RARaymond J. Abraham

Raymond J. Abraham

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Raymond J. Abraham has a total of 41 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    The Use of MM/QM Calculations of 13C Chemical Shifts in the Analysis of Edaravone Tautomers

    by Raymond J. Abraham, M. Ashley Cooper, Amin Aghamohammadi, Kamyar Afarinkia, Xiangli Liu

    The13C NMR chemical shifts of the three Edaravone tautomers (keto, enol, and amine) were calculated using a combined molecular mechanics (Pcmod 9.1/MMFF94) and ab initio (GIAO (B3LYP/DFT, 6–31 + G(d)) model. This method gave such good agreement with experiment that the assignment of the complex spectrum of Edaravone in solution, which is a mixture of the three tautomers could be made. This has been attempted previously by various methods with diverse results. In CDCl3solution, the observed spectra show only one form, the keto tautomer, and this is also the case with acetonitrile solvent. Acetone solvent reacts with Edavarone in the NMR tube. In the other solvents studied, methanol, pyridine, DMSO, trifluoroethanol (TFE), there is a mixture of the tautomers with populations which vary with the solvent. The application of the shift predictions allows the assignment of the13C spectra to the three tautomers and from this the proportions of the tautomers in the solution. The results at times differ significantly from previous studies, and this is discussed.


  • Descriptors for Edaravone; studies on its structure, and prediction of properties

    by Xiangli Liu, Amin Aghamohammadi, Kamyar Afarinkia, Raymond J. Abraham, William E. Acree, Michael H. Abraham


  • The use of MM/QM calculations of 13C chemical shifts in the conformational analysis of some monosaccharides and sucrose

    by Raymond J. Abraham, M. Ashley Cooper, Matthew Reid

    The 13C NMR chemical shifts of some common pyranose monosaccharides in D2O solution were predicted using a combined molecular mechanics (Pcmod 9.1/MMFF94) and ab initio (GIAO (B3LYP/DFT, 6-31G(d))) model.


  • The use of MM/QM calculations of 13C and 15N chemical shifts in the conformational analysis of alkyl substituted anilines

    by Raymond J. Abraham, Marcus Ashley Cooper

    The calculation of the 13C and 15N NMR chemical shifts by a combined molecular mechanics (Pcmodel 9.1/MMFF94) and ab initio (GIAO (B3LYP/DFT, 6‐31 + G(d)) procedure is used to investigate the conformations of a variety of alkyl substituted anilines. The 13C shifts are obtained from the GIAO isotropic shielding (Ciso) with separate references for sp3 and sp2 carbons (δc = δref − Ciso). The 15N shifts are obtained similarly from the GIAO isotropic shielding (Niso) with reference to the 15N chemical shift of aniline. Comparison of the observed and calculated shifts provides information on the molecular conformations. Aniline and the 2,6‐dialkylanilines exist with a rapidly inverting symmetric pyramidal nitrogen atom. The 2‐alkylanilines have similar conformations with the NH2 group tilted away from the 2‐alkyl substituent. The N,N‐dialkylanilines show more varied conformations. N,N‐dimethylaniline has a similar structure to aniline, but N‐ethyl, N‐methylaniline, N,N‐diethylaniline, and N,N‐diisopropylaniline are conformationally mobile with two rapidly interconverting conformers. In contrast, the anilines substituted at C2 and the nitrogen atom exist as one conformer where the steric interaction between the C2 substituent and the N substituent determines the conformation. In 2‐methyl‐N‐methylaniline, the nitrogen atom is pyramidal as usual with the N‐methyl opposite to the 2‐methyl, but in 2‐methyl‐N,N‐dimethyl aniline, the NMe2 group is now almost orthogonal to the phenyl plane. This is also the case with 2‐methyl‐N,N‐diethylaniline and 2,6‐diisopropyl‐N,N‐dimethylaniline. The comparison of the observed and calculated 15N chemical shifts confirms the above findings, in particular the pyramidal conformation of aniline and the above observations with respect to the conformations of the N,N‐dialkylanilines.


  • The use of chemical shift calculations in the conformational analysis of substituted benzenes

    by Raymond J. Abraham, M. Ashley Cooper

    MM/QM calculations of 13 C chemical shifts can determine the conformations and electron densities in organic compounds.


  • A convenient and accurate method for predicting13C chemical shifts in organic molecules

    by Raymond J. Abraham, M. Ashley Cooper

    13C chemical shifts of organic compounds including 5α-androstan-17-one are predicted by the MMFF94 semi-empirical and GIAO B3LYP/6-31G(d)ab initiomethods.


