Morteza Fathi
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Morteza Fathi has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Omid Jahanian
Faculty of Mechanical Engineering, Babol Noshirvani University of Technology, Babol, Iran
4 shared publications M. David Checkel
2 shared publicationsR. Khoshbakhti Saray
2 shared publications- Bahram Jafari
Faculty of Engineering Modern Technologies, Amol University of Special Modern Technologies (AUSMT), Amol, Iran
1 shared publication Bart Somers
1 shared publication- Davood Domairry Ganji
Department of Mechanical Engineering, Babol Noshirvani University of Technology, Babol, Iran
1 shared publication
Latest Publications
- Open Access
- 1 January 2026
- Published by International Digital Organization for Scientific Information (IDOSI) in International Journal of Engineering
- Vol. 39 (9) , 2326-2335
A Computational Fluid Dynamics Based Analysis of Intake Air Humidity Influence on Emission Characteristics in a Marine Diesel Engine
Shipboard diesel engines operate under unique marine conditions including high humidity, salt-laden air, variable ambient pressure/temperature, and confined engine-room ventilation, which can significantly affect combustion and emissions. This study investigates the effect of varying intake air humidity on combustion and emissions in a marine diesel engine using three-dimensional computational fluid dynamics (CFD) simulations (1D AVL-Boost and 3D AVL-FIRE with ECFM-3Z combustion chemistry). Intake relative humidity levels of 25, 50, and 75% are imposed while keeping operating conditions and combustion chamber geometry fixed at their baseline values. The simulation model is first validated against experimental data, then used to compare in-cylinder pressure, temperature, heat-release rate, equivalence ratio, indicated work, and pollutant outputs under different humidity conditions. Results show that increased intake humidity slightly raises the hydrogen content of the charge, leading to a marginally higher peak in-cylinder pressure. Heat-release rate and equivalence ratio distributions are largely unaffected by humidity. Importantly, increased intake humidity significantly reduces NOx emissions. Soot formation, however, changes only slightly, with no clear trend (any minor increase from higher local equivalence and temperature is offset by reduced oxygen). Overall, adding humidity reduces NOx by altering oxygen availability and flame temperature, while having only minor impacts on engine performance and soot.
- 1 January 2026
- Published by International Digital Organization for Scientific Information (IDOSI) in International Journal of Engineering
- Vol. 39 (9) , 2326-2335
Open AccessA Computational Fluid Dynamics Based Analysis of Intake Air Humidity Influence on Emission Characteristics in a Marine Diesel Engine
Shipboard diesel engines operate under unique marine conditions including high humidity, salt-laden air, variable ambient pressure/temperature, and confined engine-room ventilation, which can significantly affect combustion and emissions. This study investigates the effect of varying intake air humidity on combustion and emissions in a marine diesel engine using three-dimensional computational fluid dynamics (CFD) simulations (1D AVL-Boost and 3D AVL-FIRE with ECFM-3Z combustion chemistry). Intake relative humidity levels of 25, 50, and 75% are imposed while keeping operating conditions and combustion chamber geometry fixed at their baseline values. The simulation model is first validated against experimental data, then used to compare in-cylinder pressure, temperature, heat-release rate, equivalence ratio, indicated work, and pollutant outputs under different humidity conditions. Results show that increased intake humidity slightly raises the hydrogen content of the charge, leading to a marginally higher peak in-cylinder pressure. Heat-release rate and equivalence ratio distributions are largely unaffected by humidity. Importantly, increased intake humidity significantly reduces NOx emissions. Soot formation, however, changes only slightly, with no clear trend (any minor increase from higher local equivalence and temperature is offset by reduced oxygen). Overall, adding humidity reduces NOx by altering oxygen availability and flame temperature, while having only minor impacts on engine performance and soot.
