Shinya Sugiura
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Shinya Sugiura has a total of 178 co-authors. Here are the top co-authors by number of shared publications:
- Lajos Hanzo
University of Southampton
56 shared publications - Chao Xu
School of Electronics and Computer Science, University of Southampton, Southampton, U.K.
28 shared publications - Naoki Ishikawa
Faculty of Engineering, Yokohama National University, Yokohama, Kanagawa, Japan
14 shared publications Takumi Ishihara
12 shared publications- Hideo Iizuka
Toyota Research Institute of North America, Toyota Motor North America , Ann Arbor, Michigan 48105
11 shared publications - Lie-Liang Yang
Department of Electronics and Computer Science, University of Southampton, Southampton, U.K.
11 shared publications
Latest Publications
- 31 March 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Vehicular Technology
- Vol. PP (00189545) , 1-12
An Experimental Validation of Reconfigurable Intelligent Surfaces Achieving Pulse-Width-Modulated Singular Reflection Angles Without External Power Sources
In this study, we introduce a design concept that leverages pulse width variation to enable a reconfigurable intelligent surface (RIS) and to autonomously switch reflection properties between two angles without any active control system. Our RIS alters its beam pattern from a singular specular reflection to another unique singular anomalous reflection when the incoming waveform changes from a short pulse to a continuous wave, even at the same frequency. Unlike conventional RISs, our passive control mechanism eliminates the need for active components and precise symbol-level synchronization with the transmitting antennas, reducing the complexity of the system while offering dynamic material adaptability. We numerically show that the proposed RIS design is capable of varying the received magnitude of an incident wave by a factor of ten, which is also experimentally validated for the first time. Employing binary phase-shift keying (BPSK) modulation, we further report that the communication characteristics can be varied by 7 dB or more, which indicates that the proposed design is not limited to a single frequency component as long as the bandwidth of the given signal is covered by that of the RIS design. These results may present new opportunities for exploring and deploying pulse-width-dependent RISs in practical scenarios involving next-generation communication systems.
- 31 March 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Vehicular Technology
- Vol. PP (00189545) , 1-12
An Experimental Validation of Reconfigurable Intelligent Surfaces Achieving Pulse-Width-Modulated Singular Reflection Angles Without External Power Sources
In this study, we introduce a design concept that leverages pulse width variation to enable a reconfigurable intelligent surface (RIS) and to autonomously switch reflection properties between two angles without any active control system. Our RIS alters its beam pattern from a singular specular reflection to another unique singular anomalous reflection when the incoming waveform changes from a short pulse to a continuous wave, even at the same frequency. Unlike conventional RISs, our passive control mechanism eliminates the need for active components and precise symbol-level synchronization with the transmitting antennas, reducing the complexity of the system while offering dynamic material adaptability. We numerically show that the proposed RIS design is capable of varying the received magnitude of an incident wave by a factor of ten, which is also experimentally validated for the first time. Employing binary phase-shift keying (BPSK) modulation, we further report that the communication characteristics can be varied by 7 dB or more, which indicates that the proposed design is not limited to a single frequency component as long as the bandwidth of the given signal is covered by that of the RIS design. These results may present new opportunities for exploring and deploying pulse-width-dependent RISs in practical scenarios involving next-generation communication systems.
- Open Access
- 3 March 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Wireless Communications
- Vol. 25 (15361276) , 12962-12977
Reduced-Overhead Channel Estimation for FTN Signaling via Pilot Superimposition and Spectral Interference Alignment
This paper proposes low-overhead and low-complexity channel estimation (CE) of frequency-domain equalization (FDE)-aided faster-than-Nyquist (FTN) signaling. In the proposed CE scheme, the concept of pilot superimposition is employed, where the FTN block is designed to superimpose pilot symbols with information symbols, thereby eliminating the need for dedicated time and frequency resources or guard bands. Furthermore, interference induced by the pilot superimposition is eliminated by invoking a novel scheme, referred to as spectral interference alignment, where a specially-designed data-dependent sequence is subtracted from the transmitted information symbols to achieve interference-free CE. The theoretical mean-square error (MSE) of the proposed CE is derived, confirming that the MSE is no longer affected by interference from the pilot superimposition. Our performance results demonstrate that the proposed CE achieves lower CE errors, better bit-error rates, higher achievable rate, and spectral efficiency with half of the overhead compared with the conventional benchmark.
