Shinya Ohno
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Shinya Ohno has a total of 207 co-authors. Here are the top co-authors by number of shared publications:
- Masatoshi Tanaka
Faculty of Engineering, Yokohama National University, Yokohama 240-8501, Japan
36 shared publications K. Shudo
8 shared publicationsK Shudo
7 shared publicationsTakanori Suzuki
Department of Applied Physics, National Defense Academy of Japan, 1-10-20 Hashirimizu, Yokosuka, Kanagawa 239–8686, Japan
7 shared publications- Kazuhiko Mase
Institute of Materials Structure Science, High Energy Accelerator Research Organization (KEK) 1 , Tsukuba 305-0801
6 shared publications - Ken-Ichi Shudo
Department of Physics, Yokohama National University, Yokohama, Japan
6 shared publications
Latest Publications
- 19 October 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 129 (16)
Optical signature of bias-induced carrier injection in a WSe2/MoS2 heterostructure diode
We investigate the bias-dependent photoluminescence (PL) response of a WSe2/MoS2 heterostructure diode. Under forward bias, trion-related emission in WSe2 is markedly enhanced, whereas reverse bias produces minimal spectral changes. This asymmetric response cannot be explained by electric-field effects alone and instead reflects carrier injection at the functional interface. These results demonstrate that PL provides a direct optical probe of carrier injection in an operating van der Waals heterostructure. More broadly, this approach establishes spatially resolved PL spectroscopy as a versatile tool for pinpointing the interfaces governing device operation in van der Waals heterostructures.
- 19 October 2026
- Published by AIP Publishing in Applied Physics Letters
- Vol. 129 (16)
Optical signature of bias-induced carrier injection in a WSe2/MoS2 heterostructure diode
We investigate the bias-dependent photoluminescence (PL) response of a WSe2/MoS2 heterostructure diode. Under forward bias, trion-related emission in WSe2 is markedly enhanced, whereas reverse bias produces minimal spectral changes. This asymmetric response cannot be explained by electric-field effects alone and instead reflects carrier injection at the functional interface. These results demonstrate that PL provides a direct optical probe of carrier injection in an operating van der Waals heterostructure. More broadly, this approach establishes spatially resolved PL spectroscopy as a versatile tool for pinpointing the interfaces governing device operation in van der Waals heterostructures.
- 12 May 2026
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 130 (20) , 7200-7206
Ground State and Magnetic Properties of Iron Phthalocyanine Thin Films Grown on a Monolayer Graphene Sheet
- 12 May 2026
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 130 (20) , 7200-7206
Ground State and Magnetic Properties of Iron Phthalocyanine Thin Films Grown on a Monolayer Graphene Sheet
- Open Access
- 10 April 2023
- Published by Surface Science Society Japan in Vacuum and Surface Science
- Vol. 66 (4) , 198-199
特集「結晶成長ダイナミクスの展望 ―平衡過程と非平衡過程の協奏―」企画趣旨
In recent years, crystal growth processes have attracted great interest because of the importance in semiconductor devices as well as organic devices. In the present articles, experimental innovations to observe crystal growth processes using various microscopic methods are reviewed. Correspondingly, novel approaches in the theoretical investigation of crystal growth processes are also reviewed. Step dynamics including macrostep formation and step bunching, pattern formation, high-quality crystallization, chemical vapor deposition (CVD) process, and various crystal growth environments not only in vacuum but also in liquid and in space are focused.
- 10 April 2023
- Published by Surface Science Society Japan in Vacuum and Surface Science
- Vol. 66 (4) , 198-199
Open Access特集「結晶成長ダイナミクスの展望 ―平衡過程と非平衡過程の協奏―」企画趣旨
In recent years, crystal growth processes have attracted great interest because of the importance in semiconductor devices as well as organic devices. In the present articles, experimental innovations to observe crystal growth processes using various microscopic methods are reviewed. Correspondingly, novel approaches in the theoretical investigation of crystal growth processes are also reviewed. Step dynamics including macrostep formation and step bunching, pattern formation, high-quality crystallization, chemical vapor deposition (CVD) process, and various crystal growth environments not only in vacuum but also in liquid and in space are focused.
