MSMarco Schwerdt

Marco Schwerdt

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Marco Schwerdt has a total of 38 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Independent SAR System Calibration of Sentinel-1C

    by Patrick Klenk, Kersten Schmidt, Jakob Giez, Andrea Pulella, Matteo Nannini, Pau Prats-Iraola, Marco Schwerdt

    Sentinel-1 C is the third satellite of the Sentinel-1 mission. Launched in late 2024, it ensures seamless continuity of C-band SAR data for global monitoring of the Earth surface in the framework of the Copernicus program. In parallel to the commissioning of Sentinel-1 C by the European Space Agency (ESA), an independent verification of the system calibration has been performed by the German Aerospace Center (DLR) under an ESA contract. Based on an efficient calibration strategy, this paper describes the different activities performed and discusses in detail the results and main findings of DLR during the commissioning phase (CP) of Sentinel-1 C. The main goal is to provide a comprehensive compendium of the SAR calibration and performance status of S1C at the beginning of its operational mission: At the end of the commissioning phase we find that S1C achieves or even exceeds all SAR performance requirements put forth and is ready for its nominal mission operations.


  • Open Access

    Highly Accurate Radar Cross-Section and Transfer Function Measurement of a Digital Calibration Transponder without Known Reference—Part II: Uncertainty Estimation and Validation

    by Jens Reimann, Anna Maria Büchner, Sebastian Raab, Klaus Weidenhaupt, Matthias Jirousek, Marco Schwerdt

    Active radar calibrators (ARCs), also known as calibration transponders, are often used as reference targets for the absolute radiometric calibration of radar systems due to their large radar cross-sections (RCSs). Before such a transponder can be used as a reference target, the hardware itself has to be calibrated. A novel method, called the three-transponder method, was proposed some years ago to allow for RCS calibration of digital transponders without using any known RCS targets as reference. The first part of this paper refines the technique and presents the measurement setup as well as the results of a comprehensive measurement campaign performed to calibrate a single digital transponder. In this part of the paper, the results are validated and a comprehensive uncertainty analysis is performed to estimate the total RCS uncertainty associated with the presented measurement data. This uncertainty analysis follows the international standard “Guide to the expression of uncertainty in measurement” (GUM) and will derive expressions for all major sources of uncertainty. For the validation, the measurement results will be compared with full-wave electromagnetic simulations of trihedral corner reflectors; there is excellent agreement between the simulation and measurements.


  • Open Access

    Radiometric Re-Compensation of Sentinel-1 SAR Data Products for Artificial Biases due to Antenna Pattern Changes

    by Kersten Schmidt, Marco Schwerdt, Guillaume Hajduch, Pauline Vincent, Andrea Recchia, Muriel Pinheiro

    SAR data products for Sentinel-1 have been freely available and delivered operationally on behalf of the European Space Agency since the routine operation of Sentinel-1A in 2014. These products were delivered using the best knowledge at their processing time, in particular with respect to the radiometric calibration. As reprocessing of SAR data products is not foreseen in the nominal processing chain of Sentinel-1, changes of applied processing parameters impact the SAR data quality and can be a disturbing factor for long-term monitoring of radiometric features. In particular, antenna pattern updates produce artificial radiometric steps which are visible in radar backscatter time series, especially in case of monitoring radiometric stable reference targets. This paper introduces a method for correcting changes due to such updates without the need of reprocessing SAR data products. The method was applied to long-lasting time series of data acquisitions which are used to monitor the radiometric performance with reference targets at the DLR calibration site. It has been shown that artificial steps due to antenna pattern updates disappear in backscatter timelines after correct application. Furthermore, the derived absolute radiometric accuracy was improved for the joint observation period of S1A and S1B for almost five years until December 2021.