- 3 March 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Wireless Communications
- Vol. 25 (15361276) , 12962-12977
Open AccessReduced-Overhead Channel Estimation for FTN Signaling via Pilot Superimposition and Spectral Interference Alignment
This paper proposes low-overhead and low-complexity channel estimation (CE) of frequency-domain equalization (FDE)-aided faster-than-Nyquist (FTN) signaling. In the proposed CE scheme, the concept of pilot superimposition is employed, where the FTN block is designed to superimpose pilot symbols with information symbols, thereby eliminating the need for dedicated time and frequency resources or guard bands. Furthermore, interference induced by the pilot superimposition is eliminated by invoking a novel scheme, referred to as spectral interference alignment, where a specially-designed data-dependent sequence is subtracted from the transmitted information symbols to achieve interference-free CE. The theoretical mean-square error (MSE) of the proposed CE is derived, confirming that the MSE is no longer affected by interference from the pilot superimposition. Our performance results demonstrate that the proposed CE achieves lower CE errors, better bit-error rates, higher achievable rate, and spectral efficiency with half of the overhead compared with the conventional benchmark.
- 12 February 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal on Selected Areas in Communications
- Vol. 44 (07338716)
Guest Editorial: Special Issue on Recent Advances in Integrated Sensing and Communications—Part III
- 12 February 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal on Selected Areas in Communications
- Vol. 44 (07338716)
Guest Editorial: Special Issue on Recent Advances in Integrated Sensing and Communications—Part III
- 12 February 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal on Selected Areas in Communications
- Vol. 44 (07338716)
Guest Editorial: Special Issue on Recent Advances in Integrated Sensing and Communications—Part I
- 12 February 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal on Selected Areas in Communications
- Vol. 44 (07338716)
Guest Editorial: Special Issue on Recent Advances in Integrated Sensing and Communications—Part I
- Open Access
- 20 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Open Journal of Vehicular Technology
- Vol. 7, 659-675
Delay-Doppler-Domain Channel Estimation and Reduced-Complexity Detection of Faster-Than-Nyquist Signaling Aided OTFS
We conceive a novel channel estimation and data detection scheme for OTFS-modulated faster-than-Nyquist (FTN) transmission over doubly selective fading channels, aiming for enhancing the spectral efficiency and Doppler resilience. The delay-Doppler (DD) domain's input-output relationship of OTFS-FTN signaling is derived by employing a root-raised cosine (RRC) shaping filter. More specifically, we design our DD-domain channel estimator for FTN-based pilot transmission, where the pilot symbol interval is lower than that defined by the classic Nyquist criterion. Moreover, we propose a reduced-complexity linear minimum mean square error equalizer, supporting noise whitening, where the FTN-induced inter-symbol interference (ISI) matrix is approximated by a sparse one. Our performance results demonstrate that the proposed OTFS-FTN scheme is capable of enhancing the achievable information rate, while attaining a comparable BER performance to both that of its Nyquist-based OTFS counterpart and to other FTN transmission schemes, which employ the same RRC shaping filter.
- 20 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Open Journal of Vehicular Technology
- Vol. 7, 659-675
Open AccessDelay-Doppler-Domain Channel Estimation and Reduced-Complexity Detection of Faster-Than-Nyquist Signaling Aided OTFS
We conceive a novel channel estimation and data detection scheme for OTFS-modulated faster-than-Nyquist (FTN) transmission over doubly selective fading channels, aiming for enhancing the spectral efficiency and Doppler resilience. The delay-Doppler (DD) domain's input-output relationship of OTFS-FTN signaling is derived by employing a root-raised cosine (RRC) shaping filter. More specifically, we design our DD-domain channel estimator for FTN-based pilot transmission, where the pilot symbol interval is lower than that defined by the classic Nyquist criterion. Moreover, we propose a reduced-complexity linear minimum mean square error equalizer, supporting noise whitening, where the FTN-induced inter-symbol interference (ISI) matrix is approximated by a sparse one. Our performance results demonstrate that the proposed OTFS-FTN scheme is capable of enhancing the achievable information rate, while attaining a comparable BER performance to both that of its Nyquist-based OTFS counterpart and to other FTN transmission schemes, which employ the same RRC shaping filter.
