Aaesha Alnuaimi
Research Interests
Aaesha Alnuaimi has a total of 28 co-authors. Here are the top co-authors by number of shared publications:
Ammar Nayfeh
3 shared publicationsIrfan Saadat
3 shared publicationsIbraheem Almansouri
Department of Electrical and Computer Engineering (ECE), Masdar Institute, Khalifa University of Science and Technology, Abu Dhabi, United Arab Emirates
2 shared publications- Adam B. Shinn
Wh Analytics, San Francisco, CA, United States
1 shared publication - Ambarish Nag
Computational Science Center, National Renewable Energy Laboratory, 15013 Denver West Pkwy, Golden, CO 80401, USA
1 shared publication - Ammar B. A. Elnosh
Dubai Electricity & Water Authority, Dubai, UAE
1 shared publication
Latest Publications
- Open Access
- 29 December 2023
- Published by IOP Publishing in Progress in Energy
- Vol. 6 (1) , 012004
Insight into dust soiling characteristics and cleaning solutions to investigate impact on PV systems performance across the globe
The energy crisis we currently struggle with is an augmentation of decades of neglect and irrational exploitation of the Earth’s resources. With manifold contributing factors such as the high demand for energy, highly over-populated areas, and fossil fuel depletion, the EU has proposed to cut greenhouse gas emissions by at least 55% of 1990 levels by 2030, on the ambitious road to becoming carbon neutral by 2050. Enlarging and diversifying efficient renewable resources is a crucial pillar to satisfying the overwhelming energy needs. The road to this goal is paved by the intensive implementation of solar and wind resources, which are the most promising with their ability to cover an entire year’s energy consumption by just one hour of irradiation if almost 100% of the incoming solar energy could be converted. As widespread and evolved as solar photovoltaic (PV) systems might be, they do present a myriad of challenges in their lifetime. PV soiling is among the major bottlenecks in PV power plants due to its direct influence on both the performance and efficiency of the overall system. This work will shed light on soiling characteristics after guiding through the soiling concepts, rates, and geographical distribution probability. The nature of soiling, its composition, and its impact on the performance of PV modules with full-sized cells will be described. The essence of this review is based on the various cleaning mechanisms that aim to reduce soiling and enhance PV plant performance. This work is concluded by summarizing the review content whilst highlighting the current support and efforts put forth by worldwide organizations to embody the motivation and essence of requirements in the pursuit of soiling reduction and green energy pathways.
- 29 December 2023
- Published by IOP Publishing in Progress in Energy
- Vol. 6 (1) , 012004
Open AccessInsight into dust soiling characteristics and cleaning solutions to investigate impact on PV systems performance across the globe
The energy crisis we currently struggle with is an augmentation of decades of neglect and irrational exploitation of the Earth’s resources. With manifold contributing factors such as the high demand for energy, highly over-populated areas, and fossil fuel depletion, the EU has proposed to cut greenhouse gas emissions by at least 55% of 1990 levels by 2030, on the ambitious road to becoming carbon neutral by 2050. Enlarging and diversifying efficient renewable resources is a crucial pillar to satisfying the overwhelming energy needs. The road to this goal is paved by the intensive implementation of solar and wind resources, which are the most promising with their ability to cover an entire year’s energy consumption by just one hour of irradiation if almost 100% of the incoming solar energy could be converted. As widespread and evolved as solar photovoltaic (PV) systems might be, they do present a myriad of challenges in their lifetime. PV soiling is among the major bottlenecks in PV power plants due to its direct influence on both the performance and efficiency of the overall system. This work will shed light on soiling characteristics after guiding through the soiling concepts, rates, and geographical distribution probability. The nature of soiling, its composition, and its impact on the performance of PV modules with full-sized cells will be described. The essence of this review is based on the various cleaning mechanisms that aim to reduce soiling and enhance PV plant performance. This work is concluded by summarizing the review content whilst highlighting the current support and efforts put forth by worldwide organizations to embody the motivation and essence of requirements in the pursuit of soiling reduction and green energy pathways.
- 18 October 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Photovoltaics
- Vol. 10 (1) , 206-212
Reducing Interanalyst Variability in Photovoltaic Degradation Rate Assessments
The economic return on investment of a commercial photovoltaic system depends greatly on its performance over the long term and, hence, its degradation rate. Many methods have been proposed for assessing system degradation rates from outdoor performance data. However, comparing reported values from one analyst and research group to another requires a common baseline of performance; consistency between methods and analysts can be a challenge. An interlaboratory study was conducted involving different volunteer analysts reporting on the same photovoltaic performance data using different methodologies. Initial variability of the reported degradation rates was so high that analysts could not come to a consensus whether a system degraded or not. More consistent values are received when written guidance is provided to each analyst. Further improvements in analyst variance was accomplished by using the free open-source software RdTools, allowing a reduction in variance between analysts by more than two orders of magnitude over the first round, where multiple analysis methods are allowed. This article highlights many pitfalls in conducting “routine” degradation analysis, and it addresses some of the factors that must be considered when comparing degradation results reported by different analysts or methods.
