Keith Whiston
Research Subjects
Keith Whiston has a total of 65 co-authors. Here are the top co-authors by number of shared publications:
- Graham John Hutchings
Cardiff University
6 shared publications - Damien Martin Murphy
Cardiff University
5 shared publications Xi Liu
Cardiff Catalysis Institute School of Chemistry Cardiff University Cardiff CF10 3AT UK
5 shared publications- Alberto V. Puga
Department of Chemical Engineering, Rovira i Virgili University, Av. Països Catalans, 43007 Tarragona, Spain
4 shared publications - Eduardo García-Verdugo
Departamento de Química Inorgánica y Orgánica, Universidad Jaume I, Campus del Riu Sec, E-12071 Castellón, Spain
4 shared publications - H. Q. Nimal Gunaratne
The QUILL Research Centre, School of Chemistry and Chemical Engineering, The Queen’s University of Belfast, Stranmillis Road, Belfast, Northern Ireland BT9 5AG, U.K.
4 shared publications
Latest Publications
- Open Access
- 21 May 2022
- Published by Royal Society of Chemistry (RSC) in Catalysis Science & Technology
- Vol. 12 (17) , 5274-5280
The influence of solvent composition on the coordination environment of the Co/Mn/Br based para-xylene oxidation catalyst as revealed by EPR and ESEEM spectroscopy
The industrially important para-xylene oxidation reaction, based on a Co/Mn/Br catalyst, operates in a water/acetic acid (H2O/AcOH) solvent system.
- 21 May 2022
- Published by Royal Society of Chemistry (RSC) in Catalysis Science & Technology
- Vol. 12 (17) , 5274-5280
Open AccessThe influence of solvent composition on the coordination environment of the Co/Mn/Br based para-xylene oxidation catalyst as revealed by EPR and ESEEM spectroscopy
The industrially important para-xylene oxidation reaction, based on a Co/Mn/Br catalyst, operates in a water/acetic acid (H2O/AcOH) solvent system.
- Open Access
- 29 March 2021
- Published by Springer Nature in Topics in Catalysis
- Vol. 64 (17-20) , 907-915
Oxidative Dehydrogenation of 1-Butene to 1,3-Butadiene Over Metal Ferrite Catalysts
The oxidative dehydrogenation (ODH) of 1-butene to 1,3-butadiene was studied over a series of AFe2O4 catalysts, where A = Zn, Mn, Ni, Cu, Mg and Fe. The catalysts were characterised by XPS, EPR spectroscopy, BET surface area analysis, Raman spectroscopy and XRD. All the ferrites were active for ODH and gave an order of activity after 80 h on-stream of ZnFe2O4 > NiFe2O4 > MnFe2O4 > MgFe2O4 > CuFe2O4 > FeFe2O4. All catalysts lost significant surface area (up to ~ 80%) under reaction conditions of 0.75:1:15 oxygen:1-butene:steam with an overall GHSV of 10,050 h−1 at 693 K. Fe3O4 was unstable under reaction conditions and was converted to Fe2O3, which showed very low activity. Nickel ferrite was the only material that gave carbon dioxide as a significant product, all others were selective to 1,3-butadiene. Zinc ferrite gave a steady-state yield of 1,3-butadiene of ~ 80%. Inversion parameters were determined for the ferrites from XPS and a correlation was obtained between 1,3-butadiene yield and inversion parameter, indicating that Fe3+ in an octahedral hole is a key species in the mechanism of oxidative dehydrogenation. Butene isomerisation and ODH were shown to occur on different sites.
- 29 March 2021
- Published by Springer Nature in Topics in Catalysis
- Vol. 64 (17-20) , 907-915
Open AccessOxidative Dehydrogenation of 1-Butene to 1,3-Butadiene Over Metal Ferrite Catalysts
The oxidative dehydrogenation (ODH) of 1-butene to 1,3-butadiene was studied over a series of AFe2O4 catalysts, where A = Zn, Mn, Ni, Cu, Mg and Fe. The catalysts were characterised by XPS, EPR spectroscopy, BET surface area analysis, Raman spectroscopy and XRD. All the ferrites were active for ODH and gave an order of activity after 80 h on-stream of ZnFe2O4 > NiFe2O4 > MnFe2O4 > MgFe2O4 > CuFe2O4 > FeFe2O4. All catalysts lost significant surface area (up to ~ 80%) under reaction conditions of 0.75:1:15 oxygen:1-butene:steam with an overall GHSV of 10,050 h−1 at 693 K. Fe3O4 was unstable under reaction conditions and was converted to Fe2O3, which showed very low activity. Nickel ferrite was the only material that gave carbon dioxide as a significant product, all others were selective to 1,3-butadiene. Zinc ferrite gave a steady-state yield of 1,3-butadiene of ~ 80%. Inversion parameters were determined for the ferrites from XPS and a correlation was obtained between 1,3-butadiene yield and inversion parameter, indicating that Fe3+ in an octahedral hole is a key species in the mechanism of oxidative dehydrogenation. Butene isomerisation and ODH were shown to occur on different sites.
