Atsushi Iizuka
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Atsushi Iizuka has a total of 93 co-authors. Here are the top co-authors by number of shared publications:
Hideki Ohta
Research and Development Initiative, Chuo University, Tokyo, Japan
9 shared publications- Hideki Ohta
東京工業大学 工学部開発システム工学
7 shared publications Katsuyuki Kawai
Department of Civil and Environmental Engineering, Kinki University, Osaka, Japan
7 shared publications- Katsuyuki Kawai
Kobe University
7 shared publications - Shinya Tachibana
Saitama University
6 shared publications K Kawai
5 shared publications
Latest Publications
- Open Access
- 27 May 2022
- Published by Elsevier in Soils and Foundations
- Vol. 62 (4) , 101161
Constitutive model for swelling properties of unsaturated bentonite buffer materials during saturation
- 27 May 2022
- Published by Elsevier in Soils and Foundations
- Vol. 62 (4) , 101161
Open AccessConstitutive model for swelling properties of unsaturated bentonite buffer materials during saturation
- 31 August 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE/ASME Transactions on Mechatronics
- Vol. 26 (6) , 2881-2887
Automatic Construction of Three-Dimensional Ground Model by Data Processing
There have been attempts to improve the operational efficiency of construction projects and plan response countermeasures for estimated damage following disasters through the utilization of accumulated electronic data, which constructs a digital twin that can reproduce a physical space in cyberspace and feedback the cyberspace simulation results to physical space. However, the application of such simulations is limited, unless numerical models can be automatically constructed from the data. In this study, we develop a program that utilizes a data processing platform to read, transform, and integrate data to create mediated data with a common data structure. This mediated data can be used to construct analytical models for various numerical analyses. Using the program developed, a grid model of 3-D ground surface as the mediated data was constructed based on borehole data obtained through a ground survey. Each grid point has basic material parameters of soil, and these parameters are estimated from borehole data and other investigation reports. Each grid point has general geotechnical parameters and can be easily converted to a 3-D finite-element model. When the borehole data is added or changed, the analytical model can be updated with almost no cost, whereas it would be very costly to create the model manually.
- 31 August 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE/ASME Transactions on Mechatronics
- Vol. 26 (6) , 2881-2887
Automatic Construction of Three-Dimensional Ground Model by Data Processing
There have been attempts to improve the operational efficiency of construction projects and plan response countermeasures for estimated damage following disasters through the utilization of accumulated electronic data, which constructs a digital twin that can reproduce a physical space in cyberspace and feedback the cyberspace simulation results to physical space. However, the application of such simulations is limited, unless numerical models can be automatically constructed from the data. In this study, we develop a program that utilizes a data processing platform to read, transform, and integrate data to create mediated data with a common data structure. This mediated data can be used to construct analytical models for various numerical analyses. Using the program developed, a grid model of 3-D ground surface as the mediated data was constructed based on borehole data obtained through a ground survey. Each grid point has basic material parameters of soil, and these parameters are estimated from borehole data and other investigation reports. Each grid point has general geotechnical parameters and can be easily converted to a 3-D finite-element model. When the borehole data is added or changed, the analytical model can be updated with almost no cost, whereas it would be very costly to create the model manually.
- Open Access
- 1 October 2020
- Published by Elsevier in Soils and Foundations
- Vol. 60 (5) , 1287-1298
Practical method to estimate parameters of elasto-plastic constitutive model for unsaturated soils from compaction curve
- 1 October 2020
- Published by Elsevier in Soils and Foundations
- Vol. 60 (5) , 1287-1298
Open AccessPractical method to estimate parameters of elasto-plastic constitutive model for unsaturated soils from compaction curve
- Open Access
- 1 February 2020
- Published by Elsevier in Soils and Foundations
- Vol. 60 (1) , 179-197
Constitutive model with a concept of plastic rebound for expansive soils
- 1 February 2020
- Published by Elsevier in Soils and Foundations
- Vol. 60 (1) , 179-197
Open AccessConstitutive model with a concept of plastic rebound for expansive soils
- Open Access
- 1 September 2019
- Published by Emerald Publishing in Geotechnical Research
- Vol. 6 (3) , 156-176
Extension of unsaturated soil mechanics and its applications
Although the soil, water and air coupling theory has been deductively derived from the three-phase mixture theory, assumptions and interpretations inherent in soil mechanics are also conveniently introduced in this theory. Mechanical properties of unsaturated soils are phenomenologically integrated into the constitutive equation for a deformation problem, with effective stress expressed as a combination of partial stresses acting on each phase of the mixture. The governing equations of two seepage problems describing the movements of pore water and pore air are formulated by a priori introduction of Darcy’s law. Consequently, the coupling theory consists of a deformation problem and two seepage problems, in which the soil-water retention characteristics play the role of a mediator connecting these problems. If the theoretical structure is clarified in this way, an extension of this theory is easily made. In this paper, the extension of the theory to each of four examples and their performance is demonstrated. The features of settlement caused by absorption of soil water due to vegetation; dissolution, advection and diffusion of substances in groundwater; desaturation and state change due to vaporisation of dissolved gas from pore water; and the liquefaction potential of unsaturated soil are presented.
