further indicates a strong decoupling between particle number and mass, with the 10–25 μm fraction dominating particle-number emissions, but not emitted mass. Consequently, assumptions regarding particle size, density, and geometry affect global mass estimates significantly and explain the large spread observed in previously reported inventories. Our results provide an observation-constrained estimate of the global atmospheric MP budget, in which the accuracy of the emissions is supported by an independent comparison.

  • Open Access

    Global continental and oceanic emissions of atmospheric microplastics inferred from pattern-restricted Bayesian inversion

    by OndřEj Tichý, Václav Košík, Sabine Eckhardt, Nikolaos Evangeliou, Václav Šmídl

    In this paper, we present global atmospheric microplastic (MP) emissions calculated using remote deposition measurements, Lagrangian transport modelling and a pattern-restricted Bayesian inversion. Emissions were constrained using four source patterns representing agricultural activity, bare-soil resuspension, road dust, and oceanic resuspension. A Gibbs-sampling framework combined with an orthogonal transformation of the inverseproblem was used to quantify posterior source budgets and their associated uncertainties. We estimate annual atmospheric MP emissions to be 1.46×1018 particles y−1, equivalent to 1001±781 Gg y−1 for particles between 5 and 250 μm. Oceanic emissions dominate the global budget, contributing 763 ± 611 Gg y−1, while agriculture, road dust, and bare-soil resuspension contribute 170 ± 125, 51 ± 31, and 17 ± 14 Gg y−1, respectively. Independent validation against global atmospheric MP observations gives a correlationcoefficient of 0.57, with 50% of modelled values within one order of magnitude and only 12% as outliers. Restricting this comparison to only observations over the ocean, together with a sensitivity experiment in which marine emissions were strongly reduced, reveals that oceanic emissions are likely non-negligible. The measured size distribution further indicates a strong decoupling between particle number and mass, with the 10–25 μm fraction dominating particle-number emissions, but not emitted mass. Consequently, assumptions regarding particle size, density, and geometry affect global mass estimates significantly and explain the large spread observed in previously reported inventories. Our results provide an observation-constrained estimate of the global atmospheric MP budget, in which the accuracy of the emissions is supported by an independent comparison.

  • Open Access

    Impact of background representation on Bayesian radioxenon source estimation using IMS measurements

    by OndřEj Tichý, Václav Šmídl, Jolanta Kuśmierczyk-Michulec, Christian Maurer, Anne Tipka

  • Open Access

    Nonlinear Atmospheric Inversion with Interpretable Bias Correction via Gaussian Process Prior

    by Antonie Brožová, Václav Šmídl, OndřEj Tichý, Nikolaos Evangeliou

    Accurate quantification of atmospheric pollutant emissions is essential for evaluating the consequences of environmental incidents. Inverse modelling of such releases commonly employs a linear framework based on a source–receptor sensitivity (SRS) matrix; however, this matrix can be substantially biased or may even fail to represent the true scale of the release. We introduce a method in which the SRS matrix is corrected jointly with the inversion, resulting in a nonlinear inverse problem. The SRS discrepancies are interpreted as small shifts of observation points, leading to a deformation of the sensitivity field. The shifts are regularized through a Gaussian process prior, which imposes smoothness and sparsity while allowing inference at unobserved locations. The resulting posterior predictions of the shift field offer a practical tool for hyperparameter selection: the inferred shifts can be visualized geographically and evaluated by domain experts. This leads to a Bayesian framework that integrates inversion, SRS correction, and a tuning strategy based on L-curve-type diagnostics combined with maps of the predicted shifts. It will be demonstrated on a selected real continental-scale scenario of an atmospheric release. This research has been supported by the Czech Science Foundation (grant no. GA24-10400S). FLEXPART model simulations are cross-atmospheric research infrastructure services provided by ATMO-ACCESS (EU grant agreement No 101008004). Nikolaos Evangeliou was funded by the same EU grant. The computations were performed on resources provided by Sigma2 - the National Infrastructure for High Performance Computing and Data Storage in Norway.

  • Open Access

    Bayesian Top-Down Pattern-Restricted Estimates of Atmospheric Microplastics Emissions using Gibbs sampler

    by Vaclav Smidl, Ioanna Evangelou, Václav Košík, Nikolaos Evangeliou, OndřEj Tichý

