Luis Francisco Villalobos

Membrane-based liquid separations that selectively extract valuable ionic species from water can enhance resource circularity across industries. However, commercial membranes lack the selectivity required to target specific ions. Here we design crown-ether-based polymeric membranes for ion–ion separations using principles inspired by biological ion channels. Ultrathin membranes (~6 nm) are fabricated via interfacial polymerization of crosslinked 18-crown-6 units. The membranes preferentially sorb and transport potassium, which forms the most stable complexes with the crown ether motifs. Sorption experiments show strong potassium preference in mixed-salt environments, where competitive interactions increase selectivity. Transport measurements demonstrate selective permeation of potassium over competing monovalent and divalent cations, with selectivities of ~4 over cesium and lithium. The combination of ultrathin architecture, high crosslinking degree, and high binding-site density enables this behavior. This work establishes interfacial polymerization as a strategy to incorporate macrocycles into membranes for precise ion separation.

Zero-dimensional pores spanning only a few angstroms in size in two-dimensional materials such as graphene are some of the most promising systems for designing ion-ion selective membranes. However, the key challenge in the field is that so far a crack-free macroscopic graphene membrane for ion-ion separation has not been realized. Further, methods to tune the pores in the Å-regime to achieve a large ion-ion selectivity from the graphene pore have not been realized. Herein, we report an Å-scale pore size tuning tool for single layer graphene, which incorporates a high density of ion-ion selective pores between 3.5 and 8.5 Å while minimizing the nonselective pores above 10 Å. These pores impose a strong confinement for ions, which results in extremely high selectivity from centimeter-scale porous graphene between monovalent and bivalent ions and near complete blockage of ions with the hydration diameter, D_H, greater than 9.0 Å. The ion diffusion study reveals the presence of an energy barrier corresponding to partial dehydration of ions with the barrier increasing with D_H. We observe a reversal of K⁺/Li⁺ selectivity at elevated temperature and attribute this to the relative size of the dehydrated ions. These results underscore the promise of porous two-dimensional materials for solute-solute separation when Å-scale pores can be incorporated in a precise manner.

Zeolitic imidazolate frameworks (ZIFs) are a subset of metal–organic frameworks with more than 200 characterized crystalline and amorphous networks made of divalent transition metal centres (for example, Zn²⁺ and Co²⁺) linked by imidazolate linkers. ZIF thin films have been intensively pursued, motivated by the desire to prepare membranes for selective gas and liquid separations. To achieve membranes with high throughput, as in ångström-scale biological channels with nanometre-scale path lengths, ZIF films with the minimum possible thickness—down to just one unit cell—are highly desired. However, the state-of-the-art methods yield membranes where ZIF films have thickness exceeding 50 nm. Here we report a crystallization method from ultradilute precursor mixtures, which exploits registry with the underlying crystalline substrate, yielding (within minutes) crystalline ZIF films with thickness down to that of a single structural building unit (2 nm). The film crystallized on graphene has a rigid aperture made of a six-membered zinc imidazolate coordination ring, enabling high-permselective H₂ separation performance. The method reported here will probably accelerate the development of two-dimensional metal–organic framework films for efficient membrane separation.

The successful implementation of thin-film composite membranes (TFCM) for challenging solute-solute separations in the pharmaceutical industry requires a fine control over the microstructure (size, distribution, and connectivity of the free-volume elements) and thickness of the selective layer. For example, desalinating antibiotic streams requires highly interconnected free-volume elements of the right size to block antibiotics but allow the passage of salt ions and water. Here, we introduce stevioside, a plant-derived contorted glycoside, as a promising aqueous phase monomer for optimizing the microstructure of TFCM made via interfacial polymerization. The low diffusion rate and moderate reactivity of stevioside, together with its nonplanar and distorted conformation, produced thin selective layers with an ideal microporosity for antibiotic desalination. For example, an optimized 18-nm membrane exhibited an unprecedented combination of high water permeance (81.2 liter m ⁻² hour ⁻¹ bar ⁻¹ ), antibiotic desalination efficiency (NaCl/tetracycline separation factor of 11.4), antifouling performance, and chlorine resistance.

Zeolitic imidazolate frameworks (ZIFs) are a subset of metal-organic frameworks (MOFs) with more than 200 characterized crystalline and amorphous networks made of divalent transition metal centers (e.g., Zn²⁺ and Co²⁺) linked by imidazolate linkers. ZIF thin films have been pursued intensively motivated by the desire to prepare membranes for selective gas and liquid separations. To achieve membranes with high throughput, as in Å-scale biological channels with nanometer-scale pathlengths, ZIF films with the minimum possible thickness, down to just one unit cell, are highly desired. Control of ZIF film thickness at the 10-nm-scale may also enable emerging, MOF-inspired, applications including patterned crystalline MOF films, and amorphous organic-inorganic resists for high-resolution electron-beam (e-beam) and extreme UV (EUV) lithography. However, the state-of-the-art methods yield ZIF films with thicknesses exceeding 40 nanometers. Here, we report a deposition method from ultra-dilute precursor mixtures that within minutes yields uniform ZIF deposits with nm-scale thickness control. On crystalline substrate such as graphene, two-dimensional crystalline ZIF (2DZIF) film with thickness of a unit-cell could be achieved, which composed of a six-membered zincimidazolate coordination ring enabling record-high H₂ permselective separation performance. Deposition under identical conditions on amorphous substrates yields macroscopically smooth amorphous ZIF (aZIF) films, which can be used as negative- and positive-tone resists yielding pattern features down to 20 nm. The method reported here will likely accelerate the development of 2D crystalline and ultrathin amorphous MOF films for applications ranging from separation membranes to sensors and patterning for microelectronic applications.