Ji Chen
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Ji Chen has a total of 62 co-authors. Here are the top co-authors by number of shared publications:
Yuefeng Deng
15 shared publicationsDeqian Li
9 shared publicationsYu Liu
State Key Laboratory of Rare Earth Resources Utilization, Changchun Institute of Applied Chemistry, Chinese Academy of Sciences , Changchun, Jilin 130022, China
9 shared publicationsLili Zhu
State Key Laboratory of Rare Earth Resource Utilization, Changchun Institute of Applied Chemistry, Chinese Academy of Science, Changchun 130022, PR China
8 shared publicationsYinghui Liu
State Key Laboratory of Rare Earth Resources Utilization, Changchun Institute of Applied Chemistry, Chinese Academy of Sciences, 5625 Renmin Street, Changchun 130022, PR China
8 shared publicationsDongli Zhang
State Key Laboratory of Rare Earth Resources Utilization, Changchun Institute of Applied Chemistry, Chinese Academy of Sciences, 5625 Renmin Street, Changchun 130022, China
6 shared publications
Latest Publications
- Open Access
- 14 October 2026
- Published by Elsevier in SSRN Electronic Journal
Enhanced extraction and selective separation of lutetium in a P113–dimethyl sulfoxide nonaqueous system
A nonaqueous chloride extraction system comprising dimethyl sulfoxide (DMSO) as the more polar phase and P113 in n-dodecane as the less polar phase was developed to recover lutetium selectively from solutions containing other metals. The effects of chloride salts and water content on metal selectivity were examined. Lu extraction was higher from DMSO than from ethylene glycol or water, and LiCl further enhanced extraction to nearly 99% at low water contents. Adjusting the water content to 50% (v/v) in the LiCl-containing system increased the Lu/Yb separation factor to 2.32 without an additional complexing agent. In binary Lu/Al solutions containing 1.0 mol L-1 LiCl, approximately 90% of Lu was extracted while Al coextraction remained below 8%, giving a Lu/Al separation factor of 110.94. In multimetal solutions, Lu extraction reached approximately 97%, whereas the extraction of Mn, Co, Ni, Cu, and Zn remained below approximately 10%. Nearly 99% of both metals could be stripped from the Lu/Yb-loaded P113 phase using 0.2 mol L-1 HCl. Er(III) absorption spectra, extractant concentration dependence, and FTIR results support the combined roles of changes in the local environment in the more polar phase and coordination through the phosphoryl oxygen in metal transfer. The overall extraction process was exothermic. These results distinguish the roles of chloride salts in enhancing Lu recovery and Lu/Al separation from that of water in controlling Lu/Yb selectivity, demonstrating how polar-phase composition can be used to tune selective Lu extraction with a neutral phosphine oxide extractant.
- 14 October 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessEnhanced extraction and selective separation of lutetium in a P113–dimethyl sulfoxide nonaqueous system
A nonaqueous chloride extraction system comprising dimethyl sulfoxide (DMSO) as the more polar phase and P113 in n-dodecane as the less polar phase was developed to recover lutetium selectively from solutions containing other metals. The effects of chloride salts and water content on metal selectivity were examined. Lu extraction was higher from DMSO than from ethylene glycol or water, and LiCl further enhanced extraction to nearly 99% at low water contents. Adjusting the water content to 50% (v/v) in the LiCl-containing system increased the Lu/Yb separation factor to 2.32 without an additional complexing agent. In binary Lu/Al solutions containing 1.0 mol L-1 LiCl, approximately 90% of Lu was extracted while Al coextraction remained below 8%, giving a Lu/Al separation factor of 110.94. In multimetal solutions, Lu extraction reached approximately 97%, whereas the extraction of Mn, Co, Ni, Cu, and Zn remained below approximately 10%. Nearly 99% of both metals could be stripped from the Lu/Yb-loaded P113 phase using 0.2 mol L-1 HCl. Er(III) absorption spectra, extractant concentration dependence, and FTIR results support the combined roles of changes in the local environment in the more polar phase and coordination through the phosphoryl oxygen in metal transfer. The overall extraction process was exothermic. These results distinguish the roles of chloride salts in enhancing Lu recovery and Lu/Al separation from that of water in controlling Lu/Yb selectivity, demonstrating how polar-phase composition can be used to tune selective Lu extraction with a neutral phosphine oxide extractant.