- 2 July 2019
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 139 (4) , 2447-2454
Intake charge temperature effect on performance characteristics of direct injection low-temperature combustion engines
- 2 July 2019
- Published by Springer Nature in Journal of Thermal Analysis and Calorimetry
- Vol. 139 (4) , 2447-2454
Intake charge temperature effect on performance characteristics of direct injection low-temperature combustion engines
- 1 October 2017
- Published by Elsevier in Applied Thermal Engineering
- Vol. 125, 1181-1190
Stand-alone single- and multi-zone modeling of direct injection homogeneous charge compression ignition (DI-HCCI) combustion engines
- 1 October 2017
- Published by Elsevier in Applied Thermal Engineering
- Vol. 125, 1181-1190
Stand-alone single- and multi-zone modeling of direct injection homogeneous charge compression ignition (DI-HCCI) combustion engines
- 1 December 2011
- Published by Elsevier in Applied Energy
- Vol. 88 (12) , 4719-4724
The influence of Exhaust Gas Recirculation (EGR) on combustion and emissions of n-heptane/natural gas fueled Homogeneous Charge Compression Ignition (HCCI) engines
- 1 December 2011
- Published by Elsevier in Applied Energy
- Vol. 88 (12) , 4719-4724
The influence of Exhaust Gas Recirculation (EGR) on combustion and emissions of n-heptane/natural gas fueled Homogeneous Charge Compression Ignition (HCCI) engines
- 11 September 2011
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
EGR and Intake Charge Temperature Effects on Dual-Fuel HCCI Combustion and Emissions Characteristics
Homogeneous charge compression ignition (HCCI) combustion is a hybrid concept of compression and spark ignition combustions. It is a promised solution to environmental and fuel economy concerns for internal combustion engines. In this mode of combustion, a lean premixed charge combusts simultaneously from multiple sites. Utilizing very lean mixtures, and the lack of any obvious flame propagation, considerably reduces in-cylinder NOx formation. In order to make the HCCI engine a feasible alternative to the SI and CI engines, several items must be elucidated. Control of the combustion timing is one of the most important of these items to be resolved. Combustion timing should be controlled in order that heat is released at the best time in the engine cycle. In this study, a Waukesha CFR single cylinder research engine with variable EGR was used to be operated in HCCI combustion mode fueled by natural gas and n-heptane. The main goal of the experiments was to make an attempt to control the combustion timing and duration by studying different approaches such as varying EGR rates, intake charge temperature and compression ratio. The main objective of the study is the investigation of how EGR rates and intake charge temperature can affect the HCCI combustion. In order to achieve this goal, a modified first law apparent heat release model, developed by the authors, was utilized. Utilizing this model, guarantee obtaining a well-behaved and accurate apparent heat release trend and magnitude in HCCI combustion engines. Also, the influence of EGR and intake charge temperature on emissions was discussed. Results indicate that applying EGR has profound effect on combustion phasing, leading to a retarded SOC and prolonged burn duration. It is favorable regarding fuel economy, too. The influence on emission characteristics is desirable with respect to NOx formation and unfavorable in the case of CO and HC emissions in a dual fueled HCCI combustion engine. Intake charge temperature has profound effects on in-cylinder charge pressure and temperature. It alters heat release rate magnitude and phasing. This parameter also affects indicated power and fuel consumption. Measured emissions have also shown changes due to variations of this initial condition.
- 11 September 2011
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
EGR and Intake Charge Temperature Effects on Dual-Fuel HCCI Combustion and Emissions Characteristics
Homogeneous charge compression ignition (HCCI) combustion is a hybrid concept of compression and spark ignition combustions. It is a promised solution to environmental and fuel economy concerns for internal combustion engines. In this mode of combustion, a lean premixed charge combusts simultaneously from multiple sites. Utilizing very lean mixtures, and the lack of any obvious flame propagation, considerably reduces in-cylinder NOx formation. In order to make the HCCI engine a feasible alternative to the SI and CI engines, several items must be elucidated. Control of the combustion timing is one of the most important of these items to be resolved. Combustion timing should be controlled in order that heat is released at the best time in the engine cycle. In this study, a Waukesha CFR single cylinder research engine with variable EGR was used to be operated in HCCI combustion mode fueled by natural gas and n-heptane. The main goal of the experiments was to make an attempt to control the combustion timing and duration by studying different approaches such as varying EGR rates, intake charge temperature and compression ratio. The main objective of the study is the investigation of how EGR rates and intake charge temperature can affect the HCCI combustion. In order to achieve this goal, a modified first law apparent heat release model, developed by the authors, was utilized. Utilizing this model, guarantee obtaining a well-behaved and accurate apparent heat release trend and magnitude in HCCI combustion engines. Also, the influence of EGR and intake charge temperature on emissions was discussed. Results indicate that applying EGR has profound effect on combustion phasing, leading to a retarded SOC and prolonged burn duration. It is favorable regarding fuel economy, too. The influence on emission characteristics is desirable with respect to NOx formation and unfavorable in the case of CO and HC emissions in a dual fueled HCCI combustion engine. Intake charge temperature has profound effects on in-cylinder charge pressure and temperature. It alters heat release rate magnitude and phasing. This parameter also affects indicated power and fuel consumption. Measured emissions have also shown changes due to variations of this initial condition.