- 1 September 2019
- Published by Emerald Publishing in Geotechnical Research
- Vol. 6 (3) , 156-176
Open AccessExtension of unsaturated soil mechanics and its applications
Although the soil, water and air coupling theory has been deductively derived from the three-phase mixture theory, assumptions and interpretations inherent in soil mechanics are also conveniently introduced in this theory. Mechanical properties of unsaturated soils are phenomenologically integrated into the constitutive equation for a deformation problem, with effective stress expressed as a combination of partial stresses acting on each phase of the mixture. The governing equations of two seepage problems describing the movements of pore water and pore air are formulated by a priori introduction of Darcy’s law. Consequently, the coupling theory consists of a deformation problem and two seepage problems, in which the soil-water retention characteristics play the role of a mediator connecting these problems. If the theoretical structure is clarified in this way, an extension of this theory is easily made. In this paper, the extension of the theory to each of four examples and their performance is demonstrated. The features of settlement caused by absorption of soil water due to vegetation; dissolution, advection and diffusion of substances in groundwater; desaturation and state change due to vaporisation of dissolved gas from pore water; and the liquefaction potential of unsaturated soil are presented.
- 1 October 2017
- Published by Emerald Publishing in Environmental Geotechnics
- Vol. 4 (5) , 339-352
Simulation of saturation process in a transuranium disposal facility
Bentonite materials have been considered as a candidate material for engineered barriers in transuranium (TRU) waste disposal facilities due to their physical and chemical characteristics. Bentonite materials will be initially compacted and unsaturated. After closing the cavern, the bentonite material will become saturated through exposure to a percolating groundwater. It is therefore important to understand the behaviour of bentonite during saturation, which provides an initial condition of the disposal facilities. This paper explains a mathematical model which can express the saturation process. Subsequently, a series of numerical simulations were carried out. First, the swelling pressure of buffer and backfill was examined to verify the numerical model. It was confirmed that the simulated swelling pressure rises with water absorption, and swelling pressure test results from the literature are shown to be satisfactorily predicted by the numerical model, although these were slightly overestimated. Next, the mechanical behaviour of bentonite materials in a TRU waste disposal facility during the saturation process was examined using soil/water/air coupled finite-element method. Although it is difficult to examine the validity of analysis results because of the difficulty of an extremely long-term measurement, the qualitative behaviour of the saturation process could be inferred.
- 1 October 2017
- Published by Emerald Publishing in Environmental Geotechnics
- Vol. 4 (5) , 339-352
Simulation of saturation process in a transuranium disposal facility
Bentonite materials have been considered as a candidate material for engineered barriers in transuranium (TRU) waste disposal facilities due to their physical and chemical characteristics. Bentonite materials will be initially compacted and unsaturated. After closing the cavern, the bentonite material will become saturated through exposure to a percolating groundwater. It is therefore important to understand the behaviour of bentonite during saturation, which provides an initial condition of the disposal facilities. This paper explains a mathematical model which can express the saturation process. Subsequently, a series of numerical simulations were carried out. First, the swelling pressure of buffer and backfill was examined to verify the numerical model. It was confirmed that the simulated swelling pressure rises with water absorption, and swelling pressure test results from the literature are shown to be satisfactorily predicted by the numerical model, although these were slightly overestimated. Next, the mechanical behaviour of bentonite materials in a TRU waste disposal facility during the saturation process was examined using soil/water/air coupled finite-element method. Although it is difficult to examine the validity of analysis results because of the difficulty of an extremely long-term measurement, the qualitative behaviour of the saturation process could be inferred.
- Open Access
- 1 February 2017
- Published by Elsevier in Soils and Foundations
- Vol. 57 (1) , 80-91
Constitutive modeling for compacted bentonite buffer materials as unsaturated and saturated porous media
- 1 February 2017
- Published by Elsevier in Soils and Foundations
- Vol. 57 (1) , 80-91
Open AccessConstitutive modeling for compacted bentonite buffer materials as unsaturated and saturated porous media
- Open Access
- 1 October 2016
- Published by Elsevier in Soils and Foundations
- Vol. 56 (5) , 848-860
Effects of stress conditions on B-value measurement
- 1 October 2016
- Published by Elsevier in Soils and Foundations
- Vol. 56 (5) , 848-860
Open AccessEffects of stress conditions on B-value measurement
- Open Access
- 1 January 2016
- Published by Elsevier in Procedia Engineering
- Vol. 143, 276-283
Explanation of Dry Density Distribution Induced by Compaction through Soil/Water/Air Coupled Simulation
- 1 January 2016
- Published by Elsevier in Procedia Engineering
- Vol. 143, 276-283
Open AccessExplanation of Dry Density Distribution Induced by Compaction through Soil/Water/Air Coupled Simulation
- 1 January 2016
- Published by The Japanese Geotechnical Society in Japanese Geotechnical Society Special Publication
- Vol. 2 (49) , 1714-1717
Soil/water/air coupled F. E. simulation of phreatic surface generation process within a river levee
- 1 January 2016
- Published by The Japanese Geotechnical Society in Japanese Geotechnical Society Special Publication
- Vol. 2 (49) , 1714-1717
Soil/water/air coupled F. E. simulation of phreatic surface generation process within a river levee