Atul P. Jamale
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Atul P. Jamale has a total of 45 co-authors. Here are the top co-authors by number of shared publications:
L.D. Jadhav
11 shared publicationsC.H. Bhosale
9 shared publicationsS.P. Patil
6 shared publicationsA.U. Chavan
Shivaji University
4 shared publications- Lata D. Jadhav
Electrochemical Materials Research Laboratory, Department of Physics, Rajaram College, Kolhapur, India
4 shared publications S.U. Dubal
4 shared publications
Latest Publications
- Open Access
- 17 August 2026
- Published by Elsevier in Open Ceramics
- Vol. 27
Role of transition metal oxide segregation in A-site deficient LSCF oxygen electrodes
- 17 August 2026
- Published by Elsevier in Open Ceramics
- Vol. 27
Open AccessRole of transition metal oxide segregation in A-site deficient LSCF oxygen electrodes
- 11 October 2025
- Published by Elsevier in Electrochimica Acta
- Vol. 542
Insight into the carbonate features of ceria-carbonate composite membranes for electrochemical applications
- 11 October 2025
- Published by Elsevier in Electrochimica Acta
- Vol. 542
Insight into the carbonate features of ceria-carbonate composite membranes for electrochemical applications
- Open Access
- 19 January 2024
- Published by Royal Society of Chemistry (RSC) in Materials Advances
- Vol. 5 (5) , 2027-2039
Optimization of safe doping level for enhanced CO 2 flux in composite membrane
Rare earth doped oxides have been intensively promoted for the last two decades to embrace the high-performance target of a ceramic–carbonate composite CO 2 -separation membrane, with countless incidents of exsolution.
- 19 January 2024
- Published by Royal Society of Chemistry (RSC) in Materials Advances
- Vol. 5 (5) , 2027-2039
Open AccessOptimization of safe doping level for enhanced CO 2 flux in composite membrane
Rare earth doped oxides have been intensively promoted for the last two decades to embrace the high-performance target of a ceramic–carbonate composite CO 2 -separation membrane, with countless incidents of exsolution.
- Open Access
- 5 September 2022
- Published by Elsevier in Journal of Membrane Science
- Vol. 662
Elucidation of subtle degradation mechanisms in composite CO2 separation membranes
- 5 September 2022
- Published by Elsevier in Journal of Membrane Science
- Vol. 662
Open AccessElucidation of subtle degradation mechanisms in composite CO2 separation membranes
- 26 July 2021
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 125 (30) , 16843-16857
Effect of Vanadium Oxide on the Structure and Li-Ion Conductivity of Lithium Silicate Glasses
- 26 July 2021
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 125 (30) , 16843-16857
Effect of Vanadium Oxide on the Structure and Li-Ion Conductivity of Lithium Silicate Glasses
- 4 January 2021
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 104 (6) , 2495-2505
Role of vanadium oxide on the lithium silicate glass structure and properties
The structural role of V in 28Li 2 O–72SiO 2 (in mol%) lithium silicate glass doped with 0.5 mol% V 2 O 5 was assessed using 29 Si and 51 V Nuclear Magnetic Resonance (NMR), Fourier‐transform infrared (FTIR), and X‐ray photoelectron (XPS) spectroscopy techniques. Despite the low amount of V 2 O 5 used, the structural information obtained or deduced from the statistical analysis of the NMR data could explain the evolution of glass properties after V 2 O 5 addition. The XPS results indicated that all vanadium exists in 5+ oxidation state. Both the 29 Si NMR and FTIR data point toward an increase in the polymerization of the silicate network, caused by the V 2 O 5 acting as network former, capable to form various tetrahedral units (for n = 0, 1, and 2) in the glasses. These units, which are similar to phosphate units, scavenge the Li + ions and cause the silicate network to polymerize. However, in an overall balance, the entire glass network is depolymerized due to the additional nonbridging oxygens contributed by the vanadium polyhedra. The addition of vanadium causes the network to expand and increases the ionic conductivity.
