Ekrem Kandemir
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Ekrem Kandemir has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
Selim Borekci
Akdeniz Univ, Dept Elect & Elect Engn, Antalya, Turkey
5 shared publications- Selim Borekci
Department of Electrical & Electronics Engineering, Akdeniz University, Antalya, Turkey
3 shared publications Numan S. Cetin
Solar Energy Institute, Ege University, Izmir, Turkey
2 shared publicationsNuman Sabit Cetin
Ege Univ, Solar Energy Inst, Izmir, Turkey
2 shared publicationsS. Dindar
The Scientific and Technological Research Council of Turkey (TUBITAK) National Observatory Akdeniz University, 07058 Antalya, Turkey
2 shared publicationsA. Tat
The Scientific and Technological Research Council of Turkey (TUBITAK) National Observatory Akdeniz University, 07058 Antalya, Turkey
1 shared publication
Latest Publications
- 31 December 2023
- Published by Turkish Astronomical Society in Turkish Journal of Astronomy and Astrophysics
- Vol. 4 (3) , 473-477
Modernization of Dome Automation System for the RTT150 Russian-Turkish Telescope Located at TUBITAK National Observatory
RTT150 telescope is a large 1.5-meter (m) telescope, which is located on the Bakirlitepe mountain in Antalya. This telescope uses 10.5 m diameter double-skin dome, which was made by Observa Dome in USA. The old automation system of the dome includes old, hard-to-supply electronic components and it is difficult to solve system faults due to absence of the dome automation manuals. Therefore, this study proposes a new simple dome automation control system, which has new, easy-to-supply electronic components and also fiber connections in order to prevent possible surges effects. The realized system provides simple hand use control on its RS232 serial port and plug-play feature. Effectiveness and running tests of the proposed new system has been verified through test observation results.
- 31 December 2023
- Published by Turkish Astronomical Society in Turkish Journal of Astronomy and Astrophysics
- Vol. 4 (3) , 473-477
Modernization of Dome Automation System for the RTT150 Russian-Turkish Telescope Located at TUBITAK National Observatory
RTT150 telescope is a large 1.5-meter (m) telescope, which is located on the Bakirlitepe mountain in Antalya. This telescope uses 10.5 m diameter double-skin dome, which was made by Observa Dome in USA. The old automation system of the dome includes old, hard-to-supply electronic components and it is difficult to solve system faults due to absence of the dome automation manuals. Therefore, this study proposes a new simple dome automation control system, which has new, easy-to-supply electronic components and also fiber connections in order to prevent possible surges effects. The realized system provides simple hand use control on its RS232 serial port and plug-play feature. Effectiveness and running tests of the proposed new system has been verified through test observation results.
- 23 September 2023
- Published by Springer Nature in Electrical Engineering
- Vol. 106 (2) , 1585-1604
LCC-S compensated variable inductor-based hybrid topology analysis for inductive power transfer system
- 23 September 2023
- Published by Springer Nature in Electrical Engineering
- Vol. 106 (2) , 1585-1604
LCC-S compensated variable inductor-based hybrid topology analysis for inductive power transfer system
- 17 January 2022
- Published by Wiley in International Journal of Circuit Theory and Applications
- Vol. 50 (5) , 1770-1792
Single‐stage photovoltaic system design based on energy recovery and fuzzy logic control for partial shading condition
Multiple local maximum power points occur in the power–voltage characteristic curve of the photovoltaic (PV) systems due to use of bypass diodes under partial shading conditions, and this also leads to decrease the maximum power level of the PV system. This paper proposes an energy recovery‐based PV system to enhance maximum power level and working efficiency under partial shading conditions. In this study, a 350‐W PV system design and application, which can operate at maximum power point under partial shading condition, is made using two 175‐W PV panels. The main purpose of the system is to maintain power generation from the shaded PV panel by energy recovery circuit without any damage on the PV panels and also connect PV panels to the grid by single power circuit. To perform the maximum power point tracking (MPPT) task for the PV system, a single input variable used fuzzy logic control (FLC)‐based MPPT method is developed. Therefore, this study investigates and analyzes energy recovery connected and fuzzy logic control‐based MPPT controlled PV system under partial shading conditions. Effectiveness of the proposed system has been verified through simulation and experimental results.
- 17 January 2022
- Published by Wiley in International Journal of Circuit Theory and Applications
- Vol. 50 (5) , 1770-1792
Single‐stage photovoltaic system design based on energy recovery and fuzzy logic control for partial shading condition
Multiple local maximum power points occur in the power–voltage characteristic curve of the photovoltaic (PV) systems due to use of bypass diodes under partial shading conditions, and this also leads to decrease the maximum power level of the PV system. This paper proposes an energy recovery‐based PV system to enhance maximum power level and working efficiency under partial shading conditions. In this study, a 350‐W PV system design and application, which can operate at maximum power point under partial shading condition, is made using two 175‐W PV panels. The main purpose of the system is to maintain power generation from the shaded PV panel by energy recovery circuit without any damage on the PV panels and also connect PV panels to the grid by single power circuit. To perform the maximum power point tracking (MPPT) task for the PV system, a single input variable used fuzzy logic control (FLC)‐based MPPT method is developed. Therefore, this study investigates and analyzes energy recovery connected and fuzzy logic control‐based MPPT controlled PV system under partial shading conditions. Effectiveness of the proposed system has been verified through simulation and experimental results.
