PNPamela M. Norris

Pamela M. Norris

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Pamela M. Norris has a total of 77 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Engineering Interfaces at the Nanoscale

    by Pamela M. Norris, LeighAnn S. Larkin

  • Maximization of thermal conductance at interfaces via exponentially mass-graded interlayers

    by Rouzbeh Rastgarkafshgarkolaei, Jingjie Zhang, Carlos A. Polanco, Nam Q. Le, Avik W. Ghosh, Pamela M. Norris

    We propose a strategy to potentially best enhance interfacial thermal transport through solid–solid interfaces by adding nano-engineered, exponentially mass-graded intermediate layers. This exponential design rule results in a greater enhancement than a linearly mass-graded interface. By combining calculations using non-equilibrium Green's functions (NEGF) and non-equilibrium molecular dynamics (NEMD), we investigated the role of impedance matching and anharmonicity in the enhancement in addition to geometric parameters such as the number of layers and the junction thickness. Our analysis shows that the effect on thermal conductance is dominated by the phonon thermalization through anharmonic effects, while elastic phonon transmission and impedance matching play a secondary role. In the harmonic limit, increasing the number of layers results in greater elastic phonon transmission at each individual boundary, countered by the decrease of available conducting channels. Consequently, conductance initially increases with number of layers due to improved bridging, but quickly saturates. The presence of slight anharmonic effects (at very low temperature, T = 2 K) turns the saturation into a monotonically increasing trend. Anharmonic effects can further facilitate interfacial thermal transport through the thermalization of phonons at moderate temperatures. At high temperature, however, the role of anharmonicity as a facilitator of interfacial thermal transport reverses. Strong anharmonicity introduces significant intrinsic resistance, overruling the enhancement in thermal conduction at the boundaries. It follows that at a particular temperature, there exists a corresponding junction thickness at which thermal conductance is maximized.


  • Open Access

    Effects of bulk and interfacial anharmonicity on thermal conductance at solid/solid interfaces

    by Nam Q. Le, Carlos A. Polanco, Rouzbeh Rastgarkafshgarkolaei, Jingjie Zhang, Avik W. Ghosh, Pamela M. Norris

    We present the results of classical molecular dynamics simulations to assess the relative contributions to interfacial thermal conductance from inelastic phonon processes at the interface and in the adjacent bulk materials. The simulated system is the prototypical interface between argon and “heavy argon” crystals, which enables comparison with many past computational studies. We run simulations interchanging the Lennard-Jones potential with its harmonic approximation to test the effect of anharmonicity on conductance. The results confirm that the presence of anharmonicity is correlated with increasing thermal conductance with temperature, which supports conclusions from prior experimental and theoretical work. However, in the model Ar/heavy-Ar system, anharmonic effects at the interface itself contribute a surprisingly small part of the total thermal conductance. The larger fraction of the thermal conductance at high temperatures arises from anharmonic effects away from the interface. These observations are supported by comparisons of the spectral energy density, which suggest that bulk anharmonic processes increase the interfacial conductance by thermalizing energy from modes with low transmission to modes with high transmission.


  • Open Access

    Effects of bulk and interfacial anharmonicity on thermal conductance at solid/solid interfaces

    by Nam Q. Le, Carlos A. Polanco, Rouzbeh Rastgarkafshgarkolaei, Jingjie Zhang, Avik W. Ghosh, Pamela M. Norris

    We present the results of classical molecular dynamics simulations to assess the relative contributions to interfacial thermal conductance from inelastic phonon processes at the interface and in the adjacent bulk materials. The simulated system is the prototypical interface between argon and "heavy argon" crystals, which enables comparison with many past computational studies. We run simulations interchanging the Lennard-Jones potential with its harmonic approximation to test the effect of anharmonicity on conductance. The results confirm that the presence of anharmonicity is correlated with increasing thermal conductance with temperature, which supports conclusions from prior experimental and theoretical work. However, in the model Ar/heavy-Ar system, anharmonic effects at the interface itself contribute a surprisingly small part of the total thermal conductance. The larger fraction of the thermal conductance at high temperatures arises from anharmonic effects away from the interface. These observations are supported by comparisons of the spectral energy density, which suggest that bulk anharmonic processes increase interfacial conductance by thermalizing energy from modes with low transmission to modes with high transmission.

  • Open Access

    Effect of long- and short-range order on SiGe alloy thermal conductivity: Molecular dynamics simulation

    by Christopher H. Baker, Pamela M. Norris

    We report the role of long- and short-range order on the thermal conductivity and mode relaxation times of a model Si0.5Ge0.5 alloy using molecular dynamics simulation. All interactions used the Stillinger-Weber potential and the Si and Ge atoms differed only by their mass. The simulated alloys were generated using a Monte Carlo approach to decouple the short-range order from the long-range order. The thermal conductivity is almost entirely determined by the alloy's nearest-neighbor short-range order. Changes to the mode relaxation times between ∼3 and ∼6THz upon short-range ordering, and the observed f−2 power law trend, suggest that short-range ordering reduces the anharmonic scattering rate of low frequency modes. The trend of thermal conductivity with short-range order may be transferred to real Si0.5Ge0.5 and other semiconductor alloys to the extent that scattering from mass disorder dominates their thermal conductivities.


