Anders Larsson
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Anders Larsson has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Antonio Bracale
Department of Engineering University of Naples Parthenope Naples Italy
2 shared publications - Luisa Alfieri
Dep. of Electrical Engineering and Information Technology, University of Napoli Federico II, Naples, Italy
2 shared publications Andreas Thomasson
Vehicular Systems, Dept. Electrical Engineering, Linköping University, SE-581 83 Linköping, Sweden
1 shared publicationAxel Franke
Lund Institute of Technology, Sweden
1 shared publication- Guido Carpinelli
University of Naples Federico II, Naples, Italy
1 shared publication J. Luiken ter Haseborg
Institute of High Voltage Research, University of Uppsala, Uppsala, Sweden
1 shared publication
Latest Publications
- 14 November 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Delivery
- Vol. 34 (2) , 606-615
Including Uncertainties From Customer Connections in Calculating Low-Voltage Harmonic Impedance
A method is proposed in this paper to determine the harmonic impedances in low-voltage networks in a stochastic way. The consequences of resonances for harmonic propagation and stability of power converters are summarized. By using Monte Carlo simulation, the method includes the uncertainties in customer impedances, specifically due to electronic loads and local generation. The uncertainty in customer impedance is included by considering probability distribution for the resistive, inductive and capacitive parts of the impedance. The concept of transfer impedance is used for phase-to-neutral connections. A method is developed and applied to two existing low-voltage networks in Sweden. Results show that, for these two networks, the resonant frequencies decrease around 28 % once PV panels are installed. The paper includes a discussion of some of the practical aspects of applying the proposed method.
- 14 November 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Delivery
- Vol. 34 (2) , 606-615
Including Uncertainties From Customer Connections in Calculating Low-Voltage Harmonic Impedance
A method is proposed in this paper to determine the harmonic impedances in low-voltage networks in a stochastic way. The consequences of resonances for harmonic propagation and stability of power converters are summarized. By using Monte Carlo simulation, the method includes the uncertainties in customer impedances, specifically due to electronic loads and local generation. The uncertainty in customer impedance is included by considering probability distribution for the resistive, inductive and capacitive parts of the impedance. The concept of transfer impedance is used for phase-to-neutral connections. A method is developed and applied to two existing low-voltage networks in Sweden. Results show that, for these two networks, the resonant frequencies decrease around 28 % once PV panels are installed. The paper includes a discussion of some of the practical aspects of applying the proposed method.
- Open Access
New Power Quality Indices for the Assessment of Waveform Distortions from 0 to 150 kHz in Power Systems with Renewable Generation and Modern Non-Linear Loads
The widespread use of power electronics converters, e.g., to interface renewable generation systems with the grid or to supply some high-efficiency loads, has caused increased levels of waveform distortions in the modern distribution system. Voltage and current waveforms include spectral components from 0 kHz to 150 kHz, characterized by a non-uniform time-frequency behavior. This wide interval of frequencies is currently divided into “low-frequency” (from 0 kHz to 2 kHz) and “high-frequency” (from 2 kHz to 150 kHz). While the low-frequencies have been exhaustively investigated in the relevant literature and are covered by adequate standardization, studies for the high-frequencies have been addressed only in the last decade to fill current regulatory gaps. In this paper, new power quality (PQ) indices for the assessment of waveform distortions from 0 kHz to 150 kHz are proposed. Specifically, some currently available indices have been properly modified in order to extend their application also to wide-spectrum waveforms. In the particular case of waveform distortions due to renewable generation, numerical applications prove that the proposed indices are useful tools for the characterization of problems (e.g., overheating, equipment malfunctioning, losses due to skin effects, hysteresis losses or eddy current losses) in cases of both low-frequency and high-frequency distortions.
