Hiroki Hatayama
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Hiroki Hatayama has a total of 25 co-authors. Here are the top co-authors by number of shared publications:
- Ichiro Daigo
Research Center for Advanced Science and Technology (RCAST), The University of Tokyo, 4 Chome-6-1 Komaba, Meguro-ku, Tokyo 153-8904, Japan
10 shared publications Yasunari Matsuno
7 shared publicationsYoshihiro Adachi
7 shared publicationsKiyotaka Tahara
National Institute of Advanced Industrial Science and Technology
6 shared publications- Kiyotaka Tahara
National Institute of Advanced Industrial Science and Technology (AIST), 16-1 Onogawa, Tsukuba 305-8569, Japan
4 shared publications Hiroyuki Yamada
Department of Materials Engineering, Graduate School of Engineering, The University of Tokyo
3 shared publications
Latest Publications
- Open Access
- 15 August 2025
- Published by Elsevier in Resources Policy
- Vol. 109
Visualizing the regional risk in raw material supply based on event analysis
- 15 August 2025
- Published by Elsevier in Resources Policy
- Vol. 109
Open AccessVisualizing the regional risk in raw material supply based on event analysis
- Open Access
- 23 May 2025
- Published by MDPI AG in Sustainability
- Vol. 17 (11) , 4830
Social Life Cycle Assessment Methodology to Capture “More-Good” and “Less-Bad” Social Impacts—Part 1: A Methodological Framework
Social life cycle assessment (SLCA) systematically assesses the social impacts of the entire life cycle of a product system or service that stretches from extraction and processing of raw material to recycling and final disposal. Most SLCA techniques highlight negative impacts and their reductions, while positive social impacts and their increments have received less attention. Positive social impacts highlight chances for improving human well-being and present a complete picture of a product’s overall social impact. The literature shows that norms for defining positive impacts and methodologies for assessing them are not yet fully established and retain lacunae, which can lead to conflicts in the usage of the term “positive impacts”. Therefore, we develop a novel SLCA methodology that can straightforwardly distinguish between the “good” and “bad” social state at the subcategories in the latest version of methodological sheets for SLCA. Here, we refrain from using the terms “positive” and “negative” as those terms retain scattered consensus; instead, we use the fresh terms “good” and “bad”, which are simpler to understand. To describe the positive changes in good and bad states, we introduce two new terms into SLCA: “more-good” (improvements within the good domain) and “less-bad” (improvements within the bad domain). Good and bad social domains are distinguished using compliance levels (e.g., industry standards), referred to as baseline requirements. Social impacts were evaluated using the social performance index (SPI). The SPI is computed by multiplying social performance levels with working hours at the factory/company level. Social performance levels are evaluated using a decision tree and a systematically proposed set of indicators representing basic requirements and good and bad domains of each subcategory. Working hours were used as an activity variable, estimated using a working hour model. This enables the application of the SPI across the supply chain of a product by linking social impacts to the time spent on each activity.
- 23 May 2025
- Published by MDPI AG in Sustainability
- Vol. 17 (11) , 4830
Open AccessSocial Life Cycle Assessment Methodology to Capture “More-Good” and “Less-Bad” Social Impacts—Part 1: A Methodological Framework
Social life cycle assessment (SLCA) systematically assesses the social impacts of the entire life cycle of a product system or service that stretches from extraction and processing of raw material to recycling and final disposal. Most SLCA techniques highlight negative impacts and their reductions, while positive social impacts and their increments have received less attention. Positive social impacts highlight chances for improving human well-being and present a complete picture of a product’s overall social impact. The literature shows that norms for defining positive impacts and methodologies for assessing them are not yet fully established and retain lacunae, which can lead to conflicts in the usage of the term “positive impacts”. Therefore, we develop a novel SLCA methodology that can straightforwardly distinguish between the “good” and “bad” social state at the subcategories in the latest version of methodological sheets for SLCA. Here, we refrain from using the terms “positive” and “negative” as those terms retain scattered consensus; instead, we use the fresh terms “good” and “bad”, which are simpler to understand. To describe the positive changes in good and bad states, we introduce two new terms into SLCA: “more-good” (improvements within the good domain) and “less-bad” (improvements within the bad domain). Good and bad social domains are distinguished using compliance levels (e.g., industry standards), referred to as baseline requirements. Social impacts were evaluated using the social performance index (SPI). The SPI is computed by multiplying social performance levels with working hours at the factory/company level. Social performance levels are evaluated using a decision tree and a systematically proposed set of indicators representing basic requirements and good and bad domains of each subcategory. Working hours were used as an activity variable, estimated using a working hour model. This enables the application of the SPI across the supply chain of a product by linking social impacts to the time spent on each activity.
- Open Access
- 3 May 2025
- Published by Elsevier in Resources, Conservation and Recycling
- Vol. 220
Effects of promoting decarbonization and digitalization on future copper cycles in Japan
- 3 May 2025
- Published by Elsevier in Resources, Conservation and Recycling
- Vol. 220
Open AccessEffects of promoting decarbonization and digitalization on future copper cycles in Japan
- Open Access
- 25 November 2022
- Published by Elsevier in Resources, Conservation and Recycling
- Vol. 190
Spatial and in-product density characterization of in-use copper stocks in Japan for stock recyclability assessment
- 25 November 2022
- Published by Elsevier in Resources, Conservation and Recycling
- Vol. 190
Open AccessSpatial and in-product density characterization of in-use copper stocks in Japan for stock recyclability assessment
- Open Access
- 1 March 2021
- Published by Elsevier in Resources, Conservation and Recycling
- Vol. 166
Significance of country-specific context in metal scarcity assessment from a perspective of short-term mining capacity
- 1 March 2021
- Published by Elsevier in Resources, Conservation and Recycling
- Vol. 166
Open AccessSignificance of country-specific context in metal scarcity assessment from a perspective of short-term mining capacity
- Open Access
- 1 March 2018
- Published by Elsevier in Resources Policy
- Vol. 55, 96-102
Adopting an objective approach to criticality assessment: Learning from the past
- 1 March 2018
- Published by Elsevier in Resources Policy
- Vol. 55, 96-102
Open AccessAdopting an objective approach to criticality assessment: Learning from the past
- 1 January 2018
- Published by Elsevier in Journal of Cleaner Production
- Vol. 172, 582-590
Revealing hidden CO2 impacts from consequential consumption by matrix analysis: Application to Japanese single households
- 1 January 2018
- Published by Elsevier in Journal of Cleaner Production
- Vol. 172, 582-590
Revealing hidden CO2 impacts from consequential consumption by matrix analysis: Application to Japanese single households
- 20 September 2016
- Published by Springer Nature
- p. 933-943
Strategy Planning Before Urban Mining: Exploring the Targets
- 20 September 2016
- Published by Springer Nature
- p. 933-943
Strategy Planning Before Urban Mining: Exploring the Targets
- 1 June 2015
- Published by Elsevier in Resources Policy
- Vol. 44, 72-80
Evaluating the sufficiency of Japan׳s mineral resource entitlements for supply risk mitigation
- 1 June 2015
- Published by Elsevier in Resources Policy
- Vol. 44, 72-80
Evaluating the sufficiency of Japan׳s mineral resource entitlements for supply risk mitigation