Ramón Castañer
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Ramón Castañer has a total of 61 co-authors. Here are the top co-authors by number of shared publications:
C. Prieto
Instituto de Ciencia de Materiales de Madrid, C.S.I.C. Cantoblanco, 28049-MADRID, Spain
5 shared publications- Jose Luis Martinez
Instituto de Ciencia de Materiales de Madrid, CSIC, Cantoblanco, 28049 Madrid, Spain
4 shared publications A. de Andrés
3 shared publicationsC Prieto
3 shared publications- Eduardo Yubero
Atmospheric Pollution Laboratory (LCA), Department of Applied Physics, Miguel Hernández University, Avenida de la Universidad S/N, 03202, Elche, Spain
3 shared publications J. Crespo
3 shared publications
Latest Publications
- 1 September 2019
- Published by Elsevier in Atmospheric Environment
- Vol. 213, 250-257
Analysis of aerosol scattering properties and PM10 concentrations at a mountain site influenced by mineral dust transport
- 1 September 2019
- Published by Elsevier in Atmospheric Environment
- Vol. 213, 250-257
Analysis of aerosol scattering properties and PM10 concentrations at a mountain site influenced by mineral dust transport
- 1 September 2018
- Published by Elsevier in Atmospheric Research
- Vol. 210, 100-109
Seasonal variability of aerosol absorption parameters at a remote site with high mineral dust loads
- 1 September 2018
- Published by Elsevier in Atmospheric Research
- Vol. 210, 100-109
Seasonal variability of aerosol absorption parameters at a remote site with high mineral dust loads
- 1 November 2017
- Published by Elsevier in Atmospheric Research
- Vol. 197, 244-254
Influence of air mass origins on optical properties and PM concentrations measured at a high mountain station located in the southwestern Mediterranean
- 1 November 2017
- Published by Elsevier in Atmospheric Research
- Vol. 197, 244-254
Influence of air mass origins on optical properties and PM concentrations measured at a high mountain station located in the southwestern Mediterranean
- 1 January 2015
- Published by Springer Nature in Aerosol and Air Quality Research
- Vol. 15 (5) , 2150-2157
Real-Time Measurements of Ozone and UV Radiation during Pyrotechnic Displays
- 1 January 2015
- Published by Springer Nature in Aerosol and Air Quality Research
- Vol. 15 (5) , 2150-2157
Real-Time Measurements of Ozone and UV Radiation during Pyrotechnic Displays
- 1 January 2010
- Published by Elsevier in Atmospheric Environment
- Vol. 44 (3) , 338-346
Influence of Saharan dust outbreaks and atmospheric stability upon vertical profiles of size-segregated aerosols and water vapor
- 1 January 2010
- Published by Elsevier in Atmospheric Environment
- Vol. 44 (3) , 338-346
Influence of Saharan dust outbreaks and atmospheric stability upon vertical profiles of size-segregated aerosols and water vapor
- 4 December 2008
- Published by Royal Society of Chemistry (RSC) in Journal of Environmental Monitoring
- Vol. 11 (2) , 394-399
Characterization of events by aerosol mass size distributions
Continous measurements of particle mass size distributions were carried out in summer 2004 at an urban location in the western Mediterranean using an optical particle counter. In this work we propose a simple methodology to identify PM episodes and determine their influence on mass size distributions. During the study period three types of event produced a significant increase in TSP daily levels: Saharan dust intrusions, firework displays and strong winds, modifying size distributions in different ways. As well, a traffic-related mass size spectrum was obtained showing road dust particles injected into the atmosphere by vehicle-induced resuspension having mainly aerodynamic diameters between 5 and 15 µm. This was confirmed by principal component and conditional probability function analyses.
- 4 December 2008
- Published by Royal Society of Chemistry (RSC) in Journal of Environmental Monitoring
- Vol. 11 (2) , 394-399
Characterization of events by aerosol mass size distributions
Continous measurements of particle mass size distributions were carried out in summer 2004 at an urban location in the western Mediterranean using an optical particle counter. In this work we propose a simple methodology to identify PM episodes and determine their influence on mass size distributions. During the study period three types of event produced a significant increase in TSP daily levels: Saharan dust intrusions, firework displays and strong winds, modifying size distributions in different ways. As well, a traffic-related mass size spectrum was obtained showing road dust particles injected into the atmosphere by vehicle-induced resuspension having mainly aerodynamic diameters between 5 and 15 µm. This was confirmed by principal component and conditional probability function analyses.