- Open Access
- 2 June 2020
- Published by Royal Society of Chemistry (RSC) in Catalysis Science & Technology
- Vol. 10 (13) , 4210-4218
Adipic acid formation from cyclohexanediol using platinum and vanadium catalysts: elucidating the role of homogeneous vanadium species
The applicability of platinum and vanadium catalysts for the production of adipic acid from cyclohexanediol is severely limited by the instability of the latter species in liquid phase reactions.
- 2 June 2020
- Published by Royal Society of Chemistry (RSC) in Catalysis Science & Technology
- Vol. 10 (13) , 4210-4218
Open AccessAdipic acid formation from cyclohexanediol using platinum and vanadium catalysts: elucidating the role of homogeneous vanadium species
The applicability of platinum and vanadium catalysts for the production of adipic acid from cyclohexanediol is severely limited by the instability of the latter species in liquid phase reactions.
- Open Access
The Low Temperature Solvent-Free Aerobic Oxidation of Cyclohexene to Cyclohexane Diol over Highly Active Au/Graphite and Au/Graphene Catalysts
The selectivity and activity of gold-catalysts supported on graphite and graphene have been compared in the oxidation of cyclohexene. These catalysts were prepared via impregnation and sol immobilisation methods, and tested using solventless and radical initiator-free reaction conditions. The selectivity of these catalysts has been directed towards cyclohexene epoxide using WO3 as a co-catalyst and further to cyclohexane diol by the addition of water, achieving a maximum selectivity of 17% to the diol. The sol immobilisation catalysts were more reproducible and far more active, however, selectivity towards the diol was lower than for the impregnation catalyst. The results suggest that formation of cyclohexane diol through solventless oxidation of cyclohexene is limited by a number of factors, such as the formation of an allylic hydroperoxyl species as well as the amount of in situ generated water.
Open AccessThe Low Temperature Solvent-Free Aerobic Oxidation of Cyclohexene to Cyclohexane Diol over Highly Active Au/Graphite and Au/Graphene Catalysts
The selectivity and activity of gold-catalysts supported on graphite and graphene have been compared in the oxidation of cyclohexene. These catalysts were prepared via impregnation and sol immobilisation methods, and tested using solventless and radical initiator-free reaction conditions. The selectivity of these catalysts has been directed towards cyclohexene epoxide using WO3 as a co-catalyst and further to cyclohexane diol by the addition of water, achieving a maximum selectivity of 17% to the diol. The sol immobilisation catalysts were more reproducible and far more active, however, selectivity towards the diol was lower than for the impregnation catalyst. The results suggest that formation of cyclohexane diol through solventless oxidation of cyclohexene is limited by a number of factors, such as the formation of an allylic hydroperoxyl species as well as the amount of in situ generated water.
- 8 July 2016
- Published by Wiley in Chemistry – A European Journal
- Vol. 22 (35) , 12290-12294
One‐Step Production of 1,3‐Butadiene from 2,3‐Butanediol Dehydration
We report the direct production of 1,3‐butadiene from the dehydration of 2,3‐butandiol by using alumina as catalyst. Under optimized kinetic reaction conditions, the production of methyl ethyl ketone and isobutyraldehyde, formed via the pinacol–pinacolone rearrangement, was markedly reduced and almost 80 % selectivity to 1,3‐butadiene and 1,3‐butadiene could be achieved. The presence of water plays a critical role in the inhibition of oligomerization. The amphoteric nature of γ‐Al2O3 was identified as important and this contributed to the improved catalytic selectivity when compared with other acidic catalysts.
