Xiaoping Li
Xiaoping Li has a total of 37 co-authors. Here are the top co-authors by number of shared publications:
Dachao Li
8 shared publications- Honglong Chang
Ministry of Education Key Laboratory of Micro and Nano Systems for Aerospace, School of Mechanical Engineering, Northwestern Polytechnical University, China
6 shared publications Caiqin Zhao
3 shared publicationsDing Li
3 shared publicationsHonglong Chang
3 shared publicationsSongxue Chen
3 shared publications
Latest Publications
- 31 October 2026
- Published by Elsevier in Sensors and Actuators A: Physical
- Vol. 412
Evaporation kinetics of particle-laden droplets: comparison of pendant and sessile configurations
- 31 October 2026
- Published by Elsevier in Sensors and Actuators A: Physical
- Vol. 412
Evaporation kinetics of particle-laden droplets: comparison of pendant and sessile configurations
- 22 May 2026
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 164 (20)
Coarse-grained modeling of hydrodynamic behavior in DNA synthesis monomers
Efficient DNA synthesis is crucial for advancements in DNA data storage and synthetic biology, yet the micro-scale dynamics of nucleotide monomers in solution, particularly their diffusion, are not fully understood. Here, we present a novel four-bead coarse-grained (CG) model for DMT (dimethoxytrityl)-protected nucleotide monomers, meticulously validated via Boltzmann inversion. This CG approach dramatically enhances computational efficiency (≥20×) compared to all-atom models, thus enabling simulations on significantly larger spatiotemporal scales. Using the stochastic Eulerian Lagrangian method to accurately model fluid–solid interactions, our simulations in acetonitrile reveal that monomer diffusion significantly decreases with increasing concentration due to enhanced intermolecular interactions. Channel walls impose substantial, concentration-dependent restrictions, especially perpendicular to the wall. Crucially, adenine and thymine monomers diffuse slower than cytosine and guanine monomers, providing a kinetic basis for variations in mass transfer efficiency during DNA synthesis. This study offers a new perspective for profoundly understanding the micro-dynamics during DNA synthesis, providing a potential way for optimizing synthesis parameters and advancing DNA data storage technology.
- 22 May 2026
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 164 (20)
Coarse-grained modeling of hydrodynamic behavior in DNA synthesis monomers
Efficient DNA synthesis is crucial for advancements in DNA data storage and synthetic biology, yet the micro-scale dynamics of nucleotide monomers in solution, particularly their diffusion, are not fully understood. Here, we present a novel four-bead coarse-grained (CG) model for DMT (dimethoxytrityl)-protected nucleotide monomers, meticulously validated via Boltzmann inversion. This CG approach dramatically enhances computational efficiency (≥20×) compared to all-atom models, thus enabling simulations on significantly larger spatiotemporal scales. Using the stochastic Eulerian Lagrangian method to accurately model fluid–solid interactions, our simulations in acetonitrile reveal that monomer diffusion significantly decreases with increasing concentration due to enhanced intermolecular interactions. Channel walls impose substantial, concentration-dependent restrictions, especially perpendicular to the wall. Crucially, adenine and thymine monomers diffuse slower than cytosine and guanine monomers, providing a kinetic basis for variations in mass transfer efficiency during DNA synthesis. This study offers a new perspective for profoundly understanding the micro-dynamics during DNA synthesis, providing a potential way for optimizing synthesis parameters and advancing DNA data storage technology.