- 4 January 2021
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 104 (6) , 2495-2505
Role of vanadium oxide on the lithium silicate glass structure and properties
The structural role of V in 28Li 2 O–72SiO 2 (in mol%) lithium silicate glass doped with 0.5 mol% V 2 O 5 was assessed using 29 Si and 51 V Nuclear Magnetic Resonance (NMR), Fourier‐transform infrared (FTIR), and X‐ray photoelectron (XPS) spectroscopy techniques. Despite the low amount of V 2 O 5 used, the structural information obtained or deduced from the statistical analysis of the NMR data could explain the evolution of glass properties after V 2 O 5 addition. The XPS results indicated that all vanadium exists in 5+ oxidation state. Both the 29 Si NMR and FTIR data point toward an increase in the polymerization of the silicate network, caused by the V 2 O 5 acting as network former, capable to form various tetrahedral units (for n = 0, 1, and 2) in the glasses. These units, which are similar to phosphate units, scavenge the Li + ions and cause the silicate network to polymerize. However, in an overall balance, the entire glass network is depolymerized due to the additional nonbridging oxygens contributed by the vanadium polyhedra. The addition of vanadium causes the network to expand and increases the ionic conductivity.
- 1 January 2021
- Published by Elsevier in Journal of Physics and Chemistry of Solids
- Vol. 148
Synthesis of active electrocatalysts using glycine–nitrate chemistry
- 1 January 2021
- Published by Elsevier in Journal of Physics and Chemistry of Solids
- Vol. 148
Synthesis of active electrocatalysts using glycine–nitrate chemistry
- 14 September 2020
- Published by Hindawi Limited in International Journal of Energy Research
- Vol. 45 (2) , 2945-2958
Electrode protective barrier layers for molten carbonate confinement
Pure NiO or lithiated NiO with distinct Li/Ni atomic proportions (50/50—LN55 and 30/70—LN37) were tested as protective barrier layers (PBLs) to enhance the stability of LaCoO3 (LC) electrodes in cells with composite electrolytes (CEs) consisting of Gd‐doped ceria (CGO) and a eutectic mixture of Na and Li carbonates (NLCs). PBLs and LC layers were sequentially deposited by screen printing before firing at 700°C and 550°C, respectively, to yield symmetrical cells (LC|PBL|CE|PBL|LC). Electrochemical testing involved impedance spectroscopy measurements in air in the 500°C to 650°C range. Scanning electron microscopy combined with energy‐dispersive X‐ray spectroscopy (SEM/EDS) revealed that distinct PBLs possess uneven wetting tendency, with impact on the role of LC layers. The best electrode performance (0.55 Ω cm2 electrode area specific resistance at 550°C in air) was observed using the LN37 PBL, stable throughout endurance tests up to 200 hours. Possible electrode mechanisms consistent with experimental evidence suggest an active role of the molten phase as an intermediate provider of O2− transport between the electrode and CGO.
- 14 September 2020
- Published by Hindawi Limited in International Journal of Energy Research
- Vol. 45 (2) , 2945-2958
Electrode protective barrier layers for molten carbonate confinement
Pure NiO or lithiated NiO with distinct Li/Ni atomic proportions (50/50—LN55 and 30/70—LN37) were tested as protective barrier layers (PBLs) to enhance the stability of LaCoO3 (LC) electrodes in cells with composite electrolytes (CEs) consisting of Gd‐doped ceria (CGO) and a eutectic mixture of Na and Li carbonates (NLCs). PBLs and LC layers were sequentially deposited by screen printing before firing at 700°C and 550°C, respectively, to yield symmetrical cells (LC|PBL|CE|PBL|LC). Electrochemical testing involved impedance spectroscopy measurements in air in the 500°C to 650°C range. Scanning electron microscopy combined with energy‐dispersive X‐ray spectroscopy (SEM/EDS) revealed that distinct PBLs possess uneven wetting tendency, with impact on the role of LC layers. The best electrode performance (0.55 Ω cm2 electrode area specific resistance at 550°C in air) was observed using the LN37 PBL, stable throughout endurance tests up to 200 hours. Possible electrode mechanisms consistent with experimental evidence suggest an active role of the molten phase as an intermediate provider of O2− transport between the electrode and CGO.
- 15 October 2018
- Published by Wiley in International Journal of Energy Research
- Vol. 42 (15) , 4805-4816
Screening of electrode materials and cell concepts for composite ceria + salt electrolytes
- 15 October 2018
- Published by Wiley in International Journal of Energy Research
- Vol. 42 (15) , 4805-4816
Screening of electrode materials and cell concepts for composite ceria + salt electrolytes