Clinton S. Willson
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Clinton S. Willson has a total of 25 co-authors. Here are the top co-authors by number of shared publications:
- Alexandra Christensen1 shared publication
Allen H. Reed
1 shared publicationCarmen M. Puertas-Frías
1 shared publicationChristopher David White
Louisiana State University
1 shared publication- Christopher Turnipseed
Department Civil and Environmental Engineering Louisiana State University Baton Rouge LA USA
1 shared publication - David R. Legates
University of Delaware
1 shared publication
Latest Publications
- Open Access
- 6 September 2022
- Published by Elsevier in Renewable Energy
- Vol. 199, 587-598
Design and economic analysis of a hydrokinetic turbine for household applications
- 6 September 2022
- Published by Elsevier in Renewable Energy
- Vol. 199, 587-598
Open AccessDesign and economic analysis of a hydrokinetic turbine for household applications
- 1 October 2021
- Published by Elsevier in Journal of Environmental Management
- Vol. 295, 113143
Predicting the impact of biochar on the saturated hydraulic conductivity of natural and engineered media
- 1 October 2021
- Published by Elsevier in Journal of Environmental Management
- Vol. 295, 113143
Predicting the impact of biochar on the saturated hydraulic conductivity of natural and engineered media
- Open Access
- 9 February 2021
- Published by American Geophysical Union (AGU) in Water Resources Research
- Vol. 57 (2)
Numerical Modeling of Two‐Dimensional Hydrodynamics in a Highly Curving and Actively Evolving Neck Cutoff Under Different Hydrologic Conditions
Neck cutoffs are a common morphologic feature of meandering rivers though their occurrence on natural rivers is intermittent. Morphologic adjustments following cutoff initiation are typically rapid making detailed field investigations of the interactions between flow and form challenging. However, numerical models can offer insights into the hydrodynamic characteristics within the early stages of cutoff evolution. Field measurements of channel bathymetry and three‐dimensional velocities were collected during the first two years of morphologic change for a neck cutoff on the White River in Arkansas, USA. These data were used to calibrate a two‐dimensional numerical model to investigate the influence of hydrologic variability on the hydrodynamic characteristics of neck cutoffs during the early stages morphologic adjustment. The modeling results reveal complex patterns of the two‐dimensional flow field, including multiple regions of flow separation and recirculation related to strong redirection of the flow nearly 180 degrees through the cutoff. These regions of recirculation are also shown to vary depending on discharge conditions and affect hydrologic connectivity between the main channel and abandoned bend. Model results for the initial cutoff morphology show a substantial portion of discharge still conveyed by the original bend for all three discharge scenarios, resulting in a shear layer within the downstream limb of the site that limits advection of high‐momentum fluid against the bank opposite of the cutoff. The findings from this investigation are among the first detailed flow structure studies during the initiation of a neck cutoff and are used to improve conceptual models for cutoff dynamics.
- 9 February 2021
- Published by American Geophysical Union (AGU) in Water Resources Research
- Vol. 57 (2)
Open AccessNumerical Modeling of Two‐Dimensional Hydrodynamics in a Highly Curving and Actively Evolving Neck Cutoff Under Different Hydrologic Conditions
Neck cutoffs are a common morphologic feature of meandering rivers though their occurrence on natural rivers is intermittent. Morphologic adjustments following cutoff initiation are typically rapid making detailed field investigations of the interactions between flow and form challenging. However, numerical models can offer insights into the hydrodynamic characteristics within the early stages of cutoff evolution. Field measurements of channel bathymetry and three‐dimensional velocities were collected during the first two years of morphologic change for a neck cutoff on the White River in Arkansas, USA. These data were used to calibrate a two‐dimensional numerical model to investigate the influence of hydrologic variability on the hydrodynamic characteristics of neck cutoffs during the early stages morphologic adjustment. The modeling results reveal complex patterns of the two‐dimensional flow field, including multiple regions of flow separation and recirculation related to strong redirection of the flow nearly 180 degrees through the cutoff. These regions of recirculation are also shown to vary depending on discharge conditions and affect hydrologic connectivity between the main channel and abandoned bend. Model results for the initial cutoff morphology show a substantial portion of discharge still conveyed by the original bend for all three discharge scenarios, resulting in a shear layer within the downstream limb of the site that limits advection of high‐momentum fluid against the bank opposite of the cutoff. The findings from this investigation are among the first detailed flow structure studies during the initiation of a neck cutoff and are used to improve conceptual models for cutoff dynamics.
