Yang Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Yang Liu has a total of 161 co-authors. Here are the top co-authors by number of shared publications:
- Yun Qiao
School of Environmental and Chemical Engineering, Shanghai University, Shanghai 200444, China
21 shared publications - Xianluo Hu
State Key Laboratory of Materials Processing and Die & Mould Technology School of Materials Science and Engineering Huazhong University of Science and Technology Wuhan China
9 shared publications Yun Qiao
School of Chemistry and Chemical Engineering Henan Normal University Xinxiang Henan 453007 China
9 shared publications- Yunhui Huang
State Key Laboratory of Material Processing and Die & Mould Technology, School of Materials Science and Engineering, Huazhong University of Science and Technology, Wuhan, Hubei, 430074, China
8 shared publications - Shuting Yang
School of Chemistry and Chemical Engineering Henan Normal University Xinxiang Henan 453007 China
7 shared publications Yunhui Huang
7 shared publications
Latest Publications
- 24 August 2026
- Published by Wiley in Batteries & Supercaps
- Vol. 9 (9)
Research Progress of Prussian Blue Analogues and Analysis of Their Commercialization Limitations
The concept of sodium‐ion batteries (SIBs) has become a viable choice over the use of lithium‐ion batteries because of the large, available, and economical sodium resources. The three major cathode families for SIBs include layered transition‐metal oxides, polyanionic compounds, and Prussian blue analogues (PBAs), among which PBAs are widely studied because of their open framework, abundant redox sites, and low cost. Nevertheless, their practical electrochemical performance is often lower than theoretical expectations because inherent [Fe(CN) 6 ] vacancies and excess crystal water are introduced during synthesis. These structural flaws negatively impact Na + diffusion, structural reversibility, and cycling stability. This review is a systematic analysis of how vacancies and crystal water affect PBA performance, and summarizes the recent developments in crystal chemistry mechanisms, synthetic methods as well as multi‐scale modification, advanced characterization, and theoretical simulations. The advantages and disadvantages of existing modification technologies are appraised and the main research gaps in quantifying defects, unified modeling, full‐cell configuration, and industrial application are pointed out. Moreover, several future research plans are given, including machine‐learning‐based material optimization, high‐entropy PBA design, and integration with all‐solid‐state batteries.
- 24 August 2026
- Published by Wiley in Batteries & Supercaps
- Vol. 9 (9)
Research Progress of Prussian Blue Analogues and Analysis of Their Commercialization Limitations
The concept of sodium‐ion batteries (SIBs) has become a viable choice over the use of lithium‐ion batteries because of the large, available, and economical sodium resources. The three major cathode families for SIBs include layered transition‐metal oxides, polyanionic compounds, and Prussian blue analogues (PBAs), among which PBAs are widely studied because of their open framework, abundant redox sites, and low cost. Nevertheless, their practical electrochemical performance is often lower than theoretical expectations because inherent [Fe(CN) 6 ] vacancies and excess crystal water are introduced during synthesis. These structural flaws negatively impact Na + diffusion, structural reversibility, and cycling stability. This review is a systematic analysis of how vacancies and crystal water affect PBA performance, and summarizes the recent developments in crystal chemistry mechanisms, synthetic methods as well as multi‐scale modification, advanced characterization, and theoretical simulations. The advantages and disadvantages of existing modification technologies are appraised and the main research gaps in quantifying defects, unified modeling, full‐cell configuration, and industrial application are pointed out. Moreover, several future research plans are given, including machine‐learning‐based material optimization, high‐entropy PBA design, and integration with all‐solid‐state batteries.
- 25 July 2026
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 724 (Pt 2) , 141216
Plasma-spark-induced ultrafast anchoring of Ni nanocatalysts on monolithic carbon for robust Li–CO2 batteries
- 25 July 2026
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 724 (Pt 2) , 141216
Plasma-spark-induced ultrafast anchoring of Ni nanocatalysts on monolithic carbon for robust Li–CO2 batteries
- Open Access
- 14 May 2024
- Published by Royal Society of Chemistry (RSC) in Chemical Science
- Vol. 15 (25) , 9591-9598
Cross-linked K0.5MnO2 nanoflower composites for high rate and low overpotential Li–CO2 batteries
The synergistic effect between ultra-thin K0.5MnO2 nanoflowers and CNTs effectively promotes the nucleation and charging decomposition of Li2CO3, achieving low overpotential and high average energy efficiency as a Li–CO2 cathode.
