Kimiyoshi Ichikawa
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Kimiyoshi Ichikawa has a total of 89 co-authors. Here are the top co-authors by number of shared publications:
- Norio Tokuda
Nanomaterials Research Institute, Kanazawa University 3 , Kanazawa, Ishikawa 920-1192
9 shared publications Satoshi Yamasaki
8 shared publications- Taro Yoshikawa
Innovation and Business Development Headquarters, Daicel Corporation 3 , 1239, Shinzaike, Aboshi-ku, Himeji, Hyogo 671-1283, Japan
7 shared publications - Kan Hayashi6 shared publications
Atsuhito Sawabe
5 shared publications- Tsubasa Matsumoto
Nanomaterials Research Institute, Kanazawa University 3 , Kanazawa, Ishikawa 920-1192
5 shared publications
Latest Publications
- Open Access
- 2 July 2026
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 1092
Radiation tolerance of a diamond radiation detector for space use
- 2 July 2026
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
- Vol. 1092
Open AccessRadiation tolerance of a diamond radiation detector for space use
- Open Access
- 9 April 2026
- Published by Elsevier in SSRN Electronic Journal
Selective etching of atomically flat diamond (111) surfaces using H2+N2 plasma etching
Atomically flat (111) diamond surfaces were fabricated via lateral homoepitaxial growth and employed as a platform for H₂ + N₂ plasma etching. While lateral etching is dominant in conventional hydrogen plasma etching, the introduction of nitrogen into the hydrogen plasma promotes vertical etching. The etching rate was approximately 1 nm/min, and the root-mean-square (RMS) roughness (Sq) of the etched trench bottom was less than 0.25 nm. Furthermore, this technique enables the formation of anisotropically etched trenches. In addition, even when a metal mask was employed for selective etching, the atomically flat surface was preserved after mask removal. Recently, we reported the development of an innovative buried-growth process for NV centers in homoepitaxial diamond films based on microwave plasma chemical vapor deposition (MPCVD), which integrates selective etching and growth within a single process. In that study, single-crystal diamond substrates patterned with Au/Ti metal masks were selectively etched using an H₂ + N₂ plasma generated by MPCVD. However, those studies relied on commercially available mechanically polished HPHT diamond substrates, leaving critical issues unresolved, including ambiguous etching mechanisms and surface roughening at both the etched bottom and masked diamond surfaces. By employing atomically flat diamond surfaces in the present study, these issues were clarified, enabling a deeper understanding of the etching mechanism and precise surface control. This etching technique significantly expands the design flexibility of diamond devices by utilizing atomically flat interfaces and is expected to contribute to further advances in device fabrication and optimization in diamond power electronics and quantum technology.
- 9 April 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessSelective etching of atomically flat diamond (111) surfaces using H2+N2 plasma etching
Atomically flat (111) diamond surfaces were fabricated via lateral homoepitaxial growth and employed as a platform for H₂ + N₂ plasma etching. While lateral etching is dominant in conventional hydrogen plasma etching, the introduction of nitrogen into the hydrogen plasma promotes vertical etching. The etching rate was approximately 1 nm/min, and the root-mean-square (RMS) roughness (Sq) of the etched trench bottom was less than 0.25 nm. Furthermore, this technique enables the formation of anisotropically etched trenches. In addition, even when a metal mask was employed for selective etching, the atomically flat surface was preserved after mask removal. Recently, we reported the development of an innovative buried-growth process for NV centers in homoepitaxial diamond films based on microwave plasma chemical vapor deposition (MPCVD), which integrates selective etching and growth within a single process. In that study, single-crystal diamond substrates patterned with Au/Ti metal masks were selectively etched using an H₂ + N₂ plasma generated by MPCVD. However, those studies relied on commercially available mechanically polished HPHT diamond substrates, leaving critical issues unresolved, including ambiguous etching mechanisms and surface roughening at both the etched bottom and masked diamond surfaces. By employing atomically flat diamond surfaces in the present study, these issues were clarified, enabling a deeper understanding of the etching mechanism and precise surface control. This etching technique significantly expands the design flexibility of diamond devices by utilizing atomically flat interfaces and is expected to contribute to further advances in device fabrication and optimization in diamond power electronics and quantum technology.
- Open Access
- 16 March 2025
- Published by Elsevier in Electrochimica Acta
- Vol. 525
Enhanced performance of diamond electrodes with heavily N-doped surface nanolayers grown by CVD for high reduction current density
- 16 March 2025
- Published by Elsevier in Electrochimica Acta
- Vol. 525
Open AccessEnhanced performance of diamond electrodes with heavily N-doped surface nanolayers grown by CVD for high reduction current density
- Open Access
Fabrication of inversion channel diamond MOSFET with atomically step-free Al2O3/diamond interface
- Open Access
- 14 August 2024
- Published by American Chemical Society (ACS) in Accounts of Materials Research
- Vol. 5 (10) , 1181-1193
Diamond Homoepitaxial Growth Technology toward Wafer Fabrication, Atomically Controlled Surfaces, and Low Resistivity
- 14 August 2024
- Published by American Chemical Society (ACS) in Accounts of Materials Research
- Vol. 5 (10) , 1181-1193
Open AccessDiamond Homoepitaxial Growth Technology toward Wafer Fabrication, Atomically Controlled Surfaces, and Low Resistivity
- Open Access
- 22 June 2024
- Published by Elsevier in Applied Surface Science
- Vol. 669
Formation of low-dimensional nanopit structures on atomically flat surfaces of diamond (111) by nickel nanoparticles
- 22 June 2024
- Published by Elsevier in Applied Surface Science
- Vol. 669
Open AccessFormation of low-dimensional nanopit structures on atomically flat surfaces of diamond (111) by nickel nanoparticles
- Open Access
CO2 reduction by visible-light-induced photoemission from heavily N-doped diamond nano-layer