- Open AccessEmergence of metallic surface states and negative differential conductance in thin $β$-FeSi$_2$ films on Si(001)The electronic properties of the surface of $β$-FeSi$_2$ have been debated for a long while. We studied the surface states of $β$-FeSi$_2$ films grown on Si(001) substrates using scanning tunnelling microscopy (STM) and spectroscopy (STS), with the aid of density functional theory (DFT) calculations. STM simulations using the surface model proposed by Romanyuk et al. [Phys. Rev. B 90, 155305 (2014)] reproduce the detailed features of experimental STM images. The result of STS showed metallic surface states in accordance with theoretical predictions. The Fermi level was pinned by a surface state that appeared in the bulk band gap of the $β$-FeSi$_2$ film, irrespective of the polarity of the substrate. We also observed negative differential conductance at $\sim$0.45 eV above the Fermi level in STS measurements performed at 4.5 K, reflecting the presence of an energy gap in the unoccupied surface states of $β$-FeSi$_2$.Open AccessEmergence of metallic surface states and negative differential conductance in thin $β$-FeSi$_2$ films on Si(001)The electronic properties of the surface of $β$-FeSi$_2$ have been debated for a long while. We studied the surface states of $β$-FeSi$_2$ films grown on Si(001) substrates using scanning tunnelling microscopy (STM) and spectroscopy (STS), with the aid of density functional theory (DFT) calculations. STM simulations using the surface model proposed by Romanyuk et al. [Phys. Rev. B 90, 155305 (2014)] reproduce the detailed features of experimental STM images. The result of STS showed metallic surface states in accordance with theoretical predictions. The Fermi level was pinned by a surface state that appeared in the bulk band gap of the $β$-FeSi$_2$ film, irrespective of the polarity of the substrate. We also observed negative differential conductance at $\sim$0.45 eV above the Fermi level in STS measurements performed at 4.5 K, reflecting the presence of an energy gap in the unoccupied surface states of $β$-FeSi$_2$.
- 10 February 2023
- Published by IOP Publishing in Journal of Physics: Condensed Matter
- Vol. 35 (13) , 135001
Emergence of metallic surface states and negative differential conductance in thin β-FeSi2 films on Si(001)
The electronic properties of the surface of β-FeSi2 have been debated for a long. We studied the surface states of β-FeSi2 films grown on Si(001) substrates using scanning tunnelling microscopy (STM) and spectroscopy (STS), with the aid of density functional theory calculations. STM simulations using the surface model proposed by Romanyuk et al (2014 Phys. Rev. B 90 155305) reproduce the detailed features of experimental STM images. The result of STS showed metallic surface states in accordance with theoretical predictions. The Fermi level was pinned by a surface state that appeared in the bulk band gap of the β-FeSi2 film, irrespective of the polarity of the substrate. We also observed negative differential conductance at ∼0.45 eV above the Fermi level in STS measurements performed at 4.5 K, reflecting the presence of an energy gap in the unoccupied surface states of β-FeSi2.
- 10 February 2023
- Published by IOP Publishing in Journal of Physics: Condensed Matter
- Vol. 35 (13) , 135001
Emergence of metallic surface states and negative differential conductance in thin β-FeSi2 films on Si(001)
The electronic properties of the surface of β-FeSi2 have been debated for a long. We studied the surface states of β-FeSi2 films grown on Si(001) substrates using scanning tunnelling microscopy (STM) and spectroscopy (STS), with the aid of density functional theory calculations. STM simulations using the surface model proposed by Romanyuk et al (2014 Phys. Rev. B 90 155305) reproduce the detailed features of experimental STM images. The result of STS showed metallic surface states in accordance with theoretical predictions. The Fermi level was pinned by a surface state that appeared in the bulk band gap of the β-FeSi2 film, irrespective of the polarity of the substrate. We also observed negative differential conductance at ∼0.45 eV above the Fermi level in STS measurements performed at 4.5 K, reflecting the presence of an energy gap in the unoccupied surface states of β-FeSi2.
- Open Access
- 10 November 2022
- Published by Surface Science Society Japan in Vacuum and Surface Science
- Vol. 65 (11) , 526-530
Restoration of Oxygen Vacancies on an Anatase TiO2(001) Surface with Supersonic Seeded Oxygen Molecular Beam
We investigated the oxidation of oxygen vacancies at the surface of anatase TiO2(001) using a supersonic seeded molecular beam (SSMB) of oxygen. The oxygen vacancies at the top surface and subsurface could be eliminated by the supply of oxygen using an SSMB. Oxygen vacancies are present on the surface of anatase TiO2(001) which is not performed surface cleaning prior to XPS measurements under ultra-high vacuum. These vacancies, which are stable in the ambient condition, could also be effectively eliminated by using the oxygen SSMB.
