Chengxian Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Chengxian Wang has a total of 42 co-authors. Here are the top co-authors by number of shared publications:
Xiaoli Chai
4 shared publicationsBin Lu
3 shared publicationsBoran Wu
State Key Laboratory of Water Pollution Control and Green Resource Recycling, College of Environmental Science and Engineering, Tongji University, 1239 Siping Road, Shanghai 200092, China; Shanghai Institute of Pollution Control and Ecological Security, Shanghai 200092, China
3 shared publicationsHongbo Han
Hunan Sanyou Environmental Protection Co. Ltd., Changsha, Hunan, China
3 shared publicationsXiaohu Dai
State Key Laboratory of Water Pollution Control and Green Resource Recycling, College of Environmental Science and Engineering, Tongji University, 1239 Siping Road, Shanghai 200092, China; Shanghai Institute of Pollution Control and Ecological Security, Shanghai 200092, China
3 shared publications- Boran Wu
State Key Laboratory of Water Pollution Control and Green Resource Recycling, College of Environmental Science and Engineering, Tongji University, Shanghai 200092, China; Shanghai Institute of Pollution Control and Ecological Security, Shanghai 200092, China
2 shared publications
Latest Publications
- 5 March 2026
- Published by Elsevier in Bioresource Technology
- Vol. 449, 134354
Membrane aerated biofilm reactors for sustainable nitrogen management: Mechanisms, process integration, and engineering implications
- 5 March 2026
- Published by Elsevier in Bioresource Technology
- Vol. 449, 134354
Membrane aerated biofilm reactors for sustainable nitrogen management: Mechanisms, process integration, and engineering implications
- Open Access
- 19 February 2026
- Published by Elsevier in SSRN Electronic Journal
Enhanced oxygen transfer and anti-fouling performance of Membrane Aerated Biofilm Reactors modified by a novel Asymmetric membrane structure
While Membrane Aerated Biofilm Reactors offer high energy efficiency, their performance is often compromised by the inherent conflict between biomass affinity and fouling resistance. Developing membrane interfaces that support biofilm activity while mitigating surface fouling is crucial for advancing this technology. This study modified hydrophobic polypropylene membranes via thermal oxidation (0.2 M KMnO4, 70°C, 30 min) followed by Tannin deposition. The initial oxidation reduced the water contact angle from 120° to 50°, increased the bubble point to 5 kPa, and limited 24-hour Bovine Serum Albumin fouling to 93 ug/(cm2·d). The subsequent Tannin deposition created a novel asymmetric membrane structure with water contact angle of < 15°, a 12 kPa bubble point, and maintained an oxygen transfer rate of 10.23 gO2/(m2·d). In membrane aerated biofilm reactors based nitrogenous wastewater treatment, the Janus membrane achieved high NH4+-N and COD degradation rates of 238.4 and 1512.1 mg/(m2/h). The total nitrogen removal efficiency reached 174.4 mg/(m2/h) and the nitrification rate was up to 73%, demonstrating highly efficient pollutant transformation. This work offers a practical, low-cost approach to engineering high-performance membranes for advanced wastewater bioreactors. This study effectively resolves the trade-off between oxygen transfer performance and anti-fouling hydrophilicity.
- 19 February 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessEnhanced oxygen transfer and anti-fouling performance of Membrane Aerated Biofilm Reactors modified by a novel Asymmetric membrane structure
While Membrane Aerated Biofilm Reactors offer high energy efficiency, their performance is often compromised by the inherent conflict between biomass affinity and fouling resistance. Developing membrane interfaces that support biofilm activity while mitigating surface fouling is crucial for advancing this technology. This study modified hydrophobic polypropylene membranes via thermal oxidation (0.2 M KMnO4, 70°C, 30 min) followed by Tannin deposition. The initial oxidation reduced the water contact angle from 120° to 50°, increased the bubble point to 5 kPa, and limited 24-hour Bovine Serum Albumin fouling to 93 ug/(cm2·d). The subsequent Tannin deposition created a novel asymmetric membrane structure with water contact angle of < 15°, a 12 kPa bubble point, and maintained an oxygen transfer rate of 10.23 gO2/(m2·d). In membrane aerated biofilm reactors based nitrogenous wastewater treatment, the Janus membrane achieved high NH4+-N and COD degradation rates of 238.4 and 1512.1 mg/(m2/h). The total nitrogen removal efficiency reached 174.4 mg/(m2/h) and the nitrification rate was up to 73%, demonstrating highly efficient pollutant transformation. This work offers a practical, low-cost approach to engineering high-performance membranes for advanced wastewater bioreactors. This study effectively resolves the trade-off between oxygen transfer performance and anti-fouling hydrophilicity.