- 6 August 2025
- Published by Elsevier in Chemical Engineering Science
- Vol. 320
Microwell-arrayed chip with confined self-assembly of silica nanoparticles for high-capacity DNA synthesis
- 6 August 2025
- Published by Elsevier in Chemical Engineering Science
- Vol. 320
Microwell-arrayed chip with confined self-assembly of silica nanoparticles for high-capacity DNA synthesis
- 5 April 2024
- Published by Elsevier in Sensors and Actuators A: Physical
- Vol. 372
Wettability-patterned PDMS surface with high adhesion for multifunctional droplet transferring manipulation
- 5 April 2024
- Published by Elsevier in Sensors and Actuators A: Physical
- Vol. 372
Wettability-patterned PDMS surface with high adhesion for multifunctional droplet transferring manipulation
- 1 December 2023
- Published by American Chemical Society (ACS) in ACS Applied Polymer Materials
- Vol. 6 (1) , 350-361
Microzone Melting Method of Porous Reactor Fabrication with Structure-Controlled Microchannel Networks for High Yield In Situ DNA Synthesis
- 1 December 2023
- Published by American Chemical Society (ACS) in ACS Applied Polymer Materials
- Vol. 6 (1) , 350-361
Microzone Melting Method of Porous Reactor Fabrication with Structure-Controlled Microchannel Networks for High Yield In Situ DNA Synthesis
- 29 July 2023
- Published by Elsevier in Chemical Engineering Science
- Vol. 281
Three-phase contact line confined dense nanoparticle array for high-capacity DNA synthesis
- 29 July 2023
- Published by Elsevier in Chemical Engineering Science
- Vol. 281
Three-phase contact line confined dense nanoparticle array for high-capacity DNA synthesis
- Open Access
- 1 September 2022
- Published by AIP Publishing in Nanotechnology and Precision Engineering
- Vol. 5 (3) , 035002
Superhydrophilic–superhydrophobic patterned surfaces: From simplified fabrication to emerging applications
Superhydrophilic–superhydrophobic patterned surfaces constitute a branch of surface chemistry involving the two extreme states of superhydrophilicity and superhydrophobicity combined on the same surface in precise patterns. Such surfaces have many advantages, including controllable wettability, enrichment ability, accessibility, and the ability to manipulate and pattern water droplets, and they offer new functionalities and possibilities for a wide variety of emerging applications, such as microarrays, biomedical assays, microfluidics, and environmental protection. This review presents the basic theory, simplified fabrication, and emerging applications of superhydrophilic–superhydrophobic patterned surfaces. First, the fundamental theories of wettability that explain the spreading of a droplet on a solid surface are described. Then, the fabrication methods for preparing superhydrophilic–superhydrophobic patterned surfaces are introduced, and the emerging applications of such surfaces that are currently being explored are highlighted. Finally, the remaining challenges of constructing such surfaces and future applications that would benefit from their use are discussed.
- 1 September 2022
- Published by AIP Publishing in Nanotechnology and Precision Engineering
- Vol. 5 (3) , 035002
Open AccessSuperhydrophilic–superhydrophobic patterned surfaces: From simplified fabrication to emerging applications
Superhydrophilic–superhydrophobic patterned surfaces constitute a branch of surface chemistry involving the two extreme states of superhydrophilicity and superhydrophobicity combined on the same surface in precise patterns. Such surfaces have many advantages, including controllable wettability, enrichment ability, accessibility, and the ability to manipulate and pattern water droplets, and they offer new functionalities and possibilities for a wide variety of emerging applications, such as microarrays, biomedical assays, microfluidics, and environmental protection. This review presents the basic theory, simplified fabrication, and emerging applications of superhydrophilic–superhydrophobic patterned surfaces. First, the fundamental theories of wettability that explain the spreading of a droplet on a solid surface are described. Then, the fabrication methods for preparing superhydrophilic–superhydrophobic patterned surfaces are introduced, and the emerging applications of such surfaces that are currently being explored are highlighted. Finally, the remaining challenges of constructing such surfaces and future applications that would benefit from their use are discussed.
- 14 April 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 334-337
Enhanced DNA Binding Detection on Dense Particle Packed Microreactor Array
High throughput detection of multiple DNA targets has become a widely used technique in molecular diagnostics. However, due to the limited surface in dense microreactor array microchip, it is impossible to attach a large number of oligonucleotide probes to a single cell, which therefore limits the detection sensitivity. This paper presents a high sensitivity DNA detecting chip by taken particle-packed microarray as the solid carries for de novo DNA synthesis. Microwell are wet etched on silicon chip, and the surface for binding sites are significantly increased by packing with silica microspheres. Meanwhile, high-density single strand DNA (ssDNA) molecules are de novo synthesized on the functionalized amino group on the surface instead of loosely immobilizing with exogenous primers. Synergistically, the fluorescence signal is enhanced after further hybridizing with fluorescent-labeled complementary probes. By packing a 700 μm microwell with 2.5 μm silica particles, the effective synthesis area was increased about two orders of magnitude. High intensity and uniform fluorescent signal from packed microwell was confirmed both by inverted fluorescence microscopy and laser confocal fluorescence microscopy. The proposed packed array can be used as sensitive biosensors for detecting biological DNA, RNA and other antibodies.
- 14 April 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 334-337
Enhanced DNA Binding Detection on Dense Particle Packed Microreactor Array
High throughput detection of multiple DNA targets has become a widely used technique in molecular diagnostics. However, due to the limited surface in dense microreactor array microchip, it is impossible to attach a large number of oligonucleotide probes to a single cell, which therefore limits the detection sensitivity. This paper presents a high sensitivity DNA detecting chip by taken particle-packed microarray as the solid carries for de novo DNA synthesis. Microwell are wet etched on silicon chip, and the surface for binding sites are significantly increased by packing with silica microspheres. Meanwhile, high-density single strand DNA (ssDNA) molecules are de novo synthesized on the functionalized amino group on the surface instead of loosely immobilizing with exogenous primers. Synergistically, the fluorescence signal is enhanced after further hybridizing with fluorescent-labeled complementary probes. By packing a 700 μm microwell with 2.5 μm silica particles, the effective synthesis area was increased about two orders of magnitude. High intensity and uniform fluorescent signal from packed microwell was confirmed both by inverted fluorescence microscopy and laser confocal fluorescence microscopy. The proposed packed array can be used as sensitive biosensors for detecting biological DNA, RNA and other antibodies.
