ASAna Santos

Ana Santos

*This is an algorithmically generated author record based on publicly available information.

Ana Santos has a total of 24 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Assessing the Biotreatability of Produced Water From a Qatari Gas Field

    by Arnold Janson, Ana Santos, Mary Katebah, Altaf Hussain, Joel Minier-Matar, Simon Judd, Samer Adham

    Summary: Reuse of significant quantities of produced water (PW) extracted during gasfield operations requires treatment to remove both organic and inorganic materials. Biological treatment is generally regarded as the most cost-effective method for organics removal. For industrial waste waters, biotreatment faces distinct challenges because the PW composition can dramatically affect sludge settleability, a critical parameter in the operation of conventional biotreatment systems. Membrane bioreactors (MBRs) have an inherent advantage and have proved to be successful in the treatment of industrial waste waters because a membrane filter is used to separate the treated water from the sludge rather than separation being contingent on biomass settleability. The outcomes of a bench-scale experimental study on the application of an MBR to the biotreatment of PW from Qatari gas fields are presented for three operating parameters: hydraulic-retention time of 16 to 32 hours, solids-residence time of 60 to 120 days, and temperature of 22 to 38°C. The impact on chemical-oxygen-demand (COD) removal was evaluated through experimental testing by use of three parallel bench-scale MBRs. Low sludge concentrations (0.3–1.5 g/L of volatile suspended solids) were attained throughout, with instantaneous-flux values ranging from 3 to 15 L/(m2·h). Results indicated that the COD removal averaged 60% (54–63%), approximately one-third of this value being attributed to physical removal, with the operating parameter values shown to have no statistically significant effect on removal. Although trends were consistent with some previously reported studies performed on refinery waste water, overall removals were lower than expected. The pH of the bioreactor sludge ranged from 4.9 to 6.0, averaging 5.2, compared with a feedwater pH of 4.3, possibly contributing to the low carbon removal recorded. Adjustment of the feed pH to more than 6.5 caused a precipitate to form that contributed to membrane fouling. However, all feedwater acetate and more than 90% of the oil and grease were removed by the MBR treatment. Treatment appeared to be carbon-limited, accounting both for the absence of nitrification (with all removed organic nitrogen apparently being assimilated into the sludge) and for the low sludge-solids concentrations attained. Evidence suggests the feedwater contains a significant fraction (approximately 40%) of highly recalcitrant organic compounds presumed to be nitrogen-containing field chemicals (e.g., scale inhibitors and corrosion inhibitors).


  • Fate and removal of permethrin by conventional activated sludge treatment

    by A. Santos, R. Reif, P. Hillis, S.J. Judd

    The fate and removal of permethrin during conventional wastewater treatment were evaluated at pilot‐plant scale at different concentrations of mixed liquor suspended solids (MLSS) and, hence, different solids retention times (SRT). At feed concentrations of 0.26–0.86 µg L−1, the permethrin was removed by primary treatment at an efficiency rate of 37%, similar to previously reported data, and from 40% to 83% for secondary treatment, decreasing with decreasing SRT. Comparable ranges, from 37% up to 98%, have been reported for micropollutants with similar physicochemical properties to permethrin, such as galaxolide and tonalide. Little difference in removal was noted between the medium and low MLSS concentrations trials, the main difference in treated effluent permethrin concentration arising on changing from high to medium MLSS levels. This was attributed to the limited acclimatization period employed in these two trials, leading to higher levels of soluble organic matter in the treated water, with which the permethrin appeared to be associated.


  • Occurrence and fate of pharmaceutical and personal care products in a sewage treatment works

    by Rubén Reif, Ana Santos, Simon J. Judd, Juan M. Lema, Francisco Omil

    The occurrence and fate of eight pharmaceutical and personal care products (PPCPs) during sewage treatment has been studied in a pilot-scale treatment plant, comprising a primary settler (2.85 m3), an aeration tank (1.845 m3) and a secondary clarifier (0.5 m3), placed on site at a wastewater treatment works in the north west of the UK. It was fed both with raw sewage and the return liquor produced after sludge centrifugation, thus representing the most common configuration for a municipal sewage treatment plant based on the activated sludge process. Samples were taken at six different locations, including the return liquor stream, and analysed for musk fragrances and pharmaceutically active compounds belonging to various therapeutic groups such as anti-inflammatory drugs, tranquillisers and antiepileptics. Mass balances were conducted for those PPCPs that were quantifiable. The fate of the PPCPs was found to differ according to their physical-chemical characteristics. Anti-inflammatories underwent a degradation process and were almost completely removed from sewage during the biological treatment step. Musk fragrances were only partially removed, through adsorption onto the primary suspended solids and the biomass in the aerobic process, due to their strong lipophilic characteristics. The results of this study provide increasing evidence that the partial removal of these substances through the sewage treatment process contribute to the environmental occurrence of PPCPs. Consequently, existing STPs should be upgraded in order to attenuate the release of these substances into the aquatic environment.


