VNVagesh D. Narasimhamurthy

Vagesh D. Narasimhamurthy

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Vagesh D. Narasimhamurthy has a total of 107 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • 45 Years of Modelling Gas Explosions with the PDR Concept—Current Status and Future Prospects

    by Helene Hisken, Anand Zambare, Anish A. Pophale, Vagesh D. Narasimhamurthy, Kees van Wingerden, Trygve Skjold, Bjørn J. Arntzen, Melodia Lucas

  • Open Access

    Laminar–turbulent patterns in plane Couette flow: influence of three-dimensional roughness

    by S. Gokul, Vagesh D. Narasimhamurthy

    This direct numerical simulation study analyses the transition-to-turbulence in plane Couette flow (PCF) with three-dimensional (3-D) roughness. Square ribs of height $k=0.2h$ (where $h$ is the half-channel height) and a streamwise pitch separation of $\lambda =10k$ , classified as k -type roughness, are mounted on the stationary wall. This configuration features alternating rough and smooth zones in the spanwise direction and is referred to as 3-D k -type roughness. We compare the behaviour of 3-D k -type roughness in the transitional regime with that of two-dimensional (2-D) k -type roughness (Gokul & Narasimhamurthy 2024 J. Fluid Mech. vol. 1000, p. A40). The route-to-transition in 3-D k -type roughness confirms the formation of laminar–turbulent patterns, which exist in the transitional Reynolds number range $\textit{Re} \in [325, 350]$ . This range interestingly overlaps with those for smooth PCF ( $\textit{Re} \in [325, 400]$ ) and 2-D k -type roughness ( $\textit{Re} \in [300, 325]$ ), thereby indicating that 3-D k -type roughness amalgamates the characteristics of both the rough and smooth zones. In striking contrast to the 2-D k -type roughness, the laminar–turbulent bands in the 3-D k -type configuration are of non-uniform bandwidth. The 3-D k -type roughness surprisingly introduces continuous competition among bands of opposite orientations, a characteristic unique in this case. Due to this competition, the large-scale flow associated with the oblique bands is never fully aligned with the diagonal direction. The smooth zones in the 3-D k -type roughness exhibit complex interactions, evident from oscillatory velocity signals and multiple high-energy peaks in the frequency spectra, which likely contribute to the competing patterns with opposite orientations.

  • Asymmetric spectral and vorticity dynamics in rotating channel turbulence

    by Arshdeep Singh, Helge I. Andersson, Vagesh D. Narasimhamurthy

    Direct numerical simulation data of velocity- and vorticity-fluctuations are used to study the Coriolis-induced modulation of spectral-scales, spatiotemporal correlations, and vorticity-dynamics in turbulent channels. Although rotation-induced asymmetry is known, its scale-resolved manifestation and link between spectral-dynamics and local vortex-topology remain unclear. Energy spectra show a spectral shift toward larger scales and increased energy on the anti-cyclonic side, consistent with the emergence of large-scale structures, while energy is suppressed on the cyclonic side. Dissipation becomes asymmetric, but the characteristic small scales of dissipation are nearly unaffected by rotation. Vortex stretching is amplified and shifts toward larger streamwise scales on the anti-cyclonic side, indicating the formation of elongated structures, while the spanwise scales remain nearly unchanged, reflecting anisotropic modulation. Enstrophy production is enhanced and exhibits spectral similarity with viscous dissipation on the anti-cyclonic side, reflecting active small-scale turbulence, while the cyclonic side shows weakened small-scale turbulent activity, consistent with re-laminarization. Spatial two-point correlations reveal large-scale, laminar-like structures with intermittent wall-normal fluctuations on the cyclonic side. Temporal autocorrelations reveal enhanced coherence on the anti-cyclonic side and slowly evolving streamwise structures on the cyclonic side. Quadrant analysis reveals a sustained bursting cycle on the anti-cyclonic side and suppressed turbulence on the cyclonic side. Enstrophy production exhibits intermittent bursts on the anti-cyclonic side, marking regions of strong vorticity amplification.


  • Toward fundamental improvements to engineering models for gas explosions in complex geometries by utilizing experimental results in conjunction with highly resolved numerical simulations

    by Somasani Mahesh, Vagesh D. Narasimhamurthy, Trygve Skjold

    Engineering models for gas explosions chiefly rely on porosity/distributed resistance (PDR) technique, where volume and area blockage created by obstacles are primarily taken into account for modeling. However, it is anticipated that other geometric parameters like the number of obstacles and their orientation or location play a crucial role. Toward this end, a computational fluid dynamics (CFD) analysis of vented methane‐air explosions is performed using large eddy simulations (LES). Four different configurations are considered, where the obstacles' volume and area blockage are kept constant, while only altering the obstacles' orientation and position relative to each other. The resulting effects on flame position, flame speed, flame acceleration, and generated overpressure are analyzed. The results show that the configuration that exhibits the highest flame wrinkling and flame surface area among all the configurations leads to the maximum peak overpressure. Although the obstacle volume is the same in all cases, it was striking to observe that a simple reorientation or repositioning of the obstacles can mitigate or aggravate the explosion overpressures by 35% or 253%, respectively. This study highlights that obstacle orientation and pattern are as important as volume blockage and should be considered for PDR modeling.