  • Open Access

    Highly Accurate Radar Cross-Section and Transfer Function Measurement of a Digital Calibration Transponder without Known Reference—Part I: Measurement and Results

    by Jens Reimann, Anna Maria Büchner, Sebastian Raab, Klaus Weidenhaupt, Matthias Jirousek, Marco Schwerdt

    Active Radar Calibrators (ARC), also called calibration transponders, are often used as reference targets for absolute radiometric calibration of radar systems due to their large achievable Radar Cross-Section (RCS). However, before using a transponder as a reference target, the hardware itself has to be calibrated. A novel method, called the three-transponder method, was proposed some years ago and allows for RCS calibration of digital transponders without using any RCS targets as reference. In this paper, this technique is further refined and applied to a setup utilizing only one digital transponder. The accurate measurement design is described and a novel, elaborated data processing scheme is developed to minimize remaining noise and clutter effects in the data. A comprehensive error analysis is presented in the second part of this paper.


  • Open Access

    Mitigation of Mutual Antenna Coupling Effects for Active Radar Targets in L-Band

    by Anna Maria Büchner, Klaus Weidenhaupt, Bernd Gabler, Markus Limbach, Marco Schwerdt

    In order to realize a compact L-band transponder design for the calibration of spaceborne synthetic aperture radar (SAR) systems, a novel antenna was developed by DLR. As with previous designs for different frequency bands, the future transponder is based on a two-antenna concept. This paper addresses the issue of antenna coupling between corrugated L-band horn antennas, which are operated in close proximity. The antenna coupling is analyzed via simulations and measurements by utilizing specifically defined coupling parameters. Additionally, improvements to further lower the mutual antenna coupling have been designed, tested, and are described in this paper.


  • Open Access

    TanDEM-X Long-Term System Performance After 10 Years of Operation

    by Allan Bojarski, Markus Bachmann, Johannes Boer, Thomas Kraus, Christopher Wecklich, Ulrich Steinbrecher, Nuria Tous-Ramon, Kersten Schmidt, Patrick Klenk, Christo Grigorov, et al.

    The TanDEM-X mission, formed by the TanDEM-X satellite (TDX) in cooperation with its almost identical twin TerraSAR-X (TSX), has mainly been designed to acquire bistatic Synthetic Aperture Radar (SAR) images of the Earth. Initiated in 2010, the primary mission objectives were to generate a global Digital Elevation Model (DEM), to perform scientific measurements and to explore novel SAR techniques. Up to the present day all these objectives have been completed with outstanding results. In addition, the satellites maintained a stable image quality from the start throughout their entire lifetime. The ground segment, which was tailored to the capabilities of the space segment, as well as an excellent design and manufacturing of the satellites were the key elements to achieve such a performance. In addition, the elaborate calibration concept and a careful treatment of the on-board resources enabled full operability up to the present day and allowed additional mission objectives such as the generation of a Change-DEM layer as an update to the global DEM. The stable bus and SAR payload performance as revealed by long-term system monitoring provide the basis for further extension of the TanDEM-X mission for several more years. In the following paper these long-term system monitoring results are presented to provide an overview of the evolution of the radar system. The results and experience gained with more than a decade of TanDEM-X mission operation are a great value for both the scientific and commercial community and serve as a forerunner for the development of future SAR missions.


  • Open Access

    Technique for Concurrent Internal Calibration during Data Acquisition for SAR Systems

    by Jens Reimann, Marco Schwerdt

    Nowadays, stringent requirements for the quality of SAR data products exist. The radiometric and image quality requirements can only be fulfilled by knowing the disturbances caused by the radar hardware itself. The internal calibration is a mechanism to estimate these disturbances from the real hardware. Unfortunately, most of the current internal calibration schemes interrupt the SAR data acquisition during internal calibration and hence cause a loss of azimuth samples and a degradation of the image quality. The calibration is thus often performed only before and after a data take. However, these two calibration events are hardly sufficient to estimate the instrument parameters during the whole acquisition especially for long data takes, which will become more common in future SAR system. In this paper, an internal calibration scheme is introduced which allows performing the internal calibration during nominal data acquisition by injecting a coded calibration signal into the receiver with very low power. This signal causes only minor degradation of the SAR image but can be retrieved from the data using adequate signal processing. This technique is described, the theoretical performance estimated, and finally demonstrated on real data from the TerraSAR-X mission. A selection of possible coding scheme is also analyzed with respect to their suitability for the proposed internal calibration scheme.


