Daiara Faria
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Daiara Faria has a total of 48 co-authors. Here are the top co-authors by number of shared publications:
A. Latgé
5 shared publications- Ramon Carrillo-Bastos
Universidad Autónoma de Baja California
5 shared publications - Alexandre Melhorance Barboza
Universidade do Estado do Rio de Janeiro
4 shared publications - Ivan Napoleão Bastos
Universidade do Estado do Rio de Janeiro
4 shared publications - Vanessa Torres
Instituto de Física, Universidade Federal Fluminense (UFF), 24210-346 Niterói, Rio de Janeiro, Brazil
4 shared publications - Andrea Latge
Universidade Federal Fluminense
3 shared publications
Latest Publications
- 1 July 2026
- Published by Elsevier in Surfaces and Interfaces
- Vol. 97
Unraveling the electronic properties of twisted C3N bilayers using the extended Hückel method
- 1 July 2026
- Published by Elsevier in Surfaces and Interfaces
- Vol. 97
Unraveling the electronic properties of twisted C3N bilayers using the extended Hückel method
- Open Access
- 28 February 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nanotechnology
- Vol. 24 (1536125X) , 134-139
Influence of Temperature, Strain Rate, and Vacancies on the Mechanical Properties of Aluminum-Doped Bilayer Silicene
Silicene, a two-dimensional material with promising potential for future technological applications, has attracted considerable attention over the past decade. Recent research has focused on modifying silicene's electronic and magnetic properties by means of adsorption or substitutional doping. While the magnetic, electronic, and optical properties of doped silicene have been extensively studied, there is a noticeable gap in the literature regarding its mechanical properties. To address this issue, this study explores the mechanical characteristics of bilayer silicene doped with aluminum under various conditions. By employing molecular dynamics simulations, we investigate the influence of aluminum concentration, defects, temperature, and strain rate on the material's mechanical response. The findings reveal a monotonically decreasing strength with Al concentration in both the zigzag and armchair straining directions. Additionally, the material exhibits high sensitivity to defects, with even a small percentage significantly impairing its mechanical properties. Directional dependence is also observed, with the zigzag direction showing greater sensitivity than the armchair. As strain progresses, initial mono-vacancies evolve into more complex defects, hindering predictions of the mechanical response in certain cases. Lastly, strain rate sensitivity is evaluated, yielding values of 0.0485 and 0.0365 for the zigzag and armchair directions, respectively.
- 28 February 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nanotechnology
- Vol. 24 (1536125X) , 134-139
Open AccessInfluence of Temperature, Strain Rate, and Vacancies on the Mechanical Properties of Aluminum-Doped Bilayer Silicene
Silicene, a two-dimensional material with promising potential for future technological applications, has attracted considerable attention over the past decade. Recent research has focused on modifying silicene's electronic and magnetic properties by means of adsorption or substitutional doping. While the magnetic, electronic, and optical properties of doped silicene have been extensively studied, there is a noticeable gap in the literature regarding its mechanical properties. To address this issue, this study explores the mechanical characteristics of bilayer silicene doped with aluminum under various conditions. By employing molecular dynamics simulations, we investigate the influence of aluminum concentration, defects, temperature, and strain rate on the material's mechanical response. The findings reveal a monotonically decreasing strength with Al concentration in both the zigzag and armchair straining directions. Additionally, the material exhibits high sensitivity to defects, with even a small percentage significantly impairing its mechanical properties. Directional dependence is also observed, with the zigzag direction showing greater sensitivity than the armchair. As strain progresses, initial mono-vacancies evolve into more complex defects, hindering predictions of the mechanical response in certain cases. Lastly, strain rate sensitivity is evaluated, yielding values of 0.0485 and 0.0365 for the zigzag and armchair directions, respectively.
- Open Access
- 4 November 2024
- Published by Universidade Federal de Santa Maria in Ciência e Natura
- Vol. 46 (esp. 1) , e86861
Dynamics of lithium ions on a silicene anode grown by vapor deposition using Morse and MEAM potentials
Silicene, the silicon analogue of graphene, has been theoretically envisioned as a material with great potential applications, especially as an anode in lithium-ion batteries. However, the understanding of its behavior as an anode remains unclear, as research in this area is still in its preliminary phases. Furthermore, existing studies do not account for defects commonly found in silicene layers, which could potentially alter its behavior as an anode. Therefore, this study investigates the dynamics of Li ions on a defective silicene layer using molecular dynamics simulations and two distinct interatomic potentials: Morse and 2NN-MEAM. The results show that with both potentials, Li ions tend to position themselves in the middle of Si rings with six or more elements without significantly deforming the nearby lattice. However, the 2NN-MEAM potential causes severe deformation during Li diffusion on rings with five or less elements, making it impractical to investigate silicene as anode. In contrast, the Morse potential manages to maintain the silicene's structure. Nevertheless, during the insertion of Li ions into the anode’s channel, Si adatoms create barriers to Li diffusion, damaging the silicene structure. These results cast uncertainty upon the feasibility of employing silicene as anode.