- 14 April 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 157-161
Facile Wettability-Patterned Flexible Surface for Multifunctional Microdroplet Array Manipulation
Droplet array guided by wettability patterns has attracted extensive interest due to its applications ranging from multiplex bioassay to cell screening. This paper reports a facile fabrication method for a wettability patterned flexible surface to effectively generate and manipulate droplet array. Elastomeric PDMS is prepared followed by soft lithography, chemical vapor deposition, and plasma treatment. Various patterns, i.e., dots, lines, and letters, are successfully demonstrated with kinds of masked plasma exposure. Due to the fully wetted Wenzel state, the patterned surface can stick the water droplet even when bending and twisting. Droplets can also be transported directly from one to the other to perform mixing and sensing, and a proof-of-concept visualized colorimetric detection of starch was successfully demonstrated. It is expected that such facile wettability patterned flexible surfaces are promising in smart droplet-based assays.
- 14 April 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 157-161
Facile Wettability-Patterned Flexible Surface for Multifunctional Microdroplet Array Manipulation
Droplet array guided by wettability patterns has attracted extensive interest due to its applications ranging from multiplex bioassay to cell screening. This paper reports a facile fabrication method for a wettability patterned flexible surface to effectively generate and manipulate droplet array. Elastomeric PDMS is prepared followed by soft lithography, chemical vapor deposition, and plasma treatment. Various patterns, i.e., dots, lines, and letters, are successfully demonstrated with kinds of masked plasma exposure. Due to the fully wetted Wenzel state, the patterned surface can stick the water droplet even when bending and twisting. Droplets can also be transported directly from one to the other to perform mixing and sensing, and a proof-of-concept visualized colorimetric detection of starch was successfully demonstrated. It is expected that such facile wettability patterned flexible surfaces are promising in smart droplet-based assays.
- 9 January 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 373-376
Microreactor Array Based On Three-Phase Contact Line Controlling and Sintering For De Novo Oligonucleotide Synthesis
This paper presents a low-cost and high-efficiency packed microreactor array with enhanced reaction surface area for high-capacity de novo oligonucleotide synthesis on-chip. Silicon wafer was pre-treated with 1H,1H,2H,2H-perfluorodecyltrimethoxysilane (PFOS) to obtain a hydrophobic surface, thus a higher receding contact angle. By inkjet printing, SiO 2 nanoparticles droplets array were printed on the hydrophobic surface. Driven by the controlled sliding of three-phase contact line (TCL) during solvent evaporation, nanoparticles were closely aggregated to form a densely packed dots array, and the higher receding contact angle, the higher height-to-diameter ratio of dots would be achieved. After sintering, nanoparticles can be physically bonded and thus inherently keep the array configuration after hundreds of cycles of solvent treatment, which provides a favorable support for oligonucleotide synthesis. Experiments have validated that the PFOS-based microreactor array can achieve higher and more uniform fluorescence intensity, indicating that a higher density of oligonucleotide has been synthesized on the posts.
- 9 January 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 373-376
Microreactor Array Based On Three-Phase Contact Line Controlling and Sintering For De Novo Oligonucleotide Synthesis
This paper presents a low-cost and high-efficiency packed microreactor array with enhanced reaction surface area for high-capacity de novo oligonucleotide synthesis on-chip. Silicon wafer was pre-treated with 1H,1H,2H,2H-perfluorodecyltrimethoxysilane (PFOS) to obtain a hydrophobic surface, thus a higher receding contact angle. By inkjet printing, SiO 2 nanoparticles droplets array were printed on the hydrophobic surface. Driven by the controlled sliding of three-phase contact line (TCL) during solvent evaporation, nanoparticles were closely aggregated to form a densely packed dots array, and the higher receding contact angle, the higher height-to-diameter ratio of dots would be achieved. After sintering, nanoparticles can be physically bonded and thus inherently keep the array configuration after hundreds of cycles of solvent treatment, which provides a favorable support for oligonucleotide synthesis. Experiments have validated that the PFOS-based microreactor array can achieve higher and more uniform fluorescence intensity, indicating that a higher density of oligonucleotide has been synthesized on the posts.