- 10 November 2022
- Published by Surface Science Society Japan in Vacuum and Surface Science
- Vol. 65 (11) , 526-530
Open AccessRestoration of Oxygen Vacancies on an Anatase TiO2(001) Surface with Supersonic Seeded Oxygen Molecular Beam
We investigated the oxidation of oxygen vacancies at the surface of anatase TiO2(001) using a supersonic seeded molecular beam (SSMB) of oxygen. The oxygen vacancies at the top surface and subsurface could be eliminated by the supply of oxygen using an SSMB. Oxygen vacancies are present on the surface of anatase TiO2(001) which is not performed surface cleaning prior to XPS measurements under ultra-high vacuum. These vacancies, which are stable in the ambient condition, could also be effectively eliminated by using the oxygen SSMB.
- 19 February 2022
- Published by Elsevier in Surface Science
- Vol. 721, 122063
Local (111)-like reconstruction on highly-compressed Cu(001) regions
- 19 February 2022
- Published by Elsevier in Surface Science
- Vol. 721, 122063
Local (111)-like reconstruction on highly-compressed Cu(001) regions
- Open Access
- 3 February 2022
- Published by Beilstein Institut in Beilstein Journal of Nanotechnology
- Vol. 13 (1) , 172-181
Thermal oxidation process on Si(113)-(3 × 2) investigated using high-temperature scanning tunneling microscopy
Thermal oxidation of Si(113) in a monolayer regime was investigated using high-temperature scanning tunneling microscopy (STM). Dynamic processes during thermal oxidation were examined in three oxidation modes – oxidation, etching, and transition modes – in the third of which both oxidation and etching occur. A precise temperature–pressure growth mode diagram was obtained via careful measurements for Si(113), and the results were compared with those for Si(111) in the present work and Si(001) in the literature. Initial oxidation processes were identified based on high-resolution STM images.
- 3 February 2022
- Published by Beilstein Institut in Beilstein Journal of Nanotechnology
- Vol. 13 (1) , 172-181
Open AccessThermal oxidation process on Si(113)-(3 × 2) investigated using high-temperature scanning tunneling microscopy
Thermal oxidation of Si(113) in a monolayer regime was investigated using high-temperature scanning tunneling microscopy (STM). Dynamic processes during thermal oxidation were examined in three oxidation modes – oxidation, etching, and transition modes – in the third of which both oxidation and etching occur. A precise temperature–pressure growth mode diagram was obtained via careful measurements for Si(113), and the results were compared with those for Si(111) in the present work and Si(001) in the literature. Initial oxidation processes were identified based on high-resolution STM images.
- 1 February 2022
- Published by Elsevier in Surface Science
- Vol. 716
The effect of water exposure on FePc thin films grown on bismuth-covered Si(111) surfaces
- 1 February 2022
- Published by Elsevier in Surface Science
- Vol. 716
The effect of water exposure on FePc thin films grown on bismuth-covered Si(111) surfaces
- 13 October 2021
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 37 (42) , 12313-12317
Oxidation of Anatase TiO2(001) Surface Using Supersonic Seeded Oxygen Molecular Beam
We investigated the oxidation of oxygen vacancies at the surface of anatase TiO2(001) using a supersonic seeded molecular beam (SSMB) of oxygen. The oxygen vacancies at the top surface and subsurface could be eliminated by the supply of oxygen using an SSMB. Oxygen vacancies are present on the surface of anatase TiO2(001) when it is untreated before transfer to a vacuum chamber. These vacancies, which are stable in the as-grown condition, could also be effectively eliminated by using the oxygen SSMB.
- 13 October 2021
- Published by American Chemical Society (ACS) in Langmuir
- Vol. 37 (42) , 12313-12317
Oxidation of Anatase TiO2(001) Surface Using Supersonic Seeded Oxygen Molecular Beam
We investigated the oxidation of oxygen vacancies at the surface of anatase TiO2(001) using a supersonic seeded molecular beam (SSMB) of oxygen. The oxygen vacancies at the top surface and subsurface could be eliminated by the supply of oxygen using an SSMB. Oxygen vacancies are present on the surface of anatase TiO2(001) when it is untreated before transfer to a vacuum chamber. These vacancies, which are stable in the as-grown condition, could also be effectively eliminated by using the oxygen SSMB.