- 4 November 2024
- Published by Universidade Federal de Santa Maria in Ciência e Natura
- Vol. 46 (esp. 1) , e86861
Open AccessDynamics of lithium ions on a silicene anode grown by vapor deposition using Morse and MEAM potentials
Silicene, the silicon analogue of graphene, has been theoretically envisioned as a material with great potential applications, especially as an anode in lithium-ion batteries. However, the understanding of its behavior as an anode remains unclear, as research in this area is still in its preliminary phases. Furthermore, existing studies do not account for defects commonly found in silicene layers, which could potentially alter its behavior as an anode. Therefore, this study investigates the dynamics of Li ions on a defective silicene layer using molecular dynamics simulations and two distinct interatomic potentials: Morse and 2NN-MEAM. The results show that with both potentials, Li ions tend to position themselves in the middle of Si rings with six or more elements without significantly deforming the nearby lattice. However, the 2NN-MEAM potential causes severe deformation during Li diffusion on rings with five or less elements, making it impractical to investigate silicene as anode. In contrast, the Morse potential manages to maintain the silicene's structure. Nevertheless, during the insertion of Li ions into the anode’s channel, Si adatoms create barriers to Li diffusion, damaging the silicene structure. These results cast uncertainty upon the feasibility of employing silicene as anode.
- 26 July 2023
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 666
Exploring valley polarized transport in graphene bilayer flakes
- 26 July 2023
- Published by Elsevier in Physica B: Condensed Matter
- Vol. 666
Exploring valley polarized transport in graphene bilayer flakes
- 24 March 2021
- Published by American Physical Society (APS) in Physical Review B
- Vol. 103 (11) , 115437
Switching valley filtered current directions in multiterminal graphene systems
Valley filtering processes have been explored in different graphene-based configurations and scenarios to control transport responses. Here we propose graphene multiterminal setups properly designed to obtain valley filtered currents in a broad range of energy, in addition to the possibility of controlling their directions. We explore graphene systems with extended mechanical foldlike deformations as an opportunity to enhance valley filtered transmission. The mixing between the electronic confinement effects due to a magnetic field and strain results in a selective drive of the current components in the quantum Hall regime. We adopt the mode-matching method within the Green's function formalism, allowing direct analysis of the strain effect on each valley transmission. We estimate a threshold map of confinement parameters, characterized by the magnetic, deformation, and setup lengths, to optimize valley filter transport processes and the proper switch of the valley polarized current directions.
- 24 March 2021
- Published by American Physical Society (APS) in Physical Review B
- Vol. 103 (11) , 115437
Switching valley filtered current directions in multiterminal graphene systems
Valley filtering processes have been explored in different graphene-based configurations and scenarios to control transport responses. Here we propose graphene multiterminal setups properly designed to obtain valley filtered currents in a broad range of energy, in addition to the possibility of controlling their directions. We explore graphene systems with extended mechanical foldlike deformations as an opportunity to enhance valley filtered transmission. The mixing between the electronic confinement effects due to a magnetic field and strain results in a selective drive of the current components in the quantum Hall regime. We adopt the mode-matching method within the Green's function formalism, allowing direct analysis of the strain effect on each valley transmission. We estimate a threshold map of confinement parameters, characterized by the magnetic, deformation, and setup lengths, to optimize valley filter transport processes and the proper switch of the valley polarized current directions.
