Giovanni Iannaccone

An innovative fiber-optic hydrophone (FOH) was developed and investigated via an experiment at sea; it is capable of operating at a very low frequency of the seismic spectrum and detecting small magnitude earthquakes. The FOH exploits an optical fiber coil wrapped around a sensitive mandrel in a Michelson interferometric configuration. The FOH operated for about seven days at a water depth of 40 m, in the Campi Flegrei volcanic area (Southern Italy), and a few meters from a well-calibrated PZT hydrophone used as a reference. Thirty-three local earthquakes occurred during the simultaneous operation of the two hydrophones, allowing a straightforward comparison of the recordings. The local earthquakes occurred at an epicentral distance less than 2.5 km from the site of recording, and were estimated to be in the range of magnitude from −0.8 to 2.7. The analysis of the recorded earthquake waveforms in the frequency and time domains allowed retrieving the response function of the FOH in the frequency range from 5 to 70 Hz. The FOH responsivity in terms of acoustic pressure reached about 230 nm/Pa and was flat in the studied frequency range. Due to the high quality of the FOH recordings, this equipment is suitable for applications addressing submarine volcanic activity and the background seismicity of active faults in the ocean.

We developed and experimented at sea an innovative fiber optic hydrophone (FOH) capable of operating at very low frequency of the seismic spectrum and for detecting small magnitude earthquakes. The FOH exploits an optical fiber coil wrapped around a sensitive mandrel in a Michelson interferometric configuration. The FOH operated for about seven days at a water depth of 40 m, in the Campi Flegrei volcanic area (Southern Italy), a few meters from a well calibrated PZT hydrophone used as a reference. Thirty-three local earthquakes occurred during the simultaneous operation of the two hydrophones, allowing a straightforward comparison of the recordings. The local earthquakes occurred at an epicentral distance shorter than 2.5 km from the site of recording, and were estimated to be in the range of magnitude from -0.8 to 2.7. The analysis of the recorded earthquake waveforms in the frequency and time domain allowed retrieving the response function of the FOH in the frequency range from 5 to 70 Hz. The FOH responsivity in terms of acoustic pressure reaches about 230 nm/Pa and is flat in the studied frequency range. The high quality of the FOH recordings make this equipment suitable for applications addressing submarine volcanic activity and the background seismicity of active faults in the ocean.

Earthquake magnitude calibration using hydrophone records has been carried out at Campi Flegrei caldera, an active area close to the highly populated area of Naples city, partly undersea. Definite integrals of the hydrophone records amplitude spectra, between the limits of 1 and 20 Hz, were calculated on a set of small volcano-tectonic earthquakes with moment magnitudes ranging from 1 to 3.3. The coefficients of a linear relationship between the logarithm of these integrals and the magnitude were obtained by linear optimization, thus defining a useful equation to calculate the moment magnitude from the hydrophone record spectra. This method could be easily exported to other volcanic areas, where submerged volcanoes are monitored by networks of hydrophones and seismic sensors on land. The proposed approach allows indeed magnitude measurements of small magnitude earthquakes occurring at sea, thus adding useful information to the seismicity of these volcanoes.

We present 4 years of continuous seafloor deformation measurements carried out in the Campi Flegrei caldera (Southern Italy), one of the most hazardous and populated volcanic areas in the world. The seafloor sector of the caldera has been monitored since early 2016 by the MEDUSA marine research infrastructure, consisting of four instrumented buoys installed where sea depth is less than 100 m. Each MEDUSA buoy is equipped with a cabled, seafloor module with geophysical and oceanographic sensors and a subaerial GPS station providing seafloor deformation and other environmental measures. Since April 2016, the GPS vertical displacements at the four buoys show a continuous uplift of the seafloor with cumulative measured uplift ranging between 8 and 20 cm. Despite the data being affected by environmental noise associated with sea and meteorological conditions, the horizontal GPS displacements on the buoys show a trend coherent with a radial deformation pattern. We use jointly the GPS horizontal and vertical velocities of seafloor and on-land deformations for modeling the volcanic source, finding that a spherical source fits best the GPS data. The geodetic data produced by MEDUSA has now been integrated with the data flow of other monitoring networks deployed on land at Campi Flegrei.

