Dirk J. Kok
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Dirk J. Kok has a total of 50 co-authors. Here are the top co-authors by number of shared publications:
Reinhard Uecker
5 shared publicationsChristo Guguschev
4 shared publications- Christo Guguschev
Leibniz-Institut für Kristallzüchtung, Berlin, Germany
4 shared publications - Matthias Bickermann
Leibniz-Institut für Kristallzüchtung (IKZ)
4 shared publications Uta Juda
4 shared publicationsZbigniew Galazka
4 shared publications
Latest Publications
- Open Access
- 23 August 2022
- Published by Elsevier in Journal of Energy Storage
- Vol. 55
Screening double salt sulfate hydrates for application in thermochemical heat storage
- 23 August 2022
- Published by Elsevier in Journal of Energy Storage
- Vol. 55
Open AccessScreening double salt sulfate hydrates for application in thermochemical heat storage
- 12 June 2017
- Published by Royal Society of Chemistry (RSC) in CrystEngComm
- Vol. 19 (28) , 3908-3914
Crystal growth and characterization of the pyrochlore Tb2Ti2O7
Terbium titanate (Tb2Ti2O7) is a spin-ice material with remarkable magneto-optical properties.
- 12 June 2017
- Published by Royal Society of Chemistry (RSC) in CrystEngComm
- Vol. 19 (28) , 3908-3914
Crystal growth and characterization of the pyrochlore Tb2Ti2O7
Terbium titanate (Tb2Ti2O7) is a spin-ice material with remarkable magneto-optical properties.
- 1 June 2017
- Published by Elsevier in Journal of Crystal Growth
- Vol. 468, 305-310
Top-seeded solution growth of SrTiO3 single crystals virtually free of mosaicity
- 1 June 2017
- Published by Elsevier in Journal of Crystal Growth
- Vol. 468, 305-310
Top-seeded solution growth of SrTiO3 single crystals virtually free of mosaicity
- 31 March 2017
- Published by Royal Society of Chemistry (RSC) in CrystEngComm
- Vol. 19 (18) , 2553-2560
Czochralski growth and characterization of cerium doped calcium scandate
A cylindrical cerium doped CaSc2O4 bulk single crystal with a diameter of 20 mm and a total length of 70 mm was grown from the melt by the Czochralski method. Due to competitive growth and grain selection, the crystal shows high crystalline quality, verified by X-ray diffraction (XRD) rocking curve measurements and by the energy dispersive Laue mapping (EDLM) method. Rocking curve measurements revealed full width at half maximum (FWHM) values of 24, 28 and 34 arcsec for 200, 020 and 002 reflexes, respectively. The anisotropic optical and thermal properties of the biaxial material were investigated by UV-vis spectroscopy, ellipsometry and by the laser flash technique along the main crystallographic orientations. TEM measurements confirmed that cerium is preferentially incorporated into the Ca-site.
- 31 March 2017
- Published by Royal Society of Chemistry (RSC) in CrystEngComm
- Vol. 19 (18) , 2553-2560
Czochralski growth and characterization of cerium doped calcium scandate
A cylindrical cerium doped CaSc2O4 bulk single crystal with a diameter of 20 mm and a total length of 70 mm was grown from the melt by the Czochralski method. Due to competitive growth and grain selection, the crystal shows high crystalline quality, verified by X-ray diffraction (XRD) rocking curve measurements and by the energy dispersive Laue mapping (EDLM) method. Rocking curve measurements revealed full width at half maximum (FWHM) values of 24, 28 and 34 arcsec for 200, 020 and 002 reflexes, respectively. The anisotropic optical and thermal properties of the biaxial material were investigated by UV-vis spectroscopy, ellipsometry and by the laser flash technique along the main crystallographic orientations. TEM measurements confirmed that cerium is preferentially incorporated into the Ca-site.