- Open Access
- 1 September 2021
- Published by Universidad Nacional Autonoma de Mexico in Revista Mexicana de Astronomía y Astrofísica Serie de Conferencias
- Vol. 53, 18-22
NEW IMPROVEMENTS AT TUG-T60 ROBOTIC TELESCOPE
- 1 September 2021
- Published by Universidad Nacional Autonoma de Mexico in Revista Mexicana de Astronomía y Astrofísica Serie de Conferencias
- Vol. 53, 18-22
Open AccessNEW IMPROVEMENTS AT TUG-T60 ROBOTIC TELESCOPE
- 22 August 2018
- Published by Kaunas University of Technology (KTU) in Elektronika ir Elektrotechnika
- Vol. 24 (4) , 45-52
Conventional and Soft-Computing Based MPPT Methods Comparisons in Direct and Indirect Modes for Single Stage PV Systems
Conventional and Soft-Computing Based MPPT Methods Comparisons in Direct and Indirect Modes for Single Stage PV Systems
- 22 August 2018
- Published by Kaunas University of Technology (KTU) in Elektronika ir Elektrotechnika
- Vol. 24 (4) , 45-52
Conventional and Soft-Computing Based MPPT Methods Comparisons in Direct and Indirect Modes for Single Stage PV Systems
Conventional and Soft-Computing Based MPPT Methods Comparisons in Direct and Indirect Modes for Single Stage PV Systems
- 25 April 2018
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 47 (8) , 4463-4474
Comparative Analysis of Reduced-Rule Compressed Fuzzy Logic Control and Incremental Conductance MPPT Methods
- 25 April 2018
- Published by Springer Nature in Journal of Electronic Materials
- Vol. 47 (8) , 4463-4474
Comparative Analysis of Reduced-Rule Compressed Fuzzy Logic Control and Incremental Conductance MPPT Methods
- 1 October 2017
- Published by Elsevier in Renewable and Sustainable Energy Reviews
- Vol. 78, 93-112
A comprehensive overview of maximum power extraction methods for PV systems
- 1 October 2017
- Published by Elsevier in Renewable and Sustainable Energy Reviews
- Vol. 78, 93-112
A comprehensive overview of maximum power extraction methods for PV systems
- Open Access
- 22 March 2017
- Published by International University of Sarajevo in Periodicals of Engineering and Natural Sciences (PEN)
- Vol. 5 (1)
A Comparison of Perturb & Observe and Fuzzy-Logic Based MPPT Methods for Uniform Environment Conditions
A Comparison of Perturb & Observe and Fuzzy-Logic Based MPPT Methods for Uniform Environment Conditions
- 22 March 2017
- Published by International University of Sarajevo in Periodicals of Engineering and Natural Sciences (PEN)
- Vol. 5 (1)
Open AccessA Comparison of Perturb & Observe and Fuzzy-Logic Based MPPT Methods for Uniform Environment Conditions
A Comparison of Perturb & Observe and Fuzzy-Logic Based MPPT Methods for Uniform Environment Conditions
- 1 March 2016
- Published by Universitas Ahmad Dahlan in TELKOMNIKA (Telecommunication Computing Electronics and Control)
- Vol. 14 (1) , 156-161
Design of a New Telescope Control System for Use in Astronomical Transient Events
Robotic autonomous telescopes provide highlevel control by selecting astronomical targets for observation, and they usually run under the control of a scheduler. TalonVIEW is a newly designed robotic autonomous telescope control system (TCS) for 16 inches telescope mount for use in astronomical transient events. The telescope control algorithm was implemented in PXI chassis written in GProgramming (LabVIEW) on realtime operating system(PharLab) from scratch. A new TCP/IP library was also implemented in Talon software to communicate with Pharlab in PXI chassis. Initial setup without any permanent pier and polar alignment showed that the pointing error of the telescope has been obtained as 2.22 arcminutes (132 arcseconds) in RA axis (horizontal axis of the image) and 25 arcseconds in Dec axis (vertical axis of the image), and tracking error has been observed as 4.8 arcseconds per second.
- 1 March 2016
- Published by Universitas Ahmad Dahlan in TELKOMNIKA (Telecommunication Computing Electronics and Control)
- Vol. 14 (1) , 156-161
Design of a New Telescope Control System for Use in Astronomical Transient Events
Robotic autonomous telescopes provide highlevel control by selecting astronomical targets for observation, and they usually run under the control of a scheduler. TalonVIEW is a newly designed robotic autonomous telescope control system (TCS) for 16 inches telescope mount for use in astronomical transient events. The telescope control algorithm was implemented in PXI chassis written in GProgramming (LabVIEW) on realtime operating system(PharLab) from scratch. A new TCP/IP library was also implemented in Talon software to communicate with Pharlab in PXI chassis. Initial setup without any permanent pier and polar alignment showed that the pointing error of the telescope has been obtained as 2.22 arcminutes (132 arcseconds) in RA axis (horizontal axis of the image) and 25 arcseconds in Dec axis (vertical axis of the image), and tracking error has been observed as 4.8 arcseconds per second.