Measuring seafloor motion in shallow coastal water is challenging due to strong and highly variable oceanographic effects. Such measurements are potentially useful for monitoring near‐shore coastal subsidence, subsidence due to petroleum withdrawal, strain accumulation/release processes in subduction zones and submerged volcanoes, and certain freshwater applications, such as volcano deformation in caldera‐hosted lakes. We have developed a seafloor geodesy system for this environment based on an anchored spar buoy topped by high‐precision GPS. Orientation of the buoy is measured using a digital compass that provides heading, pitch, and roll information. The combined orientation and GPS tracking data are used to recover the three‐dimensional position of the seafloor marker (anchor). A test system has been deployed in Tampa Bay, Florida, for over 1 year and has weathered several major storms without incident. Even in the presence of strong tidal currents which can deflect the top of the buoy several meters from vertical, daily repeatability in the corrected three‐component position estimates for the anchor is 1–2 cm or better.

The Campi Flegrei caldera is well known for being one of the most volcanically risky areas in the world. Notably, it has an extension of about 120 square km, and 40% of its area is submerged forming the Gulf of Pozzuoli. A remarkable expression of the local volcanic dynamics is the slow ground displacement across the whole caldera. This peculiarity makes this area a natural laboratory for developing and testing innovative methods to assess seafloor deformation. Until 2008 no seafloor deformation measurements were performed in the submarine part of the caldera, while ground deformation measurements have been extensively and routinely acquired on land since the beginning of the last century. In 2008 CUMAS, a multisensor prototype buoy, was deployed in the Gulf of Pozzuoli within a program of extension of the land-based geophysical monitoring network toward the marine sector of the caldera. CUMAS, placed at 2.5 km from the coast in about 100 m water depth, was able to acquire the first sea floor deformation measurement in the submerged portion of the caldera. In 2016, a new marine monitoring network, MEDUSA, was deployed to achieve a larger coverage of the Gulf of Pozzuoli incorporating CUMAS. MEDUSA marine network presently consists of four instrumented buoys hosting geodetic GPS receivers on the top. Moreover, each buoy is connected through a cable to a seafloor module equipped with oceanographic and geophysical sensors including a bottom pressure recorder (BPR). One of the buoys is also equipped with a tide gauge. Using the GPS, BPR and tide gauge data provided by MEDUSA, we were able to assess the seafloor deformation field in the Gulf of Pozzuoli for the first time: we estimated a seafloor vertical displacement of about 10 cm ±1 cm over a period of twenty months embracing 2016 to 2018. The presentation is aimed at giving details about the design of MEDUSA and about the multiparameter data analysis leading to the deformation field estimation.

We present an assessment of vertical seafloor deformation in the shallow marine sector of the Campi Flegrei caldera (southern Italy) obtained from GPS and bottom pressure recorder (BPR) data, acquired over the period April 2016 to July 2017 in the Gulf of Pozzuoli by a new marine infrastructure, MEDUSA. This infrastructure consists of four fixed buoys with GPS receivers; each buoy is connected by cable to a seafloor multisensor module hosting a BPR. The measured maximum vertical uplift of the seafloor is about 4.2 ± 0.4 cm. The MEDUSA data were then compared to the expected vertical displacement in the marine sector according to a Mogi model point source computed using only GPS land measurements. The results show that a single point source model of deformation is able to explain both the GPS land and seafloor data. Moreover, we demonstrate that a network of permanent GPS buoys represents a powerful tool to measure the seafloor vertical deformation field in shallow water. The performance of this system is comparable to on‐land high‐precision GPS networks, marking a significant achievement and advance in seafloor geodesy and extending volcano monitoring capabilities to shallow offshore areas (up to 100 m depth). The GPS measurements of MEDUSA have also been used to confirm that the BPR data provide an independent measure of the seafloor vertical uplift in shallow water.

We present a new methodology using bottom pressure recorder (BPR) measurements in conjunction with sea level, water column, and barometric data to assess the long‐term vertical seafloor deformation to a few centimeters accuracy in shallow water environments. The method helps to remove the apparent vertical displacement on the order of tens of centimeters caused by the BPR instrumental drift and by seawater density variations. We have applied the method to the data acquired in 2011 by a BPR deployed at 96 m depth in the marine sector of the Campi Flegrei Caldera, during a seafloor uplift episode of a few centimeters amplitude, lasted for several months. The method detected a vertical uplift of the caldera of 2.5 ± 1.3 cm achieving an unprecedented level of precision in the measurement of the submarine vertical deformation in shallow water. The estimated vertical deformation at the BPR also compares favorably with data acquired by a land‐based GPS station located at the same distance from the maximum of the modeled deformation field. While BPR measurements are commonly performed in deep waters, where the oceanic noise is relatively low, and in areas with rapid, large‐amplitude vertical ground displacement, the proposed method extends the capability of estimating vertical uplifts from BPR time series to shallow waters and to slow deformation processes.