Jurgen Lange
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Jurgen Lange has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
- Argimiro Resende Secchi
Chemical Engineering Program, COPPE, Universidade Federal do Rio de Janeiro, Cidade Universitária, Rio de Janeiro 21941-972, Brazil
4 shared publications - Frederico Wanderley Tavares
Engenharia de Processos Químicos e Bioquímicos (EPQB), Escola de Química, Universidade Federal do Rio de Janeiro, Rio de Janeiro, Brazil
4 shared publications - Ángel Emilio Lozano
Institute of Polymer Science and Technology, ICTP, CSIC, C/Juan de la Cierva, 3, Madrid 28006, Spain
3 shared publications Iuri Soter Viana Segtovich
Programa de Engenharia Química/COPPE Universidade Federal do Rio de Janeiro Cidade Universitária Rio de Janeiro CP 21941‐914 Brazil
2 shared publicationsJ. Rieumont
Faculty of Chemistry, Havana University, Havana, Cuba
2 shared publications- Natalia Davidenko
Department of Materials Science and Metallurgy, University of Cambridge, 27 Charles Babbage Road, Cambridge, CB3 0FS, UK.
2 shared publications
Latest Publications
- Open Access
- 2 September 2025
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 41 (36) , 24593-24618
Molecular Dynamics Study of the Coalescence of Water Droplets with Anionic Asphaltene Molecules under a DC Electric Field
During the extraction of crude oil, water-in-oil (W/O) emulsions are mostly formed at a high pH, where water droplets can be stabilized by anionic asphaltene molecules on the surface. The study of driving forces in the electro-coalescence of these emulsions is fundamental to the efficient design of the oil dehydration process. We studied by molecular dynamics the electro-coalescence of two asphaltene-laden droplets suspended in n-hexane as a model oil. The findings indicate that a low number of anionic asphaltenes per water droplet and a moderate electric field strength (E) allow optimal droplet-droplet coalescence conditions to be reached, which is favored by high electrical polarization of water droplets. Under these conditions, it has been found that the diffusion and polarity of water molecules are enhanced, favoring the formation of the liquid bridge between colliding droplets and reducing the droplet-droplet coalescence time. On the contrary, with a high number of asphaltenes per droplet and E, the droplet-droplet coalescence is hindered and/or retarded due to the steric effect of asphaltene aggregation at the interface between water droplets. Here, the high ionic conductivity (σ) of water droplets and low interfacial tension (γ) before the formation of the liquid bridge led to the formation of a water chain (WC) between electrodes, an undesirable phenomenon impairing the dehydration efficiency in the coalescer. This study demonstrates that W/O emulsions with anionic asphaltenes under conditions of relatively low σ and somewhat high γ at moderate E (around the critical E) promote complete droplet-droplet coalescence and prevent WC formation.
- 2 September 2025
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 41 (36) , 24593-24618
Open AccessMolecular Dynamics Study of the Coalescence of Water Droplets with Anionic Asphaltene Molecules under a DC Electric Field
During the extraction of crude oil, water-in-oil (W/O) emulsions are mostly formed at a high pH, where water droplets can be stabilized by anionic asphaltene molecules on the surface. The study of driving forces in the electro-coalescence of these emulsions is fundamental to the efficient design of the oil dehydration process. We studied by molecular dynamics the electro-coalescence of two asphaltene-laden droplets suspended in n-hexane as a model oil. The findings indicate that a low number of anionic asphaltenes per water droplet and a moderate electric field strength (E) allow optimal droplet-droplet coalescence conditions to be reached, which is favored by high electrical polarization of water droplets. Under these conditions, it has been found that the diffusion and polarity of water molecules are enhanced, favoring the formation of the liquid bridge between colliding droplets and reducing the droplet-droplet coalescence time. On the contrary, with a high number of asphaltenes per droplet and E, the droplet-droplet coalescence is hindered and/or retarded due to the steric effect of asphaltene aggregation at the interface between water droplets. Here, the high ionic conductivity (σ) of water droplets and low interfacial tension (γ) before the formation of the liquid bridge led to the formation of a water chain (WC) between electrodes, an undesirable phenomenon impairing the dehydration efficiency in the coalescer. This study demonstrates that W/O emulsions with anionic asphaltenes under conditions of relatively low σ and somewhat high γ at moderate E (around the critical E) promote complete droplet-droplet coalescence and prevent WC formation.