- Open Access
- 24 January 2020
- Published by American Geophysical Union (AGU) in Water Resources Research
- Vol. 56 (1)
Wettability Effects on Primary Drainage Mechanisms and NAPL Distribution: A Pore‐Scale Study
The pore‐scale processes governing water drainage behavior in porous media have implications for geoscience multiphase scenarios including carbon capture and storage, contaminant site remediation, oil recovery, and vadose zone processes. However, few studies report directly observed pore‐scale water drainage phenomena in 3‐D soils. This knowledge gap limits our ability to verify assumptions underlying existing models and develop optimal solutions. This paper utilizes synchrotron X‐ray microtomography to present an experimental pore‐scale examination of nonaqueous phase liquid (NAPL)/water distribution along a primary drainage front as dense NAPL was injected upward into water wetting (WW) and intermediate wetting (IW) sand‐packed columns. Pore‐network structures were extracted from imaged data sets and mapped onto segmented NAPL/water data sets which allowed quantitative examinations of wettability impacts on (a) the extent to which NAPL fills individual pore bodies and (b) relationships between pore size and the phase occupying the pore, with both considered as a function of distance (and capillary pressure) relative to the NAPL front. These results revealed that several hypotheses treating IW sand similarly to WW sands are simplistic. IW systems exhibited a sequence of pore filling that deviated from traditional capillary pressure‐based model predictions: NAPL invades smaller pores, while larger, adjacent pores are bypassed leaving multipore residual water ganglia. NAPL pore saturations were close to 1 and did not change with capillary pressure in IW systems. Overall, the results illustrate how a relatively small change in operative contact angle alters NAPL distribution during water drainage, with important implications for geoscience multiphase flow scenarios.
- 24 January 2020
- Published by American Geophysical Union (AGU) in Water Resources Research
- Vol. 56 (1)
Open AccessWettability Effects on Primary Drainage Mechanisms and NAPL Distribution: A Pore‐Scale Study
The pore‐scale processes governing water drainage behavior in porous media have implications for geoscience multiphase scenarios including carbon capture and storage, contaminant site remediation, oil recovery, and vadose zone processes. However, few studies report directly observed pore‐scale water drainage phenomena in 3‐D soils. This knowledge gap limits our ability to verify assumptions underlying existing models and develop optimal solutions. This paper utilizes synchrotron X‐ray microtomography to present an experimental pore‐scale examination of nonaqueous phase liquid (NAPL)/water distribution along a primary drainage front as dense NAPL was injected upward into water wetting (WW) and intermediate wetting (IW) sand‐packed columns. Pore‐network structures were extracted from imaged data sets and mapped onto segmented NAPL/water data sets which allowed quantitative examinations of wettability impacts on (a) the extent to which NAPL fills individual pore bodies and (b) relationships between pore size and the phase occupying the pore, with both considered as a function of distance (and capillary pressure) relative to the NAPL front. These results revealed that several hypotheses treating IW sand similarly to WW sands are simplistic. IW systems exhibited a sequence of pore filling that deviated from traditional capillary pressure‐based model predictions: NAPL invades smaller pores, while larger, adjacent pores are bypassed leaving multipore residual water ganglia. NAPL pore saturations were close to 1 and did not change with capillary pressure in IW systems. Overall, the results illustrate how a relatively small change in operative contact angle alters NAPL distribution during water drainage, with important implications for geoscience multiphase flow scenarios.
- 1 June 2019
- Published by Elsevier in Computers & Geosciences
- Vol. 127, 65-74
Pore-scale modeling of nanoparticle transport and retention in real porous materials
- 1 June 2019
- Published by Elsevier in Computers & Geosciences
- Vol. 127, 65-74
Pore-scale modeling of nanoparticle transport and retention in real porous materials
- 1 October 2005
- Published by Society of Petroleum Engineers (SPE)
Application of a New Grain-Based Reconstruction Algorithm to Microtomography Images for Quantitative Characterization and Flow Modeling
X-ray computed microtomography (XMT) is used for high-resolution, non-destructive imaging and has been applied successfully to geologic media. Despite the potential of XMT to aid in formation evaluation, currently it is used mostly as a res
- 1 October 2005
- Published by Society of Petroleum Engineers (SPE)
Application of a New Grain-Based Reconstruction Algorithm to Microtomography Images for Quantitative Characterization and Flow Modeling
X-ray computed microtomography (XMT) is used for high-resolution, non-destructive imaging and has been applied successfully to geologic media. Despite the potential of XMT to aid in formation evaluation, currently it is used mostly as a res