- 1 June 2006
- Published by American Association of Physics Teachers (AAPT) in American Journal of Physics
- Vol. 74 (6) , 510-513
The magnetic dipole interaction as measured by spring dynamometers
- 1 June 2006
- Published by American Association of Physics Teachers (AAPT) in American Journal of Physics
- Vol. 74 (6) , 510-513
The magnetic dipole interaction as measured by spring dynamometers
- 18 November 2003
- Published by SPIE-Intl Soc Optical Eng
- Vol. 4829, 797-799
Yttrium hydride films as switchable mirrors: optical characterization and electronic structure
The development of switchable mirrors based on yttrium hydride thin films is shown. Yttrium is deposited on regular glass under ultra-high vacuum conditions. Upon hydrogen pressure the transition from light-reflecting metal YH2 to transparent insulating YH3 is induced. Surface and optical characterization is performed to improve the deposition and hydrogenation conditions. A good variable transparency is achieved, with transmittance up to 70% in the visible range for the completely hydrogenated sample. The electronic structure of the YH3 phase is calculated by considering strong correlation corrections to the crystal potential. We obtain a gap in the quasiparticle spectrum that agrees with the optical transmittance of the YH3 phase. A prototype device based on these films is proposed.
- 18 November 2003
- Published by SPIE-Intl Soc Optical Eng
- Vol. 4829, 797-799
Yttrium hydride films as switchable mirrors: optical characterization and electronic structure
The development of switchable mirrors based on yttrium hydride thin films is shown. Yttrium is deposited on regular glass under ultra-high vacuum conditions. Upon hydrogen pressure the transition from light-reflecting metal YH2 to transparent insulating YH3 is induced. Surface and optical characterization is performed to improve the deposition and hydrogenation conditions. A good variable transparency is achieved, with transmittance up to 70% in the visible range for the completely hydrogenated sample. The electronic structure of the YH3 phase is calculated by considering strong correlation corrections to the crystal potential. We obtain a gap in the quasiparticle spectrum that agrees with the optical transmittance of the YH3 phase. A prototype device based on these films is proposed.
- 1 August 2002
- Published by Wiley in Surface and Interface Analysis
- Vol. 34 (1) , 311-315
Surface and optical characterization of yttrium hydride films deposited on regular glass to be used as switchable mirrors
Yttrium and palladium thin films deposited on glass have been characterized by means of XPS depth profiling, SEM, energy‐dispersive x‐ray spectroscopy and ultraviolet–visible spectroscopy. These films allow optical windows of variable transparency to be obtained based on the formation of yttrium hydride by hydrogenation, with the palladium film working as a barrier against yttrium oxidation but being permeable to hydrogen. The transformation of yttrium into its hydride is concomitant with a metal–semiconducting transition that changes the physical properties of the material, especially its optical behaviour: the transmittance in the visible range goes from 0% for the metallic state to 30–70% for the hydrogenated state. In this work, the preparation conditions of optical windows using low‐cost regular glass as substrate have been optimized, both regarding the deposition and the hydrogenation. Uniform films free of impurities, such as oxygen and carbon, have been obtained under ultrahigh vacuum conditions of ∼10 −7 Pa. Deposition has been performed by electron bombardment of the material, using palladium and yttrium of high purity. Copyright © 2002 John Wiley & Sons, Ltd.
- 1 August 2002
- Published by Wiley in Surface and Interface Analysis
- Vol. 34 (1) , 311-315
Surface and optical characterization of yttrium hydride films deposited on regular glass to be used as switchable mirrors
Yttrium and palladium thin films deposited on glass have been characterized by means of XPS depth profiling, SEM, energy‐dispersive x‐ray spectroscopy and ultraviolet–visible spectroscopy. These films allow optical windows of variable transparency to be obtained based on the formation of yttrium hydride by hydrogenation, with the palladium film working as a barrier against yttrium oxidation but being permeable to hydrogen. The transformation of yttrium into its hydride is concomitant with a metal–semiconducting transition that changes the physical properties of the material, especially its optical behaviour: the transmittance in the visible range goes from 0% for the metallic state to 30–70% for the hydrogenated state. In this work, the preparation conditions of optical windows using low‐cost regular glass as substrate have been optimized, both regarding the deposition and the hydrogenation. Uniform films free of impurities, such as oxygen and carbon, have been obtained under ultrahigh vacuum conditions of ∼10 −7 Pa. Deposition has been performed by electron bombardment of the material, using palladium and yttrium of high purity. Copyright © 2002 John Wiley & Sons, Ltd.
- 1 July 2001
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 323-324, 102-106
Local structure around Fe and Cu ions in PrBaFeCuO5+δ
- 1 July 2001
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 323-324, 102-106
Local structure around Fe and Cu ions in PrBaFeCuO5+δ