  • Experimental Investigation of the Heat Transfer Performance of a Hybrid Cooling Fin Thermosyphon

    by Christina A. Pappas, Donald A. Jordan, Pamela M. Norris

    The effect of fill volume on the heat transfer performance of a hybrid cooling fin thermosyphon, characterized by an airfoil cross-sectional shape and a slot-shaped cavity, is investigated. The performance was examined at three fill volumes, expressed as a percentage of the evaporator section: 0%, 60%, and 240%. These were chosen to represent three distinct regimes: unfilled, filled, and overfilled evaporator sections, respectively. The cross section of this copper–water thermosyphon has a NACA0010 shape with a chord length of 63.5 mm and an aspect ratio (ratio of the length of the evaporator section to the cavity width) of 1.109. The evaporator length comprises 8.3% of the total thermosyphon length. The air-cooled condenser section was placed in a uniform air flow in the test section of an open return wind tunnel. The rate of heat transfer, or performance, was measured as a function of fill volume and evaporator temperature. The heat transfer performance increased by 100–170% by adding 0.86 ml of working fluid (de-ionized water), i.e., when the fill volume increased from 0% to 60%, which illustrates the improvement of a cooling fin's heat transfer rate by converting it to a hybrid cooling fin thermosyphon. Of the fill volumes investigated, the thermosyphon achieves a maximum heat transfer rate and highest average surface temperature at the 60% fill volume. Overfilling the evaporator section at 240% fill results in a slight decrease in performance from the 60% fill volume. The results of this study demonstrate the feasibility of hybridizing a cooling fin to act both as a cooling fin and a thermosyphon.


  • Impedance Matching of Atomic Thermal Interfaces Using Primitive Block Decomposition

    by Carlos A. Polanco, Christopher B. Saltonstall, Pamela M. Norris, Patrick E. Hopkins, Avik W. Ghosh

    We explore the physics of thermal impedance matching at the interface between two dissimilar materials by controlling the properties of a single atomic mass or bond. The maximum thermal current is transmitted between the materials when we are able to decompose the entire heterostructure solely in terms of primitive building blocks of the individual materials. Using this approach, we show that the minimum interfacial thermal resistance arises when the interfacial atomic mass is the arithmetic mean, whereas the interfacial spring constant is the harmonic mean of its neighbors. The contact-induced broadening matrix for the local vibronic spectrum, obtained from the self-energy matrices, generalizes the concept of acoustic impedance to the nonlinear phonon dispersion or the short-wavelength (atomic) limit.


  • Tuning Phonon Transport: From Interfaces to Nanostructures

    by Pamela M. Norris, Nam Q. Le, Christopher H. Baker

    A wide range of modern technological devices utilize materials structured at the nanoscale to improve performance. The efficiencies of many of these devices depend on their thermal transport properties; whether a high or low conductivity is desirable, control over thermal transport is crucial to the continued development of device performance. Here we review recent experimental, computational, and theoretical studies that have highlighted potential methods for controlling phonon-mediated heat transfer. We discuss those parameters that affect thermal boundary conductance, such as interface morphology and material composition, as well as the emergent effects due to several interfaces in close proximity, as in a multilayered structure or superlattice. Furthermore, we explore future research directions as well as some of the challenges related to improving device thermal performance through the implementation of phonon engineering techniques.


  • The Effect of Fill Volume on Heat Transfer From Air-Cooled Thermosyphons

    by Christina A. Pappas, Paul M. De Cecchis, Donald A. Jordan, Pamela M. Norris

    The effect of fill volume on the heat transfer performance of a cylindrical thermosyphon with an aspect ratio (ratio of the length of the evaporator section to the inner diameter) of 2.33 immersed in a cooling air flow is investigated. The fill volume was systematically varied from 0% to 70.3% of the volume of the evaporator section in a copper-water thermosyphon having an inner diameter of 19 mm. The condenser section was immersed in a uniform air flow in the test section of an open return wind tunnel. The heat transfer rate was measured as a function of evaporator temperature and fill volume, and these results were characterized by three distinct regions. From 0% to roughly 16% fill volume (Region I), the low rate of heat transfer, which is insensitive to fill volume, suggests that dry out may be occurring. In Region II (extending to approximately 58% fill volume), the heat transfer rate increases approximately linearly with fill volume, and increasing evaporator temperature results in decreased rate of heat transfer. Finally, in Region III (from roughly 58–70.3%), the rate of heat transfer increases more rapidly, though still linearly, with fill volume, and increasing evaporator temperature results in increased rate of heat transfer. The thermosyphon rate of heat transfer is greatest at 70.3% fill volume for every evaporator temperature.


  • Application of the wavelet transform to nanoscale thermal transport

    by Christopher H. Baker, Donald A. Jordan, Pamela M. Norris

    The continuous wavelet transform is employed to analyze the dynamics and time-dependent energy distribution of phonon wave-packet propagation and scattering in molecular dynamics simulations. The equations of the one-dimensional continuous wavelet transform are presented and then discretized for implementation. Practical aspects and limitations of the transform are discussed, with attention to its application in the analysis of molecular dynamics simulations. The transform is demonstrated using three examples that are relevant to nanoscale thermal transport. First, a system of wave packets that interfere in both the spatial and Fourier domains are separated by the wavelet transform, allowing the measurement of each packet's contribution to the system energy. Second, the wavelet transform is applied to a multiple wave-packet simulation of a silicon, heavy-silicon interface. The wavelet-based calculation of mode-dependent transmission is validated through comparison to literature results and theoretical predictions. Third, the dynamic scattering of a large amplitude wave packet is studied using the wavelet transform. The transform reveals a transition in the structure of the energy distribution. Unlike current techniques, the wavelet transform can be used to determine how the energy of a simulated system is distributed in time, in space, and among wave numbers, simultaneously. The ability to resolve phonon motion and energy from a vibrating ensemble of atoms in a molecular dynamics simulation makes the wavelet transform a promising technique for probing the physical mechanisms of nanoscale thermal transport.