Mojtaba Bagherzadeh
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Mojtaba Bagherzadeh has a total of 82 co-authors. Here are the top co-authors by number of shared publications:
Akbar Rostami-Vartooni
Department of Chemistry, Faculty of Science, University of Qom, Qom, Islamic Republic of Iran
4 shared publicationsJ. Mokhtari
Reactor and Nuclear Safety Research School, Nuclear Science and Technology Research Institute, Isfahan, Iran
4 shared publications- Mahmoud Nasrollahzadeh
Department of Chemistry, Faculty of Science, University of Qom, Qom 37185-359, Iran
4 shared publications Reza Karimi Shervedani
4 shared publications- Reza Karimi Shervedani
Department of Chemistry, University of Isfahan, Isfahan 81746-73441, Islamic Republic of Iran
4 shared publications Zahra Shams Ghahfarokhi
4 shared publications
Latest Publications
- Open Access
- 9 November 2026
- Published by Springer Nature in Discover Electrochemistry
- Vol. 3 (1) , 96
Coating of carbon steel alloy with polyvinyl alcohol/Fe3O4 nanocomposite to increase its corrosion resistance in 3.5% NaCl environment
- 9 November 2026
- Published by Springer Nature in Discover Electrochemistry
- Vol. 3 (1) , 96
Open AccessCoating of carbon steel alloy with polyvinyl alcohol/Fe3O4 nanocomposite to increase its corrosion resistance in 3.5% NaCl environment
- Open Access
- 11 May 2026
- Published by Springer Nature in Discover Electrochemistry
- Vol. 3 (1) , 43
Walnut leaf extract as a green corrosion inhibitor for carbon steel in NaCl solution across temperatures from ambient to 70 °C
- 11 May 2026
- Published by Springer Nature in Discover Electrochemistry
- Vol. 3 (1) , 43
Open AccessWalnut leaf extract as a green corrosion inhibitor for carbon steel in NaCl solution across temperatures from ambient to 70 °C
- 1 December 2025
- Published by Springer Nature in Journal of Radioanalytical and Nuclear Chemistry
- Vol. 335 (2) , 1261-1271
Synthesis of Pd/SiO2 nanoparticles in MNSR reactor and its catalytical application in reduction decolorization of aqueous organic dyes
- 1 December 2025
- Published by Springer Nature in Journal of Radioanalytical and Nuclear Chemistry
- Vol. 335 (2) , 1261-1271
Synthesis of Pd/SiO2 nanoparticles in MNSR reactor and its catalytical application in reduction decolorization of aqueous organic dyes
- Open Access
- 30 January 2025
- Published by Elsevier in Cleaner Chemical Engineering
- Vol. 11
In-situ synthesize of Ag NPs/SiO2 nanocomposite by gamma ray and its application as catalyst in decolorization of dyes
- 30 January 2025
- Published by Elsevier in Cleaner Chemical Engineering
- Vol. 11
Open AccessIn-situ synthesize of Ag NPs/SiO2 nanocomposite by gamma ray and its application as catalyst in decolorization of dyes
- Open Access
- 24 January 2025
- Published by Elsevier in Cleaner Chemical Engineering
- Vol. 11
Microwave and heat-assisted extracted Melilotus officinalis as a potential eco-friendly corrosion inhibitor for carbon steel in 0.5 M HCl solution
- 24 January 2025
- Published by Elsevier in Cleaner Chemical Engineering
- Vol. 11
Open AccessMicrowave and heat-assisted extracted Melilotus officinalis as a potential eco-friendly corrosion inhibitor for carbon steel in 0.5 M HCl solution
- 16 April 2024
- Published by Wiley in ChemistrySelect
- Vol. 9 (15)
Reduction of Methylene Blue Using Silica Nanoparticles Obtained from Waste ZrC
The study conducted an extraction of pure amorphous nano‐silica (SiO 2 NP) from waste product at the ZrC factory. Various techniques such as TEM, SEM‐EDX, ICP, XRD, FTIR, BET, and DLS were utilized to synthesize and characterize the silica nanoparticle. The results showed successful production of pure amorphous silica, with no discernible difference in purity percentage between samples prepared with or without acidic pre‐treatment. It was found that the leaching temperature, process time, and reactant ratio all played a role in the production of nano‐silica. The ideal leaching temperature was determined to be 368 K, with an optimal process time of 2 h. The weight ratio of WPZF/NaOH that yielded the highest percentage of silica extraction was 9 : 10. Additionally, at pH 7, the nano‐silica exhibited the best specific surface area (BET) of 472.51 m 2 /g. The average size of the spherical nano‐silica, as determined by DLS, was approximately 38 nm. Furthermore, the produced nano‐silica was found to be an effective catalyst for the treatment of methylene blue (MB). MB could be degraded by more than 99 % of the initial concertation (10 mg/L) in the presence of NaBH 4 within 16 min and rate constant of the catalytic reduction achieved as 0.134 min −1 . These findings demonstrate the potential of amorphous nano‐silica as a valuable resource in various applications.