    We present a top-down estimate of atmospheric microplastics (MPs) emissions based on deposition measurements, optimized against an atmospheric transport model (ATM). The central challenge of this work is the severe ill-posedness of the spatial-temporal inverse problem, as emissions cannot be uniquely inferred from the limited number of available measurements. To regularize the inversion, we constrain emissions to follow physically motivated source patterns associated with global road dust, agricultural activities, bare soils, and ocean surface, while estimating their strengths. The relationship between emissions and measurements is established using source–receptor sensitivity (SRS) fields calculated using the ATM Flexpart 11. To estimate source strengths and rigorously quantify uncertainties, we employ a Bayesian inversion framework with a hierarchical prior model, whose parameters are inferred using Gibbs sampler. This approach avoids excessive tuning and enables a realistic representation of uncertainty arising from measurements, transport modeling, and emission assumptions. The inferred atmospheric MPs emissions ranges are broadly consistent with existing literature and measurements from different areas around the world, and the framework provides a transparent and robust quantification of uncertainty in global atmospheric MPs emissions. Acknowledgment:This research has been supported by the Czech Science Foundation (grant no. GA24-10400S). N.E. were funded by the Norwegian Research Council (NFR) project MAGIC (No.: 334086). FLEXPART model simulations are cross-atmospheric research infrastructure services provided by ATMO-ACCESS (EU grant agreement No 101008004). The computations were performed on resources provided by Sigma2 - the National Infrastructure for High Performance Computing and Data Storage in Norway.

  • Open Access

    Global Atmospheric Microplastics Emissions Estimated Using Constrained Bayesian Inverse Modeling

    by OndřEj Tichý, Michal Uliáš, Ioanna Evangelou, Václav Šmídl, Nikolaos Evangeliou

    We present an analysis of global atmospheric microplastics (MPs) concentration and deposition measurements using constrained Bayesian inverse modeling to estimate global MPs emissions. The proposed Bayesian framework explicitly accounts for unknown ratios between size fractions inherent to MPs measurements and incorporates prior emission information to stabilize the inversion. The coupling between observations and unknown emissions is established using the atmospheric transport model FLEXPART version 11 operated in backward mode for each measurement. Model parameters are inferred using a variational Bayes approach, resulting in an iterative estimation scheme that updates both model parameters and the effective spatial structure of the computational domain. This methodology reduces the need for manual intervention during the inversion process and limits potential bias in the results. The resulting global MPs emission estimates are evaluated against previously published ones. Acknowledgment:This research has been supported by the Czech Science Foundation (grant no. GA24-10400S). N.E. was funded by the Norwegian Research Council (NFR) project MAGIC (No.: 334086). FLEXPART model simulations are cross-atmospheric research infrastructure services provided by ATMO-ACCESS (EU grant agreement No 101008004). The computations were performed on resources provided by Sigma2 - the National Infrastructure for High Performance Computing and Data Storage in Norway.

  • Open Access

    Unchanged PM2.5 levels over Europe during COVID-19 were buffered by ammonia

    by Nikolaos Evangeliou, Ondřej Tichý, Marit Svendby Otervik, Sabine Eckhardt, Yves Balkanski, Didier A. Hauglustaine

    The coronavirus outbreak in 2020 had a devastating impact on human life, albeit a positive effect on the environment, reducing emissions of primary aerosols and trace gases and improving air quality. In this paper, we present inverse modelling estimates of ammonia emissions during the European lockdowns of 2020 based on satellite observations. Ammonia has a strong seasonal cycle and mainly originates from agriculture. We further show how changes in ammonia levels over Europe, in conjunction with decreases in traffic-related atmospheric constituents, modulated PM2.5. The key result of this study is a −9.8 % decrease in ammonia emissions in the period of 15 March–30 April 2020 (lockdown period) compared to the same period in 2016–2019, attributed to restrictions related to the global pandemic. We further calculate the delay in the evolution of the ammonia emissions in 2020 before, during, and after lockdowns, using a sophisticated comparison of the evolution of ammonia emissions during the same time periods for the reference years (2016–2019). Our analysis demonstrates a clear delay in the evolution of ammonia emissions of −77 kt, which was mainly observed in the countries that imposed the strictest travel, social, and working measures. Despite the general drop in emissions during the first half of 2020 and the delay in the evolution of the emissions during the lockdown period, satellite and ground-based observations showed that the European levels of ammonia increased. On one hand, this was due to the reductions in SO2 and NOx (precursors of the atmospheric acids with which ammonia reacts) that caused less binding and thus less chemical removal of ammonia (smaller loss – higher lifetime). On the other hand, the majority of the emissions persisted because ammonia mainly originates from agriculture, a primary production sector that was influenced very little by the lockdown restrictions. Despite the projected drop in various atmospheric aerosols and trace gases, PM2.5 levels stayed unchanged or even increased in Europe due to a number of reasons that were attributed to the complicated NH3-H2SO4-HNO3 system. Higher water vapour during the European lockdowns favoured more sulfate production from SO2 and OH (gas phase) or O3 (aqueous phase). Ammonia first reacted with sulfuric acid, also producing sulfate. Then, the continuously accumulating free ammonia reacted with nitric acid, shifting the equilibrium reaction towards particulate nitrate. In high-free-ammonia atmospheric conditions such as those in Europe during the 2020 lockdowns, a small reduction in NOx levels drives faster oxidation toward nitrate and slower deposition of total inorganic nitrate, causing high secondary PM2.5 levels.