MBMohammed Moustafa Bouzaki

Mohammed Moustafa Bouzaki

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Mohammed Moustafa Bouzaki has a total of 12 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    A new improved of incorporating photovoltaic energy into the production of green hydrogen

    by Yacine Benchenina, Abderrahim Zemmit, Mohammed Moustafa Bouzaki, Khaled Belhouchet

    The integration of renewable energies, particularly photovoltaic energy, into green hydrogen production presents a highly promising prospect in the energy sector. Nonetheless, these energy sources face challenges due to their inherent instability and susceptibility to various atmospheric factors...


  • Improvement of parameters in a-Si(p)/c-Si(n)/a-Si(n) solar cells

    by Mohammed Moustafa Bouzaki, Michel Aillerie, Sidi Ould Saad Hamady, Meriem Chadel, Boumediene Benyoucef

    We analyzed and discussed the influence of thickness and doping concentration of the different layers in a-Si(p)/c-Si(n)/a-Si(n) photovoltaic (PV) cells with the aim of increasing its efficiency while decreasing its global cost. Compared to the efficiency of a standard marketed PV cell, elaborated with a ZnO transparent conductive oxide (TCO) layer but without Back Surface Field (BSF) layer, an optimization of the thickness and dopant concentration of both the emitter a-Si(p) and absorber c-Si(n) layers will gain about 3% in the global efficiency of the cell. The results also reveal that with introduction of the third layer, i.e. the BSF layer, the efficiency always achieves values above 20% and all other parameters of the cell, such as the open-circuit voltage, the short-circuit current and the fill-factor, are strongly affected by the thickness and dopant concentration of the layers. The values of all parameters are given and discussed in the paper. Thereby, the simulation results give for an optimized a-Si(p)/c-Si(n)/a-Si(n) PV cells the possibility to decrease the thickness of the absorber layer down to 50 μm which is lower than in the state-of-the-art. This structure of the cell achieves suitable properties for high efficiency, cost-effectiveness and reliable heterojunction (HJ) solar cell applications.


  • Simulation of the outdoor energy efficiency of an autonomous solar kit based on meteorological data for a site in Central Europa

    by Mohammed Moustafa Bouzaki, Meriem Chadel, Boumediene Benyoucef, Pierre Petit, Michel Aillerie

    This contribution analyzes the energy provided by a solar kit dedicated to autonomous usage and installed in Central Europa (Longitude 6.10°; Latitude 49.21° and Altitude 160 m) by using the simulation software PVSYST. We focused the analysis on the effect of temperature and solar irradiation on the I-V characteristic of a commercial PV panel. We also consider in this study the influence of charging and discharging the battery on the generator efficiency. Meteorological data are integrated into the simulation software. As expected, the solar kit provides an energy varying all along the year with a minimum in December. In the proposed approach, we consider this minimum as the lowest acceptable energy level to satisfy the use. Thus for the other months, a lost in the available renewable energy exists if no storage system is associated.


  • Improvement of the photovoltaic conversion efficiency using nanostructuring in intermediate-band photovoltaic solar cells

    by H. Mammar, A. Benmansour, M. Bouzaki

    Nanostructuring is one of the most developed technologies that are able to improve considerably the photovoltaic conversion for low cost. This approach removes certain limitations of current technology; the photons that have low energy and do not participate in the photovoltaic conversion. Also, the photons that have a high energy that sell their excess energy in phonons' form. This work focuses on intermediate band solar cells introduced by material with a high-energy gap, an intermediate energy level, by quantum dots or quantum wells of some nanometers. This study attempts to show the great interest of this approach by calculating first, the efficiency limits of solar cell Shockley and interests in the intermediate-band photovoltaic solar cells approach by studying the parameters affecting their performances as well as the choice of materials and energy level of the nanostructure. All this, is achieved through the simulation software Matlab. The mathematical model developing stretches of photon emission by sun until the photovoltaic conversion in the semiconductor material.