Open AccessNew Power Quality Indices for the Assessment of Waveform Distortions from 0 to 150 kHz in Power Systems with Renewable Generation and Modern Non-Linear Loads
The widespread use of power electronics converters, e.g., to interface renewable generation systems with the grid or to supply some high-efficiency loads, has caused increased levels of waveform distortions in the modern distribution system. Voltage and current waveforms include spectral components from 0 kHz to 150 kHz, characterized by a non-uniform time-frequency behavior. This wide interval of frequencies is currently divided into “low-frequency” (from 0 kHz to 2 kHz) and “high-frequency” (from 2 kHz to 150 kHz). While the low-frequencies have been exhaustively investigated in the relevant literature and are covered by adequate standardization, studies for the high-frequencies have been addressed only in the last decade to fill current regulatory gaps. In this paper, new power quality (PQ) indices for the assessment of waveform distortions from 0 kHz to 150 kHz are proposed. Specifically, some currently available indices have been properly modified in order to extend their application also to wide-spectrum waveforms. In the particular case of waveform distortions due to renewable generation, numerical applications prove that the proposed indices are useful tools for the characterization of problems (e.g., overheating, equipment malfunctioning, losses due to skin effects, hysteresis losses or eddy current losses) in cases of both low-frequency and high-frequency distortions.
- Open Access
A Wavelet-Modified ESPRIT Hybrid Method for Assessment of Spectral Components from 0 to 150 kHz
Waveform distortions are an important issue in distribution systems. In particular, the assessment of very wide spectra, that include also components in the 2–150 kHz range, has recently become an issue of great interest. This is due to the increasing presence of high-spectral emission devices like end-user devices and distributed generation systems. This study proposed a new sliding-window wavelet-modified estimation of signal parameters by rotational invariance technique (ESPRIT) method, particularly suitable for the spectral analysis of waveforms that have very wide spectra. The method is very accurate and requires reduced computational effort. It can be applied successfully to detect spectral components in the range of 0–150 kHz introduced both by distributed power plants, such as wind and photovoltaic generation systems, and by end-user equipment connected to grids through static converters, such as fluorescent lamps.
Open AccessA Wavelet-Modified ESPRIT Hybrid Method for Assessment of Spectral Components from 0 to 150 kHz
Waveform distortions are an important issue in distribution systems. In particular, the assessment of very wide spectra, that include also components in the 2–150 kHz range, has recently become an issue of great interest. This is due to the increasing presence of high-spectral emission devices like end-user devices and distributed generation systems. This study proposed a new sliding-window wavelet-modified estimation of signal parameters by rotational invariance technique (ESPRIT) method, particularly suitable for the spectral analysis of waveforms that have very wide spectra. The method is very accurate and requires reduced computational effort. It can be applied successfully to detect spectral components in the range of 0–150 kHz introduced both by distributed power plants, such as wind and photovoltaic generation systems, and by end-user equipment connected to grids through static converters, such as fluorescent lamps.
- Open Access
- 1 January 2016
- Published by Elsevier in IFAC-PapersOnLine
- Vol. 49 (11) , 121-127
The AAC2016 Benchmark - Look-Ahead Control of Heavy Duty Trucks on Open Roads
- 1 January 2016
- Published by Elsevier in IFAC-PapersOnLine
- Vol. 49 (11) , 121-127
Open AccessThe AAC2016 Benchmark - Look-Ahead Control of Heavy Duty Trucks on Open Roads
- 3 March 2003
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
The Role of the Electrodes for the Ionization Sensor Signal
The effect of the electrodes on the early signal of the ionization sensor has been studied experimentally and with a model for the sensor. Experiments in a constant-volume combustion chamber with a generic electrode configuration allowed to investigate the role of electrode contact and the main path
- 3 March 2003
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
The Role of the Electrodes for the Ionization Sensor Signal
The effect of the electrodes on the early signal of the ionization sensor has been studied experimentally and with a model for the sensor. Experiments in a constant-volume combustion chamber with a generic electrode configuration allowed to investigate the role of electrode contact and the main path
- 1 April 1999
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Delivery
- Vol. 14 (2) , 405-410
Numerical simulation of gas discharge protectors-a review
- 1 April 1999
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Delivery
- Vol. 14 (2) , 405-410
Numerical simulation of gas discharge protectors-a review