Manjari Bagchi

Pulsars can be either isolated or binary (or even in triple) systems. Observational features of pulsars are used to probe various aspects of fundamental physics, including emission mechanism, gravitational physics, etc. Theoretical models of various phenomena need different coordinate frames. Often different physical processes affect each other and we need to use multiple coordinate frames and relations between those. This short review presents an extensive set of coordinate frames and relations between those.

We present 18 pulsar discoveries from the AO327 pulsar survey, along with their timing solutions and those for an additional 31 AO327-discovered pulsars. Timing solutions were constructed using observations from a follow-up timing campaign taken during the period of 2013–2019 using the Arecibo Observatory’s 327 MHz receiver. Aside from PSR J0916+0658, an isolated pulsar that shows evidence for partial recycling, the remaining discoveries are nonrecycled pulsars. We present a brief census of emission features for all pulsars with the following standouts. PSR J1942+0142 is found to exhibit the very rare phenomenon of subpulse bi-drifting, and PSR J0225+1727 has an interpulse. We also report distance estimates using the NE2001, YMW16, and NE2025 Galactic electron density models and identify at least 10 sources where one or more models underestimate the maximum Galactic line-of-sight dispersion measure. We compare our discoveries with those of the GBNCC survey, finding that off the Galactic plane, the majority of failures arise from YMW16, while in the Galactic plane, NE2025 shows a marginal degradation of performance relative to NE2001.

In the wideband paradigm of pulsar timing, the time of arrival of a pulsar pulse is measured simultaneously with the corresponding dispersion measure from a frequency-resolved integrated pulse profile. We present a new method for performing wideband measurements that rigorously accounts for measurement noise. We demonstrate this method using observations of PSR J2124−3358 made as part of the Indian Pulsar Timing Array experiment using the upgraded Giant Metre-wave Radio Telescope, and show that our method produces more realistic measurement uncertainty estimates compared to the existing wideband measurement method.

Matter inside neutron stars is compressed to densities several times greater than nuclear saturation density, while maintaining low temperatures and large asymmetries between neutrons and protons. Neutron stars, therefore, provide a unique laboratory for testing physics in environments that cannot be recreated on Earth. To uncover the highly uncertain nature of cold, ultra-dense matter, discovering and monitoring pulsars is essential, and SKA will play a crucial role in this endeavour. In this paper, we will present the current state-of-the-art in dense matter physics and dense matter superfluidity, and discuss recent advances in measuring global neutron star properties (masses, moments of inertia, and maximum rotation frequencies) as well as non-global observables (pulsar glitches and free precession). We will specifically highlight how radio observations of isolated neutron stars and those in binaries—such as those performed with SKA in the near future—inform our understanding of ultra-dense physics and address in detail how SKA’s unprecedented sensitivity, large-scale survey and sub-arraying capabilities will enable novel dense matter constraints. We will also address the potential impact of dark matter and modified gravity models on these constraints and emphasise the role of synergies between SKA and other facilities, specifically X-ray telescopes and next-generation gravitational wave observatories.

The known population of non-accreting neutron stars is ever growing and currently consists of more than 3500 sources. Pulsar surveys with the SKAO telescopes will greatly increase the known population, adding radio pulsars to every subgroup in the radio-loud neutron star family. These discoveries will not only add to the current understanding of neutron star physics by increasing the sample of sources that can be studied, but will undoubtedly also uncover previously unknown types of sources that will challenge our theories of a wide range of physical phenomena. A broad variety of scientific studies will be made possible by a significantly increased known population of neutron stars, unravelling questions such as: How do isolated pulsars evolve with time; What is the connection between magnetars, high B-field pulsars, and the newly discovered long-period pulsars; How is a pulsar’s spin-down related to its radio emission; What is the nuclear equation of state? Increasing the known numbers of pulsars in binary or triple systems may enable both larger numbers and higher precision tests of gravitational theories and general relativity, as well as probing the neutron star mass distribution. The excellent sensitivity of the SKAO telescopes combined with the wide field of view, large numbers of simultaneous tied-array beams that will be searched in real time, wide range of observing frequencies, and the ability to form multiple sub-arrays will make the SKAO an excellent facility to undertake a wide range of neutron star research. In this paper, we give an overview of different types of neutron stars and discuss how the SKAO telescopes will aid in our understanding of the neutron star population.