  • Fate and behaviour of copper and zinc in secondary biological wastewater treatment processes: II Removal at varying sludge age

    by A. Santos, P. Barton, E. Cartmell, F. Coulon, R.S. Crane, P. Hillis, J.N. Lester, T. Stephenson, S.J. Judd

    The mechanisms for the removal of heavy metals during secondary biological treatment of wastewater, with particular emphasis on the activated sludge process, are considered. It is concluded that the predominant mechanism is the entrapment and co‐settlement of insoluble metal species in the mixed liquor (biomass). Secondary extracellular polymeric materials, particularly extracellular polysaccharides and other capsule‐forming materials, may also play a role. In general, removal of both copper and zinc was superior at the higher sludge ages employed in this study, 4.3 and 8 days, and can in part be attributed to the superior removals of both biochemical oxygen demand and effluent suspended solids achieved at these sludge ages compared with the lowest sludge age studied, 3.6 days. For both copper and zinc there is an increase in soluble metal across the activated sludge process. However, significant removal of both metals occurs as a consequence of the removal of substantial amounts of insoluble metal. The presence of returned sludge liquors, high in settleable solids, to the mixed liquor appears to moderately enhance the percentage removal of copper and zinc. Membranes used in place of secondary sedimentation also enhance removal of both metals by reducing effluent suspended solids. It is concluded that there is potential for maximizing metal removal by optimization of secondary biological treatment in a sustainable manner, without recourse to energy‐intensive or chemically‐dependent tertiary treatment technologies.


  • Fate and behaviour of copper and zinc in secondary biological wastewater treatment processes: I Evaluation of biomass adsorption capacity

    by R.S. Crane, P. Barton, E. Cartmell, F. Coulon, P. Hillis, S.J. Judd, A. Santos, T. Stephenson, J.N. Lester

    The current sources of copper and zinc in municipal wastewaters have been considered, and the changes in the concentrations and quantities of these two elements entering sewage treatment works over the last three decades have been calculated. The concentrations and quantities of the heavy metals cadmium, chromium, copper, mercury, nickel, lead and zinc, entering UK sewage treatment works, have been reduced by between 50% and 90% during this period. However, the reductions in copper and zinc appear to be at the lower end of these ranges and thus remain a cause for concern, particularly their concentrations in sewage effluents and their potential environmental impacts on receiving waters. Bench studies have been undertaken to predict removals by three types of biological wastewater treatment plants: trickling filters, conventional activated sludge and membrane bioreactors, to determine if any of these processes are more efficacious for the removal of these metals. These results suggest that, despite membrane bioreactor biomass achieving the lowest effluent suspended solids concentration and having the lowest effluent chemical oxygen demand, which is accepted as a surrogate measure of organic chemical chelating ability of the aqueous phase, they produce the highest effluent values for the two metals in this study (copper and zinc). Removals of zinc and copper in biological wastewater treatment processes are probably primarily determined by those factors influencing metal solubility in the biomass matrix.


  • The Commercial Status of Membrane Bioreactors for Municipal Wastewater

    by A. Santos, S. Judd

    The status of membrane products for membrane bioreactors is reviewed with specific reference to the municipal wastewater market. Products are identified according to their geographical location and characteristics. The latter are appraised with reference to the membrane configuration, polymeric material type, pore size and, for the hollow fiber (HF) products, the filament diameter. The market penetration of 11 of the suppliers is also assessed.


  • Criticality of Flux and Aeration for a Hollow Fiber Membrane Bioreactor

    by Hector Monclus, Sebastian Zacharias, Ana Santos, Marc Pidou, Simon Judd

    A three-element microfiltration (MF) hollow fiber (HF) membrane module has been evaluated for treating municipal wastewater by an immersed membrane bioreactor (iMBR) based on a pilot-scale plant. The flux-step method, classically used to identify the critical flux, was compared with an aeration-step method conducted at the identified critical flux of 14.5 l m−2 h−1. It was found that the permeability of the central element was found to be higher, since the air stream imparted to the end elements was dissipated because there is no channel formed by the proximity of the neighboring elements. The aeration-step trials revealed the critical specific aeration demand for both intermittent and continuous aeration regimes to be lower than that applied to the critical flux-step experiments. This implies that the operating conditions identified for critical flux-step experiment are over conservative, corroborating results from previous reports, and that aeration stepping presents a more representative method for identifying sustainable operating conditions.


  • The fate of metals in wastewater treated by the activated sludge process and membrane bioreactors: A brief review

    by Ana Santos, Simon Judd

    The fate of metals in wastewater treatment by the conventional activated sludge process (ASP) and membrane bioreactors (MBRs) is reviewed. The review outlines the environmental and health impacts of metals, but focuses primarily on data reported for removal of toxic metals, and some other high-profile inorganic micropollutants such as aluminium and arsenic, by wastewater treatment processes. Information from pilot and full scale plants is included, with corroboratory reports from bench-scale tests. General trends in removal across different metals are considered, along with the impact of the key process operating determinant of solids retention time. It is concluded that the only consistent trend in metals removal is that it is most effectively achieved through efficient solids separation, and that this represents the primary advantage offered by the MBR. As such, MBRs achieve averaged metals removals which are consistently but not dramatically higher than the ranges reported by the ASP: 64–92% vs. 51–87%, with no more than a 55% decrease on average in effluent concentration. The slightly greater removal attained is attributable to the additional suspended solids retention attained by the membrane process. In either case, further removal of metals would demand a tertiary process for removal of the dissolved material.


  • Integrated immobilized cell reactor-adsorption system for β-cyclodextrin production: a model study using PVA-cryogel entrapped Bacillus agaradhaerens cells

    by Rita F. Martins, Fatima M. Plieva, Ana Santos, Rajni Hatti-Kaul

    Production of cyclodextrins (CDs) by immobilized cells of the alkaliphilic Bacillus agaradhaerensLS-3C with integrated product recovery was studied. The microorganism was entrapped in polyvinyl...