- 8 July 2016
- Published by Wiley in Chemistry – A European Journal
- Vol. 22 (35) , 12290-12294
One‐Step Production of 1,3‐Butadiene from 2,3‐Butanediol Dehydration
We report the direct production of 1,3‐butadiene from the dehydration of 2,3‐butandiol by using alumina as catalyst. Under optimized kinetic reaction conditions, the production of methyl ethyl ketone and isobutyraldehyde, formed via the pinacol–pinacolone rearrangement, was markedly reduced and almost 80 % selectivity to 1,3‐butadiene and 1,3‐butadiene could be achieved. The presence of water plays a critical role in the inhibition of oligomerization. The amphoteric nature of γ‐Al2O3 was identified as important and this contributed to the improved catalytic selectivity when compared with other acidic catalysts.
- 9 December 2015
- Published by Springer Nature in Catalysis Letters
- Vol. 146 (1) , 126-135
Insights into the Reaction Mechanism of Cyclohexane Oxidation Catalysed by Molybdenum Blue Nanorings
- 9 December 2015
- Published by Springer Nature in Catalysis Letters
- Vol. 146 (1) , 126-135
Insights into the Reaction Mechanism of Cyclohexane Oxidation Catalysed by Molybdenum Blue Nanorings
- 1 September 2015
- Published by Elsevier in Applied Catalysis A: General
- Vol. 504, 373-380
Liquid phase oxidation of cyclohexane using bimetallic Au–Pd/MgO catalysts
- 1 September 2015
- Published by Elsevier in Applied Catalysis A: General
- Vol. 504, 373-380
Liquid phase oxidation of cyclohexane using bimetallic Au–Pd/MgO catalysts
- 28 January 2015
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 17 (16) , 10398-10416
3-Methylpiperidinium ionic liquids
Ionic liquids based on the 3-methylpiperidinium cation core exhibit little or no tendency to crystallise upon cooling and high electrochemical stabilities.
- 28 January 2015
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 17 (16) , 10398-10416
3-Methylpiperidinium ionic liquids
Ionic liquids based on the 3-methylpiperidinium cation core exhibit little or no tendency to crystallise upon cooling and high electrochemical stabilities.
- 23 October 2014
- Published by Royal Society of Chemistry (RSC) in Catalysis Science & Technology
- Vol. 5 (1) , 217-227
Molybdenum blue nano-rings: an effective catalyst for the partial oxidation of cyclohexane
Molybdenum blue (MB), a multivalent molybdenum oxide with a nano-ring morphology is well-known in analytical chemistry but, to date it has been largely ignored in other applications.
- 23 October 2014
- Published by Royal Society of Chemistry (RSC) in Catalysis Science & Technology
- Vol. 5 (1) , 217-227
Molybdenum blue nano-rings: an effective catalyst for the partial oxidation of cyclohexane
Molybdenum blue (MB), a multivalent molybdenum oxide with a nano-ring morphology is well-known in analytical chemistry but, to date it has been largely ignored in other applications.
- 8 March 2013
- Published by Royal Society of Chemistry (RSC) in Green Chemistry
- Vol. 15 (5) , 1166-1172
Production of polyetheretherketone in ionic liquid media
Polyetheretherketones were successfully synthesised in an ionic liquid, namely 1-butyl-3-methylimidazolium bis{(trifluoromethyl)sulfonyl}amide, by polycondensation reactions of hydroquinone with 4,4′-dihalobenzophenones in the presence of potassium carbonate at elevated temperatures (up to 320 °C). The materials thus produced were similar to polymers prepared in the solvent usually employed in commercial processes, i.e. diphenyl sulfone, as suggested by spectroscopic techniques and X-ray crystallography. By replacing volatile diphenyl sulfone with the effectively involatile ionic liquid, the separation efficiency was significantly improved but the molecular weights were lower.
- 8 March 2013
- Published by Royal Society of Chemistry (RSC) in Green Chemistry
- Vol. 15 (5) , 1166-1172
Production of polyetheretherketone in ionic liquid media
Polyetheretherketones were successfully synthesised in an ionic liquid, namely 1-butyl-3-methylimidazolium bis{(trifluoromethyl)sulfonyl}amide, by polycondensation reactions of hydroquinone with 4,4′-dihalobenzophenones in the presence of potassium carbonate at elevated temperatures (up to 320 °C). The materials thus produced were similar to polymers prepared in the solvent usually employed in commercial processes, i.e. diphenyl sulfone, as suggested by spectroscopic techniques and X-ray crystallography. By replacing volatile diphenyl sulfone with the effectively involatile ionic liquid, the separation efficiency was significantly improved but the molecular weights were lower.