- 16 April 2024
- Published by Wiley in ChemistrySelect
- Vol. 9 (15)
Reduction of Methylene Blue Using Silica Nanoparticles Obtained from Waste ZrC
The study conducted an extraction of pure amorphous nano‐silica (SiO 2 NP) from waste product at the ZrC factory. Various techniques such as TEM, SEM‐EDX, ICP, XRD, FTIR, BET, and DLS were utilized to synthesize and characterize the silica nanoparticle. The results showed successful production of pure amorphous silica, with no discernible difference in purity percentage between samples prepared with or without acidic pre‐treatment. It was found that the leaching temperature, process time, and reactant ratio all played a role in the production of nano‐silica. The ideal leaching temperature was determined to be 368 K, with an optimal process time of 2 h. The weight ratio of WPZF/NaOH that yielded the highest percentage of silica extraction was 9 : 10. Additionally, at pH 7, the nano‐silica exhibited the best specific surface area (BET) of 472.51 m 2 /g. The average size of the spherical nano‐silica, as determined by DLS, was approximately 38 nm. Furthermore, the produced nano‐silica was found to be an effective catalyst for the treatment of methylene blue (MB). MB could be degraded by more than 99 % of the initial concertation (10 mg/L) in the presence of NaBH 4 within 16 min and rate constant of the catalytic reduction achieved as 0.134 min −1 . These findings demonstrate the potential of amorphous nano‐silica as a valuable resource in various applications.
- Open Access
- 9 October 2023
- Published by Springer Nature in Scientific Reports
- Vol. 13 (1) , 1-14
Long-time irradiation effect on corrosion behavior of aluminum alloy in pool water of low-power research reactor
This study conducted an evaluation of the corrosion behavior of an aluminum alloy utilized in the Isfahan Miniature Neutron Source Reactor (MNSR). The component analyzed, dry channel (DC), had been exposed to radiation for 12 years in a water environment within the reactor pool since its installation. To determine the effect of radiation on the corrosion of the LT-21 aluminum alloy used in the DC, different parts of the pipe were sampled and various tests were performed. These tests included mechanical strengths (impact, and micro-hardening), XRD, TEM, SEM–EDS, and potentiodynamic polarization (PDP). The parameters measured included corrosion potential, corrosion rate, changes in microscopic structure, and mechanical properties of the aluminum alloy along the entire length of the DC. The neutron and gamma dose distribution along the height of the DC, which was 540 cm, was calculated to determine the correlation between the dose distribution and observed corrosion. The study found that the corrosion mechanisms were complex and resulted from the simultaneous presence of the DC in the pool water and radiation from the reactor core. The observed results are presented and discussed in this study.