- Open Access
- 22 February 2024
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 26 (12) , 9234-9252
A density functional theory study on interactions in water-bridged dimeric complexes of lignin
The hydrogen bonds and π-stacking interactions cling together syringyl and guaiacyl subunits, promoting the formation of stable water-bridged dimeric complexes in S–G and S-lignins.
- 22 February 2024
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 26 (12) , 9234-9252
Open AccessA density functional theory study on interactions in water-bridged dimeric complexes of lignin
The hydrogen bonds and π-stacking interactions cling together syringyl and guaiacyl subunits, promoting the formation of stable water-bridged dimeric complexes in S–G and S-lignins.
- 16 December 2022
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 11 (1) , 238-255
Molecular Dynamics Study of Thermophysical and Mechanical Properties in Hydrated Lignin with Compositions Close to Softwood
- 16 December 2022
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 11 (1) , 238-255
Molecular Dynamics Study of Thermophysical and Mechanical Properties in Hydrated Lignin with Compositions Close to Softwood
- 26 March 2020
- Published by Wiley in Macromolecular Theory and Simulations
- Vol. 29 (4)
Thermophysical Properties of Amorphous‐Paracrystalline Celluloses by Molecular Dynamics
For the engineering and process design of chemical and pharmaceutical plants, the knowledge of thermophysical properties is essential. Here, glass transition temperature (Tg), curves of heat capacity (Cp), isotropic thermal expansion (∝p), and isothermal compressibility (βT) are computed for amorphous/paracrystalline (Am‐Par) structures of cellulose over a wide range of temperature (380–680 K) using molecular dynamics with the CHARMM36 (C36) force field (FF). The fluctuation method under the NPT ensemble is used to calculate Cp, ∝p, and βT, whereas Tg is computed by monitoring specific volume versus temperature. Here, the fluctuation method is used with a quantum mechanical correction term for the calculation of Cp. Results of Cp, ∝p, and βT values at 298 K using extrapolation from these curves are also obtained. The thermophysical properties values from the simulations are compared with experimental data for cellulose with different degree of crystallinity and with those obtained by prominent FFs suggested for cellulose, such as GLYCAM06 and COMPASS. The findings reveal that ∝p, βT, and Tg are somewhat better reproduced than Cp with C36 over the studied temperature range. From this study, it is inferred that, for accurate modeling of heat capacity of pure Am‐Par celluloses with large fragments of glucose, the C36 FF needs re‐parameterization.
- 26 March 2020
- Published by Wiley in Macromolecular Theory and Simulations
- Vol. 29 (4)
Thermophysical Properties of Amorphous‐Paracrystalline Celluloses by Molecular Dynamics
For the engineering and process design of chemical and pharmaceutical plants, the knowledge of thermophysical properties is essential. Here, glass transition temperature (Tg), curves of heat capacity (Cp), isotropic thermal expansion (∝p), and isothermal compressibility (βT) are computed for amorphous/paracrystalline (Am‐Par) structures of cellulose over a wide range of temperature (380–680 K) using molecular dynamics with the CHARMM36 (C36) force field (FF). The fluctuation method under the NPT ensemble is used to calculate Cp, ∝p, and βT, whereas Tg is computed by monitoring specific volume versus temperature. Here, the fluctuation method is used with a quantum mechanical correction term for the calculation of Cp. Results of Cp, ∝p, and βT values at 298 K using extrapolation from these curves are also obtained. The thermophysical properties values from the simulations are compared with experimental data for cellulose with different degree of crystallinity and with those obtained by prominent FFs suggested for cellulose, such as GLYCAM06 and COMPASS. The findings reveal that ∝p, βT, and Tg are somewhat better reproduced than Cp with C36 over the studied temperature range. From this study, it is inferred that, for accurate modeling of heat capacity of pure Am‐Par celluloses with large fragments of glucose, the C36 FF needs re‐parameterization.
