JWJenny Pui Shan Wong

Jenny Pui Shan Wong

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Jenny Pui Shan Wong has a total of 118 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Oxidative potential of fine particulate matter emitted from traditional and improved biomass cookstoves

    by Bradley H. Isenor, Jillian P. Downey, Samuel A. Whidden, Megan M. Fitzgerald, Jenny P. S. Wong

    Reduced PM2.5 emissions from improved cookstoves do not necessarily equate to reduced exposure to toxic PM2.5, due to changes in PM2.5 chemical composition and toxic potency.


  • Fine Particle Iron in Soils and Road Dust Is Modulated by Coal-Fired Power Plant Sulfur

    by Jenny Pui Shan Wong, Yuhan Yang, Ting Fang, James A. Mulholland, Armistead G. Russell, Stefanie Ebelt, Athanasios Nenes, Rodney J. Weber

    Transition metal ions, such as water-soluble iron (WS-Fe), are toxic components of fine particles (PM2.5). In Atlanta from 1998 to 2013, a previous study found that WS-Fe was the PM2.5 species most associated with adverse cardiovascular outcomes. We examined this data set to investigate the sources of WS-Fe and effects of air quality regulations on ambient levels of WS-Fe. We find insoluble forms of iron in mineral and road dust combined with sulfate from coal-fired electrical generating units were converted to soluble forms by sulfate-driven acid-dissolution. Sulfate produced both the highly acidic aerosol (summer pH 1.5-2) and liquid water required for the aqueous phase acid-dissolution, but variability in WS-Fe was mainly driven by particle liquid water. These processes were more pronounced in summer when particles were most acidic, whereas in winter the relative importance of WS-Fe from combustion emissions increased. Although WS-Fe constituted a minute fraction of PM2.5 mass (0.15%), the WS-Fe-PM2.5 mass correlation was high (r=0.67) and may be explained by these formation routes, which in part, could account for observed associations between PM2.5 mass and adverse health seen in past studies. Similar processes are expected in many regions, implying these unexpected benefits from coal-burning reduction may be widespread.


  • Open Access

    Chemical Composition and Toxicity of Particles Emitted from a Consumer-Level 3D Printer Using Various Materials

    by Qian Zhang, Michal Pardo, Yinon Rudich, Ifat Kaplan-Ashiri, Jenny Pui Shan Wong, Aika Yano Davis, Marilyn S. Black, Rodney J. Weber

    Consumer-level 3D printers emit ultrafine and fine particles, though little is known about their chemical composition or potential toxicity. We report on chemical characteristics of the particles in comparison to raw filaments, and assessments of particle toxicity. Particles emitted from polylactic acid (PLA) appeared to be largely composed of the bulk filament material with mass spectra similar to the PLA monomer spectra. Acrylonitrile butadiene styrene (ABS), extruded at a higher temperature than PLA, emitted vastly more particles and their composition differed from that of the bulk filament, suggesting that trace additives may control particle formation. In vitro cellular assays and in vivo mice exposure all showed toxic responses when exposed to PLA and ABS-emitted particles, where PLA-emitted particles elicited higher response levels than ABS-emitted particles at comparable mass doses. A chemical assay widely used in ambient air-quality studies showed particles from various filament materials had comparable particle oxidative potentials, slightly lower than those of ambient particulate matter (PM2.5). However, particle emissions from ABS filaments are likely more detrimental when considering overall exposure due to much higher emissions. Our results suggest that 3D printer particle emissions are not benign and exposures should be minimized.


  • Open Access

    Atmospheric evolution of molecular-weight-separated brown carbon from biomass burning

    by Jenny P. S. Wong, Maria Tsagkaraki, Irini Tsiodra, Nikolaos Mihalopoulos, Kalliopi Violaki, Maria Kanakidou, Jean Sciare, Athanasios Nenes, Rodney J. Weber

    Biomass burning is a major source of atmospheric brown carbon (BrC), and through its absorption of UV/VIS radiation, it can play an important role in the planetary radiative balance and atmospheric photochemistry. The considerable uncertainty of BrC impacts is associated with its poorly constrained sources, transformations, and atmospheric lifetime. Here we report laboratory experiments that examined changes in the optical properties of the water-soluble (WS) BrC fraction of laboratory-generated biomass burning particles from hardwood pyrolysis. Effects of direct UVB photolysis and OH oxidation in the aqueous phase on molecular-weight-separated BrC were studied. Results indicated that the majority of low-molecular-weight (MW) BrC (10 h) biomass burning emissions, poor linear correlations were found between light absorptivity and levoglucosan, consistent with other studies suggesting a short atmospheric lifetime for levoglucosan. However, a much stronger correlation between light absorptivity and total hydrous sugars was observed, suggesting that they may serve as more robust tracers for aged biomass burning emissions. Overall, the results from this study suggest that robust model estimates of BrC radiative impacts require consideration of the atmospheric aging of BrC and the stability of high-MW BrC.