- 22 September 2025
- Published by Elsevier in Water Research
- Vol. 288 (Pt A) , 124635
Micro-granular sludge driven by powder carrier in membrane bioreactor: highly-efficient N & P removal and membrane fouling alleviation
- 22 September 2025
- Published by Elsevier in Water Research
- Vol. 288 (Pt A) , 124635
Micro-granular sludge driven by powder carrier in membrane bioreactor: highly-efficient N & P removal and membrane fouling alleviation
- Open Access
- 4 May 2025
- Published by Elsevier in Water Research X
- Vol. 28
Enhanced selective recovery of powder carrier-supported biofilms for enrichment of denitrifying functional bacteria
- 4 May 2025
- Published by Elsevier in Water Research X
- Vol. 28
Open AccessEnhanced selective recovery of powder carrier-supported biofilms for enrichment of denitrifying functional bacteria
- 13 March 2024
- Published by Elsevier in Water Research
- Vol. 255, 121465
Dissolved organic carbon spurs bacterial-algal competition and phosphorus-paucity adaptation: Boosting Microcystis' phosphorus uptake capacity
- 13 March 2024
- Published by Elsevier in Water Research
- Vol. 255, 121465
Dissolved organic carbon spurs bacterial-algal competition and phosphorus-paucity adaptation: Boosting Microcystis' phosphorus uptake capacity
- 30 November 2023
- Published by Elsevier in Electrochimica Acta
- Vol. 475
Novel three-dimensional electrode structures with urchin-like pore canal for high-performance microbial fuel cells
- 30 November 2023
- Published by Elsevier in Electrochimica Acta
- Vol. 475
Novel three-dimensional electrode structures with urchin-like pore canal for high-performance microbial fuel cells
- 1 January 2022
- Published by Elsevier in Chemosphere
- Vol. 287 (Pt 3) , 132322
Novel micro-granular sludge process for highly efficient treatment of low-strength and low C/N ratio municipal wastewater
- 1 January 2022
- Published by Elsevier in Chemosphere
- Vol. 287 (Pt 3) , 132322
Novel micro-granular sludge process for highly efficient treatment of low-strength and low C/N ratio municipal wastewater
- Open Access
Applications of Graphene-Modified Electrodes in Microbial Fuel Cells
Graphene-modified materials have captured increasing attention for energy applications due to their superior physical and chemical properties, which can significantly enhance the electricity generation performance of microbial fuel cells (MFC). In this review, several typical synthesis methods of graphene-modified electrodes, such as graphite oxide reduction methods, self-assembly methods, and chemical vapor deposition, are summarized. According to the different functions of the graphene-modified materials in the MFC anode and cathode chambers, a series of design concepts for MFC electrodes are assembled, e.g., enhancing the biocompatibility and improving the extracellular electron transfer efficiency for anode electrodes and increasing the active sites and strengthening the reduction pathway for cathode electrodes. In spite of the challenges of MFC electrodes, graphene-modified electrodes are promising for MFC development to address the reduction in efficiency brought about by organic waste by converting it into electrical energy.
Open AccessApplications of Graphene-Modified Electrodes in Microbial Fuel Cells
Graphene-modified materials have captured increasing attention for energy applications due to their superior physical and chemical properties, which can significantly enhance the electricity generation performance of microbial fuel cells (MFC). In this review, several typical synthesis methods of graphene-modified electrodes, such as graphite oxide reduction methods, self-assembly methods, and chemical vapor deposition, are summarized. According to the different functions of the graphene-modified materials in the MFC anode and cathode chambers, a series of design concepts for MFC electrodes are assembled, e.g., enhancing the biocompatibility and improving the extracellular electron transfer efficiency for anode electrodes and increasing the active sites and strengthening the reduction pathway for cathode electrodes. In spite of the challenges of MFC electrodes, graphene-modified electrodes are promising for MFC development to address the reduction in efficiency brought about by organic waste by converting it into electrical energy.