  • Open Access

    Radiometric Comparison within the Sentinel-1 SAR Constellation over a Wide Backscatter Range

    by Kersten Schmidt, Marco Schwerdt, Nuno Miranda, Jens Reimann

    Radiometric calibration adjusts the measured pixel intensity to a physical property, the radar cross section (RCS). After calibration, this relationship is defined over the entire backscatter range: from low image power (near noise) up to high reflections (below saturation). Based on a proper radiometric calibration, the measured radar backscatter for the Sentinel-1 synthetic aperture radar (SAR) satellite constellation is validated over a wide backscatter range using different target types. Therefore, the RCS derived from point targets and radar brightness from distributed targets are compared between Sentinel-1A (S-1A) and Sentinel-1B (S-1B) acquisitions over the same observation area for regions where a stable target backscatter is expected for a certain period of time. Low differences (in the order of 0.3 dB) are found between S-1A and S-1B for high and medium backscatter derived from point targets or rainforest regions, but higher differences for low backscattering regions like ice areas and lakes. For comparing radar brightness containing low backscatter targets, an accurate derived noise level has to be taken into account. In addition to the measured lower noise equivalent beta zero (NEBZ) level, higher transmit power was detected for S-1B compared to S-1A. The higher antenna gain of S-1B leads finally to a higher sensitivity for low backscattering areas of S-1B compared to S-1A and explains the found differences.


  • Open Access

    Precise Antenna Pointing Determination in Elevation for Spaceborne SAR Systems Using Coherent Pattern Differences

    by Jens Reimann, Marco Schwerdt, Kersten Schmidt, Patrick T. P. Klenk, Ulrich Steinbrecher, Helko Breit

    The precise determination of the SAR (synthetic aperture radar) antenna pointing is an essential task initially performed during the commissioning phase of a spaceborne SAR system and is permanently monitored during the whole mission life-time. Besides a correct illumination of the scene during data acquisition, antenna pointing is required for proper compensation of the radiation pattern for radiometric correction during SAR data processing. The Amazon rainforest is a well-established target area for antenna pointing estimation in elevation as proven by many past and current SAR missions. Several new SAR systems are now proposed which are using long wavelengths, i.e., L- and P-bands, which will be implemented using reflector-based antenna systems. These reflectors have, in contrast to planar phased array antennas, no completely rigid connection to the satellite body and, hence, a more volatile antenna pointing. Due to the huge dimensions of such reflector antennas required for the envisaged long wavelengths and the finite stiffness of the boom, the antenna pointing may change significantly along the orbit. Such variation cannot be tracked using the common Amazon rainforest approach only, as this measurement opportunity exists only at two positions along the orbit (ascending and descending). Here, the performance of an alternative technique is presented which mitigates the influence of the underlying SAR scene by employing two coherent SAR datasets acquired simultaneously with different antenna patterns. This allows the use of amplitude and phase information for pointing estimation. No assumption upon the homogeneity of the underlying scene is required and, hence, pointing estimation becomes feasible at nearly any point along the orbit. This paper outlines the technique, describes simulation results and presents outcomes from first experimental acquisitions performed with the TerraSAR-X satellite.


  • Open Access

    Radiometric Performance of the TerraSAR-X Mission over More Than Ten Years of Operation

    by Marco Schwerdt, Kersten Schmidt, Patrick Klenk, Núria Tous Ramon, Daniel Rudolf, Sebastian Raab, Klaus Weidenhaupt, Jens Reimann, Manfred Zink

    The TerraSAR-X mission, based on two satellites, has produced SAR data products of high quality for a number of scientific and commercial applications for more than ten years. To guarantee the stability and the reliability of these highly accurate SAR data products, both systems were first accurately calibrated during their respective commissioning phases and have been permanently monitored since then. Based on a short description of the methods applied, this paper focuses on the radiometric performance including the gain and phase properties of the transmit/receiver modules, the antenna pattern checked by evaluating scenes acquired over uniformly distributed targets and the radiometric stability derived from permanently deployed point targets. The outcome demonstrates the remarkable performance of both systems since their respective launch.