- Open Access
- 1 January 2021
- Published by Even3
- Vol. 24, 1
COMPUTATIONAL STUDY OF EPITAXIAL SILICENE GROWTH ON Au(110) SUBSTRATE BY VAPOR DEPOSITION
Encontro Nacional de Modelagem Computacional e Encontro de Ciência e Tecnologia de Materiais (978-65-86084-34-4) - Computational Study Of Epitaxial Silicene Growth On Au(110) Substrate By Vapor Deposition
- 1 January 2021
- Published by Even3
- Vol. 24, 1
Open AccessCOMPUTATIONAL STUDY OF EPITAXIAL SILICENE GROWTH ON Au(110) SUBSTRATE BY VAPOR DEPOSITION
Encontro Nacional de Modelagem Computacional e Encontro de Ciência e Tecnologia de Materiais (978-65-86084-34-4) - Computational Study Of Epitaxial Silicene Growth On Au(110) Substrate By Vapor Deposition
- 18 February 2020
- Published by American Physical Society (APS) in Physical Review B
- Vol. 101 (8) , 081410
Valley polarization braiding in strained graphene
Previous works on deformed graphene predict the existence of valley-polarized states, however, optimal conditions for their detection remain challenging. We show that in the quantum Hall regime, edgelike states in strained regions can be isolated in energy within Landau gaps. We identify precise conditions for conducting edgelike states to be valley polarized. By the appropriate design of strain profiles these states can be positioned at chosen locations in the sample. A map of the local density of states as a function of energy and position reveals a unique braid pattern that serves as a fingerprint to identify valley polarization.
- 18 February 2020
- Published by American Physical Society (APS) in Physical Review B
- Vol. 101 (8) , 081410
Valley polarization braiding in strained graphene
Previous works on deformed graphene predict the existence of valley-polarized states, however, optimal conditions for their detection remain challenging. We show that in the quantum Hall regime, edgelike states in strained regions can be isolated in energy within Landau gaps. We identify precise conditions for conducting edgelike states to be valley polarized. By the appropriate design of strain profiles these states can be positioned at chosen locations in the sample. A map of the local density of states as a function of energy and position reveals a unique braid pattern that serves as a fingerprint to identify valley polarization.
- 28 September 2018
- Published by American Chemical Society (ACS) in Nano Letters
- Vol. 18 (10) , 6654
Correction to Tuning the Pseudospin Polarization of Graphene by a Pseudomagnetic Field
- 28 September 2018
- Published by American Chemical Society (ACS) in Nano Letters
- Vol. 18 (10) , 6654
Correction to Tuning the Pseudospin Polarization of Graphene by a Pseudomagnetic Field
- 23 April 2018
- Published by American Physical Society (APS) in Physical Review B
- Vol. 97 (16) , 165429
Tuning transport properties of graphene three-terminal structures by mechanical deformation
Straintronic devices made of carbon-based materials have been pushed up due to the graphene high mechanical flexibility and the possibility of interesting changes in transport properties. Properly designed strained systems have been proposed to allow optimized transport responses that can be explored in experimental realizations. In multiterminal systems, comparisons between schemes with different geometries are important to characterize the modifications introduced by mechanical deformations, especially if the deformations are localized at a central part of the system or extended in a large region. Then, in the present analysis, we study the strain effects on the transport properties of triangular and hexagonal graphene flakes, with zigzag and armchair edges, connected to three electronic terminals, formed by semi-infinite graphene nanoribbons. Using the Green's function formalism with circular renormalization schemes, and a single band tight-binding approximation, we find that resonant tunneling transport becomes relevant and is more affected by localized deformations in the hexagonal graphene flakes. Moreover, triangular systems with deformation extended to the leads, like longitudinal three-folded type, are shown as an interesting scenario for building nanoscale waveguides for electronic current.
- 23 April 2018
- Published by American Physical Society (APS) in Physical Review B
- Vol. 97 (16) , 165429
Tuning transport properties of graphene three-terminal structures by mechanical deformation
Straintronic devices made of carbon-based materials have been pushed up due to the graphene high mechanical flexibility and the possibility of interesting changes in transport properties. Properly designed strained systems have been proposed to allow optimized transport responses that can be explored in experimental realizations. In multiterminal systems, comparisons between schemes with different geometries are important to characterize the modifications introduced by mechanical deformations, especially if the deformations are localized at a central part of the system or extended in a large region. Then, in the present analysis, we study the strain effects on the transport properties of triangular and hexagonal graphene flakes, with zigzag and armchair edges, connected to three electronic terminals, formed by semi-infinite graphene nanoribbons. Using the Green's function formalism with circular renormalization schemes, and a single band tight-binding approximation, we find that resonant tunneling transport becomes relevant and is more affected by localized deformations in the hexagonal graphene flakes. Moreover, triangular systems with deformation extended to the leads, like longitudinal three-folded type, are shown as an interesting scenario for building nanoscale waveguides for electronic current.