- 18 October 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Photovoltaics
- Vol. 10 (1) , 206-212
Reducing Interanalyst Variability in Photovoltaic Degradation Rate Assessments
The economic return on investment of a commercial photovoltaic system depends greatly on its performance over the long term and, hence, its degradation rate. Many methods have been proposed for assessing system degradation rates from outdoor performance data. However, comparing reported values from one analyst and research group to another requires a common baseline of performance; consistency between methods and analysts can be a challenge. An interlaboratory study was conducted involving different volunteer analysts reporting on the same photovoltaic performance data using different methodologies. Initial variability of the reported degradation rates was so high that analysts could not come to a consensus whether a system degraded or not. More consistent values are received when written guidance is provided to each analyst. Further improvements in analyst variance was accomplished by using the free open-source software RdTools, allowing a reduction in variance between analysts by more than two orders of magnitude over the first round, where multiple analysis methods are allowed. This article highlights many pitfalls in conducting “routine” degradation analysis, and it addresses some of the factors that must be considered when comparing degradation results reported by different analysts or methods.
- 1 April 2018
- Published by Elsevier in Solar Energy
- Vol. 164, 174-179
High performance graphene-silicon Schottky junction solar cells with HfO2 interfacial layer grown by atomic layer deposition
- 1 April 2018
- Published by Elsevier in Solar Energy
- Vol. 164, 174-179
High performance graphene-silicon Schottky junction solar cells with HfO2 interfacial layer grown by atomic layer deposition
- Open Access
- 16 March 2018
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 8 (19) , 10593-10597
Interface engineering of graphene–silicon Schottky junction solar cells with an Al2O3 interfacial layer grown by atomic layer deposition
One approach to improve Gr/Si SBSC performance is engineering the interface with an interfacial layer. We demonstrate the improved performance of Gr/Si SBSC upon engineering the interface with an aluminium oxide (Al2O3) layer grown by atomic layer deposition (ALD)..
- 16 March 2018
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 8 (19) , 10593-10597
Open AccessInterface engineering of graphene–silicon Schottky junction solar cells with an Al2O3 interfacial layer grown by atomic layer deposition
One approach to improve Gr/Si SBSC performance is engineering the interface with an interfacial layer. We demonstrate the improved performance of Gr/Si SBSC upon engineering the interface with an aluminium oxide (Al2O3) layer grown by atomic layer deposition (ALD)..
- Open Access
- 8 November 2017
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 7 (82) , 51951-51957
Toward fast growth of large area high quality graphene using a cold-wall CVD reactor
In this work we provide a detailed analysis on graphene synthesis by Chemical Vapor Deposition (CVD) using a cold wall CVD reactor to achieve fast production of large area high quality graphene. Using Raman spectroscopy and mapping, the effect of growth temperature, pressure and CH4 : H2 ratio have been analyzed. The results show that graphene synthesis at high temperature results in reducing the multilayer nucleation density. At a high temperature of 1060 °C, the density of multilayer graphene was reduced by more than 50%. In addition, our analysis revealed that the chamber pressure plays a major role in reducing the multilayer region formation and controlling the grain size of graphene. At 15 mbar, high quality graphene with a large grain size greater than 5 μm is achieved. Moreover, the hydrogen to methane ratio has a significant role in determining the morphology and the size of graphene domains. Our analysis provide guidelines toward the synthesis of high quality graphene using 4′′ cold wall CVD reactor that are beneficial for the large scale production of graphene.
- 8 November 2017
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 7 (82) , 51951-51957
Open AccessToward fast growth of large area high quality graphene using a cold-wall CVD reactor
In this work we provide a detailed analysis on graphene synthesis by Chemical Vapor Deposition (CVD) using a cold wall CVD reactor to achieve fast production of large area high quality graphene. Using Raman spectroscopy and mapping, the effect of growth temperature, pressure and CH4 : H2 ratio have been analyzed. The results show that graphene synthesis at high temperature results in reducing the multilayer nucleation density. At a high temperature of 1060 °C, the density of multilayer graphene was reduced by more than 50%. In addition, our analysis revealed that the chamber pressure plays a major role in reducing the multilayer region formation and controlling the grain size of graphene. At 15 mbar, high quality graphene with a large grain size greater than 5 μm is achieved. Moreover, the hydrogen to methane ratio has a significant role in determining the morphology and the size of graphene domains. Our analysis provide guidelines toward the synthesis of high quality graphene using 4′′ cold wall CVD reactor that are beneficial for the large scale production of graphene.
- 21 November 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 0318-0322
∼12% Efficiency improvement in a-Si thin-film solar cells using ALD grown 2-nm-thick ZnO nanoislands
2-nm-thick ZnO nanoislands have been grown using Atomic Layer Deposition (ALD) on the surface of n-i-p a-Si:H solar cells. With the nanoislands, an average improvement of 10.6% in short circuit current density (Jsc) and 12.05% in efficiency compared to the reference cell are achieved. Improved spectral response is obtained from ZnO nanoislands coated cell with an improvement of 4.2% and 5.25% in peak EQE and IQE respectively. The coated cell also minimizes reflection between 340–520 nm indicating light scattering ability of these nanoislands. Further analysis suggests that overall enhancement can be attributed to photon energy downshifting with a reduction in reflectivity.
- 21 November 2016
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 0318-0322
∼12% Efficiency improvement in a-Si thin-film solar cells using ALD grown 2-nm-thick ZnO nanoislands
2-nm-thick ZnO nanoislands have been grown using Atomic Layer Deposition (ALD) on the surface of n-i-p a-Si:H solar cells. With the nanoislands, an average improvement of 10.6% in short circuit current density (Jsc) and 12.05% in efficiency compared to the reference cell are achieved. Improved spectral response is obtained from ZnO nanoislands coated cell with an improvement of 4.2% and 5.25% in peak EQE and IQE respectively. The coated cell also minimizes reflection between 340–520 nm indicating light scattering ability of these nanoislands. Further analysis suggests that overall enhancement can be attributed to photon energy downshifting with a reduction in reflectivity.