  • Effects of Atmospheric Processing on the Oxidative Potential of Biomass Burning Organic Aerosols

    by Jenny Pui Shan Wong, Maria Tsagkaraki, Irini Tsiodra, Nikolaos Mihalopoulos, Kalliopi Violaki, Maria Kanakidou, Jean Sciare, Athanasios Nenes, Rodney J. Weber

    Oxidative potential (OP), which is the ability of certain components in atmospheric particles to generate reactive oxidative species (ROS) and deplete antioxidants in-vivo, is a prevailing toxicological mechanism underlying the adverse health effects associated with exposure to ambient aerosols. While previous studies have identified the high OP of fresh biomass burning organic aerosols (BBOA), it remains unclear how it evolves throughout atmospheric transport. Using the dithiothreitol (DTT) assay as a measure of OP, a combination of field observations and laboratory experiments is used to determine how atmospheric aging transforms the intrinsic OP (OPDTTmass) of BBOA. For ambient BBOA collected during the fire seasons in Greece, OPDTTmass was observed to increase by a factor of 2.1 ± 0.9 for samples of atmospheric ages up to 68 hours. Laboratory experiments indicate that aqueous photochemical aging (aging by UVB and UVA photolysis; as well as OH oxidation), as well as aging by ozone and atmospheric dilution can transform the OPDTTmass of the water-soluble fraction of wood smoke within 2 days of atmospheric transport. The results from this work suggest that the air quality impacts of biomass burning emissions can extend beyond regions near fire sites and should be accounted for.


  • Open Access

    Supplementary material to "Atmospheric Evolution of Molecular Weight Separated Brown Carbon from Biomass Burning"

    by Jenny P. S. Wong, Maria Tsagaraki, Irini Tsiodra, Nikolaos Mihalopoulos, Kalliopi Violaki, Maria Kanakidou, Jean Sciare, Athanasios Nenes, Rodney J. Weber


  • Open Access

    Atmospheric Evolution of Molecular Weight Separated Brown Carbon from Biomass Burning

    by Jenny P. S. Wong, Maria Tsagaraki, Irini Tsiodra, Nikolaos Mihalopoulos, Kalliopi Violaki, Maria Kanakidou, Jean Sciare, Athanasios Nenes, Rodney J. Weber

    Biomass burning is a major source of atmospheric brown carbon (BrC) and through its absorption of UV/VIS radiation, it can play an important role on the planetary radiative balance and atmospheric photochemistry. The considerable uncertainty of BrC impacts is associated with its poorly constrained sources, transformations and atmospheric lifetime. Here we report laboratory experiments that examined changes in the optical properties of the water-soluble BrC fraction of biomass burning particles. Effects of direct UVB photolysis and OH oxidation in the aqueous phase on molecular weight-separated BrC were studied. Results indicated that low molecular weight (MW) BrC ( 10 hours) biomass burning emissions, poor linear correlations were found between light absorptivity and levoglucosan, consistent with other studies suggesting a short atmospheric lifetime for levoglucosan. However, a much stronger correlation between light absorptivity and total hydrous sugars was observed, suggesting that they may serve as more robust tracers for aged biomass burning emissions. Overall, the results from this study suggest that robust model estimates of BrC radiative impacts require consideration of the atmospheric aging of BrC and the stability of high-MW BrC.


  • Investigating particle emissions and aerosol dynamics from a consumer fused deposition modeling 3D printer with a lognormal moment aerosol model

    by Qian Zhang, Girish Sharma, Jenny P. S. Wong, Aika Y. Davis, Marilyn S. Black, Pratim Biswas, Rodney J. Weber

    Particle emissions from consumer-fused deposition modeling 3D printers have been reported previously; however, the complex processes leading to observed aerosols have not been investigated. We measured particle concentrations and size distributions between 7 nm and 25 μm emitted from a 3D printer under different conditions in an emission test chamber. The experimental data was combined with a moment lognormal aerosol dynamic model to better understand particle formation and subsequent evolution mechanisms. The model was based on particles being formed from nucleation of unknown semivolatile compounds emitted from the heated filament during printing, which evolve due to condensation of emitted vapors and coagulation, all within a small volume near the printer extruder nozzle. The model captured observed steady state particle number size distribution parameters (total number, geometric mean diameter and geometric standard deviation) with errors nominally within 20%. Model solutions provided a range of vapor generation rates, saturation vapor pressures and vapor condensation factors consistent with measured steady state particle concentrations and size distributions. Vapor generation rate was a crucial factor that was linked to printer extruder temperature and largely accounted for differences between filament material and brands. For the unknown condensing vapor species, saturation vapor pressures were in the range of 10−3 to 10−1 Pa. The model suggests particles could be removed by design of collection surfaces near the extruder tip. Copyright © 2018 American Association for Aerosol Research


  • Changes in Light Absorptivity of Molecular Weight Separated Brown Carbon Due to Photolytic Aging

    by Jenny P. S. Wong, Athanasios Nenes, Rodney J. Weber

    Brown carbon (BrC) consists of those organic compounds in atmospheric aerosols that absorb solar radiation and may play an important role in planetary radiative forcing and climate. However, little is known about the production and loss mechanisms of BrC in the atmosphere. Here, we study how the light absorptivity of BrC from wood smoke and secondary BrC generated from the reaction of ammonium sulfate with methylglyoxal changes under photolytic aging by UVA radiation in the aqueous phase. Owing to its chemical complexity, BrC is separated by molecular weight using size exclusion chromatography, and the response of each molecular weight fraction to aging is studied. Photolytic aging induced significant changes in the light absorptivity of BrC for all molecular weight fractions; secondary BrC was rapidly photoblenched, whereas for wood smoke BrC, both photoenhancement and photobleaching were observed. Initially, large biomass burning BrC molecules were rapidly photoenhanced, followed by slow photolysis. As a result, large BrC molecules dominated the total light absorption of aged biomass burning BrC. These experimental results further support earlier observations that large molecular weight BrC compounds from biomass burning can be relatively long-lived components in atmospheric aerosols, thus more likely to have larger impacts on aerosol radiative forcing and could serve as biomass burning tracers.