- 14 June 2016
- Published by Royal Society of Chemistry (RSC) in CrystEngComm
- Vol. 18 (30) , 5658-5666
The influence of oxygen partial pressure in the growth atmosphere on the coloration of SrTiO3single crystal fibers
A variety of SrTiO3 (STO) fibers have been grown by the laser-heated pedestal growth method to determine the influence of the oxygen partial pressure in the growth atmosphere and the composition of the feed material on the coloration of SrTiO3. Crystals grown in oxygen rich environments are typically brown and show high Sr/Ti-ratios. Decreasing oxygen partial pressure leads to less coloration and decreasing Sr/Ti-ratios. Growth under very low oxygen partial pressure produces crystals with blueish and greyish tints. By using a feed rod with Sr-excess in an atmosphere that contains about one vol% oxygen, colorless STO fibers can be produced. The main reason for the low transmittance in crystals grown in high oxygen partial pressures is probably off-stoichiometry and the formation of scattering centers from clustered vacancies. The formation energy of the metal vacancies is considerably higher in oxygen poor environments which hinders the formation of the scattering centers. This phenomenon is further prevented by Sr-excess in the feed material that compensates SrO(g) evaporating from the melt.
- 14 June 2016
- Published by Royal Society of Chemistry (RSC) in CrystEngComm
- Vol. 18 (30) , 5658-5666
The influence of oxygen partial pressure in the growth atmosphere on the coloration of SrTiO3single crystal fibers
A variety of SrTiO3 (STO) fibers have been grown by the laser-heated pedestal growth method to determine the influence of the oxygen partial pressure in the growth atmosphere and the composition of the feed material on the coloration of SrTiO3. Crystals grown in oxygen rich environments are typically brown and show high Sr/Ti-ratios. Decreasing oxygen partial pressure leads to less coloration and decreasing Sr/Ti-ratios. Growth under very low oxygen partial pressure produces crystals with blueish and greyish tints. By using a feed rod with Sr-excess in an atmosphere that contains about one vol% oxygen, colorless STO fibers can be produced. The main reason for the low transmittance in crystals grown in high oxygen partial pressures is probably off-stoichiometry and the formation of scattering centers from clustered vacancies. The formation energy of the metal vacancies is considerably higher in oxygen poor environments which hinders the formation of the scattering centers. This phenomenon is further prevented by Sr-excess in the feed material that compensates SrO(g) evaporating from the melt.
- 9 May 2016
- Published by Royal Society of Chemistry (RSC) in CrystEngComm
- Vol. 18 (24) , 4580-4586
Origin of brown coloration in top-seeded solution grown SrTiO3crystals
SrTiO3 crystals grown by the top-seeded solution growth method in air show different shades of light brown coloration, depending on the growth conditions. In the optical transmission spectrum this is manifested as a broad absorption, tailing off from the fundamental absorption edge into the visible range. The investigation by transmission electron microscopy reveals that the light brown crystals contain voids of varying sizes in the nanometer range. Using the found size density distribution, the light scattering caused by such nano-voids in SrTiO3 is calculated on the basis of the Mie theory. A good agreement with the measured optical spectra is found. It is proposed that the formation of the nano-voids is due to vacancy clustering.
- 9 May 2016
- Published by Royal Society of Chemistry (RSC) in CrystEngComm
- Vol. 18 (24) , 4580-4586
Origin of brown coloration in top-seeded solution grown SrTiO3crystals
SrTiO3 crystals grown by the top-seeded solution growth method in air show different shades of light brown coloration, depending on the growth conditions. In the optical transmission spectrum this is manifested as a broad absorption, tailing off from the fundamental absorption edge into the visible range. The investigation by transmission electron microscopy reveals that the light brown crystals contain voids of varying sizes in the nanometer range. Using the found size density distribution, the light scattering caused by such nano-voids in SrTiO3 is calculated on the basis of the Mie theory. A good agreement with the measured optical spectra is found. It is proposed that the formation of the nano-voids is due to vacancy clustering.
- 2 June 2015
- Published by Royal Society of Chemistry (RSC) in CrystEngComm
- Vol. 17 (25) , 4662-4668
Growth of SrTiO3bulk single crystals using edge-defined film-fed growth and the Czochralski methods
Cylindrical SrTiO3 bulk single crystals with diameters of about 15 mm and lengths between 13 and 50 mm were grown from stoichiometric melts by the edge-defined film fed growth (EFG) method. Typical average etch pit density values are in the range of 1.7–2.0 × 105 cm−2. Rocking curve measurements revealed FWHM values between 28′′ and 41′′. Suitable conditions for the growth of puck-shaped single crystals were also found for the Czochralski (Cz) method. However, the structural quality was lower as compared to crystals grown by the EFG method. So far pulling SrTiO3 crystals from the melt using the Czochralski method suffered from growth instabilities like diameter fluctuation, foot formation and subsequent spiraling immediately after the seeding stage. We achieved crystals with diameters up to 42 mm and lengths of 15 mm.