- Open Access
- 11 May 2026
- Published by Elsevier in SSRN Electronic Journal
Highly selective removal of transition metal impurities from non-aqueous media using an imidazolium-functionalized gel-type anion exchange resin
The efficient removal of trace transition metal impurities from high-ionic-strength complex matrices remains a critical challenge in the preparation of advanced material precursors. To overcome the limited selectivity of conventional separation systems under highly competitive conditions, a non-aqueous deep purification strategy based on a gel-type N-methylimidazolium-functionalized anion exchange resin (G-MIMCl) was developed. Results indicated that in anhydrous ethanol systems, transition metal impurities such as Fe(III) were readily converted into polychlorinated anionic species, which were effectively captured by the resin, with an equilibrium adsorption capacity for Fe(III) exceeding 120 mg g-1. Simultaneously, the gel-type framework of G-MIMCl effectively inhibited the non-exchangeable co-adsorption of bulky neutral host metal ion pairs, thereby achieving selective impurity removal with minimal host metal loss. Under strong background salt conditions of up to 0.4 M TmCl3, G-MIMCl exhibited impurity removal performance significantly superior to that of the commercial strongly basic resin IRA-402, demonstrating exceptional resistance to matrix interference. Notably, when applied to a real high-ionic-strength TmCl3 ethanol feed (~110 g L-1), G-MIMCl enabled the simultaneous deep removal of multiple trace impurities. The predominant Fe impurity decreased from 911.63 to 52.13 µg L-1, while the residual levels of Zn, Cu, Co, and Mn were all below 10 µg L-1. This strategy achieves the synergistic removal of multiple transition metal impurities in complex non-aqueous high-salt systems, offering a viable and reusable pathway for low-loss deep purification under strong background interference.
- 11 May 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessHighly selective removal of transition metal impurities from non-aqueous media using an imidazolium-functionalized gel-type anion exchange resin
The efficient removal of trace transition metal impurities from high-ionic-strength complex matrices remains a critical challenge in the preparation of advanced material precursors. To overcome the limited selectivity of conventional separation systems under highly competitive conditions, a non-aqueous deep purification strategy based on a gel-type N-methylimidazolium-functionalized anion exchange resin (G-MIMCl) was developed. Results indicated that in anhydrous ethanol systems, transition metal impurities such as Fe(III) were readily converted into polychlorinated anionic species, which were effectively captured by the resin, with an equilibrium adsorption capacity for Fe(III) exceeding 120 mg g-1. Simultaneously, the gel-type framework of G-MIMCl effectively inhibited the non-exchangeable co-adsorption of bulky neutral host metal ion pairs, thereby achieving selective impurity removal with minimal host metal loss. Under strong background salt conditions of up to 0.4 M TmCl3, G-MIMCl exhibited impurity removal performance significantly superior to that of the commercial strongly basic resin IRA-402, demonstrating exceptional resistance to matrix interference. Notably, when applied to a real high-ionic-strength TmCl3 ethanol feed (~110 g L-1), G-MIMCl enabled the simultaneous deep removal of multiple trace impurities. The predominant Fe impurity decreased from 911.63 to 52.13 µg L-1, while the residual levels of Zn, Cu, Co, and Mn were all below 10 µg L-1. This strategy achieves the synergistic removal of multiple transition metal impurities in complex non-aqueous high-salt systems, offering a viable and reusable pathway for low-loss deep purification under strong background interference.