- 14 May 2024
- Published by Royal Society of Chemistry (RSC) in Chemical Science
- Vol. 15 (25) , 9591-9598
Open AccessCross-linked K0.5MnO2 nanoflower composites for high rate and low overpotential Li–CO2 batteries
The synergistic effect between ultra-thin K0.5MnO2 nanoflowers and CNTs effectively promotes the nucleation and charging decomposition of Li2CO3, achieving low overpotential and high average energy efficiency as a Li–CO2 cathode.
- 27 November 2023
- Published by Wiley in Chemistry – A European Journal
- Vol. 30 (4) , e202303319
Porous Carbon Foam with Carbon Nanotubes as Cathode for Li−CO2 Batteries
With the extensive use of fossil fuels, the ever‐increasing greenhouse gas of mainly carbon dioxide emissions will result in global climate change. It is of utmost importance to reduce carbon dioxide emissions and its utilization. Li−CO2 batteries can convert carbon dioxide into electrochemical energy. However, developing efficient catalysts for the decomposition of Li2CO3 as the discharge product represents a challenge in Li−CO2 batteries. Herein, we demonstrate a carbon foam composite with growing carbon nanotube by using cobalt as the catalyst, showing the ability to enhance the decomposition rate of Li2CO3, and thus improve the electrochemical performance of Li−CO2 batteries. Benefiting from its abundant pore structure and catalytic sites, the as‐assembled Li−CO2 battery exhibits a desirable overpotential of 1.67 V after 50 cycles. Moreover, the overpotentials are 1.05 and 2.38 V at current densities of 0.02 and 0.20 mA cm−2, respectively. These results provide a new avenue for the development of efficient catalysts for Li−CO2 batteries.
- 27 November 2023
- Published by Wiley in Chemistry – A European Journal
- Vol. 30 (4) , e202303319
Porous Carbon Foam with Carbon Nanotubes as Cathode for Li−CO2 Batteries
With the extensive use of fossil fuels, the ever‐increasing greenhouse gas of mainly carbon dioxide emissions will result in global climate change. It is of utmost importance to reduce carbon dioxide emissions and its utilization. Li−CO2 batteries can convert carbon dioxide into electrochemical energy. However, developing efficient catalysts for the decomposition of Li2CO3 as the discharge product represents a challenge in Li−CO2 batteries. Herein, we demonstrate a carbon foam composite with growing carbon nanotube by using cobalt as the catalyst, showing the ability to enhance the decomposition rate of Li2CO3, and thus improve the electrochemical performance of Li−CO2 batteries. Benefiting from its abundant pore structure and catalytic sites, the as‐assembled Li−CO2 battery exhibits a desirable overpotential of 1.67 V after 50 cycles. Moreover, the overpotentials are 1.05 and 2.38 V at current densities of 0.02 and 0.20 mA cm−2, respectively. These results provide a new avenue for the development of efficient catalysts for Li−CO2 batteries.
- 8 November 2023
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 655, 693-698
Carbon nanotubes with CoNi alloy nanoparticles growing on porous carbon substrate as cathode for Li-CO2 batteries
- 8 November 2023
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 655, 693-698
Carbon nanotubes with CoNi alloy nanoparticles growing on porous carbon substrate as cathode for Li-CO2 batteries
- 19 July 2023
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 11 (30) , 11052-11066
Homogeneous Ni Single-Atom Sites in the NiZn Intermetallic Nanostructure for Efficient Semihydrogenation of Acetylene
- 19 July 2023
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 11 (30) , 11052-11066
Homogeneous Ni Single-Atom Sites in the NiZn Intermetallic Nanostructure for Efficient Semihydrogenation of Acetylene
- 7 June 2023
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- Vol. 59 (61) , 9320-9335
Low-cost Prussian blue analogues for sodium-ion batteries and other metal-ion batteries
This review summarizes the recent progress and presents the challenges and strategies of Fe-based and Mn-based Prussian blue analogues for metal-ion batteries.
- 7 June 2023
- Published by Royal Society of Chemistry (RSC) in Chemical Communications
- Vol. 59 (61) , 9320-9335
Low-cost Prussian blue analogues for sodium-ion batteries and other metal-ion batteries
This review summarizes the recent progress and presents the challenges and strategies of Fe-based and Mn-based Prussian blue analogues for metal-ion batteries.