- 9 October 2023
- Published by Springer Nature in Scientific Reports
- Vol. 13 (1) , 1-14
Open AccessLong-time irradiation effect on corrosion behavior of aluminum alloy in pool water of low-power research reactor
This study conducted an evaluation of the corrosion behavior of an aluminum alloy utilized in the Isfahan Miniature Neutron Source Reactor (MNSR). The component analyzed, dry channel (DC), had been exposed to radiation for 12 years in a water environment within the reactor pool since its installation. To determine the effect of radiation on the corrosion of the LT-21 aluminum alloy used in the DC, different parts of the pipe were sampled and various tests were performed. These tests included mechanical strengths (impact, and micro-hardening), XRD, TEM, SEM–EDS, and potentiodynamic polarization (PDP). The parameters measured included corrosion potential, corrosion rate, changes in microscopic structure, and mechanical properties of the aluminum alloy along the entire length of the DC. The neutron and gamma dose distribution along the height of the DC, which was 540 cm, was calculated to determine the correlation between the dose distribution and observed corrosion. The study found that the corrosion mechanisms were complex and resulted from the simultaneous presence of the DC in the pool water and radiation from the reactor core. The observed results are presented and discussed in this study.
- 26 September 2023
- Published by Elsevier in Nuclear Engineering and Design
- Vol. 414
Feasibility study of nanomaterials synthesis at MNSR research reactor through design and construction of a gamma irradiation cell
- 26 September 2023
- Published by Elsevier in Nuclear Engineering and Design
- Vol. 414
Feasibility study of nanomaterials synthesis at MNSR research reactor through design and construction of a gamma irradiation cell
- Open Access
- 22 June 2023
- Published by Springer Nature in Research Square
Evaluating the possibility of gamma-ray assisted synthesis of nanomaterials at MNSR research reactor
Herein, a gamma irradiation cell consist of a borated polyethylene (BPE) cylinder with a cadmium inner wall was designed and constructed at Isfahan miniature neutron source reactor (MNSR) for synthesize of metal nanoparticles. The cell is placed in a dry channel irradiation site near the reactor core. The performance of this irradiation cell with appropriate shape and size was evaluated and the neutron flux (φ) and the neutron and gamma dose rates (Dn and Dg) inside it are calculated using MCNP code. The results showed that the designed cell could deliver appropriate gamma dose rate to samples and reduce the thermal neutron flux from 5.82×1010 to 6.28×107 n.cm-2.s-1, i.e. over 99.89% attenuation. Also, the gamma dose rate inside the designed neutron shield is calculated to be 3.83 kSv.h-1. To evaluate the designed and constructed cell, synthesis of Pd and Ag nanoparticles (NPs) on SiO2 supporter was done. Prepared nanocomposites were characterized by using XRD, FE-SEM, and EDXA techniques. Observed results showed metallic Pd and Ag NPs were produced successfully by means of a designed gamma irradiation cell at the reactor via gamma assisted route in nanometer sizes for the first time.
- 22 June 2023
- Published by Springer Nature in Research Square
Open AccessEvaluating the possibility of gamma-ray assisted synthesis of nanomaterials at MNSR research reactor
Herein, a gamma irradiation cell consist of a borated polyethylene (BPE) cylinder with a cadmium inner wall was designed and constructed at Isfahan miniature neutron source reactor (MNSR) for synthesize of metal nanoparticles. The cell is placed in a dry channel irradiation site near the reactor core. The performance of this irradiation cell with appropriate shape and size was evaluated and the neutron flux (φ) and the neutron and gamma dose rates (Dn and Dg) inside it are calculated using MCNP code. The results showed that the designed cell could deliver appropriate gamma dose rate to samples and reduce the thermal neutron flux from 5.82×1010 to 6.28×107 n.cm-2.s-1, i.e. over 99.89% attenuation. Also, the gamma dose rate inside the designed neutron shield is calculated to be 3.83 kSv.h-1. To evaluate the designed and constructed cell, synthesis of Pd and Ag nanoparticles (NPs) on SiO2 supporter was done. Prepared nanocomposites were characterized by using XRD, FE-SEM, and EDXA techniques. Observed results showed metallic Pd and Ag NPs were produced successfully by means of a designed gamma irradiation cell at the reactor via gamma assisted route in nanometer sizes for the first time.