- 2 February 2026
- Published by American Chemical Society (ACS) in ACS Sustainable Resource Management
- Vol. 3 (2) , 602-608
Effective and Eco-friendly Lithium Recovery from High Mg/Li Ratio Brine by DEHEHP and P507
The global surge in lithium demand, driven by the lithium-ion battery (LIBs) industry, has intensified the need to develop domestic resources. In China, the focus has turned to the salt lakes of the Qinghai-Tibet Plateau. However, their high Mg/Li ratio has prevented commercial extraction. While cost-effective, the solvent extraction method faces industrial limitations due to extractant loss and the need for acidic stripping. This study introduces an eco-friendly extraction system using di(2-ethylhexyl)-2-ethylhexyl phosphonate and di-(2-ethylhexyl) phosphoric acid (DEHEHP-P507). In this system, DEHEHP minimizes dissolution loss, while P507 enables efficient stripping with water. A process involving eight-stage extraction and two-stage stripping was tested on brine from the Daqai dam salt lake, achieving a lithium recovery rate of >97.5%. The Li+ concentration was enriched by approximately 6-fold in the stripping liquor, while the Mg/Li ratio was drastically reduced from 87.89 to 1.41, a 62-fold decrease. Finally, Li2CO3 with a purity of >98% was produced. By completely avoiding contact with acids and alkalis, the DEHEHP-P507 system proves to be an efficient and sustainable method for lithium recovery from high Mg/Li ratio brines, demonstrating significant industrial potential.
- 2 February 2026
- Published by American Chemical Society (ACS) in ACS Sustainable Resource Management
- Vol. 3 (2) , 602-608
Effective and Eco-friendly Lithium Recovery from High Mg/Li Ratio Brine by DEHEHP and P507
The global surge in lithium demand, driven by the lithium-ion battery (LIBs) industry, has intensified the need to develop domestic resources. In China, the focus has turned to the salt lakes of the Qinghai-Tibet Plateau. However, their high Mg/Li ratio has prevented commercial extraction. While cost-effective, the solvent extraction method faces industrial limitations due to extractant loss and the need for acidic stripping. This study introduces an eco-friendly extraction system using di(2-ethylhexyl)-2-ethylhexyl phosphonate and di-(2-ethylhexyl) phosphoric acid (DEHEHP-P507). In this system, DEHEHP minimizes dissolution loss, while P507 enables efficient stripping with water. A process involving eight-stage extraction and two-stage stripping was tested on brine from the Daqai dam salt lake, achieving a lithium recovery rate of >97.5%. The Li+ concentration was enriched by approximately 6-fold in the stripping liquor, while the Mg/Li ratio was drastically reduced from 87.89 to 1.41, a 62-fold decrease. Finally, Li2CO3 with a purity of >98% was produced. By completely avoiding contact with acids and alkalis, the DEHEHP-P507 system proves to be an efficient and sustainable method for lithium recovery from high Mg/Li ratio brines, demonstrating significant industrial potential.
- 11 September 2025
- Published by American Chemical Society (ACS) in ACS Sustainable Resource Management
- Vol. 2 (9) , 1742-1750
Efficient Recovery of Gallium and Iron from the Acid Leaching Solution of NdFeB Waste Based on Solvent Extraction
- 11 September 2025
- Published by American Chemical Society (ACS) in ACS Sustainable Resource Management
- Vol. 2 (9) , 1742-1750
Efficient Recovery of Gallium and Iron from the Acid Leaching Solution of NdFeB Waste Based on Solvent Extraction
- 27 June 2024
- Published by Elsevier in Separation and Purification Technology
- Vol. 353
A novel magnesium reduction technique for the separation of ytterbium from non-aqueous solutions
- 27 June 2024
- Published by Elsevier in Separation and Purification Technology
- Vol. 353
A novel magnesium reduction technique for the separation of ytterbium from non-aqueous solutions
- 1 January 2022
- Published by Elsevier in Separation and Purification Technology
- Vol. 280, 119929
An innovative technique for the separation of ion-adsorption high yttrium rare earth ore by Er (III) / Tm (III) grouping first
- 1 January 2022
- Published by Elsevier in Separation and Purification Technology
- Vol. 280, 119929
An innovative technique for the separation of ion-adsorption high yttrium rare earth ore by Er (III) / Tm (III) grouping first