- 1 July 2019
- Published by Elsevier in Fluid Phase Equilibria
- Vol. 491, 56-76
Amorphous paracrystalline structures from native crystalline cellulose: A molecular dynamics protocol
- 1 July 2019
- Published by Elsevier in Fluid Phase Equilibria
- Vol. 491, 56-76
Amorphous paracrystalline structures from native crystalline cellulose: A molecular dynamics protocol
- 22 September 2015
- Published by Wiley in Macromolecular Theory and Simulations
- Vol. 25 (1) , 45-62
Molecular Dynamic Simulation of Oxaliplatin Diffusion in Poly(lactic acid-co-glycolic acid). Part A: Parameterization and Validation of the Force-Field CVFF
- 22 September 2015
- Published by Wiley in Macromolecular Theory and Simulations
- Vol. 25 (1) , 45-62
Molecular Dynamic Simulation of Oxaliplatin Diffusion in Poly(lactic acid-co-glycolic acid). Part A: Parameterization and Validation of the Force-Field CVFF
- Open Access
- 11 May 2012
- Published by Wiley in Macromolecular Theory and Simulations
- Vol. 21 (4)
Macromol. Theory Simul. 4/2012
- 11 May 2012
- Published by Wiley in Macromolecular Theory and Simulations
- Vol. 21 (4)
Open AccessMacromol. Theory Simul. 4/2012
- 19 August 2011
- Published by Wiley in Macromolecular Theory and Simulations
- Vol. 20 (9) , 850-866
Reactivity Study of Elementary Steps in the Polymerization Mechanism of Acrylfuranic Compounds by Frontier Molecular Orbital Theory
A reactivity study of the most important elementary steps (propagation, intermolecular degradative transfer, and re‐initiation) in free‐radical polymerization of acrylfuranic systems, furfuryl acrylate (FA), and furfuryl methacrylate (FM), using the frontier molecular orbital theory is described. A qualitative explanation of reactivity trends of these steps for both systems is given based on absolute values of the SOMO/HOMO gap. The small difference between values of kp for FA and FM compared to that found for MA and MMA (${{k_{{\rm p}}^{{\rm (FA)}} } \mathord{\left/ {\vphantom {{k_{{\rm p}}^{{\rm (FA)}} } {k_{{\rm p}}^{{\rm (FM)}} }}} \right. } {k_{{\rm p}}^{{\rm (FM)}} }}< {{k_{{\rm p}}^{{\rm (MA)}} } \mathord{\left/ {\vphantom {{k_{{\rm p}}^{{\rm (MA)}} } {k_{{\rm p}}^{{\rm (MMA)}} }}} \right. } {k_{{\rm p}}^{{\rm (MMA)}} }}$ ) is justified semi‐quantitatively by applying a formulation for the change of energy in the transition state using second‐order perturbation theory. magnified image
- 19 August 2011
- Published by Wiley in Macromolecular Theory and Simulations
- Vol. 20 (9) , 850-866
Reactivity Study of Elementary Steps in the Polymerization Mechanism of Acrylfuranic Compounds by Frontier Molecular Orbital Theory
A reactivity study of the most important elementary steps (propagation, intermolecular degradative transfer, and re‐initiation) in free‐radical polymerization of acrylfuranic systems, furfuryl acrylate (FA), and furfuryl methacrylate (FM), using the frontier molecular orbital theory is described. A qualitative explanation of reactivity trends of these steps for both systems is given based on absolute values of the SOMO/HOMO gap. The small difference between values of kp for FA and FM compared to that found for MA and MMA (${{k_{{\rm p}}^{{\rm (FA)}} } \mathord{\left/ {\vphantom {{k_{{\rm p}}^{{\rm (FA)}} } {k_{{\rm p}}^{{\rm (FM)}} }}} \right. } {k_{{\rm p}}^{{\rm (FM)}} }}< {{k_{{\rm p}}^{{\rm (MA)}} } \mathord{\left/ {\vphantom {{k_{{\rm p}}^{{\rm (MA)}} } {k_{{\rm p}}^{{\rm (MMA)}} }}} \right. } {k_{{\rm p}}^{{\rm (MMA)}} }}$ ) is justified semi‐quantitatively by applying a formulation for the change of energy in the transition state using second‐order perturbation theory. magnified image