- Open Access
- 5 April 2023
- Published by Oxford University Press (OUP) in Journal of the Royal Statistical Society Series B: Statistical Methodology
- Vol. 85 (4) , 1085-1086
Yang Liu's contribution to the Discussion of ‘Vintage Factor Analysis with Varimax Performs Statistical Inference’ by Rohe & Zeng
Yang Liu; Yang Liu’s contribution to the Discussion of “Vintage Factor Analysis with Varimax Performs Statistical Inference” by Rohe & Zeng, Journal of the
- 5 April 2023
- Published by Oxford University Press (OUP) in Journal of the Royal Statistical Society Series B: Statistical Methodology
- Vol. 85 (4) , 1085-1086
Open AccessYang Liu's contribution to the Discussion of ‘Vintage Factor Analysis with Varimax Performs Statistical Inference’ by Rohe & Zeng
Yang Liu; Yang Liu’s contribution to the Discussion of “Vintage Factor Analysis with Varimax Performs Statistical Inference” by Rohe & Zeng, Journal of the
- 29 November 2022
- Published by Royal Society of Chemistry (RSC) in Inorganic Chemistry Frontiers
- Vol. 10 (3) , 880-887
Spherical, flower-like MnCo 2 O 4 with a hollow structure as the cathode for efficient Li-CO 2 batteries
A flower-like MnCo 2 O 4 sphere with a hollow structure was introduced as the cathode to enhance the electrochemical performance of Li-CO 2 batteries.
- 29 November 2022
- Published by Royal Society of Chemistry (RSC) in Inorganic Chemistry Frontiers
- Vol. 10 (3) , 880-887
Spherical, flower-like MnCo 2 O 4 with a hollow structure as the cathode for efficient Li-CO 2 batteries
A flower-like MnCo 2 O 4 sphere with a hollow structure was introduced as the cathode to enhance the electrochemical performance of Li-CO 2 batteries.
- Open Access
- 20 June 2022
- Published by SAGE Publications in Applied Psychological Measurement
- Vol. 46 (6) , 509-528
Characterizing Sampling Variability for Item Response Theory Scale Scores in a Fixed-Parameter Calibrated Projection Design
A common practice of linking uses estimated item parameters to calculate projected scores. This procedure fails to account for the carry-over sampling variability. Neglecting sampling variability could consequently lead to understated uncertainty for Item Response Theory (IRT) scale scores. To address the issue, we apply a Multiple Imputation (MI) approach to adjust the Posterior Standard Deviations of IRT scale scores. The MI procedure involves drawing multiple sets of plausible values from an approximate sampling distribution of the estimated item parameters. When two scales to be linked were previously calibrated, item parameters can be fixed at their original published scales, and the latent variable means and covariances of the two scales can then be estimated conditional on the fixed item parameters. The conditional estimation procedure is a special case of Restricted Recalibration (RR), in which the asymptotic sampling distribution of estimated parameters follows from the general theory of pseudo Maximum Likelihood (ML) estimation. We evaluate the combination of RR and MI by a simulation study to examine the impact of carry-over sampling variability under various simulation conditions. We also illustrate how to apply the proposed method to real data by revisiting Thissen et al. (2015).
- 20 June 2022
- Published by SAGE Publications in Applied Psychological Measurement
- Vol. 46 (6) , 509-528
Open AccessCharacterizing Sampling Variability for Item Response Theory Scale Scores in a Fixed-Parameter Calibrated Projection Design
A common practice of linking uses estimated item parameters to calculate projected scores. This procedure fails to account for the carry-over sampling variability. Neglecting sampling variability could consequently lead to understated uncertainty for Item Response Theory (IRT) scale scores. To address the issue, we apply a Multiple Imputation (MI) approach to adjust the Posterior Standard Deviations of IRT scale scores. The MI procedure involves drawing multiple sets of plausible values from an approximate sampling distribution of the estimated item parameters. When two scales to be linked were previously calibrated, item parameters can be fixed at their original published scales, and the latent variable means and covariances of the two scales can then be estimated conditional on the fixed item parameters. The conditional estimation procedure is a special case of Restricted Recalibration (RR), in which the asymptotic sampling distribution of estimated parameters follows from the general theory of pseudo Maximum Likelihood (ML) estimation. We evaluate the combination of RR and MI by a simulation study to examine the impact of carry-over sampling variability under various simulation conditions. We also illustrate how to apply the proposed method to real data by revisiting Thissen et al. (2015).