- Open Access
- 13 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Communications Standards Magazine
- Vol. 10 (2) , 199-207
Faster-Than-Nyquist Signaling for Next-Generation Wireless: Principles, Applications, and Challenges
Future wireless networks are expected to deliver ultra-high throughput for supporting emerging applications. In such scenarios, conventional Nyquist signaling may falter. As a remedy, faster-than-Nyquist (FTN) signaling facilitates the transmission of more symbols than Nyquist signaling without expanding the time-frequency resources. We provide an accessible and structured introduction to FTN signaling, covering its core principles, theoretical foundations, unique advantages, open facets, and its road map. Specifically, we present promising coded FTN results and highlight its compelling advantages in integrated sensing and communications (ISAC), an increasingly critical function in future networks. We conclude with a discussion of open research challenges and promising directions.
- 13 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Communications Standards Magazine
- Vol. 10 (2) , 199-207
Open AccessFaster-Than-Nyquist Signaling for Next-Generation Wireless: Principles, Applications, and Challenges
Future wireless networks are expected to deliver ultra-high throughput for supporting emerging applications. In such scenarios, conventional Nyquist signaling may falter. As a remedy, faster-than-Nyquist (FTN) signaling facilitates the transmission of more symbols than Nyquist signaling without expanding the time-frequency resources. We provide an accessible and structured introduction to FTN signaling, covering its core principles, theoretical foundations, unique advantages, open facets, and its road map. Specifically, we present promising coded FTN results and highlight its compelling advantages in integrated sensing and communications (ISAC), an increasingly critical function in future networks. We conclude with a discussion of open research challenges and promising directions.
- Open Access
- 1 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Internet of Things Journal
- p. 1
Secret Key Generation Assisted by Denoising Autoencoder
- 1 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Internet of Things Journal
- p. 1
Open AccessSecret Key Generation Assisted by Denoising Autoencoder
- Open Access
- 1 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Communications
- Vol. 74, 13301-13316
Skyrmion Number Modulation in Free-Space Optical Communication
- 1 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Communications
- Vol. 74, 13301-13316
Open AccessSkyrmion Number Modulation in Free-Space Optical Communication
- 30 December 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Network
- Vol. PP (08908044) , 1-8
Simultaneous Classical and Quantum Communications: Recent Progress and Three Challenges
A critical aspect of next-generation wireless networks is the integration of quantum communications to guard against quantum computing threats to classical networks. Despite successful experimental demonstrations, integrating quantum communications into the classical infrastructure faces substantial challenges, including high costs, compatibility issues, and extra hardware deployment to accommodate both classical and quantum communication equipment. To mitigate these challenges, we explore novel protocols that enable simultaneous classical and quantum communications, relying on a single set of transceivers to jointly modulate and decode classical and quantum information onto the same signal. Additionally, we emphasize extending quantum communication capabilities beyond traditional optical bands into the terahertz, even possibly to millimeter-wave and microwave frequencies, thereby broadening the potential horizon of quantum-secure applications. Finally, we identify open problems that must be addressed to facilitate practical implementation.
- 30 December 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Network
- Vol. PP (08908044) , 1-8
Simultaneous Classical and Quantum Communications: Recent Progress and Three Challenges
A critical aspect of next-generation wireless networks is the integration of quantum communications to guard against quantum computing threats to classical networks. Despite successful experimental demonstrations, integrating quantum communications into the classical infrastructure faces substantial challenges, including high costs, compatibility issues, and extra hardware deployment to accommodate both classical and quantum communication equipment. To mitigate these challenges, we explore novel protocols that enable simultaneous classical and quantum communications, relying on a single set of transceivers to jointly modulate and decode classical and quantum information onto the same signal. Additionally, we emphasize extending quantum communication capabilities beyond traditional optical bands into the terahertz, even possibly to millimeter-wave and microwave frequencies, thereby broadening the potential horizon of quantum-secure applications. Finally, we identify open problems that must be addressed to facilitate practical implementation.