  • A theoretical and NMR lanthanide‐induced shift (LIS) investigation of the conformations of lactams.

    by Raymond J. Abraham, Marco Filippi, Giovanni Petrillo, Paola Piaggio, Chiara Vladiskovic, Fernando Sancassan

    Molecular mechanics (MM) with MMFF94 and MMX force fields and ab initio (RHF/6‐31G*,RHF/6‐311G**, and B3LYP/6‐311G**) calculations are used with lanthanide‐induced shift (LIS) to investigate the conformations of N‐methyl‐2‐pyrrolidone 1, N‐methyl‐2‐piperidone 2, ε‐caprolactam 3, γ‐valerolactam (1,5‐dimethyl‐2‐pyrrolidone) 4, 2‐azetidinone 5, 4‐methyl azetidinone 6, 4‐phenyl azetidinone 7, and N‐methyl‐4‐phenyl azetidinone 8. The Yb(fod)3 paramagnetic induced shifts of all the 1H and 13C nuclei are measured and the corresponding diamagnetic complexation shifts obtained by the addition of Lu(fod)3. The complexation model (two‐, three‐, or four‐site) used depends on the relative rates of the processes involved. The amide inversion is the same order as that of the 5‐ and 6‐membered lactam rings and much faster than the lanthanide complexation and the inversion of the 7‐membered ring.Both MM and ab initio calculations give an envelope conformation for 1 with C‐4 out of the ring plane in agreement with the LIS analysis. For the piperidone ring of 2, the half‐chair is calculated as the most stable form. The LIS analysis confirms this but cannot exclude a small amount (1.5%). In 4‐phenyl azetidinone 7, the MMFF94 geometry with 60% of the axial conformer gave Rcryst 1.2% but the other geometries Rcryst >1.5%. In contrast the N‐methyl‐4‐phenyl‐2‐azetidinone 8 gave good agreement for all the geometries. The butterfly conformation gave Rcryst 1.1% for 80% of the axial conformer and the planar geometries Rcryst 0.98%. The LIS results confirm the ab initio and MM optimised geometries, but the conformer energies at times differ from the calculated values. They also differ considerably from the corresponding values for the lactones studied previously, and possible reasons for this are discussed.


  • A molecular mechanics and ab initio prediction of the 1H chemical shifts of pinanes

    by Raymond J. Abraham, M. Ashley Cooper

    Molecular mechanics calculations plus the application of a refined Karplus equation gave the conformations of 19 pinanes. These range from a Y‐shaped geometry in the apopinene and α‐pinene series to a pseudo chair conformation in β‐pinene, nopinone and verbanone, a flattened chair in pinocarvone and the pinocarveols and a distorted Y shape for iso‐verbanone.These structures were then used as input to predict the 1H chemical shifts of these compounds by semi‐empirical (1H‐NMR spectra (HSPEC)) and ab initio gauge‐invariant atomic orbital (GIAO) calculations, the latter at the B3LYP hybrid density functional theory level using 6‐31++G** basis set. The two methods gave generally good agreement with the 184 observed shifts with root mean square (RMS) errors 0.07 ppm (HSPEC) and 0.10 ppm (GIAO), but the GIAO calculations gave several significant (>0.25 ppm) errors. One was for the H3 proton in apopinenone and other α,β unsaturated ketones; the others occurred for protons in close proximity to hydroxyl groups. To provide more information, smaller analogues of known geometry and chemical shifts were subject to the same analysis. In cyclopentenone, the Gaussian geometry gave good agreement with the observed shifts, but the MMFF94, MMX and MM3 geometries all gave errors for different protons. These results show clearly that the molecular geometries of the α,β unsaturated ketones are responsible for the errors. The errors for the alcohols were examined using ethanol as model and were shown to be due to the different possible conformations of the OH group. Similar GIAO calculations on substituted methanes gave good agreement for the methyl compounds but poor agreement for di and tri halosubstituted methanes.The aforementioned method of molecular mechanics plus GIAO calculations is shown to be a very useful tool for the investigation of molecular geometries and conformations. However, multihalogen compounds may require different basis sets for accurate calculations. Copyright © 2017 John Wiley & Sons, Ltd.


  • A re-investigation of 4 J FF and 5 J FF nuclear spin–spin couplings in substituted benzenes, a novel conformational tool

    by Raymond J. Abraham, M. Ashley Cooper

    A theoretical analysis of the 4JFF and 5JFF couplings in fluorobenzenes separates the σ and π components of the substituent coefficients. The π bond mechanism is dominant but the σ bond mechanism must be included to give accurate values of the couplings. For monosubstituted difluorobenzenes the 4JFF and 5JFF couplings can be predicted from the calculated π densities by linear equations. The use of additive substituent effects allows the prediction of the meta4JFF couplings for multisubstituted compounds. The π dependence of the 4JFF coupling in 2,6-difluorobenzenes provides a novel and simple method of determining the torsional angle of the C1 substituent and the benzene ring for non-symmetrical functional groups (acetyl, carboxymethyl, dimethylamino, amide, nitro etc.). This could be used to determine the geometries of such molecules in biological systems. The π dependence of the 4JFF coupling is also of importance in the charged species of 2,6-difluoroanilinium (4JFF 2.1 Hz) and 2,6-difluoro-N,N,N-trimethylanilinium (4JFF 0.0 Hz) due to the very different π electron densities.