- 2 June 2015
- Published by Royal Society of Chemistry (RSC) in CrystEngComm
- Vol. 17 (25) , 4662-4668
Growth of SrTiO3bulk single crystals using edge-defined film-fed growth and the Czochralski methods
Cylindrical SrTiO3 bulk single crystals with diameters of about 15 mm and lengths between 13 and 50 mm were grown from stoichiometric melts by the edge-defined film fed growth (EFG) method. Typical average etch pit density values are in the range of 1.7–2.0 × 105 cm−2. Rocking curve measurements revealed FWHM values between 28′′ and 41′′. Suitable conditions for the growth of puck-shaped single crystals were also found for the Czochralski (Cz) method. However, the structural quality was lower as compared to crystals grown by the EFG method. So far pulling SrTiO3 crystals from the melt using the Czochralski method suffered from growth instabilities like diameter fluctuation, foot formation and subsequent spiraling immediately after the seeding stage. We achieved crystals with diameters up to 42 mm and lengths of 15 mm.
- Open Access
- 28 April 2015
- Published by Wiley in Physica Status Solidi (a)
- Vol. 212 (9) , 1880-1887
Temperature-dependent optical absorption of SrTiO3
- 28 April 2015
- Published by Wiley in Physica Status Solidi (a)
- Vol. 212 (9) , 1880-1887
Open AccessTemperature-dependent optical absorption of SrTiO3
- 6 March 2015
- Published by Royal Society of Chemistry (RSC) in CrystEngComm
- Vol. 17 (17) , 3224-3234
Influence of oxygen partial pressure on SrTiO 3 bulk crystal growth from non-stoichiometric melts
Cylindrical SrTiO3 single crystals with diameters and lengths exceeding one inch were grown from non-stoichiometric melts below 1800 °C using the high temperature top-seeded solution growth (TSSG) method. Despite the large crystal diameter the quality has been improved compared to Verneuil grown crystals. Typical etch pit density (EPD) values are in the range between 2 × 104 and 2 × 105 cm−2 for bulk crystals pulled in the direction and using seeds with EPD values of 5 × 105 cm−2. So far pulling SrTiO3 crystals from the melt suffers from growth instabilities like foot formation and subsequent spiraling. To avoid them an effective heat transport via the crystal is indispensable. Especially at elevated temperatures it requires a high optical transparency in the infrared region. In this paper we report the correlation between oxygen partial pressure, composition, IR-transmittance and coloration of the crystals. The growth at a sufficiently high oxygen partial pressure leads to an increase in the optical transparency of the crystals and can thereby suppress foot or spiral formation.
- 6 March 2015
- Published by Royal Society of Chemistry (RSC) in CrystEngComm
- Vol. 17 (17) , 3224-3234
Influence of oxygen partial pressure on SrTiO 3 bulk crystal growth from non-stoichiometric melts
Cylindrical SrTiO3 single crystals with diameters and lengths exceeding one inch were grown from non-stoichiometric melts below 1800 °C using the high temperature top-seeded solution growth (TSSG) method. Despite the large crystal diameter the quality has been improved compared to Verneuil grown crystals. Typical etch pit density (EPD) values are in the range between 2 × 104 and 2 × 105 cm−2 for bulk crystals pulled in the direction and using seeds with EPD values of 5 × 105 cm−2. So far pulling SrTiO3 crystals from the melt suffers from growth instabilities like foot formation and subsequent spiraling. To avoid them an effective heat transport via the crystal is indispensable. Especially at elevated temperatures it requires a high optical transparency in the infrared region. In this paper we report the correlation between oxygen partial pressure, composition, IR-transmittance and coloration of the crystals. The growth at a sufficiently high oxygen partial pressure leads to an increase in the optical transparency of the crystals and can thereby suppress foot or spiral formation.