  • An Eulerian-Lagrangian parallel algorithm for simulation of particle-laden turbulent flows

    by Harshal P. Mahamure, Deekshith I. Poojary, Vagesh D. Narasimhamurthy, Lihao Zhao


  • Laminar separation bubble in a spinning ball aerodynamics

    by Navaneeth Krishnan, Vagesh D. Narasimhamurthy, Mahesh V. Panchagnula

    We explore the flow past a spinning smooth ball at Re=1×105 for the spin factor range 0≤α≤1 using large eddy simulation (LES). When a spinning ball passes through a uniform flow field, an asymmetrical boundary-layer separation occurs along the retreating and advancing sides of the ball. This causes a deflection in the trajectory of the ball with a positive lift force, known as the Magnus effect. A counter-intuitive phenomenon was found at the critical Re regime and specific α due to the creation of a laminar separation bubble (LSB) on the advancing side, which reverses the direction of the lift, i.e., an inverse Magnus effect. The size of the LSB decreases as it moves upstream and finally disappears as α increases. The disappearance of LSB at a particular α is the starting point of the second Magnus effect, where the laminar boundary layer directly transitions to a turbulent condition. The LSB is associated with weak vortex shedding and high shedding frequency. The relaminarized zone is created on the retreating side while the laminar boundary layer shifts to a turbulent condition on the advancing side. Particular attention has been given to report mean force coefficients, Strouhal number of K–H instability of spinning cases, Strouhal number ratio, mean surface pressure coefficients, and wake dynamics.


  • Impact of planar shear inflow on wake behind a normal flat plate

    by Deekshith I. Poojary, Vagesh D. Narasimhamurthy

    This study employs a direct numerical simulation to analyze the effects of planar shear inflow on the flow characteristics around a normal flat plate. The influence of shear is examined by comparing it with a uniform inflow condition. Based on the centerline inflow velocity and plate height, the Reynolds number was taken as 170 and the non-dimensional shear rate as 0.1. Flow visualization shows that the wake from uniform inflow is experiencing a temporal beating phenomenon that switches between coherent and incoherent states, whereas the planar shear drives the flow toward a fully incoherent state. A comparison with the uniform inflow case shows that planar shear induces weaker vortex shedding, a lower drag coefficient, and a corresponding increase in the recirculation length. Furthermore, a phase-time analysis using the Hilbert transform revealed that the vortices are shed in-phase in the uniform inflow case, whereas they are mostly out-of-phase in the planar shear case. Reduction of coherent vortices and enhancement of incoherent fluctuations are evident in the planar shear case, thereby affecting the mean velocity and Reynolds stress symmetry and a modest increase in the magnitude of turbulent components.


  • Open Access

    Transition to turbulence in rough plane Couette flow

    by S. Gokul, Vagesh D. Narasimhamurthy

    This DNS study considers transition to turbulence in plane Couette flow (pCf) with a rough stationary wall and a smooth moving wall. The roughness elements are square ribs of height $k=0.2h$ (where $h$ is the half-channel height). Two different pitch separations, $\lambda =2k$ and $10k$ , are considered, i.e. d-type and k-type roughness, respectively. The transition in both rough pCf cases takes place through a stage of alternate laminar–turbulent bands aligned in an oblique fashion. However, roughness causes a shift in the transitional Reynolds number ( $Re$ ) range. In the k-type roughness, stable bands are observed in the range $Re \in [300, 325]$ , which is a downwards shift from the transitional $Re$ range for the smooth pCf ( $Re \in [325,400]$ ). The d-type roughness, on the other hand, surprisingly shifts the transitional $Re$ range upwards to $Re \in [350,425]$ . This peculiar behaviour is associated with the ability of the ribs to shed and regenerate vorticity. Large-scale components extracted using a filtering process relate to the transition bands and flow parallel to the oblique laminar–turbulent boundaries. Counter-rotating vortices are present in the turbulent regions of the flow field, which exist in tandem with the high- and low-velocity streaks. Another interesting observation is the secondary Reynolds shear stresses, $-\overline {v^{\prime }u^{\prime }}$ and $-\overline {w^{\prime }v^{\prime }}$ , which are non-zero in the transitional regime, in contrast to the turbulent regime where they are negligible.