Pablo Oscar Vaccaro

We deposited Ge layers on (001) Si substrates by molecular beam epitaxy and used them to fabricate suspended membranes with high uniaxial tensile strain. We demonstrate a CMOS-compatible fabrication strategy to increase strain concentration and to eliminate the Ge buffer layer near the Ge/Si hetero-interface deposited at low temperature. This is achieved by a two-steps patterning and selective etching process. First, a bridge and neck shape is patterned in the Ge membrane, then the neck is thinned from both top and bottom sides. Uniaxial tensile strain values higher than 3% were measured by Raman scattering in a Ge membrane of 76 nm thickness. For the challenging thickness measurement on micrometer-size membranes suspended far away from the substrate a characterization method based on pump-and-probe reflectivity measurements was applied, using an asynchronous optical sampling technique.

We report on structural, compositional, and thermal characterization of self-assembled in-plane epitaxial Si_1−x Ge _x alloy nanowires grown by molecular beam epitaxy on Si (001) substrates. The thermal properties were studied by means of scanning thermal microscopy (SThM), while the microstructural characteristics, the spatial distribution of the elemental composition of the alloy nanowires and the sample surface were investigated by transmission electron microscopy and energy dispersive x-ray microanalysis. We provide new insights regarding the morphology of the in-plane nanostructures, their size-dependent gradient chemical composition, and the formation of a 5 nm thick wetting layer on the Si substrate surface. In addition, we directly probe heat transfer between a heated scanning probe sensor and Si_1−x Ge _x alloy nanowires of different morphological characteristics and we quantify their thermal resistance variations. We correlate the variations of the thermal signal to the dependence of the heat spreading with the cross-sectional geometry of the nanowires using finite element method simulations. With this method we determine the thermal conductivity of the nanowires with values in the range of 2–3 W m⁻¹ K⁻¹. These results provide valuable information in growth processes and show the great capability of the SThM technique in ambient environment for nanoscale thermal studies, otherwise not possible using conventional techniques.

Mechanisms of carrier sweep-out in tandem InGaN multiple-quantum-well self-pulsating laser diodes were investigated. Laser diodes showed self-pulsating characteristics without significant change in the light output–current (I–L) characteristics when an electric field high enough was established in the saturable absorber by the applied reverse bias. Improvements in the design of the band-energy profile allowed a substantial reduction in the bias required for self-pulsating operation. These results indicate that carrier lifetime can be controlled by the electric field in the saturable absorber and that band-energy profile engineering is effective for the reduction of carrier lifetime.

Mechanisms of carrier sweep-out in tandem InGaN multiple-quantum-well self-pulsating laser diodes were investigated. Laser diodes showed self-pulsating characteristics without significant change in the light output–current (I–L) characteristics when an electric field high enough was established in the saturable absorber by the applied reverse bias. Improvements in the design of the band-energy profile allowed a substantial reduction in the bias required for self-pulsating operation. These results indicate that carrier lifetime can be controlled by the electric field in the saturable absorber and that band-energy profile engineering is effective for the reduction of carrier lifetime.