Because of their extreme stellar densities, globular clusters are highly efficient factories of X-ray binaries and radio pulsars: per unit of stellar mass, they contain about 1000 times more of these exotic objects. Thus far, 345 radio pulsars have been found in globular clusters. These can be used as precision probes of the structure, gas content, magnetic field, and dynamic history of their host clusters; some of them are also highly interesting in their own right because they probe exotic stellar evolution scenarios as well as the physics of dense matter, accretion, and gravity; one of them (PSR J0514-4002E) might even be the first pulsar - black hole system known. Deep searches with SKA-MID and SKA-LOW will only require one to a few tied-array beams, and can be done during early commissioning of the telescope, before an all-sky pulsar survey using hundreds to thousands of tied-array beams is feasible. Even a conservative approach predicts new discoveries only with the core of SKA-MID AA , and the full AA and eventually AA4 is expected to increase the number of discoveries even more, leading to more than doubling the current known population. This offers a great opportunity for early SKAO pulsar science, even before all the collecting area is in place. On the other hand, a more optimistic prediction calls for a 4-5 times growth of the population, leading to a total of about 1700 pulsars to be detectable with SKA-MID AA4 configuration in all Galactic GCs visible by SKA telescopes. Thus, a dedicated search for pulsars in globular clusters will fully exploit the best possible natural laboratories to study many branches of physics and astrophysics, including properties of dense matter, stellar evolution, and the dynamical history of the Galactic globular cluster systems.

Because of their extreme stellar densities, globular clusters are highly efficient factories of X-ray binaries and radio pulsars: per unit of stellar mass, they contain about 1000 times more of these exotic objects. Thus far, 345 radio pulsars have been found in globular clusters. These can be used as precision probes of the structure, gas content, magnetic field, and dynamic history of their host clusters; some of them are also highly interesting in their own right because they probe exotic stellar evolution scenarios as well as the physics of dense matter, accretion, and gravity; one of them (PSR~J0514$-$4002E) might even be the first pulsar - black hole system known. Deep searches with SKA-MID and SKA-LOW will only require one to a few tied-array beams, and can be done during early commissioning of the telescope, before an all-sky pulsar survey using hundreds to thousands of tied-array beams is feasible. Even a conservative approach predicts new discoveries only with the core of SKA-MID AA*, and the full AA* and eventually AA4 is expected to increase the number of discoveries even more, leading to more than doubling the current known population. This offers a great opportunity for early SKAO pulsar science, even before all the collecting area is in place. On the other hand, a more optimistic prediction calls for a 4-5 times growth of the population, leading to a total of about 1700 pulsars to be detectable with SKA-MID AA4 configuration in all Galactic GCs visible by SKA telescopes. Thus, a dedicated search for pulsars in globular clusters will fully exploit the best possible natural laboratories to study many branches of physics and astrophysics, including properties of dense matter, stellar evolution, and the dynamical history of the Galactic globular cluster systems.

Context. Low radio frequency data are highly valuable for enhancing the sensitivity of pulsar timing arrays (PTAs) to propagation effects, such as dispersion measure (DM) variations. These low-frequency observations are particularly sensitive to DM fluctuations and can therefore significantly improve noise characterization in PTA datasets, which is essential for detecting the stochastic gravitational wave background (GWB). Aims. For this work we incorporated for the first time low-frequency observations from LOFAR (100 − 200 MHz) and NenuFAR (30 − 90 MHz) into a PTA context by combining them with the most recent data release from the European and Indian PTAs (in particular, with the subsample labeled DR2new+ , which includes only data from the new backends). This new combined dataset, labeled DR2low , consists of 12 pulsars observed over a time span of ∼11 years, with radio frequencies spanning the range 30 − 2500 MHz. The expanded frequency coverage of DR2low enables us to update and refine the noise models of DR2new+ , and this is crucial in order to increase the PTA sensitivity when searching for the stochastic gravitational wave background, which is the primary goal of PTA observations. This work is a milestone in the integration of low-frequency data into the upcoming third data release of the International PTA, which is posed to achieve the 5 σ detection of the GWB. Methods. We used the pulsar timing software packages L IBSTEMPO and E NTERPRISE to perform a noise analysis of DR2low . At first, we applied a standard noise model including red noise (RN) and time-variable dispersion measure (DMv) as power laws, with Fourier components up to 30 and 100 frequencies, respectively. Next, we performed a fully Bayesian model selection to identify the favored noise model for each pulsar and compute the Bayes factors across all combinations of RN, DMv, and a noise term with a chromatic index of 4 (CN ₄ ). Finally, we carried out a detailed analysis on the choice of the chromatic index for CN ₄ and the contribution of the solar wind. Results. The comparison between DR2low and DR2new+ using the standard noise model highlights the benefits of including low-frequency data. In particular, the additional frequency coverage improves the constraints on the DM variations and helps disentangle the DM and RN noise components in most pulsars. Through a Bayesian model selection, we found that the RN is required in the final model for 10 out of 12 pulsars, compared to only 5 in the DR2new+ dataset. The improved sensitivity to plasma effects provided by DR2low also favors the identification of significant CN ₄ in eight pulsars, while none showed such evidence in DR2new+ . The chromatic index of this process is consistent with four of the five pulsars, while two (PSRs J0030+0451 and J1022+1001) show significant deviations from such a value. We attribute this discrepancy to unmodeled contributions from the solar wind, especially because of the high DM sensitivity of LOFAR and NenuFAR and the high observing cadence provided by these datasets near solar conjunction. A dedicated analysis confirms that the current solar wind model fails to fully capture the observed delay, and residual power is absorbed into the DM component of the model.